The study of metal contamination in urban topsoils of Mexico City using GIS

This research presents and discusses information concerning the spatial distribution of heavy metals (Pb, Cu, Zn, Ba, Co, Cr, Ni and V) in the urban environments of Mexico City using geographical information system and statistical analysis. Superficial soil samples (n = 146) were analyzed. The highest contamination indices were found in the north and center zone of the metropolitan area. In contrast, the surrounding rural fields show a lower impact grade. The higher concentrations of Pb, Cu, Zn and Ba were observed as being related to high vehicular traffic, nevertheless other elements such as Co, Cr, Ni and V do not show anthropogenic influence and their content can be attributed to the parental rock. The results are compared with previous surveys carried out in 2003 in order to evaluate temporal deposition trends. No changes were found on reported concentrations except for Cu and Zn, whose concentration has increased in later years. The results suggest that spatial distribution analysis and results in comparison with previous studies could be useful for the management and sustainable development of the metropolitan area of Mexico City.     

Rječina River sediments (Croatia): from captured spring to polluted prodelta

Surface sediments (fraction <63 μm) from the source to the mouth of the Rječina, short (18.3 km) karst allogenic river in Croatia, which is an important source of drinking water, were studied to investigate their mineral (by XRD) and chemical (by ICP-MS) composition to check possible anthropogenic influence at the lower course due to paper industry and mills, and in the prodelta area from untreated municipal sewage and the large harbor of Rijeka town. In all analyzed sediment samples and in the sandstone source, rock quartz is a major mineral, while feldspar and mica group minerals are less abundant. Chlorite is a minor or trace mineral in all samples. Calcite and dolomite are abundant in the river prodelta, reflecting changes in bedrock lithology from flysch to carbonates. In river sediments, Fe is the most abundantly analyzed element, while Ca is the most abundant in prodelta sediments. Concentrations of Al, Mn, Ni, Cr, Co, La and Nd decrease downstream, while Mg, S, Na, B, Pb, Zn, As, Sn, U, Mo, Hg and Ag have relatively higher concentration in prodelta sediments. The results are compared with sediments of other rivers in the area: Raša, Rižana and Dragonja, as well as with those of the Rosandra Creek (Italy). Sediments in the Raša River showed similar behavior as those in the Rječina, as the highest concentration of metals was found in the restricted upper part of the estuary, characterized by rapid deposition of clay particles and terrestrial sedimentary organic matter. The comparison also showed that the most contaminated were the sediments from the Rižana, followed by those from the Rječina and Rosandra Creek, which had similar results. Among the studied elements, As was present in all sediment samples at concentrations >6 ppm that might have the lowest toxic effects. At the lower Rječina and in prodelta sediments, Pb was also present at slightly elevated concentrations (>31 ppm) that could cause such effects. Concentrations of Zn in the prodelta correspond to those occurring in moderately polluted sediments (90–200 ppm). In the prodelta sediments, Hg is slightly below toxicity threshold (1 ppm), while Ag is present at toxicity threshold (0.5 ppm) or close to it. Rječina River could act as a good illustrative example for behavior of toxic metals in allogenic karstic rivers, in which accumulation of anthropogenically introduced pollutants usually occurs in their estuaries, as a result of transport and deposition of fine particles.     

Barium-rich fluids and melts in a subduction environment (La Corea and Sierra del Convento mélanges,eastern Cuba)

Whole-rock compositions of muscovite-bearing amphibolite, trondhjemite, pegmatite and quartz-muscovite rocks from Sierra del Convento and La Corea mélanges (eastern Cuba), as well as mineralogy, record complex circulation of Ba-rich fluids and melts in the subduction environment. Partial melting of fluid-fluxed, MORB-derived amphibolite produced trondhjemite magmas that crystallized at depth, in some cases evolving into pegmatites. Qtz-Ms rocks probably crystallized from primary fluids derived from subducted sediments. All these rocks have elevated concentrations of large-ion lithophile elements, especially Ba (up to 11,810 ppm), presumably released from slab sediments by fluids and/or melts. Fluid–rock interaction produced crystallization of phengite in parental amphibolites. The phengite crystallized in all types of rocks is rich in Ba, with concentric zoning, characterized by Ba-rich cores and Ba-poor rims, indicating a compatible behaviour of Ba in the studied systems. Zoning in phengite is governed primarily by the celadonite (tschermak) exchange vector ((Mg,Fe)Si-(Al)_-2), with more moderate contributions of the celsian (BaAl-(KSi)_-1) and paragonite (NaK_-1) exchange vectors. Late remobilization of Ba at relatively low temperature formed retrograde celsian. The compatible behaviour of Ba in the studied rocks strengthens the importance of the stability of phengite for the transfer of LIL elements from the subduction to the volcanic arc environments.     

Sequence stratigraphy of Holocene incised-valley fills and coastal evolution in the Gulf of Cádiz (southern Spain)

This first sedimentary interpretation of two incised-valley fills in the Gulf of Cádiz (southern Spain), which accumulated during the last fourth-order eustatic cycle in response to fluvial incision, changes of sea level, and correlative deposition, relates the filling of the estuarine basins and their barriers with four regional progradation phases, H₁ to H₄. The cases studied are the wave-dominated Guadalete, and the mixed, tide and wave-dominated Odiel-Tinto estuaries. The sequence boundary is a type-1 surface produced during the lowstand of the Last Glacial period ca. 18 000 ¹⁴C yr BP. No fluvial lowstand deposits were found in the area. Due to rapid transgression the valley fills consist of transgressive and highstand sediments. The maximum landward advance of the estuarine barriers occurred ca. 6500–6000 ¹⁴C yr BP during the maximum of the Flandrian transgression, but there is no evidence of sea level rising appreciably above the present. A large part of the estuaries was filled during H₁ (ca. 6500–4400 ¹⁴C yr BP) but ravinement by shifting tidal inlets destroyed most of the coeval barriers. During the H₂ phase (ca. 4200–2550 ¹⁴C yr BP) sedimentation was favoured by arid conditions and concentrated in the axial estuarine zones and the barriers. Between H₂ and H₃ prevailing winds changed from W to WSW, increasing spit growth to the east and south-east. Progradation of bay-head deltas and flood-plains during H₃ (ca. 2300–800 ¹⁴C yr BP) and H₄ (500 yr ago to the present) further reduced the accommodation space in the largely-filled valleys, and sediment by-passed the estuaries and accumulated in the estuarine barriers as fast-growing spits. Arid conditions and increasing human activity have caused rapid coastal modifications.     

Seismic Zoning of Croatia

The territory of Croatia and neighboring regions is divided into 17 seismic source zones, considering available seismological and geological data. On this basis, seismic hazard elements (seismicity rate, maximum magnitude, b-value, probabilities of exceedance and return periods for a predefined set of magnitudes) are computed using the maximum likelihood method appropriate for treating data-sets with variable completeness thresholds. The values of long term expected peak horizontal acceleration obtained by using a combination of the deterministic and the probabilistic procedure are the highest in the Dubrovnik zone, while the Zagreb zone has the highest earthquake hazard in the continental part of the country. This revised version was published online in June 2006 with corrections to the Cover Date.     

A macroscopic damage‐plastic constitutive law for modeling quasi‐brittle fracture and ductile behavior of concrete

A new phenomenological macroscopic constitutive model for the numerical simulation of quasi‐brittle fracture and ductile concrete behavior, under general triaxial stress conditions, is presented. The model is particularly addressed to simulate a wide range of confinement stress states, as also, to capture the strong influence of the mean stress value in the concrete failure mechanisms. The model is based on a two‐surface damage‐plastic formulation. The mechanical behavior in different domains of the stress space is separately described by means of a quasi‐brittle or ductile material response:

相似文献   

The 2011 submarine volcanic eruption in El Hierro (Canary Islands)

Forty years after the Teneguía Volcano (La Palma, 1971), a submarine eruption took place off the town of La Restinga, south of El Hierro, the smallest and youngest island of the Canarian Archipelago. Precursors allowed an early detection of the event and its approximate location, suggesting it was submarine. Uncertainties derived from insufficient scientific information available to the authorities during the eruption, leading to disproportionate civil protection measures, which had an impact on the island's economy—based primarily on tourism—while residents experienced extra fear and distress.     

In Situ Determination of Au and Cu in Natural Pyrite by Near‐Infrared Femtosecond Laser Ablation‐Inductively Coupled Plasma‐Quadrupole Mass Spectrometry: No Evidence for Matrix Effects

Gold and copper concentrations were determined in natural pyrite by near‐infrared femtosecond LA‐ICP‐QMS, using both sulfide reference materials (pyrrhotite Po‐726 and in‐house natural chalcopyrite Cpy‐RM) and NIST SRM 610 as external calibrators. Firstly, using NIST SRM 610 as the external calibrator, we calculated the Au concentration in Po‐726 and the Cu concentration in Cpy‐RM. The calculated concentration averages for Au and Cu were similar to the values published for Po‐726 and Cpy‐RM, respectively. Secondly, we calculated Au and Cu concentrations taking NIST SRM 610 as an unknown sample and using Po‐726 and Cpy‐RM as external calibrators. Again, the average values obtained closely reflected the preferred concentrations for NIST SRM 610. Finally, we calculated Au and Cu concentrations in natural pyrite using sulfide and silicate reference materials as external calibrators. In both cases, calculated concentrations were very similar, independent of the external calibrator used. The aforementioned data, plus the fact that we obtained very small differences in relative sensitivity values (percentage differences are between 5% and 17% for ⁵⁷Fe, ⁶³Cu and ¹⁹⁷Au) on analyses of silicate and sulfide RMs, indicate that there were no matrix effects related to the differences in material composition. Thus, it is possible to determine Au and Cu in natural sulfides using NIST silicate glasses as an external calibrator.     

Fluid inclusion studies in datolite of low grade metamorphic origin from a Jurassic pillow basalt series in northeastern Hungary

The Jurassic pillow basalt blocks in the Szarvask? Unit in the SW-Bükk Mountains are incorporated into an accretionary mélange of Cretaceous age which had been displaced from the Dinarides to NE-Hungary during the Alpine-Carpathian collision. The pillow basalt series is a part of an incomplete remnant of an ophiolite-like sequence from which ultramafic units and sheeted dikes are almost completely absent. At the studied Egerbakta quarry, closely packed pillow, pillow fragmented hyaloclastite breccia and peperitic facies of submarine basaltic volcanism were recognized. Peperitic facies was formed by local admixture of unconsolidated siliciclastic sediment into the basaltic lava. Basaltic pillows contains short and thin prehnite-chlorite-carbonate-quartz veins formed during the interaction of seawater with the cooling lava, as well as cross-cutting datolite-prehnite-quartzchlorite-albite bearing veins. Calcite in the short cooling cracks crystallised from upheated seawater at around 160°C temperature and 0.5?C0.6 kbar pressure (water depth of about 5?C6 km). Datolite precipitations in veins can be classified into at least three different textural-morphological types but all of them contain methane bearing primary fluid inclusion assemblages, with variable methane/water ratios, suggesting an inhomogeneous entrapment from a heterogeneous aqueous-carbonic fluid. End member primary fluid inclusions contain aqueous liquid with methane rich vapour phase and apparently methane only inclusions characterized by liquid phase on room temperature. A combination of results from fluid inclusion microthermometry, Raman spectroscopy (used not only for phase identification but also for determination of salinities) and temperatures calculated from chlorite compositions, show that the precipitation of datolite had taken place from low salinity (0.2?C2 NaCl equiv. mass%) aqueous-methane fluids under increasing temperature and pressure (from 160 to 210°C, and from 0.6 to 1.1 kbar) conditions. The elevated pressures and temperatures in comparison to the submarine hydrothermal processes suggest that the datolite bearing mineral parageneses had been formed during the progression of Alpine very low grade metamorphic processes.     

Palaeoshoreline for the Late Cretaceous marine platform in the Iberian Trough (Leonese Area, Spain) deduced from outcrop and subsurface analysis

The location of the Late Cretaceous paleoshoreline in the Leonese Area (Iberian Trough, Spain) has been investigated by seismic analysis through isobath and isopach maps. The succession can be divided into two depositional sequences: DS-1 and DS-2. These sequences are composed of fluvial systems at the base, with paleocurrents that flowed eastward and north-eastward. The DS-1 sequence (Late Albian-Middle Turonian) shows intertidal to subtidal and offshore deposits at the top, while the DS-2 sequence (Late Turonian-Campanian) presents intertidal to subtidal, tidal flat and shallow marine and lacustrine deposits at its top. The stratigraphic cyclicity based on systems tracts shows that these two depositional sequences exhibit remarkable eustatic control. Both sequences start at the base with a significant sedimentary supply from fluvial systems, related to eustatic fall episodes, and conclude at the top with transgressive periods. The evolution of the basin reveals the history of base-level changes and associated shifts in depositional trends during successive stages. The deeper sectors of the DS-1 sequence are located towards the northeastern part of the study area while the proximal portion of the basin-margin is located to the southwest. The paleoshoreline is placed in a direction oriented at 120. The variations in thickness are elongated in orientations between 030 and 050 and are mainly related to paleovalleys and tributary fluvial networks that supply sediment through the shoreline. It is possible that these variations may be related to active synsedimentary faults. Depocenters move toward the northeast and east during the DS-2 sequence while the proximal portion of the basin-margin moves to the southwest. The paleoshoreline has an orientation of 155 direction and moves basinward. The isopach maps show a group of corridors oriented at 130?C140 and 165?C170, interpreted as result of accumulation of sandy bodies such as inter and subtidal bars. The fluvial systems are transversal to the paleoshoreline direction.