With the advent of new global navigation satellite systems (GNSSs) and new signals, GNSS users will rely more on them to obtain higher-accuracy positioning. Evil waveform monitoring and assessment are of great importance for GNSS to achieve its positioning, velocity, and timing service with high accuracy. However, the advent of new navigation signals introduces the necessity to extend the traditional analyzing techniques already accepted for binary phase-shift keying modulation to new techniques. First, the well-known second-order step thread model adopted by the International Civil Aviation Organization is introduced. Then the extended new general thread models are developed for the new binary offset carrier modulated signals. However, no research has been done on navigation signal waveform symmetry yet. Simulation results showed that, waveform asymmetry may also cause tracking errors, range biases, and position errors in GNSS receivers. It is thus imperative that the asymmetry be quantified to enable the design of appropriate error budgets and mitigation strategies for various application fields. A novel evil waveform analysis method, called waveform rising and falling edge symmetry (WRaFES) method, is proposed. Based on this WRaFES method, the correlation metrics are provided to detect asymmetric correlation peaks distorted by received signal asymmetry. Then the statistical properties of the proposed methods are analyzed, and a proper deformation detection threshold is calculated. Finally, both simulation results and experimentally measured results of Beidou navigation satellite system (BDS) M1-S B1Cd signal are given, which show the effectiveness and robustness of the proposed thread models. 相似文献
Discrete element method has been widely adopted to simulate processes that are challenging to continuum-based approaches. However, its computational efficiency can be greatly compromised when large number of particles are required to model regions of less interest to researchers. Due to this, the application of DEM to boundary value problems has been limited. This paper introduces a three-dimensional discrete element–finite difference coupling method, in which the discrete–continuum interactions are modeled in local coordinate systems where the force and displacement compatibilities between the coupled subdomains are considered. The method is validated using a model dynamic compaction test on sand. The comparison between the numerical and physical test results shows that the coupling method can effectively simulate the dynamic compaction process. The responses of the DEM model show that dynamic stress propagation (compaction mechanism) and tamper penetration (bearing capacity mechanism) play very different roles in soil deformations. Under impact loading, the soil undergoes a transient weakening process induced by dynamic stress propagation, which makes the soil easier to densify under bearing capacity mechanism. The distribution of tamping energy between the two mechanisms can influence the compaction efficiency, and allocating higher compaction energy to bearing capacity mechanism could improve the efficiency of dynamic compaction.