Transient soft X-ray sources

A rocket observation of cosmic soft X-rays suggests the existence of transient, recurrent soft X-ray sources which are found variable during the flight time of the rocket. Some of the soft X-ray sources thus far reported are considered to be of this time. These sources are listed in Table I, and their positions are shown in Figure 2.Paper presented at the COSPAR Symposium on Fast Transients in X- and Gamma-Rays, held at Varna, Bulgaria, 29–31 May, 1975.     

Zonal variations in abundance and body length of chaetognaths in the 140°E seasonal ice zone during the austral summer of 2001/02

Time-series observations of chaetognaths were carried out during four cruises along the 140°E transect between 61°S and 66°28′S from November to March in the 2001/02 austral summer. Three species – Eukrohnia hamata, Sagitta gazellae and Sagitta marri – occurred in the samples between 0 and 150 m. E. hamata was the most dominant species comprising between 89.6 and 100% of the chaetognath population, followed by S. gazellae (0–5.7%). There were large differences in the abundance and size frequency distribution of body length of E. hamata between the north and south of the Southern Boundary of the Antarctic Circumpolar Current (SB-ACC) which was located between 64°S and 65°S. For E. hamata, low abundance and large sized animals (22–24 mm) occurred south of the SB-ACC. A possible reason could be that the breeding season in waters north of the SB-ACC may be early spring and summer. On the other hand, low reproduction was recognized by low the abundance of E. hamata and few occurrences of juveniles south of the SB-ACC (65°S). The result of a general comparison suggests that the abundance of chaetognaths along the 140°E transect has decreased during the 20 years since 1983.     

A new climatology of the Okhotsk Sea derived from the FERHRI database

This paper introduces a new hydrographic climatology of the Okhotsk Sea; this climatology was constructed from the Far Eastern Regional Hydrometeorological Research Institute (FERHRI) database. The FERHRI database has a volume of data three to five times larger than the data used in previous studies because unpublished Russian observation data have been included in the FERHRI database. After removing erroneous data from the database by pertinent quality control methods, the climatology for 1/4°?×?1/4° grids is produced by applying objective analysis procedures. Features similar to those in previous studies are seen in the intermediate layers in the Okhotsk Sea, whereas our climatology provides values that fill in gaps in previous climatologies. It is obvious from the monthly climatologies that temperature and salinity distributions evolve in accordance with seasonal variations in the Eastern Sakhalin Current and inflow from the North Pacific. We also reconstructed climatologies for the winter mixed layer and dense shelf water from data obtained from the temperature minimum waters identified as the remnants of these two layers. Free access to the 1°?×?1° versions of all climatologies constructed in this study is available through the website.     

Availability of an equation to evaluate error by optical path discretization in radiative transfer computation based on the successive order of scattering method

The availability of an equation to evaluate the influence of multiple scattering in the single scattering process corresponding to a layer of arbitrary optical thickness was established. In order to confirm the validity of this equation, the radiance distribution in this layer was computed using a plane–parallel layer model based on the successive order of scattering method. The relative errors in a radiance distribution computed were evaluated as a function of optical thickness by the derived equation. It was shown that this equation provides a theoretical background for determining layer thickness using the plane–parallel layer model.     

A Note on Seasonal Variation in Radiolarian Abundance

A statistical analysis of two consecutive sequences of observations on radiolarian abundances in the western North Pacific, by methods appropriate to data on the simplex (i.e., compositional data), show that although the overall graphical presentations of the frequencies appear similar, there are substantial differences in the earlier part of each of the series. The results of the multivariate analyses are used for identifying those species that contribute most to the analysis. A brief guide to the mathematical properties of compositional data is given.     

Laboratory experiments and thermal calculations for the development of a next-generation glacier-ice exploration system: Development of an electro-thermal drilling device

A next-generation drilling system, equipped with a thermal drilling device, is proposed for glacier ice. The system is designed to penetrate glacier ice via melting of the ice and continuously analyze melt-water in a contamination-free sonde. This new type of drilling system is expected to provide analysis data in less time and at less cost than existing systems. Because of the limited number of parameters that can be measured, the proposed system will not take the place of conventional drilling systems that are used to obtain ice cores; however, it will provide a useful method for quickly and simply investigating glacier ice.An electro-thermal drilling device is one of the most important elements needed to develop the proposed system. To estimate the thermal supply required to reach a target depth in a reasonable time, laboratory experiments were conducted using ice blocks and a small sonde equipped solely with heaters. Thermal calculations were then performed under a limited range of conditions. The experiments were undertaken to investigate the effects of the shape and material of the drill head and heater temperature on the rate of penetration into the ice. Additional thermal calculations were then performed based on the experimental results.According to the simple thermal calculations, if the thermal loss that occurs while heat is transferred from the heater to ice (in melting the ice) is assumed to be 50%, the total thermal supply required for heaters in the sonde and cable is as follows: (i) 4.8 kW (sonde) plus 0 W (cable) to penetrate to 300 m depth over 10 days into temperate glacier ice for which the temperature is 0 °C at all depths and to maintain a water layer along 300 m of cable; (ii) 10 kW (sonde) plus 19–32 kW (cable) to penetrate to 1000 m depth over 1 month into cold glacier ice for which the temperature is −25 °C at the surface and 0 °C at 1000 m depth and to maintain a water layer along 1000 m of cable; and (iii) 19 kW (sonde) plus 140–235 kW (cable) to penetrate to 3000 m depth over 2 months into an ice sheet for which the temperature is −55 °C at the surface and 0 °C at 3000 m depth and to maintain a water layer along 3000 m of cable. The thermal supply required for the cable is strongly affected by the thickness of the water layer, cable diameter, and the horizontal distance from the ice wall at which the ice temperature was maintained at its initial temperature. A large thermal supply is required to heat 3000 m of cable in an ice sheet (scenario (iii) above), but penetration into glacier ice (scenarios (i) and (ii) above) could be realistic with the use of a currently employed generator.     

Impacts of elevated CO2 on particulate and dissolved organic matter production: microcosm experiments using iron-deficient plankton communities in open subarctic waters

Response of phytoplankton to increasing CO₂ in seawater in terms of physiology and ecology is key to predicting changes in marine ecosystems. However, responses of natural plankton communities especially in the open ocean to higher CO₂ levels have not been fully examined. We conducted CO₂ manipulation experiments in the Bering Sea and the central subarctic Pacific, known as high nutrient and low chlorophyll regions, in summer 2007 to investigate the response of organic matter production in iron-deficient plankton communities to CO₂ increases. During the 14-day incubations of surface waters with natural plankton assemblages in microcosms under multiple pCO₂ levels, the dynamics of particulate organic carbon (POC) and nitrogen (PN), and dissolved organic carbon (DOC) and phosphorus (DOP) were examined with the plankton community compositions. In the Bering site, net production of POC, PN, and DOP relative to net chlorophyll-a production decreased with increasing pCO₂. While net produced POC:PN did not show any CO₂-related variations, net produced DOC:DOP increased with increasing pCO₂. On the other hand, no apparent trends for these parameters were observed in the Pacific site. The contrasting results observed were probably due to the different plankton community compositions between the two sites, with plankton biomass dominated by large-sized diatoms in the Bering Sea versus ultra-eukaryotes in the Pacific Ocean. We conclude that the quantity and quality of the production of particulate and dissolved organic matter may be altered under future elevated CO₂ environments in some iron-deficient ecosystems, while the impacts may be negligible in some systems.     

Generalized Lyzenga's Predictor of Shallow Water Depth for Multispectral Satellite Imagery

Multispectral satellite remote sensing can predict shallow-water depth distribution inexpensively and exhaustively, but it requires many in situ measurements for calibration. To extend its feasibility, we improved a recently developed technique, for the first time, to obtain a generalized predictor of depth. We used six WorldView-2 images and obtained a predictor that yielded a 0.648 m root-mean-square error against a dataset with a 5.544 m standard deviation of depth. The predictor can be used with as few as two pixels with known depth per image, or with no depth data, if only relative depth is needed.     

Application of a Numerical Inverse Laplace Integration Method to Surface Loading on a Viscoelastic Compressible Earth Model

Normal mode approaches for calculating viscoelastic responses of self-gravitating and compressible spherical earth models have an intrinsic problem of determining the roots of the secular equation and the associated residues in the Laplace domain. To bypass this problem, a method based on numerical inverse Laplace integration was developed by Tanaka et al. (2006, 2007) for computations of viscoelastic deformation caused by an internal dislocation. The advantage of this approach is that the root-finding problem is avoided without imposing additional constraints on the governing equations and earth models. In this study, we apply the same algorithm to computations of viscoelastic responses to a surface load and show that the results obtained by this approach agree well with those obtained by a time-domain approach that does not need determinations of the normal modes in the Laplace domain. Using the elastic earth model PREM and a convex viscosity profile, we calculate viscoelastic load Love numbers (h, l, k) for compressible and incompressible models. Comparisons between the results show that effects due to compressibility are consistent with results obtained by previous studies and that the rate differences between the two models total 10–40%. This will serve as an independent method to confirm results obtained by time-domain approaches and will usefully increase the reliability when modeling postglacial rebound.     

An Application of Hydraulic Tomography to a Large‐Scale Fractured Granite Site,Mizunami, Japan

While hydraulic tomography (HT) is a mature aquifer characterization technology, its applications to characterize hydrogeology of kilometer‐scale fault and fracture zones are rare. This paper sequentially analyzes datasets from two new pumping tests as well as those from two previous pumping tests analyzed by Illman et al. (2009) at a fractured granite site in Mizunami, Japan. Results of this analysis show that datasets from two previous pumping tests at one side of a fault zone as used in the previous study led to inaccurate mapping of fracture and fault zones. Inclusion of the datasets from the two new pumping tests (one of which was conducted on the other side of the fault) yields locations of the fault zone consistent with those based on geological mapping. The new datasets also produce a detailed image of the irregular fault zone, which is not available from geological investigation alone and the previous study. As a result, we conclude that if prior knowledge about geological structures at a field site is considered during the design of HT surveys, valuable non‐redundant datasets about the fracture and fault zones can be collected. Only with these non‐redundant data sets, can HT then be a viable and robust tool for delineating fracture and fault distributions over kilometer scales, even when only a limited number of boreholes are available. In essence, this paper proves that HT is a new tool for geologists, geophysicists, and engineers for mapping large‐scale fracture and fault zone distributions.