Characterization of soil's structural crust by spectral reflectance in the SWIR region (1.2–2.5 μm)

Structural crust is a thin layer formed on the soil surface after a rainstorm. The crust is the result of a physical segregation and rearrangement of soil particles in a way that affects some of the soil properties, such as infiltration, runoff and soil erosion. In practice, there is no rapid, in situ method for monitoring, assessing and mapping crust intensity and quality. In this study, a controlled spectral investigation of the structural crust across the NIR–SWIR spectral region was conducted on three selected Israeli soils, to study the potential of reflectance radiation to detect structural crust in soils. Two major factors served as the driving forces for this study: (1) there is no valid method for in situ assessment of the crust's characteristics in the agriculture field, and (2) the crust might bias thematic remote sensing of soils, because the thin layer of crust blocks photon–matter interaction, which represents the relevant soil body. Through the use of a laboratory rainfall simulator and a sensitive spectrometer, it was revealed that for three selected soils, significant spectral differences occurred between the crust and its bulk soil. The spectral information was found to be related to changes in particle size distribution and texture at the surface of the soil. This conclusion was based on indications of absorption of OH in clay lattice, OH in adsorbed water and CO₃ in carbonates. It was concluded that the structural crust is a phenomenon that should not be ignored by remote-sensing users. In fact, in the field of agriculture, the spectral properties of crust can be used as tools for estimating the crust's intensity.     

Deep-ocean vertical noise directionality

The structure of beam noise measured at the output of a vertical array in a range dependent ocean basin was investigated using the modified wide-angle parabolic equation (PE). Noise sources were distributed throughout the basin, and the field due to each noise source at an array located in the midbasin was calculated. The response of the array to the superposition of the noise sources was found by beamforming. An efficient and direct approach that superimposes the noise sources on the PE field as the field is marched toward the array was developed. Downslope calculations of the midbasin vertical directionality were made between 50 and 400 Hz with this technique. Use of a geoacoustic model shows that the bottom behaves as a low-pass filter     

Inverted echo sounder measurement of dynamic height through an ENSOcycle in the central equatorial Pacific

A four-year record from an inverted echo sounder deployed near Palmyra Island at 6°N in the central Pacific Ocean is compared with a simultaneous record of subsurface pressure from this island lagoon. A factor m, converting round-trip acoustic travel time to surface dynamic height relative to a deep pressure level, was estimated from the ratio of the spectra of the two records in the energetic synoptic oscillation band. Year-to-year variation in m was not statistically significant. For the overall record, m was found to be -70±8 dynamic m/s, where the error bounds represent a 90% confidence interval. This is consistent with first-baroclinic-mode excitation     

Three-dimensional linear solution for wave propagation with slopingbottom

This paper presents a three-dimensional analytic linear wave solution for surface gravity wave propagation over a sloping bottom that is valid for small, but realistic, slopes. The sloping-bottom linear model is compared to published laboratory data and to predictions of two-dimensional, constant-bottom nonlinear theories. The model is shown to describe the measured wave-height growth in the wave transformation region up to a limiting local Ursell number U_r of 0.35-1.0, depending on the wave type, although, as a linear model, it does not predict the harmonics observed in that range. For U_r<0.35, the harmonics can generally be neglected and the sloping-bottom linear theory agrees closely with both the published wave-height data and third-order Stokes nonlinear theory. As a three-dimensional linear model, superposition can be invoked to synthesize and relate wave structure in the transformation region to complex incident ocean spectra with both wind wave and swell components that arrive with a range of incidence angles. As such, the sloping-bottom linear model presented here should be a convenient useful tool for ocean modeling through a significant portion of the wave transformation region     

Evolution of 2:1 layered silicates in low-grade metamorphosed Liassic shales of Central Switzerland

White mica from the Liassic black shales and slates in Central Switzerland was analysed by transmission electron microscopy (TEM) and electron microprobe to determine its textural and compositional evolution during very low-grade prograde metamorphism. Samples were studied from the diagenetic zone, anchizone and epizone (T ≈100°–450 °C). Phyllosilicate minerals analysed include illite/smectite (I/S), phengite, muscovite, brammallite, paragonite, margarite and glauconite. Textural evolution primarily is towards larger, more defect-free grains with compositions that approach those of their respective end-members. The smectite-to-illite transformation reduced the amounts of the exchange components SiK_?1Al_?1, MgSiAl_?2, and Fe³⁺Al_?1. These trends continue to a lesser degree in the anchizone and epizone. Correlations between the proportion of smectite in I/S and the composition of I/S indicate that smectite layers may contain a high layer charge. Illite in I/S bears a compositional resemblance to macrocrystalline phengite in some samples, but is different in others. Paragonite first appears in the upper diagenetic zone or lower anchizone as an interlayer-deficient brammallite, and it may be mixed with muscovite on the nanometre scale. Owing to the small calculated structure factor for paragonite-muscovite superstructures, conventional X-ray powder diffraction cannot distinguish between mixed-layer structures and a homogeneous compositionally intermediate solid solutions. However, indirect TEM evidence shows that irregularly shaped domains of Na- and K-rich mica exist below 10 nm. Subsequent coarsening of domains at higher grades produced discrete paragonite grains at the margins of muscovite crystals or in laths parallel to the basal plane of the host muscovite. Margarite appears in the epizone and follows a textural evolution similar to paragonite in that mixtures of margarite, paragonite, and muscovite may initially occur on the nanometre scale. However, no evidence of interlayer-poor margarite has been found.     

Depositional and post‐depositional history of warm stage deposits at Knocknacran,Co. Monaghan,Ireland: implications for preservation of Irish last interglacial deposits

Organic‐rich deposits, uncovered during overburden removal from mantled gypsum karst at Knocknacran opencast gypsum mine, Co. Monaghan, are the best candidate to date for a last interglacial record in Ireland. The two till and organic‐rich deposits (preserved at different quarry elevations) were emplaced on to a Tertiary dolerite surface during high‐energy flood events and subsequently folded and faulted by movement towards sinkholes in underlying gypsum. Uranium–thorium disequilibrium dating suggests that the organic‐rich deposits in the upper section were hydrologically isolated at ca. 41 ka and those in the lower section at ca. 86 ka. Interpretation of the pollen content, although tentative because of the depositional and post‐depositional history of the material, suggests that the organic material originated in a warm stage possibly warmer than the post‐Eemian interstadials. The unusual setting of preservation may indicate that in situ, last interglacial deposits have generally been removed by erosion in Ireland. Copyright © 2004 John Wiley & Sons, Ltd.     

A comparative study of the zooplankton in two adjacent embayments,Port Phillip and Westernport Bays,Australia

We report on a year's study of spatial and seasonal patterns of zooplankton abundance in Port Phillip and Westernport Bays, July 1982 to August 1983. These two bays, closely adjacent on the southern coast of Victoria, Australia, differ in several respects: Port Phillip is a nearly landlocked bay with a broad basin, while Westernport is an open tidal embayment with extensive mud and seagrass banks. Both bays have a resident zooplankton fauna distinct from that of Bass Strait. Although these resident communities have many species in common, patterns of abundance and dominance are quite different. We found that the holoplankton of Port Phillip was about half copepods, mostly Paracalanus indicus, with 23% Caldocera and 21% larvaceans. Westernport Bay zooplankton was dominated by Acartia tranteri, with no resident cladoceran fauna. Bass Strait species were more often found in Westernport than in Port Phillip Bay, but the resident community of Port Phillip Bay was more similar to that of Bass Strait than to that of Westernport.Although this study was undertaken in an exceptionally dry year, the available historical data show that the overall patterns found in 1982–1983 are typical for these bays. The differences in community composition probably relate to differences in depth profile, predator abundance, and suspended matter between the bays.     

Stable isotope geochemistry and structural elements of the Sabina region (Central Apennines, Italy)

Various tectonic features are present in the Meso-Cenozoic basin units of the Sabina region (Central Apennines, Italy): Mio-Pliocene northeasterly verging thrusts are followed by Plio-Pleistocene, N-S oriented right-lateral strike-slip faults. Stable isotope geochemistry and examination of meso- and microstructures show that strain conditions differed through the course of tectonic history. Carbon and oxygen isotope analyses of the calate-filled extensional fractures, the sigmoidal veins present between stylolitic cleavage surfaces, and fault plane surfaces with differing motion, demonstrate those different geneses.
The "C/'" C of the older calcite-filling fractures (present both in the thrust and the strike-slip systems) suggests a deposition from shallow, fresh water circulation. Furthermore, the calcite fill of en echelon systems, that occur in the southernmost Plio-Pleistocene units, is clearly the result of a more recent, right-lateral strike-slip movement, connected with shallow water circulation within Mesozoic limestones.
The sigmoidal vein fills are derived from solid-state pressure solution processes which were the result of strike-slip movement. The deformation pattern related to the older thrust system is similar, but less intense; this also demonstrates general recrystallization processes in a closed system.
This suggests that the total shortening of the deformed sections is lower than that obtained on the basis of solution on stylolitic planes, because a sigruficant volume of dissolved carbonates remained in the system.
Stable isotope analysis also confirms that the deformational history of strongly cleaved rocks in the Sabina region took place in two phases and that extensional fractures formed before stylolithic planes, as suggested by structural and field observations.