全文获取类型
收费全文 | 223篇 |
免费 | 5篇 |
国内免费 | 9篇 |
专业分类
测绘学 | 4篇 |
大气科学 | 13篇 |
地球物理 | 45篇 |
地质学 | 63篇 |
海洋学 | 15篇 |
天文学 | 86篇 |
自然地理 | 11篇 |
出版年
2020年 | 3篇 |
2018年 | 6篇 |
2017年 | 5篇 |
2016年 | 5篇 |
2015年 | 3篇 |
2014年 | 4篇 |
2013年 | 6篇 |
2012年 | 9篇 |
2011年 | 9篇 |
2010年 | 10篇 |
2009年 | 20篇 |
2008年 | 8篇 |
2007年 | 13篇 |
2006年 | 9篇 |
2005年 | 7篇 |
2004年 | 6篇 |
2003年 | 8篇 |
2002年 | 2篇 |
2001年 | 4篇 |
2000年 | 5篇 |
1999年 | 4篇 |
1998年 | 4篇 |
1997年 | 8篇 |
1996年 | 2篇 |
1995年 | 3篇 |
1994年 | 4篇 |
1993年 | 8篇 |
1992年 | 3篇 |
1990年 | 2篇 |
1989年 | 6篇 |
1988年 | 2篇 |
1987年 | 1篇 |
1986年 | 2篇 |
1985年 | 5篇 |
1984年 | 3篇 |
1983年 | 2篇 |
1982年 | 4篇 |
1981年 | 1篇 |
1980年 | 9篇 |
1979年 | 3篇 |
1978年 | 1篇 |
1977年 | 2篇 |
1976年 | 2篇 |
1975年 | 2篇 |
1974年 | 2篇 |
1973年 | 2篇 |
1971年 | 2篇 |
1964年 | 1篇 |
1963年 | 1篇 |
1947年 | 1篇 |
排序方式: 共有237条查询结果,搜索用时 15 毫秒
41.
Scattered ground roll is a type of noise observed in land seismic data that can be particularly difficult to suppress. Typically, this type of noise cannot be removed using conventional velocity‐based filters. In this paper, we discuss a model‐driven form of seismic interferometry that allows suppression of scattered ground‐roll noise in land seismic data. The conventional cross‐correlate and stack interferometry approach results in scattered noise estimates between two receiver locations (i.e. as if one of the receivers had been replaced by a source). For noise suppression, this requires that each source we wish to attenuate the noise from is co‐located with a receiver. The model‐driven form differs, as the use of a simple model in place of one of the inputs for interferometry allows the scattered noise estimate to be made between a source and a receiver. This allows the method to be more flexible, as co‐location of sources and receivers is not required, and the method can be applied to data sets with a variety of different acquisition geometries. A simple plane‐wave model is used, allowing the method to remain relatively data driven, with weighting factors for the plane waves determined using a least‐squares solution. Using a number of both synthetic and real two‐dimensional (2D) and three‐dimensional (3D) land seismic data sets, we show that this model‐driven approach provides effective results, allowing suppression of scattered ground‐roll noise without having an adverse effect on the underlying signal. 相似文献
42.
In this paper, we present the development and application of a two-dimensional, automatic unstructured mesh generator for shallow water models called Admesh. Starting with only target minimum and maximum element sizes and points defining the boundary and bathymetry/ topography of the domain, the goal of the mesh generator is to automatically produce a high-quality mesh from this minimal set of input. From the geometry provided, properties such as local features, curvature of the boundary, bathymetric/topographic gradients, and approximate flow characteristics can be extracted, which are then used to determine local element sizes. The result is a high-quality mesh, with the correct amount of refinement where it is needed to resolve all the geometry and flow characteristics of the domain. Techniques incorporated include the use of the so-called signed distance function, which is used to determine critical geometric properties, the approximation of piecewise linear coastline data by smooth cubic splines, a so-called mesh function used to determine element sizes and control the size ratio of neighboring elements, and a spring-based force equilibrium approach used to improve the element quality of an initial mesh obtained from a simple Delaunay triangulation. Several meshes of shallow water domains created by the new mesh generator are presented. 相似文献
43.
The Open-source Project for a Network Data Access Protocol (OPeNDAP) software framework has evolved over the last 10 years to become a robust, high performance, service oriented architecture for the access and transport of scientific data from a broad variety of disciplines, over the Internet. Starting with version 4.0 of the server release, Hyrax, has at its core, the Back-End Server (BES). The BES offers ease of programming, extensibility and reliability allowing added functionality especially related to high-performance data Grids, that goes beyond its original goal of distributed data access. We present the fundamentals of the BES server as a component based architecture, as well as our experiences using the BES to distribute data processing in Grid-oriented intensive parallel computational tasks. 相似文献
44.
45.
Hiroshi Ishida Lars G. Golmen Julia West Martin Krüger Patricia Coombs John Arthur Berge Tastuo Fukuhara Michimasa Magi Jun Kita 《Marine pollution bulletin》2013
Carbon capture and storage (CCS) methods, either sub-seabed or in ocean depths, introduces risk of CO2 leakage and subsequent interaction with the ecosystem. It is therefore important to obtain information on possible effects of CO2. In situ CO2 exposure experiments were carried out twice for 10 days during 2005 using a Benthic Chamber system at 400 m depth in Storfjorden, Norway. pCO2 in the water above the sediment in the chambers was controlled at approximately 500, 5000 and 20,000 μatm, respectively. This article describes the experiment and the results from measured the biological responses within the chamber sediments. The results show effects of elevated CO2 concentrations on biological processes such as increased nanobenthos density. Methane production and sulphate reduction was enhanced in the approximately 5000 μatm chamber. 相似文献
46.
47.
Clay-rich till plains cover much of the UK. Such sites are attractive locations for landfills, since clay aquitards lower the risk of landfill leachate entering groundwater. However, such tills often contain sand and gravel bodies that can act as leachate flow routes. Such bodies may not be detected by conventional site investigation techniques such as drilling boreholes and trial pitting. A method of guided inversion, where a priori data are used to construct structural reference models for use in inverting electrical resistivity tomography data, was proposed as a tool to improve the detection of sand and gravel bodies within clay-rich till sequences.
Following a successful 2D guided inversion synthetic modelling study, a field study was undertaken. Wenner 2D electrical resistivity tomography lines, resistivity cone penetrometry bores and electromagnetic induction ground resistivity data were collected over a site on the East Yorkshire coast, England, where sand and gravel lenses were known to exist from cliff exposures. A number of equally valid geoelectrical models were constructed using the electromagnetic and resistivity cone data. These were used as structural reference models in the inversion of the resistivity tomography data. Blind inversion using an homogenous reference model was also carried out for comparison.
It was shown for the first time that the best solution model produced by 2D inversion of one data set with a range of structural reference models could be determined by using the l2 model misfit between the solution models and associated reference models (reference misfit) as a proxy for the l 2 misfit between the solution models and the synthetic model or 'best-guess' geoelectrical model (true misfit). The 2D methodology developed here is applicable in clay-rich till plains containing sand and gravel bodies throughout the UK. 相似文献
Following a successful 2D guided inversion synthetic modelling study, a field study was undertaken. Wenner 2D electrical resistivity tomography lines, resistivity cone penetrometry bores and electromagnetic induction ground resistivity data were collected over a site on the East Yorkshire coast, England, where sand and gravel lenses were known to exist from cliff exposures. A number of equally valid geoelectrical models were constructed using the electromagnetic and resistivity cone data. These were used as structural reference models in the inversion of the resistivity tomography data. Blind inversion using an homogenous reference model was also carried out for comparison.
It was shown for the first time that the best solution model produced by 2D inversion of one data set with a range of structural reference models could be determined by using the l
48.
Soil erosion caused by water flow is a complex problem. Both empirical and physically based approaches were used for the estimation of surface erosion rates. Their applications are mainly limited to experimental areas or laboratory studies. The maximum sediment concentration overland flow can carry is not considered in most of the existing surface erosion models. The lack of erosion capacity limitation may cause over estimations of sediment concentration. A correlation analysis is used in this study to determine significant factors that impact surface erosion capacity. The result shows that the unit stream power is the most dominant factor for overland flow erosion which is consistent with experimental data. A bounded regression formula is used to reflect the limits that sediment concentration cannot be less than zero nor greater than a maximum value. The coefficients used in the model are calibrated using published laboratory data. The computed results agree with laboratory data very well. A one dimensional overland flow diffusive wave model is used in conjunction with the developed soil erosion equation to simulate field experimental results. This study concludes that the non-linear regression method using unit stream power as the dominant factor performs well for estimating overland flow erosion capacity. 相似文献
49.
In this paper we analyze the effects of Faraday rotation on the azimuth of a transverse magnetic field as determined from the linear polarization in the inverse Zeeman effect. Observations of a simple sunspot were obtained with the Marshall Space Flight Center's vector magnetograph over the wavelength interval of 170 mÅ redward of line center of the Fe i 5250.22 Å spectral line to 170 mÅ to the blue, in steps of 10 mÅ. These data were analyzed to produce the variation of the azimuth as a function of wavelength at each pixel over the field of view of the sunspot. At selected locations in the sunspot, curves of the observed variation of azimuth with wavelength were compared with model calculations for the azimuth at each wavelength as derived from the inverse Zeeman effect modified by Faraday rotation. From these comparisons we derived the maximum amount of rotation as functions of both the magnitude and inclination of the sunspot's field. These results show that Faraday rotation of the azimuth will be a significant problem in observations taken near the center of a spectral line for fields as low as 1200 G and inclinations of the field in the range 20–80 deg. Conversely, they show that measurements taken in the wing of a spectral line are relatively free of the effects of Faraday rotation. 相似文献
50.