Iron isotopic analyses of geological reference materials on MC-ICP-MS with instrumental mass bias corrected by three independent methods

Here we report iron (Fe) isotopic data of three pure Fe solution standards (IRMM-014, GSB Fe, and NIST 3126a) and five widely used geological reference materials (RMs) from the United States Geological Survey and Geological Survey of Japan obtained on a Neptune Plus multi-collector–inductively coupled plasma–mass spectrometer (MC-ICP-MS) in our laboratory over the past 3 years. The instrumental mass bias was corrected by three independent methods: sample-standard bracketing (SSB), Ni doping?+?SSB, and ⁵⁷Fe–⁵⁸Fe double spike?+?SSB. Measurements reveal that both the Ni doping and double spike methods helped calibrate short-term fluctuations in mass bias. Collectively, almost all measurements of RMs yielded δ⁵⁶Fe within?±?0.05 of recommended values, provided that each sample was measured four times on MC-ICP-MS. For the first time, new recommended values for NIST SRM3126a are reported (δ⁵⁶Fe?=?0.363?±?0.006, 2SE, 95% CI; and δ⁵⁷Fe?=?0.534?±?0.010, 2SE).     

The effect of annealing on the luminescence decay-time of synthetic calcite:Mn

Calcite was synthesized by four methods, and the luminescence decay-time was measured for nine samples before and after heating hydrothermally in the temperature range 200–400°C. Decay-time data were collected between room temperature and approximately 15 K. The decay time at room temperature is approximately 50 ms, with little difference between a given calcite before and after hydrothermal treatment. The decay time at 15 K is always greater than at room temperature as the effect of thermal quenching diminishes. Differences in decay time before and after heating are more apparent at low temperature owing to this reduction in thermal quenching. The decay time decreased significantly in two samples, and an increase in decay time was observed in the remaining seven samples following heating. Among the latter group, the change in decay time was insignificant in three samples. The results are compared with previous data in which it was shown that the effect of heating is to increase the intensity of luminescence.     

Copper(II) humate mobility in kaolinite soil

An investigation of the influence of humate on the mobility of copper(II) ions in a kaolinite soil using leaching tests and electrokinetic experiments is reported. The data are interpreted in terms of humate–copper–clay interactions and humate electrical charge. Humate is mostly immobile below pH8 but is more mobile in alkaline conditions (sorption to kaolinite reduces its mobility in neutral conditions). Copper humate complexes are mobile in both acidic and alkaline conditions, but not in neutral conditions where they are sorbed. The dissolved copper humate complexes that form in acidic conditions are positively charged. The net effect of humate is to increase cupric ion mobility in kaolinite soil, especially in alkaline conditions.     

Citizens as sensors: the world of volunteered geography

In recent months there has been an explosion of interest in using the Web to create, assemble, and disseminate geographic information provided voluntarily by individuals. Sites such as Wikimapia and OpenStreetMap are empowering citizens to create a global patchwork of geographic information, while Google Earth and other virtual globes are encouraging volunteers to develop interesting applications using their own data. I review this phenomenon, and examine associated issues: what drives people to do this, how accurate are the results, will they threaten individual privacy, and how can they augment more conventional sources? I compare this new phenomenon to more traditional citizen science and the role of the amateur in geographic observation.     

Assessing the vulnerability of social–environmental system from the perspective of hazard,sensitivity, and resilience: a case study of Beijing,China

Despite a recent increase in the number of vulnerability analyses there has been relatively little discussion of vulnerability assessment of social–environment system, especially when they face multiple hazards. In this study, we developed an applicable and convenient method to assess vulnerability of social–environment system at a regional scale. Vulnerability is quantified by measuring three critical elements (i.e. hazards, sensitivity, and resilience) through some key variables. The results showed that vulnerability is high in Miaofeng Mountain in Mengtougou District, the hills of Pinggu County and the riparian zones of the lower courses of the Beiyun and Yongding Rivers; but low in the city of Beijing and the southwestern part of the Fangshan District. Areas of very high, high, medium, and low-vulnerability account for 6.19, 25.48, 33.06, and 35.27% of the total area, respectively. The degree of vulnerability decreases in a northwest direction in mountainous areas and declines from watercourses to riparian zones along a lateral direction in the plain. Some adaptive strategies are also proposed.     

Structural improvement of age-hardened gypsum-treated bauxite red mud waste using readily decomposable phyto-organics

Several years (7) after incidental lithification by added gypsum, the effect of crushing and phyto-organics on some physical properties of red mud wastes (RMW) was examined under laboratory conditions. It was hypothesized that mechanically breaking up the hardened masses would increase their permeability. However, on the contrary, crushing these rock-hard masses into <2-mm particles did not increase permeability. A phyto-organic treatment on the other hand greatly improved permeability of the crushed entities such that infiltration rates increased from 0 to 10 cm/h. After 24 weeks of incubation, the structure of the newly formed phyto-organically treated gypsum-hardened RMW aggregates was also substantially improved over that of the controls, as a >3-fold increase in resistance to disintegration during wet sieving was exhibited by the phyto-organically treated samples. The increase in water infiltration by combining crushing with phyto-organic applications was ascribed to a decrease in particle dispersion, creating more stable clay clusters, which in turn stabilized channels and pores. Conversely, it was concluded that the singular crushing of gypsum-hardened bauxite waste in the waste dumps is potentially wasteful and ineffective.     

四川攀枝花2008年8月31日Ms 5.6地震震源深度的确定

利用四川区域数字地震台网记录,采用滑动时窗相关法识别sPn震相,测定了四川攀枝花2008年8月31日Ms 5.6地震的震源深度.研究结果显示,震源深度为17 km,表明震源位于中上地壳.元谋-绿汁江断裂带上中强地震分布与断裂走向吻合,震源机制解以走滑为主,这些表明此断裂近乎直立.结合此次地震的震源深度,我们推测此断裂可能达到20 km深.     

Relationships between Interannual and Intraseasonal Variations of the Asian-Western Pacific Summer Monsoon Hindcasted by BCC_CSM1.1（m）

Using hindcasts of the Beijing Climate Center Climate System Model, the relationships between interannual variability （IAV） and intraseasonal variability （ISV） of the Asian-western Pacific summer monsoon are diagnosed. Predictions show reasonable skill with respect to some basic characteristics of the ISV and IAV of the western North Pacific summer monsoon （WNPSM） and the Indian summer monsoon （ISM）. However, the links between the seasonally averaged ISV （SAISV） and seasonal mean of ISM are overestimated by the model. This deficiency may be partially attributable to the overestimated frequency of long breaks and underestimated frequency of long active spells of ISV in normal ISM years, although the model is capable of capturing the impact of ISV on the seasonal mean by its shift in the probability of phases. Furthermore, the interannual relationships of seasonal mean, SAISV, and seasonally averaged long-wave variability （SALWV; i.e., the part with periods longer than the intraseasonal scale） of the WNPSM and ISM with SST and low-level circulation are examined. The observed seasonal mean, SAISV, and SALWV show similar correlation patterns with SST and atmospheric circulation, but with different details. However, the model presents these correlation distributions with unrealistically small differences among different scales, and it somewhat overestimates the teleconnection between monsoon and tropical central-eastern Pacific SST for the ISM, but underestimates it for the WNPSM, the latter of which is partially related to the too-rapid decrease in the impact of E1 Nifio-Southern Oscillation with forecast time in the model.     

浅谈阿舍勒黄铁矿型多金属矿的垂直分带

阿舍勒黄铁型多金属矿床位于阿尔泰地槽褶皱系的中泥盆统安山质—英安质火山—沉积岩中.矿体充填在火山管道内或火山口近侧,主矿体隐伏地下.矿化元素有铁、铜、铅、锌、金、银、硫、钡等,伴生有锗、镓、铟、硒、镉、铋等.矿体上部形态复杂并有分枝,向深部连成一体,是一个向北东侧伏的筒状体.矿体自上而下具垂宜分带,依次为:重晶石—硅化带;黄铁矿—多金属带;黄铁矿—铜、锌带等…     

Bristen granite: a highly differentiated,fluorite-bearing A-type granite from the Aar massif,Central Alps,Switzerland

Bristen granite is a body of fine-grained leucogranite occurring in the Gotthard rail base tunnel in the Central Alps. During construction of the tunnel, Bristen granite (Brgr) has been drilled along a 600 m long section. The aplite-granite belongs to the suite of Variscan granitoid intrusions of the Aar massif and contains a variety of accessory minerals typical of highly differentiated granites. Rock forming fluorite, partly enriched in yttrium (Y) and rare earth elements (REE), is intergrown with the late Y- and REE-bearing carbonate mineral synchysite. The granite contains a variety of Ti- and Y-REE-niobates, thorite, and zircon. Compared with the calc-alkaline central Aar granite (cAgr), Bristen granite is strongly depleted in Ti, P, Mg, Sr, and Ba and shows a remarkable enrichment in incompatible elements such as Rb, Th, U, Nb, Y, HREE and F. Bristen granite is the most evolved granitoid rock of the Aar massif. The composition of Brgr is typical of post-collisional reduced (ferroan) A-type granites. The Brgr melt formed in the lower crust and crystallized from a highly differentiated melt at the cotectic point in the quartz-feldspar system close to 100 MPa and 700 °C. The Brgr intruded as a small isolated stock pre-Variscan gneisses with sharply discordant contacts. The primary igneous host of Nb, Ta, Y, U, Th and REE is biotite in addition to minor amounts of allanite, and zircon. The presence of Y-REE-fluorite, synchysite, parisite and Y- and Ti-niobates and other REE-minerals can be related to reaction of igneous biotite and primary fluorite with hydrothermal fluids. The reaction is associated with alpine metamorphism, because Y-bearing fluorite and synchysite have been reported from Alpine fissures. The transformation of primary biotite to chlorite and muscovite released the heavy metal oxides under lower greenschist facies conditions that formed the Alpine diagnostic mineral stilpnomelane at about 300 °C.