印度东南部海岸拉梅斯沃勒姆滨外保克湾底层水特征对底栖有孔虫的影响

有孔虫生活在海洋和半咸水环境。底栖有孔虫的存在很大程度上受物理因素（深度、温度、光量、水体扰动）、化学因素（盐度、溶解氧和可用元素）和生物因素（食物供给量和底层沉积物特征）的制约。研究人员对印度东、西岸现代底栖有孔虫生态学和分布状态进行了研究。Ｎａｉｄｕ等在对Ｖｉｓａｋｈａｐａｔｎａｍ港复合体有孔虫进行分析后提出 ,可以将有孔虫作为海洋污染的指示物。ＳｒｅｅｎｉｖａｓａＲａｏ等采用Ｑ模式系数分析对尼赞伯德讷姆湾有孔虫的分布进行了研究 ,确认此区域存在４种组合 ,受不同环境条件的影响。Ｋｈａｒｅ等对门格…     

Genetic Relationships Among One Non-Endemic and Two Endemic Mediterranean Triplefin Blennies (Pisces, Blennioidei)

Abstract. Three triplefin blennies occur sympatrically in the Mediterranean Sea; Tripterygion tripteronotus and T. melanurus are endemic, whereas T. delaisi is also found in the Eastern Atlantic. Although very similar in morphology, ecology and behaviour, some striking differences exist among reproductive strategies. Several authors proposed hypotheses on the evolution of these species. In order to enhance insight into the genetic structure of this genus, an enzyme electrophoretic survey was performed. Samples of 40 to 45 specimens of each species were collected near Calvi (Corsica, France). Twenty-four enzyme loci were analysed, of which 17 appeared polymorphic. T. delaisi showed a high level of average observed heterozygosity (H_o) of 0.140, as opposed to very low levels of 0.009 and 0.021 in T. tripteronotus and T. melanurus , respectively. Nei's genetic distance was 0.21 between T. delaisi and T. tripteronotus , 0.35 between T. delaisi and T. melanurus and 0.45 between T. tripteronotus and T. melanurus . We hypothesise that divergence of these species started before the Pleistocene and that the endemic species survived the Pleistocene glaciations in refugia within the Mediterranean. The possibility that T. tripteronotus and T. delaisi diverged through sympatric speciation is discussed.     

Methods of fitting the Fisher-Tippett type 1 extreme value distribution

Methods are described for estimating the parameters of the Fisher-Tippet Type 1 extreme value distribution and associated return values from measured extremes, such as maximum wave height. A comparison of these methods, with simulated data, shows that those using Gumbel's plotting position are least satifactory. Maximum likelihood methods give the smallest mean square errors, but the very much simpler method of moments is nearly as good.     

Local buckling strength of ring stiffened cylindrical shells under external pressure

The paper presents a non-linear buckling analysis of ring stiffened cylindrical shells subject to external pressure. The collapse pressure is calculated by assuming failure to occur when the material reaches a plastic stress state defined by the Ilyushin criterion. It is shown in the paper that use of the non-linear theory can reduce the estimated first yield by up to 25% in comparison to the linear buckling analysis used up to now. Comparison of predicted failure loads are in good agreement with the lower bound of test results.     

A literature review of the saturation state of seawater with respect to calcium carbonate and its possible significance for scale formation on OTEC heat exchangers

An investigation has been made of available data on the saturation state of seawater with respect to calcium carbonate and its possible significance for scale formation on Ocean Thermal Energy Conversion (OTEC) heat exchangers. Pertinent oceanographic data is lacking at or near potential OTEC sites for the calculation of the degree of saturation of seawater with respect to calcium carbonate. Consequently, only “extrapolated” saturation values can be used. These indicate that near surface seawater is probably supersaturated, with respect to the calcium carbonate phases calcite and aragonite, at all potential OTEC sites. The deep seawater that would be brought to the surface at the potential Atlantic Ocean sites is also likely to be supersaturated with respect to calcium carbonate. The deep seawater at the potential Pacific Ocean sites may be slightly undersaturated.The fact that OTEC heat exchangers will be operating in seawater, which is supersaturated with respect to calcium carbonate, means that if nucleation of calcite or aragonite occurs on the heat exchanger surfaces, significant growth rates of calcium carbonate scale may be expected. The potential for calcium carbonate nucleation is highest at cathodic metal surface locations, which are produced as the result of aluminum corrosion in seawater. Consequently, corrosion and scale formation may be closely related. What the possible effects of biofouling may be on this process are not known.