Eiweisschemische Untersuchungen an Belebtschlamm aus Abwasserreinigungsanlagen)

Summary The protein component of activated sludge is constituted by numerous aminoacids. The amino-acid content of 1 lb. of activated sludge solids (produced by the purification of about 1000 gal. of sewage) may be quantitatively and qualitatively compared with that of 0·50 gal. of fresh cow milk.      

Temperaturmessungen nahe der Wasseroberfläche

Summary This paper deals with the results obtained from temperature measurements within a range of 50 cm above and about 6 cm below the water surface. These observations were carried out on small pools in the tide lands around the island of Neuwerk in summer 1950 with the so called pan or knitting needle thermometer, a thermometer whose mercury bulb is replaced by a long and very thin-walled tube allowing the mercury to quickly adapt to fluctuations of temperature.

---

Mesures de la température effectuées près de la surface de l'eau

Résumè On expose les résultats des mesures de la température effectuées entre l'altitude de 50 cm au dessus de la surface d'une part et la profondeur de 6 cm environ au dessous de la surface d'autre part. Ces observations qui ont été faites dans des flaques de marée des bas fonds aux alentours de l'île de Neuwerk en été 1950 furent exécutées avec un thermomètre à aiguille à tricoter. L'originalité de cet instrument réside dans la forme de la cuvette de mercure, tube long à paroi mince qui assure une vite adaptation du mercure à la température du milieu environnant.

     

Seasonal occurrence and growth of benthic algae in the Patos Lagoon estuary, Brazil

The seasonal occurrence of 94 benthic algal species, including Cyanophyta, was observed on a monthly basis over one year in the Patos Lagoon estuary (32°S, 52°W), Brazil, and showed three patterns of algal periodicity. An aseasonal group of 46 species was present throughout the year and two groups of 24 species each occurred either during summer and fall or winter and spring. The seasonal growth of 55 green, brown and red algae was correlated with monthly variations of salinity, water temperature, daylength and light radiation energy, which were measured daily in the estuary. Summer/fall peak growth was observed in 15 algae most of which correlated significantly with high salinities alone or in combination with other factors during this period. Growth peak of 11 species in winter/spring was principally a function of low water temperatures alone or together with a reduced light regime.Both periodicity of benthic algae and their seasonal growth, as a more sensitive measure of their floristic affinity, demonstrated the presence of cool temperate and tropical elements in this flora typical for warm temperate biogeographic regions. Correlations between seasonal variation of algal growth and selected environmental parameters aided in the evaluation of causal factors for algal seasonality.     

Geochemical modelling of a Zn–Pb skarn: Constraints from LA–ICP–MS analysis of fluid inclusions

The Bismark deposit (northern Chihuahua, Mexico) is one of several base metal-rich high-temperature, carbonate-replacement deposits hosted in northern Mexico. Previous fluid inclusion studies based on microthermometry and PIXE have shown that the Zn-rich, Pb-poor Bismark deposit formed from a moderate salinity magmatic fluid [Baker, T. and Lang, J.R., 2003. Reconciling fluid inclusion types, fluid processes, and fluid sources in skarns: an example from the Bismark Deposit, Mexico. Mineralium Deposita 38(4), 474–495; Baker, T., van Achterberg, E., Ryan, C.G. and Lang, J.R., 2004. Composition and evolution of ore fluids in a magmatic-hydrothermal skarn deposit. Geology 32(2), 117–120]. The exact precipitation mechanisms are unclear and may have due to cooling, salinity decrease and wall rock reaction. Furthermore, PIXE data suggested that Pb and Zn concentrations were comparable and inconsistent with the Zn-rich nature of the ore. However, Pb was commonly below the limit of detection for PIXE and the data presented by Baker et al. [Baker, T., van Achterberg, E., Ryan, C.G. and Lang, J.R., 2004. Composition and evolution of ore fluids in a magmatic-hydrothermal skarn deposit. Geology 32(2), 117–120] are regarded as the maximum concentrations of Pb in the fluid. In this study new LA ICP MS analysis was carried out on the same fluid inclusion population to compare with the PIXE data in order to constrain the uncertainty related to the Pb data and the new results are used to model possible ore deposition mechanisms. The new laser ablation data reveal overall lower concentrations of Pb in the ore fluid (average value ~ 285 ppm) than previously indicated by PIXE analysis (average value ~ 713 ppm). Chemical modelling using the new laser ablation data tested the following ore deposition processes: 1) cooling; 2) fluid–rock reaction at constant temperature; 3) cooling and simultaneous fluid–rock interaction. Modelling results show that the gangue and ore minerals observed at Bismark are best reproduced by fluid–rock interaction and simultaneous cooling. Results from the simulations strongly indicate that ore deposition was mainly driven by a pH increase due to the neutralization of the acidic ore fluid (pH = 3.9) as the result of the reaction with the limestone. Modelling results also suggest that the deposit likely formed under cooling conditions, but do not support the hypothesis of a temperature decrease as the principal ore-forming process.     

Pyroclastic dune bedforms: macroscale structures and lateral variations. Examples from the 2006 pyroclastic currents at Tungurahua (Ecuador)

Pyroclastic currents are catastrophic flows of gas and particles triggered by explosive volcanic eruptions. For much of their dynamics, they behave as particulate density currents and share similarities with turbidity currents. Pyroclastic currents occasionally deposit dune bedforms with peculiar lamination patterns, from what is thought to represent the dilute low concentration and fluid‐turbulence supported end member of the pyroclastic currents. This article presents a high resolution dataset of sediment plates (lacquer peels) with several closely spaced lateral profiles representing sections through single pyroclastic bedforms from the August 2006 eruption of Tungurahua (Ecuador). Most of the sedimentary features contain backset bedding and preferential stoss‐face deposition. From the ripple scale (a few centimetres) to the largest dune bedform scale (several metres in length), similar patterns of erosive‐based backset beds are evidenced. Recurrent trains of sub‐vertical truncations on the stoss side of structures reshape and steepen the bedforms. In contrast, sporadic coarse‐grained lenses and lensoidal layers flatten bedforms by filling troughs. The coarsest (clasts up to 10 cm), least sorted and massive structures still exhibit lineation patterns that follow the general backset bedding trend. The stratal architecture exhibits strong lateral variations within tens of centimetres, with very local truncations both in flow‐perpendicular and flow‐parallel directions. This study infers that the sedimentary patterns of bedforms result from four formation mechanisms: (i) differential draping; (ii) slope‐influenced saltation; (iii) truncative bursts; and (iv) granular‐based events. Whereas most of the literature makes a straightforward link between backset bedding and Froude‐supercritical flows, this interpretation is reconsidered here. Indeed, features that would be diagnostic of subcritical dunes, antidunes and ‘chute and pools’ can be found on the same horizon and in a single bedform, only laterally separated by short distances (tens of centimetres). These data stress the influence of the pulsating and highly turbulent nature of the currents and the possible role of coherent flow structures such as Görtler vortices. Backset bedding is interpreted here as a consequence of a very high sedimentation environment of weak and waning currents that interact with the pre‐existing morphology. Quantification of near‐bed flow velocities is made via comparison with wind tunnel experiments. It is estimated that shear velocities of ca 0·30 m.s^?1 (equivalent to pure wind velocity of 6 to 8 m.s^?1 at 10 cm above the bed) could emplace the constructive bedsets, whereas the truncative phases would result from bursts with impacting wind velocities of at least 30 to 40 m.s^?1.     

Landforms and landscape evolution in the Skardu,Shigar and Braldu Valleys,Central Karakoram

The Central Karakoram, which includes K2 in Pakistan, is one of the most rapidly rising areas on Earth and exhibits complex topography and extreme relief. Impressive valley fills and glacial landforms are present throughout the valleys. The dynamics of landscape evolution of the region are currently not well understood. Consequently, the landforms were mapped and assessed in the Skardu, Shigar, and Braldu valleys, to elucidate the spatio-temporal scale dependencies of surface processes active in the region. These valleys were examined using geomorphic field methods, remote sensing, geomorphometry, and terrestrial cosmogenic nuclides (TCNs) surface exposure dating. The glaciers in this region have oscillated considerably throughout the Late Quaternary, and four glacial stages have been recognized including at least six glacial advances. Surface processes readjusted after glacier retreat, and ubiquitous mass movements and catastrophic landsliding transported material from steep slopes to valley bottoms, while glaciofluvial meltwater and glacier outburst floods redistributed sediment down valley. Glacier geochronology and late Holocene ages of the outburst flood deposits indicate that landscape evolution has been dominated by glaciation and paraglaciation during the late Quaternary.     

Characteristics of developing scour-holes at a sand-embedded cylinder

Characteristics of developing scour-holes at a sand-embedded 0.2 m diameter circular cylinder are presented. Non-intrusive, high-resolution topographic measurements of developing scour-holes were made with an experimental installation using a laser distance sensor （LDS） and precision step-motors. A clear-water experiment was conducted with bed shear stress equal to 95% of the critical bed shear stress for the initiation of sediment motion at the undisturbed plane sand bed with a d50 of 0.26 mm. During the running experiment of 21 hours duration, measurements were taken by the LDS in different azimuthal half-planes with θ= 0, 15, 30, 45, 60, 75, 90, 105, 120, 135, 150, 165 and 180° in order to study the spatio-temporal variation of geometric properties in developing scour-holes. After 21 hours, the equilibrium condition was approached, with a scour rate less than d50 per hour. Measurement of maximum scour depth in different azimuthal half-planes at different points in time during the experiment show that scour started at the cylinder side and surrounded the cylinder after about 20% of experiment time. Slopes of developing scour-holes presented three regions with different inclinations, which were attributed to vortex action. Both maximum scour depth and maximum scour radius at different azimuthal half-planes are well correlated with the maximum scour depth at plane with θ = 0°. When providing maximum scour depth at the cylinder front, the presented correlations are useful for simple calculation of scour-hole topography. This work provides an experimental database for advanced numerical simulation for loose sediment hydraulics.