Greenhouse Gas Dynamics of an Increased Use of Wood in Buildings in Switzerland

Long-living wood products contribute to the mitigation of climate change in many ways. They act as a carbon pool during their service life, as they withdraw CO₂ from its natural cycle. After their service life, they can stitute for fossil fuels if they are incinerated in adequate furnaces. Furthermore, wood products can stitute for more energy-intense products made of ‘conventional’ materials. This paper quantifies the stitution and pool effects of an increased use of wood in the building sector in Switzerland for the years 2000–2130. Life cycle data on greenhouse gas (GHG) emissions of 12 wood products and their stitutes are used as proxies for relevant building products; this data is linked to the forecasted wood flows for each group of building products in a cohort-model. For the political assessment, GHG effects occurring abroad and in Switzerland are distinguished. The results show that the pool effect of an increased use of long-living wood products is of minor importance, whereas the energetic and material stitution effects are much more relevant, especially on a long-term. For construction products, the Swiss share of the GHG effect related to the material stitution is relatively high, as mainly nationally produced materials are stituted for. For interior products, the Swiss share of the GHG effect related to the material stitution is rather small because mainly imports are stituted for. The results must be considered as rough estimates. Nonetheless, these calculations show that an increased use of wood in the building sector is a valid and valuable option for the mitigation of greenhouse gas emissions and for reaching GHG emission targets in a mid- to long-term. Still, the pool and stitution capacity of an increased use of wood is relatively small compared to the overall GHG emissions of Switzerland.     

A Fully Depleted pn-Junction CCD for Infrared-, UV- and X- ray detection

This paper describes the performance of the Fully Depleted pn-junction CCD (pn-CCD) system, developed for ESA's XMM-satellite mission for soft x-ray imaging and spectroscopy in the single photon counting mode in the 100 eV to 10 keV photon range. The 58 mm x 60 mm large pn-CCD array, designed and fabricated at the Semiconductor Lab (Halbleiterlabor) of the Max-Planck-Institut, uses pn-junctions for registers and as backside structure. This concept naturally enables full depletion of the detector volume independent of the silicon wafer's resistivity and thickness, and as such make it an efficient detector for the x-ray region and the infrared. For high detection efficiency in the soft x-ray region and UV, an ultrathin pn-CCD backside deadlayer has been realized. Each pn-CCD-channel is equipped with its own on-chip JFET amplifier which, in combination with the CAMEX-amplifier and multiplexing chip, facilitates parallel readout and fast data rate: the cooled pn-CCD system can be read out at a data rate up to 3 MHz with an electronic noise floor of ENC < 5 e-.     

Orthogneisses of the Spessart crystalline complex,Northwest Bavaria: Indicators of the geotectonic environment?

The orthogneisses of the Spessart crystalline complex are derived from a granitic to granodioritic magma of S-type character which must have formed by anatexis of continental crust. It intruded into a relatively shallow crustal level, 410–420 Ma ago, at the Silurian. Trace element characteristics are consistent with a post-collision geotectonic environment testifying to extensional tectonics at the end of the Caledonian era.

---

Zusammenfassung Die Orthogneise des Spessartkristallins lassen sich von einem granitischen bis granodioritischen Magma von S-Typ-Charakter ableiten, das durch Anatexis kontinentaler Kruste entstanden sein mu\ und in ein relativ oberflächennahes Krustenniveau intrudierte. Die Platznahme erfolgte vor 410–420 Ma, d. h. im Silur. Die Spurenelement-Muster der Orthogneise entsprechen denen von Post-Kollisions-Granitoiden, was als Hinweis auf eine Phase der Dehnungstektonik am Ende der kaledonischen ära bewertet werden kann.

---

Résumé Les orthogneiss du Spessart sont dérivés d'un magma granitique à granodioritique de type S qui doit s'Être formé par anatexie de la croûte continentale. Ce magma a été intrudé dans un niveau peu profond de la croûte il y a 410–420 Ma c'est-à-dire au Silurien. La distribution des éléments en traces est en accord avec celle des granitoÏdes formés dans un contexte géodynamique de post-collision. Cette observation est en faveur d'une phase d'extension tectonique à la fin du cycle calédonien.

---

, — Wojcieszów-Kalke. , — . . , , , , .

     

Proterozoic deformation of the East Saharan Craton in Southeast Libya, South Egypt and North Sudan

The basement areas in Southeast Libya, South Egypt and North Sudan, west of the Nile, between Gebel Uweinat and the Bayuda Desert, are part of an approximately 1000-km-wide, complexly folded, polymetamorphic zone with a regional N-NNE-NE-ENE trend of foliation and fold axis. Since this belt extends southwestward into the area of Zalingei in the southern Darfur block (West Sudan), it is named the Northern Zalingei fold zone. Sr and Nd isotopic studies suggest that this zone is older than Pan-African and further indicate that, apart from Archean rocks in the Gebel Uweinat area, this belt is of Early-Middle Proterozoic age. An Early-Middle Proterozoic three-stage deformational and anatectic event established the present-day fold and fault geometry in the western parts of this zone in the Gebel Uweinat—Gebel Kamil area. The Pan-African tectono-thermal episode was most effective in the eastern part of the belt, near the boundary with the Nubian Shield volcano-sedimentary-ophiolite-granitoid assemblages. It caused migmatization, granite emplacement, mylonitization and large-scale wrench faulting which was related to Late Proterozoic accretionary and collisional events of the Arabian-Nubian Shield with the margin of the East Saharan Craton.     

Fish and ostracod remains from the Santos Basin (Cretaceous to Recent), Brazil

For the first time, ichthyoliths are described from the Santos sedimentary basin, offshore southern Brazil. Isolated teeth, dermal scales and the first documented otoliths from Cretaceous (Albian) to Recent cuttings from five wells are described. The following groups are represented: Chondrichthyans: Triakidae, Carcharhinidae; Ginglymostomatidae: ?Ginglymostoma sp., Lamnidae indet., Scyliorhinidae; Osteichthyans: Teleostei; Myctophiidae: Diaphus aff. splendidus sp. complex, Diaphus spp., Diaphus cf. garmani, Ceratoscopelus aff. warmingii; Sternoptychidae: Valenciennellus tripunctulatus, teeth of indeterminate Teleostei. The majority of these ichthyofossils represent extant forms, known to occur in the Atlantic Ocean, and are of potential value for stratigraphical correlations between oil‐yielding basins in the region. Ostracods are not well preserved but can be identified to generic level indicating marine environments. The ostracod faunas offer potential for intrabasinal correlation in the Eocene and Oligocene. Copyright © 2002 John Wiley & Sons, Ltd.     

New insights into Southern Caucasian glacial–interglacial climate conditions inferred from Quaternary gastropod fauna

In the present study, we performed gastropod analyses on loess–palaeosol sequences from northeast Armenia (Southern Caucasia) covering at least three glacial–interglacial cycles. The elaborated ecostratigraphy shows significant patterns of species composition related to the succession of pedocomplexes and loess, respectively. Pedocomplexes included species that can be associated with high-grass to forest-steppe biomes, indicating increased humidity for these sections compared to the loess layers. In contrast, loess layers that relate to glacial periods are associated with gastropod species of semidesert environments with shrub- and shortgrass-steppes, indicating semiarid to arid conditions. Furthermore, the loess deposits do not show any evidence for cold-adapted gastropod species. Therefore, we suggest that average July temperatures in the study area were above 10 °C, even during periods of loess deposition. Consequently, we propose that the limiting factor for tree growth during glacial periods was aridity, rather than temperature. In addition, we observe environmental differences between the various glacial times, with our results indicating a trend towards steadily increasing aridity in Southern Caucasia across the Middle to Late Pleistocene.     

Constructing 3D Models of Rigid Objects from Satellite Images with High Spatial Resolution Using Convolutional Neural Networks

Izvestiya, Atmospheric and Oceanic Physics - A way of constructing 3D models of rigid objects from one satellite image is described. It is based on the use of two convolution neural networks which...