Eddy Covariance Measurements On Mountain Slopes: The Advantage Of Surface-Normal Sensor Orientation Over A Vertical Set-Up

The measurement of scalar fluxes employing the eddy covariance method is a widely used experimental approach,for which the flow distortion due to obstacles (e.g., sensor mounts and mast)is a well-known but not fully solved problem. In order to reduce flow distortion we installed a sonic anemometer in a surface-normal orientationrelative to the terrain slope, and a second instrument in a verticalposition at a horizontal distance of 1.54 m from the first instrumentWe found a significant reduction in the rotation angle necessary for the coordinaterotation procedure in the x-z plane whencomputing 30-minute flux averages with the surface-normal orientation. In 91% of all cases this rotation angleremained within the angle of incidence of ±10° recommended bythe manufacturer. In contrast, only 24% of the measurements taken with the vertically mounted anemometer were obtained at an angle of incidencewithin ±10°, and 3% were outside the ±30° range specified for an acceptable operation.A data quality test based on the variance of vertical windspeed normalized with friction velocity (_w/u_*) revealed problems for application under stable conditions due to large uncertainties in the determination of the Monin–Obukhov stability parameter z/L. An alternative test using the bulk drag coefficient C_D revealed other problems related to the dependence of C_D on z/z₀, the measuring height normalized by the roughness length, which do not appear to be constantin complex terrain. With both tests, a tendency for a slightly improved dataquality was found for the surface normal set-up, which, however, proved statistically insignificant.It is concluded that the surface-normal set-up of a sonic anemometer significantly reduces flow distortion by thesensor head. Although the surface-normal mounting position therefore appears to be the preferred one, with decreased flow distortion and a slightly improved data quality, no significant differences in turbulent quantities were found between the two set-uppositions. Hence, the consequences for short-term measurements of massand energy fluxes with a surface-normal set-up in complex terrain appearto be relevant only if single flux events are to be inspected, while for long-term measurements of integrated fluxes both the surface-normaland vertical installation of the sonic anemometer are adequate,indicating that eddy covariance measurements in complex terrain are lessdelicate than expected.     

Simulating midday all-slope surface temperatures along a climatic-latitudinal transect during cloudless summer conditions

Two physically-models of solar radiation transmission and of a steady-state slope energy budget have been coupled. Using climatic observational inputs, averaged in 10-deg latitude bands, a systematic examination was made of changing surface temperatures and differences between surface and air temperatures as functions of varying slope angles (0 to 90 deg) and orientations (south-, west-, and north-facing). Along a latitudinal transect of the east coast of the Americas (northern hemisphere), two contrasting landscapes were examined: barren and grassy. No simple relationship was discovered among the factors regarding shortwave and longwave radiative absorption, components of the energy budget, and surface temperature trends, yet the response of temperatures on a latitudinal basis was systematic and orderly. Characteristically, a great diversity existed among surface temperatures of different slopes and orientations at any particular latitude. Such diversity was accentuated in the higher latitudes. The findings were assumed general enough to encompass most of the possible contrasts encountered in a real-world north-south transect.Dr. O'Rourke is currently a Visiting Scholar at UCLA from Litton Systems, Inc., Data Systems Division.     

The role of precursor emissions on ground level ozone concentration during summer season in Poland

Three online coupled chemical transport model simulations were analyzed for three summer months of 2015 in Poland. One of them was run with default emission inventory, the other two with NO_x and VOC emissions reduced by 30%, respectively. Obtained ozone concentrations were evaluated with data from air quality measurement stations and ozone sensitivity to precursor emissions was estimated by ozone concentration differences between simulations and with the use of indicator ratios. They were calculated based on modeled mixing ratios of ozone, total reactive nitrogen and its components, nitric acid and hydrogen peroxide. The results show that the model overestimates ozone concentrations with the largest errors in the morning and evening, which is primarily related to the way vertical mixing is resolved by the model. Better model performance for ozone is achieved in rural than urban environment, as PBL and mixing mechanisms play more significant role in urban areas. Modeled ozone shows mixed sensitivity to precursor concentrations, similarly to other European regions, but indicator ratios have different values than are found in literature, particularly H₂O₂/HNO₃ is larger than in southern Europe. However, indicator ratios often differ between locations and transition values need to be established individually for a given region.     

Zielvorgaben für Pflanzenschutzmittelwirkstoffe und andere Schadstoffe in Oberflächengewässern

Quality Targets for Pesticides and Other Pollutants in Surface Waters Surface waters are not only adversely affected by industrial and municipal wastewaters but also by diffuse sources. For the control of the ecological water quality, so‐called quality targets are set. The quality targets are threshold concentrations for hazardous substances related to the protected goods like water ecosystems, drinking water supply, sediments, or fishing. In this paper, quality targets for the protection of aquatic life in surface waters were derived on the basis of a concept developed by the International Commission for the Protection of the Rhine (Internationale Kommission zum Schutze des Rheins – IKSR). The quality targets for the selected hazardous substances, which mainly belong to the chemical class of pesticides, were calculated using ecotoxicological results for species of bacteria, algae, fish, and small crustaceans, as the four trophic standards of the water ecosystem. In cooperation with the Federal Environmental Agency (Umweltbundesamt – UBA) the effect data were taken from ecotoxicological data bases. According to the concept of the IKSR, the lowest test result for the most sensitive species was multiplied by an assessment factor. This proceeding concerns the difficulty in describing the complex interactions in water ecosystems with toxicity data of single laboratory experiments for a few organisms. For seven pesticides quality targets below 0.1 μg/L were proposed. These results show that the ecotoxicologically based quality targets might be even lower than the limit values for pesticides in drinking water of 0.1 μg/L. But for most of the substances the determined values are significantly higher. The great concentration range of quality targets demonstrates distinctly that one standard concentration for all pesticides could not be given with regard to the different effects on aquatic organisms.     

Mulching as a means of exploiting dew for arid agriculture?

A traditional mulching technique used in Lanzarote, Canary Islands, allows dry farming as well as pronounced water savings in irrigation. It is known to reduce evaporational losses, but is also supposed to enhance the nocturnal condensation of water vapour from the atmosphere. The mulch layer consists of porous volcanic rock fragments abundantly available on the island. The mulched surface is believed to cool rapidly and to be more hygroscopic than a bare soil surface. This was investigated during a field experiment conducted over 68 nights during different seasons in 2001 and 2002, as well as some simple laboratory measurements. It was found that nocturnal condensation on the mulch surface (max 0.33 mm) was lower than on the bare soil surface (max 0.57 mm) or any one of three alternative mulch substrates. However, a slightly stronger nocturnal cooling of the mulched as compared to the bare surface was present. It is shown that these contrary findings can be explained by the higher hygroscopicity of the dry loam soil, resulting in condensation gains beyond the strict definition of dew. Differences in plant-availability of non-hygroscopic dew water and hygroscopic water uptakes are discussed, and conditions under which mulching would show positive condensation effects are defined. This includes a theoretical section demonstrating that non-hygroscopic mulch layers of a proper thickness can provide small amounts of dew to plant roots at the mulch–soil interface. This condensation could also happen during the day and would be favoured by a high amplitude of the diurnal atmospheric moisture cycle.     

Response of a River Catchment to Climatic Change: Application of Expanded Downscaling to Northern Germany

We used the technique of expanded General Circulation Model (GCM) downscalingto derive time series of daily weather for the analysis of potential climaticchange impact on a river catchment in Northern Germany. The derived timeseries was then fed into a spatially distributed hydrological model tosimulate various water balance components and river discharge. All componentsof this modelling approach are known to provide fairly accurate results undernormal (current) climatic conditions. Hydrological time series, theirstatistics and spatial patterns of various water balance components, resultingfrom a `business-as-usual' emission scenario, were analysed. The simulationresults showed that if everything apart from climate is held constant, asignificant increase in river discharge may be expected in the coming decadesas a consequence of increased rainfall amounts. Although the modellingapproach provides an operational way of performing watershed climate changeimpact studies, many uncertainties still have to be considered.     

Transient Recharge Estimability Through Field‐Scale Groundwater Model Calibration

The estimation of recharge through groundwater model calibration is hampered by the nonuniqueness of recharge and aquifer parameter values. It has been shown recently that the estimability of spatially distributed recharge through calibration of steady‐state models for practical situations (i.e., real‐world, field‐scale aquifer settings) is limited by the need for excessive amounts of hydraulic‐parameter and groundwater‐level data. However, the extent to which temporal recharge variability can be informed through transient model calibration, which involves larger water‐level datasets, but requires the additional consideration of storage parameters, is presently unknown for practical situations. In this study, time‐varying recharge estimates, inferred through calibration of a field‐scale highly parameterized groundwater model, are systematically investigated subject to changes in (1) the degree to which hydraulic parameters including hydraulic conductivity (K) and specific yield (S_y) are constrained, (2) the number of water‐level calibration targets, and (3) the temporal resolution (up to monthly time steps) at which recharge is estimated. The analysis involves the use of a synthetic reality (a reference model) based on a groundwater model of Uley South Basin, South Australia. Identifiability statistics are used to evaluate the ability of recharge and hydraulic parameters to be estimated uniquely. Results show that reasonable estimates of monthly recharge (<30% recharge root‐mean‐squared error) require a considerable amount of transient water‐level data, and that the spatial distribution of K is known. Joint estimation of recharge, S_y and K, however, precludes reasonable inference of recharge and hydraulic parameter values. We conclude that the estimation of temporal recharge variability through calibration may be impractical for real‐world settings.