The distribution and abundance of marine litter on 26 beaches along the Sea of Japan were investigated from September to November 2000. The mean concentration of stranded litter in Japan and Russia was 2144 and 1344 g/100 m(2), respectively. The mean number of pieces of stranded litter in Japan and Russia was 341 and 20.7/100 m(2), respectively. The most abundant type of stranded litter was plastic, which accounted for 40-80 % of the total items in terms of weight and number. The mean concentration of buried litter in Japan and Russia was 9.03 and 2.70 g/m(2), respectively. The total weight ratio of buried litter to stranded litter in the samples was 0.65, suggesting the significance of buried litter when evaluating the status of litter on beaches. Resin pellets were found on 12 Japanese beaches, but on none of the Russian beaches. 相似文献
Freezing was used in the jointing section of two shields (diameter 3.14 m) which ran across at right angles and at 25-m depth under the crossing of main roads for the construction of a 2.4-m diameter sewer tunnel. The object of freezing was to create a frozen barrier to prevent the inflow of water and fine sand into the area to be excavated.
Thirty-five freeze pipes (length about 7 m) were placed from one shield conically in the direction of the flank of another shield with freeze pipes attached to its inside wall. The cooling unit was placed on unoccupied land at about 60 m distant from the jointing section and the freeze pipes were connected with the cooling unit by supply and return pipelines.
The cooling unit had a cooling capacity of 79,000 kcal/h at an evaporation temperature of −27°C and a condensation temperature of +40°C. Freezing was continued for 180 days and the CaCl2 brine temperature was −25 to −30°C. These works were accomplished without the sinking of shaft and the use of injection, in complete safety with no traffic restriction on the road surface. 相似文献
Near-liquidus phase relations in one-atmosphere dry and water-saturated high pressure conditions were experimentally determined on products of three historic andesitic eruptions. Run conditions ranged from 900 to 1100°C, at pressures up to 1500 bars with fO2 controlled close to the nickel-nickel oxide (NNO) buffer. In order to represent the compositions of the true liquid parts of the erupting magmas, groundmass portions were mechanically separated from the porphyritic andesites. Such groundmass materials should lie exactly on the liquidus field boundary between the phases precipitating from the magma just prior to eruption under the prevailing P-T condition.All the samples showed a crossing of the plagioclase and orthopyroxene liquidi in the pressure-temperature range from 1 to 800 bar and 950–1090°C. The crossing condition approximates the magmatic condition immediately prior to eruption. In the case of the 1970 eruption of Akita-komagatake, the crossing point is at 150 bar and 1090°C, matching closely the observed explosive gas pressure and the temperature. In both cases of the 1783 eruption of Asama and the 1914–1915 eruption of Sakurajima volcanoes, the crossing point shift from higher water pressure and lower temperature for the earlier erupting magmas to lower pressure and higher temperature for the later magmas. This regularity may be explained by a vertical gradient of the temperature and water content within the magma column prior to eruption. 相似文献
The tsunami caused by the Great East Japan Earthquake on 11 March 2011 greatly influenced the coastal benthic environment on the northern Pacific coast of Japan. We used the direct count method to investigate changes in the abundance and distribution of Alexandrium (Alexandrium tamarense and Alexandrium catenella) cysts before and after the tsunami in Sendai Bay. Densities of Alexandrium cysts in sediments collected in summer 2011 ranged from 0 to 8,190 cysts cm?3. In the western part of the bay, the density increased greatly after the tsunami, the highest density being approximately 10 times the density recorded in 2005. Molecular identification of single cysts with multiplex polymerase chain reaction (PCR) showed that Alexandriumtamarense dominated the cyst population in the southwestern part of the bay in 2011. Furthermore, accumulation of cysts on the surface sediment after disturbance of the sediment was confirmed by a laboratory experiment. The main factor causing the drastic changes in abundance and distribution of Alexandrium cysts after the earthquake was considered to be vertical and horizontal redistribution of the cysts in sediments after the tsunami. 相似文献
The conditions under which rear-arc magmas are generated were estimated using primary basalts from the Sannome-gata volcano, located in the rear of the NE Japan arc. Scoriae from the volcano occur with abundant crustal and mantle xenoliths, suggesting that the magma ascended rapidly from the upper mantle. The scoriae show significant variations in their whole-rock compositions (7.9–11.1 wt% MgO). High-MgO scoriae (MgO > ~9.5 wt%) have mostly homogeneous 87Sr/86Sr ratios (0.70318–0.70320), whereas low-MgO scoriae (MgO < ~9 wt%) have higher 87Sr/86Sr ratios (>0.70327); ratios tend to increase with decreasing MgO content. The high-MgO scoriae are aphyric, containing ~5 vol% olivine microphenocrysts with Mg# [100 × Mg/(Mg + Fe2+)] of up to 90. In contrast, the low-MgO scoriae have crustal xenocrysts of plagioclase, alkali feldspar, and quartz, and the mineralogic modes correlate negatively with whole-rock MgO content. On the basis of these observations, it is inferred that the high-MgO scoriae represent primary or near-primary melts, while the low-MgO scoriae underwent considerable interaction with the crust. Using thermodynamic analysis of the observed petrological features of the high-MgO scoriae, the eruption temperature of the magmas was constrained to 1,160–1,220 °C. Given that the source mantle was depleted MORB-source mantle, the primary magma was plausibly generated by ~7 % melting of a garnet-bearing spinel peridotite; taking this into consideration, and considering the constraints of multi-component thermodynamics, we estimated that the primary Sannome-gata magma was generated in the source mantle with 0.5–0.6 wt% H2O at 1,220–1,230 °C and at ~1.8 GPa, and that the H2O content of the primary magma was 6–7 wt%. The rear-arc Sannome-gata magma was generated by a lower degree of melting of the mantle at greater depths and lower temperatures than the frontal-arc magma from the Iwate volcano, which was also estimated to be generated by ~15 % melting of the source mantle with 0.6–0.7 wt% H2O at ~1,250 °C and at ~1.3 GPa. 相似文献
The December 26, 2003 Mw 6.6 Bam earthquake is one of the most disastrous earthquakes in Iran. QuickBird panchromatic and multispectral satellite imagery with 61 cm and 2.4 m ground resolution, respectively provide new insights into the surface rupturing process associated with this earthquake. The results indicate that this earthquake produced a 2–5 km-wide surface rupture zone with a complex geometric pattern. A 10-km-long surface rupture zone developed along the pre-existing Bam fault trace. Two additional surface rupture zones, each 2–5 km long, are oblique to the pre-existing Bam fault in angles of 20–35°. An analysis of geometric and geomorphic features also shows that movement on the Bam fault is mainly right-lateral motion with some compressional component. This interpretation is consistent with field investigations, analysis of aftershocks as well as teleseismic inversion. Therefore, we suggest that the 2003 Bam earthquake occurred on the Bam fault, and that the surface ruptures oblique to the Bam fault are caused by secondary faulting such as synthetic shears (Reidel shears). Our fault model for the Bam earthquake provides a new tectonic scenario for explaining complex surface deformations associated with the Bam earthquake. 相似文献