Numerical study of the rectilinear isosceles restricted problem

We study the orbit of a particle in the plane of symmetry of two equal mass primaries in rectilinear keplerian motion. Using the surfaces of section we look for periodic orbits, examine their stability and search for quasi-periodic orbits and regions of escape. For large values of the angular momentumC, we verify the validity of the approximation of two fixed centers. However, we also find irregular families of orbits and resonance zones.For small values ofC, the approximation is no longer valid, but we find invariant curves whose interpretation might be interesting.     

Absolute abundances and distribution of material versus density and temperature in a coronal condensation

Data derived from coronal eclipse spectra in the visible range are analyzed in terms of electron density and temperature in a coronal condensation using the method recently developed by Jefferies, Orrall and Zirker. A mean density and a certain amount of material are associated to each temperature. Abundances relative to Fe are derived for Ni, Cr, Mn, S, Ca. The absolute abundance of Fe is found to be 2 × 10^?5. No absolute calibration is required. It appears that there must exist a non-negligible amount of ‘cold’ material (T _e < 10⁶K) in the corona, which cannot be observed in the visible spectral range.

     

Systems of colliding bodies in a gravitational field: Evolution and role of the internal rotations

To emphasize the rotational effects of a simple friction between colliding bodies in a keplerian field we investigate numerically the evolution of the rotational energies in a three dimensional system of spherical particles interacting through inelastic collisions in a deterministic model. All the particles are made of the same material but they possibly have different sizes. Each collision reduces the relative surface velocity and there are exchanges between orbital energy and rotational energy. Our results are compared with some previous papers and our aim is to supply other probabilists models with simple basic references about mean dynamical properties.The rotational energy of the colliding bodies tends to reach an equilibrium state that depends only on the rate of energy loss in the collision process. Internal rotations prevent the complete flattening of the system. With this model, light and small particles spin faster than the massive and big ones. We observe an excess of prograde rotations on counterclockwise orbits. The ratio of rotational and orbital energies is % MathType!MTEF!2!1!+-% feaafeart1ev1aaatCvAUfeBSjuyZL2yd9gzLbvyNv2CaerbuLwBLn% hiov2DGi1BTfMBaeXatLxBI9gBaerbd9wDYLwzYbItLDharqqtubsr% 4rNCHbGeaGqiVu0Je9sqqrpepC0xbbL8F4rqqrFfpeea0xe9Lq-Jc9% vqaqpepm0xbba9pwe9Q8fs0-yqaqpepae9pg0FirpepeKkFr0xfr-x% fr-xb9adbaqaaeGaciGaaiaabeqaamaabaabaaGcbaGaamyramaaBa% aaleaacaWGYbaabeaakiaac+cacaWGfbWaaSbaaSqaaiaadUgaaeqa% aOGaeyisISRaaGymaiaaicdadaahaaWcbeqaaiabgkHiTiaaiodaaa% aaaa!3F83!\[E_r /E_k \approx 10^{ - 3} \] while the ratio of corresponding mean angular velocities is % MathType!MTEF!2!1!+-% feaafeart1ev1aaatCvAUfeBSjuyZL2yd9gzLbvyNv2CaerbuLwBLn% hiov2DGi1BTfMBaeXatLxBI9gBaerbd9wDYLwzYbItLDharqqtubsr% 4rNCHbGeaGqiVu0Je9sqqrpepC0xbbL8F4rqqrFfpeea0xe9Lq-Jc9% vqaqpepm0xbba9pwe9Q8fs0-yqaqpepae9pg0FirpepeKkFr0xfr-x% fr-xb9adbaqaaeGaciGaaiaabeqaamaabaabaaGcbaWaaaWaaeaacq% aHjpWDaiaawMYicaGLQmcacaGGVaWaaaWaaeaacqGHPoWvaiaawMYi% caGLQmcacqGHijYUcaaIYaaaaa!4008!\[\left\langle \omega \right\rangle /\left\langle \Omega \right\rangle \approx 2\] These values depends strongly on the dimensional scale of the model.     

Sunken wood habitat for thiotrophic symbiosis in mangrove swamps

Large organic falls to the benthic environment, such as dead wood or whale bones, harbour organisms relying on sulfide-oxidizing symbionts. Nothing is known however, concerning sulfide enrichment at the wood surface and its relation to wood colonization by sulfide-oxidizing symbiotic organisms.In this study we combined in situ hydrogen sulfide and pH measurements on sunken wood, with associated fauna microscopy analyses in a tropical mangrove swamp. This shallow environment is known to harbour thiotrophic symbioses and is also abundantly supplied with sunken wood. A significant sulfide enrichment at the wood surface was revealed. A 72 h sequence of measurements emphasized the wide fluctuation of sulfide levels (0.1–>100 μM) over time with both a tidal influence and rapid fluctuations. Protozoans observed on the wood surface were similar to Zoothamnium niveum and to vorticellids. Our SEM observations revealed their association with ectosymbiotic bacteria, which are likely to be sulfide-oxidizers. These results support the idea that sunken wood surfaces constitute an environment suitable for sulfide-oxidizing symbioses.     

Experimental investigation on the seismic performance of masonry buildings using shaking table testing

Masonry buildings worldwide exhibited severe damage and collapse in recent strong earthquake events. It is known that their brittle behavior, which is mainly due to the combination of low tensile strength, large mass and insufficient connection between structural elements, is the main limitation for their structural implementation in residential buildings. A new construction system for masonry buildings using concrete blocks units and trussed reinforcement is presented here and its seismic behavior is validated through shaking table tests. Dynamic tests of two geometrically identical two-story reduced scale (1:2) models have been carried out, considering artificial accelerograms compatible with the elastic response spectrum defined by the Eurocode 8. The first model was reinforced with the new proposed system while the second model was built with unreinforced masonry. The experimental analysis encompasses local and global parameters such as cracking patterns, failure mechanisms, and in-plane and out-of-plane behavior in terms of displacements and lateral drifts from where the global dynamic behavior of the two buildings is analyzed comparatively. Finally, behavior factors for the design recommendations in case of unreinforced masonry are also evaluated.     

Sorption-desorption kinetics and toxic cell concentration in marine phytoplankton microalgae exposed to Linear Alkylbenzene Sulfonate

Linear Alkylbenzene Sulfonates (LAS) are ubiquitous surfactants. Traces can be found in coastal environments. Sorption and toxicity of C₁₂-LAS congeners were studied in controlled conditions (2-3500 μg C₁₂LAS/L) in five marine phytoplanktonic species, using standardized methods. IC₅₀ values ranged from 0.5 to 2 mg LAS/L. Sorption of ¹⁴C₁₂-6 LAS isomer was measured at environmentally relevant trace levels (4 μg/L) using liquid scintillation counting. Steady-state sorption on algae was reached within 5 h in the order dinoflagellate > diatoms > green algae. The sorption data, fitted a L-type Freundlich isotherm, indicating saturation. Desorption was rapid but a low LAS fraction was still sorbed after 24 h. Toxic cell concentration was 0.38 ± 0.09 mg/g for the studied species. LAS toxicity results from sorption on biological membranes leading to non-specific disturbance of algal growth. Results indicate that LAS concentrations in coastal environments do not represent a risk for these organisms.     

Macrobenthic community for assessment of estuarine health in tropical areas (Northeast, Brazil): Review of macrofauna classification in ecological groups and application of AZTI Marine Biotic Index

The aim of the present study was to investigate the ecological quality of tropical estuaries on the northeastern coast of Brazil using the AMBI. Macrofauna classification based on ecological groups was reviewed using the Indicator Value (IndVal) coefficient. The results indicate that the ecosystems exhibit some level of disturbance. Most sites are situated between slightly-moderately disturbed boundaries due to the higher proportion of Nematoda (assigned here as Ecological Group I) and of Oligochaeta and Tubificidae (both classified as Ecological Group V). The AMBI proved efficient in evaluating environmental status, although the applicability of this index requires adjustments regarding some species in ecological groups. The present study also highlights the merits of the IndVal method for examining the assignments of species/taxa to an ecological group and demonstrates the validity of this coefficient is an assessment tool. Moreover, the complementary use of different methods is recommended for the assessment of ecosystem quality.     

A Multi‐Element Ion‐Pair Extraction for Trace Metals Determination in Environmental Samples

A multi‐element ion‐pair extraction method was described for the preconcentration of Cd(II), Co(II), Cr(III), Cu(II), Fe(III), Mn(II), Ni(II), Pb(II), and Zn(II) ions in environmental samples prior to their determinations by flame atomic absorption spectrometry (FAAS). As an ion‐pair ligand 2‐(4‐methoxybenzoyl)‐N′‐benzylidene‐3‐(4‐methoxyphenyl)‐3‐oxo‐N‐phenyl‐propono hydrazide (MBMP) was used. Some analytical parameters such as pH of sample solution, amount of MBMP, shaking time, sample volume, and type of counter ion were investigated to establish optimum experimental conditions. No interferences due to major components and some metal ions of the samples were observed. The detection limits of the proposed method were found in the range of 0.33–0.9 µg L^?1 for the analyte ions. Recoveries were found to be higher than 95% and the relative standard deviation (RSD) was less than 4%. The accuracy of the procedure was estimated by analyzing the two certified reference materials, LGC6019 river water and RTC‐CRM044 soil. The developed method was applied to several matrices such as water, hair, and food samples.     

Numerically based proposals for the stiffness and strength of masonry infills with openings in reinforced concrete frames

Aimed at investigating the effect of openings on the in‐plane behaviour of masonry infills in reinforced concrete frames, a parametric study is presented based on model calibration via experimental tests. Two types of openings are investigated: central window openings and different combinations of door and window openings based on the typologies of southern European countries. First, a finite element model of the structure is made using the DIANA software program. Then, after calibration with experimental results, a parametric analysis is carried out to investigate the effect of the presence and location of the different types of openings on the in‐plane behaviour of the infilled frame. Finally, different equations for predicting the initial stiffness and lateral strength of infilled frames with any types of openings were obtained. An α factor related to the geometry of the piers between openings is proposed to take into account the location of the openings in the developed equations. Subsequently, the masonry infill panel is replaced by a diagonal strut. An empirical equation is also proposed for the width of an equivalent strut to replace a masonry infill panel with openings in such a way that they possess the same initial stiffness. Copyright © 2015 John Wiley & Sons, Ltd.