Bathymetry, biota and sediments on the Hirota Reef, Tane-ga-shima – the northernmost coral reef in the Ryukyu Islands

Abstract Investigations were conducted on bathymetry, reef biota and sediments on the Hirota Reef, Tane‐ga‐shima, North Ryukyus, near the northern limit for coral‐reef formation. A bathymetric profile from shore to the reef edge was depicted along an approximately 420‐m transect on the Hirota Coast of this island. A total of 20 quadrats (1 m × 1 m) were analyzed along the profile at 10‐ or 20‐m intervals to clarify distribution of macrobenthos inhabiting the reef. The Hirota Reef is divided into four geomorphologic zones according to their depth, gradient, surface roughness, substrate and characteristic macrobenthos. They are, from shore to offshore, shallow lagoon, seaward reef flat, reef edge and reef slope. The shallow lagoon comprises a shoreward depression (∼160 m wide on the transect) with a sand/gravel bottom that inclines gently toward offshore, and a seaward patch zone (∼70 m wide). The patches (<2 m high) are covered with fleshy algae, coralline algae and hermatypic corals. The seaward reef flat (∼190 m wide) is a flat plane that is constructed by biogenic carbonates and is covered with turf algae, with hermatypic corals scattered. Although the seaward reef flat of the Hirota Reef cannot be differentiated into different geomorphologic zones, similar seaward reef flat areas in the Central and South Ryukyus can be clearly subdivided into inner reef flat, reef crest and outer reef flat. This difference may be attributed to a lower reef growth rate and/or the later reef formation of the Hirota Reef in Holocene time than the southern examples. The coral fauna on the Hirota Reef is delineated by low diversity and characterized by taxa typical of high‐latitude, non‐reefal communities. The algal flora consists of tropical to subtropical species associated with warm‐temperate species. These faunal and floral characteristics may be related largely to lower water temperature in Tane‐ga‐shima than those in typical coral‐reef regions.     

Collision structure in the upper crust beneath the southwestern foot of the Hidaka Mountains, Hokkaido, Japan as derived from explosion seismic observations

The P-wave velocity structure of the upper crust beneath a profile ranging from Niikappu to Samani in the southwestern foot of the Hidaka Mountains, Hokkaido, Japan was obtained through analysis of refraction and wide-angle reflection data. The mountains are characterized by high seismicity and a large gravity anomaly. The present profile crosses the source region of the 1982 Urakawa-oki earthquake (M_s 6.8). The length of the profile is 66 km striking northwest and southeast. Along the profile, 64 vertical geophones were set up and 5 shot points were chosen. For each shot, a 400–600 kg charge of dynamite was detonated. The studied area is composed of four major geological belts: Neogene sedimentary rocks, the Kamuikotan belt, the Yezo Group, and the Hidaka belt. The measurement line crosses these geological trend at an oblique angle. The structure obtained is characterized by remarkable velocity variations in the lateral direction and reflects the surface geological characteristics. A thin, high-velocity layer (HVL) was found between low-velocity materials in the central part of the profile, beneath the Kamuikotan Metamorphic Belt, at a depth ranging from 0.5 to 6 km, overthrusting toward the west on the low-velocity materials consisting of Neogene sedimentary rocks, and forming gentle folds. Outlines of the velocity structure of the Hidaka Mountains yielded by other studies have shown a large-scale overthrust structure associated with the collision of the Outer Kurile and the Outer Northern Honshu Arcs. The shallow velocity structure inferred by the present study showed a similar (although small scale) overthrust structure. The obtained structure shows that the composite tectonic force, comprising westward movement of the Outer Kurile Arc and northward movement of the Outer Northern Honshu Arc, plays an important role in the evolution of the tectonic features of the crust and upper mantle in a wide depth range beneath the Hidaka Mountains.     

Observational tests of x-matter models

We study gravitational lensing statistics, matter power spectra and the angular power spectra of the cosmic microwave background (CMB) radiation in x-matter models. We adopt an equation of state of x-matter which can express a wide range of matter from pressureless dust to the cosmological constant. A new ingredient in this model is the sound speed of the x-component, in addition to the equation of state w ₀ =  p _x0/ρ_x0. Except for the cosmological constant case, the perturbations of x-matter itself are considered. Our primary interest is in the effect of non-zero sound speed on the structure formation and the CMB spectra. It is found that there exist parameter ranges where x-matter models are consistent with all current observations. The x-matter generally leaves imprints in the CMB anisotropy and the matter power spectrum, which should be detectable in future observations.     

Irrigation related arsenic contamination of a thin,alluvial aquifer,Madison River Valley,Montana, U.S.A.

The arsenic concentration in 13 water samples from wells in the thin, alluvial aquifer of the Madison River Valley, Montana, U.S.A. ranged from 26 to 150 μg/l. The Madison River, which originates in Yellowstone National Park, has a mean arsenic concentration of 51 μg/l (σ=26 μg/l), based upon very limited sampling in the study area during the main irrigation period. Groundwater arsenic concentration increases down the valley can be best correlated with the intensity of ditch irrigation in this semiarid area. No other sources of dissolved arsenic as concentrated as that of the river water have been identified. Evaporative concentration of river-derived irrigation water is believed to have been the overwhelming factor in the contamination of this shallow aquifer.     

Iron oxidation state of a 2.45-Byr-old paleosol developed on mafic volcanics

The 2.45-Byr-old weathering profile developed on early Proterozoic mafic volcanics located near Cooper Lake, Ontario, Canada, was examined geochemically and mineralogically for a better understanding of the atmospheric oxygen evolution. Ferrous to ferric ion, Fe(II) and Fe(III), respectively, ratios of the bulk rock samples were analyzed by Mössbauer spectrometry. The total Fe (Fe(T)) and Fe(II) concentrations decrease from 12.0 and 11.2 wt.% to 1.85 and 0.89 wt.%, respectively, from the bottom to the top of the weathering profile. The Fe(T) and Fe(II) concentrations normalized to Ti and Zr, as well as the Fe(II)/Fe(III) ratio of raw data, linearly decrease with depth toward the top, while the Fe(III) concentration remains nearly constant throughout the profile. The linear decrease of Fe(II), accompanied by the nearly constant distribution of Fe(III), is difficult to be explained by the scenario of oxidizing weathering and subsequent reducing hydrothermal alteration. The behaviors of Fe(II) and Fe(III) can be simply explained by anoxic weathering. The anoxic weathering suggests that the 2.45-Ga atmosphere was anoxic. The slight increase of Fe/(Fe+Mg) in the octahedral sites of chlorite toward the top and no Ce anomaly in the REE patterns are also consistent with anoxic weathering.     

Shear Strength Behavior of Two Landfill Clay Liners

Direct shear tests were conducted to obtain both the shear strength of compacted clay liners (CCLs) specimens and the interface shear strength between compacted clay liner and base soil. These experiments were conducted under the conditions of five different water contents. The experimental results show that shear strength of both CCLs and CCLs/base interface decreases with the increase in the water content of CCLs and base soil. In addition, the considerate concentration of NaCl in leachate has no deteriorating effect on the shear strength of liners. Triaxial shear tests were also conducted on clay liner specimens to obtain total and effective shear strength under a fast compression. The shear strength c‘=100 kPa for sand-bentonite, respectively. These results indicate that the compacted clay-bentonite shows normal consolidation, but that the compacted sand-bentonite exhibits over-consolidation.     

Map projection errors in the Weber problem

 When demand points are given as a planar map where projection method is explicitly stated, we usually know the latitudes and longitudes of these points from the map. Then we can solve the Weber problem on the globe, and we do not suffer from errors. This paper analyses how cylindrical projections cause distortion in the Weber problem when demands are distributed on the Northern Hemisphere. First, we demonstrate that planar solutions are always located south of the spherical solution if the Mercator projection, the equirectangular projections with standard parallels near the demands, or the equal-area projection with the same characteristic is chosen. Second, we verify that this geographical tendency is inclined to hold when the demand points, are distributed symmetrically, widely or toward the north. Received: 15 August 2001 / Accepted: 20 April 2002 This paper was partially written while the first author was visiting the Department of Geography at the Catholic University of Louvain, Louvain-la-Neuve, Belgium [1993–1994]. He is grateful for the hospitality of this department. An earlier version of this paper was presented in 1994 at the Seventh Meeting of the European Operational Research Working Group on Locational Analysis in Brussels, and in 1996 at the Fifth World Congress of the Regional Science Association International in Tokyo. The authors would also like to thank the participants as well as three anonymous referees for their constructive comments.     

Three-Dimensional Geopositioning Accuracy of Ikonos Imagery

An investigation of the accuracy potential of Ikonos 1m satellite imagery is reported. Three sensor orientation/triangulation models are applied to stereo- and three-image configurations of "Geo" imagery with the aim of achieving 3D geopositioning to sub-metre accuracy. The models considered comprise rational functions with bias compensation, affine projection and the direct linear transformation. Test results from the Melbourne Ikonos Testfield are reported and these show that with modest provision of good quality ground control, Ikonos "Geo" imagery can yield 3D object-point determination to an accuracy of 0.5m in planimetry and 0.7m in height. The accuracy achieved is not only consistent with expectations for rigorous sensor orientation models, but is also readily attainable in practice with only a small number of ground control points being required     

Magnetic and electric field observations during the 2000 activity of Miyake-jima volcano, Central Japan

Magnetic and electric field variations associated with the 2000 eruption of Miyake-jima volcano are summarized. For about 1 week prior to the July 8 phreatic explosion, significant changes in the total intensity were observed at a few stations, which indicated uprising of a demagnetized area from a depth of 2 km towards the summit: this non-magnetic source can be regarded as a vacant space itself. Electric and magnetic field variations were observed simultaneously associated with the tilt-step event, which was the abrupt (∼50 s) inflation at a few km depth within the volcano followed by gradual recovery (∼several hours). The electric field is ascribed to the electrokinetic effect most probably due to forced injection of fluids from the source, while the magnetic field to the piezomagnetic effect due to increased pressure. Large magnetic variations amounting to a few tens of nT were observed at several stations since July 8, and they turned almost flat after the August 18 largest eruption. Magnetic changes are explained mostly by the vanishing of magnetic mass in the summit and additionally by the thermal demagnetization at a rather shallow depth. A large increase in the self-potential by 130 mV was also observed near the summit caldera associated with the August 18 eruption, which suggests that the hydrothermal circulation system sustained within the volcano for the past more than 10 years was destroyed by this eruption.     

Water-weakened lower crust and its role in the concentrated deformation in the Japanese Islands

The nature and origin of the concentrated deformation zone along the Japan Sea coast (NKTZ: Niigata-Kobe tectonic zone) was investigated by carefully analyzing the GPS data and qualitatively modeling the lower crust in NKTZ. It was concluded that this deformation zone is not a plate boundary between the Amurian plate (AMU) and the North America plate but is rather an internal deformation zone near the eastern margin of AMU. The data previously obtained on the conductivity anomalies in the lower crust and the ³He/⁴He ratios suggest that the concentrated deformation in NKTZ results from the lower crust in NKTZ being weakened by a high water content. The high water content is thought to result from the dehydration of subducting slabs. NKTZ has a higher water content in the lower crust than other regions do because there is no Philippine Sea plate (PHS) seismic slab beneath NKTZ. In other regions, it is estimated that the mantle wedge above the seismic Philippine Sea slab prevents the water dehydrated from the slab from rising to the lower crust, and that the lithosphere within PHS itself prevents the water dehydrated from the Pacific plate from rising up through it.