性外激素诱导大弹涂鱼成熟和产卵

成熟大弹涂鱼的卵巢、精巢和储精囊稀释液中的性外激素以及缩宫素和脱氧皮质酮（DOC）能诱导第4时相的大弹涂鱼卵母细胞在离体培养的条件下发育成熟，成熟率与性外激素的种类和剂量有关。前列腺素E1（PGE1）单独使用的效果不明显，但与人绒毛膜促性腺激素（HCG）混合使用时显著提高了卵母细胞的成熟率。以卵巢、精巢和储精囊稀释液以及PGE1分别注射雌性大弹涂鱼，剂量为0．01cm^3/尾的卵巢液、0．1cm^3/尾的储精囊液、0．1cm^3／尾的精巢液以及剂量为10μg/尾的PGE1都有诱导卵母细胞成熟的作用，其中储精囊液的作用最为显著。在人工管道中放置大弹涂鱼成熟亲鱼卵巢、精巢或储精囊的稀释液，有诱异性亲鱼进入管道内的作用，其中以储精囊液对雌鱼的吸引作用尤为明显。放置于陶瓷管道或海绵管道内的卵巢、精巢或储精囊稀释液都能诱导大弹涂鱼产卵，在陶瓷管道的产卵量和受精率显著高于海绵管道。     

Investigation on the Deposition in an Excavated Trough at the East Shore of Jiaozhou Bay, China

- Based on field investigations, this paper analyzes three types of harbour basinns and navigation channel excavated on seabed in Jiaozhou Bay, get a general rule of deposition for excavated trough, it found that pollution is one of crucial factors resulting in the deposition of the excavated trough in the east shore of Jiaozhou Bay. With these results, it predicted the annual deposition thickness for the excavated trough and disclosed the fact that it can't be deposited deadly during one storm. At the same time, with two-dimensional numerical model, it studied the effects of the excavated trough and the reclamation near shore on tidal cureent and said that the excavated trough can decrease the current velocity passing through the trough about 10- 15%, but only limited inside and near the trough and there are no effect on other regions; reclamation can cut off the pollution sources and no obvious effect on the currents of the Jiaozhou Bay. Connecting the deep trough and Cangkou tidal channel with a new     

Study on “J”Type Offshore Pipeline-Laying Method

-Considering both the seabed foundation and wave, an analytic model of "J" type is proposed for offshore pipeline-laying. The governing differential equation is also obtained for the pipeline on the seabed and for the suspension sections. By utilizing weighted- residual method and dual iteration technique, an approximate solution is obtained, too. In the end, calculation examples are given for analyzing the changeable relationship among the major parameters.     

Design of Mooring System for Oil Storage Vessels

The floating oil storage system has been proposed as a new facility for Strategic Petroleum Reserve (SPR) in China. Mooring is one of the key technologies to ensure the safety, reliability, and performance of the oil storage system. This paper describes the concept, analysis, design and reliability of the mooring system. For mooring system design of these oil vessels, analysis is essential of the behavior of the vessel in connection with mooring facilities of nonlinear resilience. A nonlinear mathematical model for analyzing a moored vessel is established and solved. Some results of numerical simulations are presented. Assessment of the safety regarding the mooring system in terms of failure probability is carried out. Another simulation model for calculating the failure probability of the mooring system is proposed. The design parameters that have an influence on the characteristics of the failure probability have been identified. The simulation results show that the mooring system has an annual reliab     

Second-Order Wave Diffraction Around 3-D Bodies by A Time-Domain Method

A time-domain method is applied to simulate nonlinear wave diffraction around a surface piercing 3-D arbitrary body. The method involves the application of Taylor series expansions and the use of perturbation procedure to establish the corresponding boundary value problems with respect to a time-independent fluid domain. A boundary element method based on B-spline expansion is used to calculate the wave field at each time step, and the free surface boundary condition is satisfied to the second order of wave steepness by a numerical integration in time. An artificial damping layer is adopted on the free surface for the removal of wave reflection from the outer boundary. As an illustration, the method is used to compute the second-order wave forces and run-up on a surface-piercing circular cylinder. The present method is found to be accurate, computationally efficient, and numerically stable.     

我国近海沉积层地震速度特征

我国近海纵向上发育了新生界、中生界碎屑岩和古生界沉积地层。在分析整理收集到的地层速度资料的基础上,分析了地层速度的变化规律:沉积层地震速度随地层的埋深增加而增加,新地层速度低、老地层速度高;欠压实地层的砂岩速度与泥岩速度基本相当或低于泥岩速度,正常地层的砂岩速度大于泥岩速度;砂岩储层的速度随孔隙度的增加而降低,流体成分的变化对速度的影响不大。     

Non-Simultaneous Failure of Ice in Front of Multi-Leg Structures

Because the multi-leg jacket structure is the major type of offshore structures in the Bohai Sea, the study of non-si-multaneous failure of i鏴 on multi-leg structures is important. However, the non-simultaneous failure has not been consid-ered in engineering design until now, obviously resulting in costly design and notable waste. To resolve this problem, this paper, by means of analysis of experimental data, calculates the coefficient of the non-simultaneous failure for the double-pile structure, the square four-leg structure, the single-line multi-pile structure, and the conical structure, respectively, and provides some reference criteria for engineering design.     

The Structure of A Turbulent Jet in A Crossflow-Effect of Jet-Crossflow Velocity

A comprehensive numerical study on the three-dimensional structure of a turbulent jet in crossflow is performed. The jet-to-crossflow velocity ratio (R) varies in the range of 2 - 16; both vertical jets and inclined jets without excess streamwise momentum are considered. The numerical results of the Standard two-equation k-ε model show that the turbulent structure can be broadly categorised according to the jet-to-crossflow velocity ratio. For strong to moderate jet discharges, i.e. R> 4, the jet is characterized by a longitudinal transition through a bent-over phase during which the jet becomes almost parallel with the main freestream, to a sectional vortex-pair flow with double concentration maxima; the computed flow details and scalar mixing characteristics can be described by self-similar relations beyond a dimensionless distance of around 20-60. The similarity coefficients are only weakly dependent on R. The cross-section scalar field is kidney-shaped and bifurcated, vvith distinct double concentr     

Regression Formulations for the Stress at Hot Spot of Multiplanar Tubular DT Joints

- Stress concentration analysis of multiplanar tubular DT joints plays an important role in the fatigue design of offshore platforms. A semi-analytic method for stress analysis under the condition of any loads is briefly introduced in the paper. Nineteen multiplanar tubular DT joints with one of two braces of the same dimension subjected to axial loads and out- of- plane bending moments are computed for parametric stress analysis by using the present method. The influence of geometrical parameters on the stresses of multiplanar tubular DT joints is discussed and compared with corresponding uniplanar T joints. The regression formulae for the stress at hot spot of multiplanar DT joints are found by modification of SCF of corresponding uniplanar T joints. The parametric formulae for the maximum stress by superposition. Finally, the influences of stiffening effect and load-interaction effect on the maximum stress of DT joints are discussed.     

哀牢山-红河断裂带中段应变分析

对哀牢山—红河断裂带中段和平—水塘剖面、墨江—元江剖面和其它地段的岩石应变及磁组构进行了分析，表明应变强度的校正磁各向异性度PJ从断裂带向西至三叠系明显降低，变形强度向西迅速减弱。磁化率椭球体主轴展布反映出剪切带内、外变形方式的改变。剪切带内，以水平走滑运动为主；向西则以水平缩短为主。在应变分析中，对断裂带内的S—C组构两组面理夹角、杏仁体和石榴石应变标志体进行了测量，结果显示，剪切带内的磁组构和岩石组构间关系较差。此外，还对这两条剖面中的三叠系进行了应变和磁组构分析，找出了它们与磁化率椭球体对应轴率间的相关性。