Carbon storage in desertified lands: A case study from North China

Based on the organic and carbonate carbon levels of the top 1 m of soil from desertified soils of Northern People's Republic of China, climatic and vegetative cover zones have been derived for some 334000 km² of desertification-prone lands. Regional accumulations of pedogenic carbonates were examined relative to precipitation, altitude, and temperature. The largest accumulations of pedogenic carbonates were found in Calcic soils in warm, arid areas. Accumulated organic carbon predominated in soils under Betula platyphylla. In the naturally desertified lands of China, for example, the top 1.0-m soil layer contains some 7.84 Pg of organic carbon and 14.9 Pg of carbonate carbon. Total stored carbon, including carbonate carbon, is 1.8-fold more than organic carbon alone. The carbon released through land desertification in China may be an important factor affecting changes in concentrations of greenhouse gases worldwide.     

A comparative analysis of large-scale flood disasters

Natural Hazards - The purpose of this study is to analyze and compare the human suffering exacerbation processes in the coastal metropolitan areas of Nagoya, New Orleans and Metro Manila caused by...     

Seismic evidence for a sharp lithospheric base persisting to the lowermost mantle beneath the Caribbean

Broad-band data from South American earthquakes recorded by Californian seismic networks are analysed using a newly developed seismic wave migration method—the slowness backazimuth weighted migration (SBWM). Using the SBWM, out-of-plane seismic P -wave reflections have been observed. The reflection locations extend throughout the Earth's lower mantle, down to the core–mantle boundary (CMB) and coincide with the edges of tomographically mapped high seismic velocities. Modelling using synthetic seismograms suggests that a narrow (10–15 km) low- or high-velocity lamella with about 2 per cent velocity contrast can reproduce the observed reflected waveforms, but other explanations may exist. Considering the reflection locations and synthetic modelling, the observed out-of-plane energy is well explained by underside reflections off a sharp reflector at the base of the subducted lithosphere. We also detect weaker reflections corresponding to the tomographically mapped top of the slab, which may arise from the boundary between the Nazca plate and the overlying former basaltic oceanic crust. The joint interpretation of the waveform modelling and geodynamic considerations indicate mass flux of the former oceanic lithosphere and basaltic crust across the 660 km discontinuity, linking processes and structure at the top and bottom of the Earth's mantle, supporting the idea of whole mantle convection.     

Composition and pressure dependence of lattice thermal conductivity of (Mg,Fe)O solid solutions

We measured the lattice thermal conductivities of Fe_0.98O wüstite and iron-rich (Mg,Fe)O magnesiowüstite using the pulsed light heating thermoreflectance technique with a diamond anvil cell up to 61 GPa at 300 K. We found that the thermal conductivity of wüstite does not show a monotonic increase as a function of pressure, contrary to that of MgO periclase. Rocksalt (B1) to rhombohedral B1 transition is likely to induce an abnormal pressure response in the conductivity of wüstite. Our results also show that magnesiowüstite has a lower conductivity than that of MgO and FeO endmembers due to a strong iron impurity effect, which is well reproduced by a model considering phonon-impurity scattering in a binary solid solution.     

Three‐dimensional inversion of towed streamer electromagnetic data

A towed streamer electromagnetic system capable of simultaneous seismic and electromagnetic data acquisition has recently been developed and tested in the North Sea. We introduce a 3D inversion methodology for towed streamer electromagnetic data that includes a moving sensitivity domain. Our implementation is based on the 3D integral equation method for computing responses and Fréchet derivatives and uses the re‐weighted regularized conjugate gradient method for minimizing the objective functional with focusing regularization. We present two model studies relevant to hydrocarbon exploration in the North Sea. First, we demonstrate the ability of a towed electromagnetic system to detect and characterize the Harding field, a medium‐sized North Sea hydrocarbon target. We compare our 3D inversion of towed streamer electromagnetic data with 3D inversion of conventional marine controlled‐source electromagnetic data and observe few differences between the recovered models. Second, we demonstrate the ability of a towed streamer electromagnetic system to detect and characterize the Peon discovery, which is representative of an infrastructure‐led shallow gas play in the North Sea. We also present an actual case study for the 3D inversion of towed streamer electromagnetic data from the Troll field in the North Sea and demonstrate our ability to image all the Troll West Oil and Gas Provinces and the Troll East Gas Province. We conclude that 3D inversion of data from the current generation of towed streamer electromagnetic systems can adequately recover hydrocarbon‐bearing formations to depths of approximately 2 km. We note that by obviating the need for ocean‐bottom receivers, the towed streamer electromagnetic system enables electromagnetic data to be acquired over very large areas in frontier and mature basins for higher acquisition rates and relatively lower cost than conventional marine controlled‐source electromagnetic methods.     

Wax and wane of Chattonella (Raphidophyceae) bloom with special reference to competition between Skeletonema (Bacillariophyceae) in the Ariake Sea, Japan

The raphidophyte Chattonella and the bacillariophyte Skeletonema are representative bloom-causing organisms in the Ariake Sea, Japan. Changes in their abundance were monitored to clarify the role of river discharge in the red tides caused by these organisms in the innermost area of the sea. In late June 2010, heavy rain occurred and subsequently river discharge increased. A Chattonella bloom occurred after heavy rain on July 5, although Chattonella abundance was very low (<1?cell?ml^?1) before the heavy rain (June 29). Maximum cell density reached 4.2?×?10³?cells?ml^?1 at the surface. Thus, the bloom developed as the river plume extended in the estuary. During the course of extension of the river plume, the Chattonella population rapidly developed using the nutrients supplied by the river. Just after the Chattonella bloom, heavy rain occurred again and a very large quantity of river water flowed into the estuary. Consequently, the salinity of the surface decreased to 5 in the study area on July 16. Chattonella did not migrate to the surface probably because of the overlying low-salinity water; Chattonella formed a thin layer (20–50?cm in thickness) at the depth where salinity was 10. However, a Skeletonema population developed at the surface. On July 20, Skeletonema density at the surface exceeded 10⁵?cells?ml^?1. With the decline of the Skeletonema abundance due to the nutrient limitation, Chattonella again formed bloom probably using deep-nutrient pool by their vertical migration behavior. The present study clearly demonstrates that the Chattonella can form dense bloom after the heavy rain. The seed population awaiting the river discharge is probably essential to the rapid development of Chattonella in the estuary.     

Pressure‐temperature history of titanite‐bearing eclogite from the Western Iratsu body,Sanbagawa Metamorphic Belt,Japan

Evidence for eclogite‐facies metamorphism is widespread in the Western Iratsu body of the oceanic subduction type Sanbagawa Belt, Southwest Japan. Previous studies in this region focused on typical mafic eclogites and have revealed the presence of an early epidote‐amphibolite facies metamorphism overprinted by a phase of eclogite facies metamorphism. Ca‐rich and titanite‐bearing eclogite, which probably originated from a mixture of basaltic and calc‐siliceous sediments, is also relatively common in the Western Iratsu body, but there has been no detailed petrological study of this lithology. Detailed petrographic observations reveal the presence of a relic early epidote‐amphibolite facies metamorphism preserved in the cores of garnet and titanite in good agreement with studies of mafic eclogite in the area. Thermobarometric calculations for the eclogitic assemblage garnet + omphacite + epidote + quartz + titanite ± rutile ± phengite give peak‐P of 18.5–20.5 kbar at 525–565°C and subsequent peak‐T conditions of about 635°C at 14–16 kbar. This eclogite metamorphism initiated at about 445°C/11–15 kbar, implying a significantly lower thermal gradient than the earlier epidote‐amphibolite facies metamorphism (～650°C/12 kbar). These results define a P–T path with early counter‐clockwise and later clockwise trajectories. The overall P–T path may be related to two distinct phases in the tectono‐thermal evolution in the Sanbagawa subduction zone. The early counter‐clockwise path may record the inception of subduction. The later clockwise path is compatible with previously reported P–T paths from the other eclogitic bodies in the Sanbagawa Belt and supports the tectonic model that these eclogitic bodies were exhumed as a large‐scale coherent unit shortly before ridge subduction.     

DO-increasing effects of a microscopic bubble generating system in a fish farm

We have developed a "microscopic bubble generating system for the fish farm" and evaluated its ability to improve the quality of seawater and costs of it in marine cages of red sea bream (Pagrus major) in Kusuura Bay, Japan. Our results revealed that DO concentration of bubbling net pens increased and became significantly higher than the level outside the net pen (between 0.52 and 0.87 mg/L), and the whole water column was nearly saturated. Temperatures of the bubbling net pens decreased slightly between 0.08 and 0.12 degrees C in all the layers. Furthermore, micro-bubbles seemed to reach the deeper water due to the downward flow and diffusion. This study demonstrated that the microscopic bubble generating system developed in our research project could increase efficiently the dissolved oxygen concentration throughout all water layers of the fish farm. A capital and operation costs of the system is recoverable within a year.     

Estimation of Oxygen Consumption Rate Using T-DO Diagram in the Benthic Layer of Ohmura Bay, Kyushu, Japan

We have observed the temporal variation of oxygen deficient water with short time scale (less than a few days) in the central area of Ohmura Bay, Kyushu, Japan, in summer, 1995 and 1996. The vertical profiles of temperature were similar to those of dissolved oxygen. We noticed a linear relation between temperature and dissolved oxygen in the bottom layer, and applied the T-DO relation to estimate the net oxygen consumption rate, rather than direct evaluation of the advection and diffusion. Oxygen consumption rate just above the bottom was estimated to be about 0.21 g O₂ m^–3day^–1 in July 1995, and about 0.28 g O₂ m^–3day^–1 in August 1996. The net oxygen consumption rate estimated for the bottom layer below the second thermocline was about 0.61 g O₂ m^–3day^–1 with variability from 0.55 to 0.66 g O₂ m^–3day^–1 during July 25 to 29, 1995. This is was about 0.64 g O₂ m^–3day^–1 with variability from 0.18 to 1.4 g O₂ m^–3day^–1 during August 22 to 30, 1996. The net oxygen consumption rates are about half of those measured with a closed system in the Seto Inland Sea.     

Complex resistivity of mineral rocks in the context of the generalised effective‐medium theory of the induced polarisation effect

This paper develops the generalised effective‐medium theory of induced polarisation for rock models with elliptical grains and applies this theory to studying the complex resistivity of typical mineral rocks. We first demonstrate that the developed generalised effective‐medium theory of induced polarisation model can correctly represent the induced polarisation phenomenon in multiphase artificial rock samples manufactured using pyrite and magnetite particles. We have also collected representative rock samples from the Cu–Au deposit in Mongolia and subjected them to mineralogical analysis using Quantitative Evaluation of Minerals by Scanning Electron Microscopy technology. The electrical properties of the same samples were determined using laboratory complex resistivity measurements. As a result, we have established relationships between the mineral composition of the rocks, determined using Quantitative Evaluation of Minerals by Scanning Electron Microscopy analysis, and the parameters of the generalised effective‐medium theory of induced polarisation model defined from the laboratory measurements of the electrical properties of the rocks. These relationships open the possibility for remote estimation of types of mineralisation and for mineral discrimination using spectral induced polarization data.