Performance of dry-separation processes in the recovery of cenospheres from fly ash and their implementation in a recovery unit

Cenospheres recovery is one of the coal fly ash beneficiations, providing economic as well as environmental benefits. Current techniques, such as lagoon or other wet-separation processes, consume large amounts of water and add to water pollution due to leaching of toxic materials from fly ash. The other possible disadvantage is the need for a wide operational area, which is unsuitable for densely populated countries. As wet-separation processes have some disadvantages, an improved and/or sustainable alternative recovery technique is required. An air classifier is one of the alternative techniques. In this study, two types of air classifiers, namely a closed-type pneumatic separator and a micron separator, have been investigated. In terms of separation efficiency, it was found that the micron separator has the potential to be applied in cenospheres recovery from coal fly ash, giving a Newton's efficiency of 0.44, as compared to a value of about 0.26 for the closed-type pneumatic separator. The cenospheres recoveries of both pieces of equipment at their optimum Newton's efficiencies were similar at over 60 wt.%. The separation performance was further assessed from the particle distributions of the overflow and underflow products obtained from both pieces of equipment, as well as from SEM images. It was found that the lower Newton's efficiency of the closed-type pneumatic separator was due to the re-concentration of fine particles in the underflow product at air-flow rates higher than 2.2 m/s (the underflow product yield was about 55 wt.%).In order to further confirm the applicability of this technique, the micron separator, which had provided higher separation efficiency and cenospheres recovery, was deployed in a cenospheres recovery unit prior to the use of a wet-separation process (float and sink tank). About 80% of the cenospheres was recovered, with an 87.8% reduction in the total mass of fly ash to be separated in the float and sink tank. Consequently, much less water was needed for the process of cenospheres recovery. Moreover, it was also confirmed that the micron separator could yield higher quality fly ashes, that is, fly ash types I and II, from lower feed quality of fly ash type IV, which is the lowest category in commercial classification of fly ash according to JIS A6201.     

Experimental study on prevention of acid mine drainage by silica coating of pyrite waste rocks with amorphous silica solution

Acid mine drainage (AMD) is a widespread environmental problem associated with working and abandoned mining operations. It results from the microbial oxidation of pyrite in the presence of water and air, affording an acidic solution that contains toxic metal ions. Pyrite microencapsulation, utilizing silica coating, is a novel approach for controlling AMD that has been shown to be very effective in controlling pyrite oxidation. The roles of the solution pH and silica concentration in the formation mechanism for the AMD-preventing coating were investigated. A silica coating can be formed from silica solution at pH 7, at which the amount of Fe eluted from pyrite into the solution is small. No coating was formed at other pH values, and the amounts of eluted Fe were larger than at pH 7, especially at pH 11. The silica coating forms from 2,500 to 5,000 mg/L silica solutions, but not from 0 or 1,000 mg/L silica solutions. The coating formation rate was slower in the 2,500 mg/L silica solution than in the 5,000 mg/L silica solution. The formation of silica coating on pyrite surfaces depends on three main steps: formation of Fe(OH)₃ on the surface of pyrite, reaction between Fe(OH)₃ and silicate in the solution on the pyrite surface, and growth of the silica layer on the first layer of silica. The best pH condition to enable these steps was around 7, and the silica coating formation rate can be controlled by the concentration of silica.     

Duluth Complex apatites: Age reference material for LA–ICP–MS‐based fission‐track dating

Anorthositic series apatites of the Duluth Complex, Minnesota, USA, have high spontaneous fission‐track densities of up to ~10⁷ cm^–2 and a homogeneous age of ~900 Ma, allowing high‐precision fission‐track dating based on LA–ICP–MS U analysis. Absolute fission‐track dating, track‐length measurement and chemical composition analysis were performed to evaluate a cooling history, which is essential for age reference materials. Preliminary inverse modelling for a sample with a shortened track‐length distribution yielded a monotonic cooling history from ~100°C at 925 Ma. The apatites incur an over‐etching problem when employing the commonly used etching protocol involving 5.5 M HNO₃.     

Development of partial factor design method on bending strength of piles for Japanese Specifications for Highway Bridges

ABSTRACT

This paper describes the development of a partial factor design method on the bending strength of piles for the Japanese Specifications for Highway Bridges. First, uncertainties in mobilised bending moments and yield bending moments were evaluated by Monte Carlo simulations. Second, the reliability of piles designed by the previous specifications were evaluated on the basis of reliability analysis considering uncertainties in the mobilised bending moments, yield bending moments, and other factors. Finally, a partial factor design method utilising a survey subsurface investigation method and ground type was developed to reach target reliability levels determined by the Standards.     

Characteristics of ionic components in precipitation in Kitakyushu City,Japan

Precipitation samples were collected by filtrating bulk sampler in Kitakyushu City, Japan, from January 1988 to December 1990. Volume weighted annual mean of pH was 4.93, but the pH distribution indicated that most probable value lay in the range pH 6.0–6.4. Volume weighted annual mean concentrations of major ionic components were as follows; SO ₄ ^2– : 84.2, NO ₃ ^– : 28.1, Cl^–: 86.3, NH ₄ ⁺ : 45.5, Ca²⁺: 63.3, Mg²⁺: 27.0, K⁺: 3.4, Na⁺: 69.0 µ eq l^–1. The highest concentrations of these ionic components were observed in winter and the lowest occurred in the rainy season. The ratio of ex-SO ₄ ^2– /NO ₃ ^– exhibited the lowest ratio in summer, and the highest ratio in winter. Good correlations were obtained between Cl^– and Na⁺, ex-SO ₄ ²⁺ and ex-Ca²⁺, NO ₃ ^– and ex-Ca²⁺, and NH ₄ ⁺ and ex-SO ₄ ^2– , respectively. However, no correlation between Cl^– and Na⁺ with Ca²⁺ was observed. The relationship of H⁺ with (ex-SO ₄ ^2– + NO ₃ ^– ) - (ex-Ca²⁺ + NH ₄ ⁺ ) indicated positive correlation.     

Small scale turbulent diffusion determined with underwater flow visualization

Dye plumes were generated at three depths in the seasonal thermocline between 7 and 11 m, 22 km south of Key West on 21 August 1980 and photographed at about 10 second intervals with an underwater camera system. Eleven pairs of consecutive pictures are analyzed to determine the mean current vertical shear and the width of the plumes by positioning reference points relative to the rod attached to the camera system. The relative distances of reference points are calibrated with the stereophotogrammetric method for one pair. The eddy diffusivity is calculated by use of a model of turbulent diffusion developed byTaylor (1921). Its values range from 5 to 25 cm²s^–1 for the plume widths ranging from 33 to 132 cm. The Richardson number is calculated for each pair of pictures with the vertical density gradient estimated from temperature profiles. Its values are higher than the critical value of 0.25 except for one case. The diffusivity was higher by orders of magnitude than the molecular one and indicates the presence of turbulence together with billow like features of the plumes in spite of high Richardson numbers. This suggests that the billow turbulence might be caused by effects of surface gravity waves and not by the Kelvin-Helmholtz instability.     

International survey on the distribution of stranded and buried litter on beaches along the Sea of Japan

The distribution and abundance of marine litter on 26 beaches along the Sea of Japan were investigated from September to November 2000. The mean concentration of stranded litter in Japan and Russia was 2144 and 1344 g/100 m(2), respectively. The mean number of pieces of stranded litter in Japan and Russia was 341 and 20.7/100 m(2), respectively. The most abundant type of stranded litter was plastic, which accounted for 40-80 % of the total items in terms of weight and number. The mean concentration of buried litter in Japan and Russia was 9.03 and 2.70 g/m(2), respectively. The total weight ratio of buried litter to stranded litter in the samples was 0.65, suggesting the significance of buried litter when evaluating the status of litter on beaches. Resin pellets were found on 12 Japanese beaches, but on none of the Russian beaches.     

Scoria cone formation through a violent Strombolian eruption: Irao Volcano, SW Japan

Scoria cones are common volcanic features and are thought to most commonly develop through the deposition of ballistics produced by gentle Strombolian eruptions and the outward sliding of talus. However, some historic scoria cones have been observed to form with phases of more energetic violent Strombolian eruptions (e.g., the 1943–1952 eruption of Parícutin, central Mexico; the 1975 eruption of Tolbachik, Kamchatka), maintaining volcanic plumes several kilometers in height, sometimes simultaneous with active effusive lava flows. Geologic evidence shows that violent Strombolian eruptions during cone formation may be more common than is generally perceived, and therefore it is important to obtain additional insights about such eruptions to better assess volcanic hazards. We studied Irao Volcano, the largest basaltic monogenetic volcano in the Abu Monogenetic Volcano Group, SW Japan. The geologic features of this volcano are consistent with a violent Strombolian eruption, including voluminous ash and fine lapilli beds (on order of 10^?1 km³ DRE) with simultaneous scoria cone formation and lava effusion from the base of the cone. The characteristics of the volcanic products suggest that the rate of magma ascent decreased gradually throughout the eruption and that less explosive Strombolian eruptions increased in frequency during the later stages of activity. During the eruption sequence, the chemical composition of the magma became more differentiated. A new K–Ar age determination for phlogopite crystallized within basalt dates the formation of Irao Volcano at 0.4?±?0.05 Ma.