中国大陆动力学研究内涵与轨迹的思考

大陆动力学已成为21世纪地球科学研究中的热点和中坚,在它面对当今资源、能源、灾害和环境等社会与经济快速发展需求日益增长的同时,是机遇,却也是挑战.因此厘定其研究的内涵和导向是十分重要的.基于多年的研究实践和探索,本文将对以下五个方面进行讨论:1)大陆动力学研究的内涵与界定;2)大陆动力学研究的导向和轨迹;3)大陆动力学研究中地球物理反演结果和解释中的矛盾;4)强化发展学科交叉以构成交叉科学;5)对2011年大陆动力学委员会学术活动的思考.     

Frequency‐domain acoustic‐elastic coupled waveform inversion using the Gauss‐Newton conjugate gradient method

We developed a frequency‐domain acoustic‐elastic coupled waveform inversion based on the Gauss‐Newton conjugate gradient method. Despite the use of a high‐performance computer system and a state‐of‐the‐art parallel computation algorithm, it remained computationally prohibitive to calculate the approximate Hessian explicitly for a large‐scale inverse problem. Therefore, we adopted the conjugate gradient least‐squares algorithm, which is frequently used for geophysical inverse problems, to implement the Gauss‐Newton method so that the approximate Hessian is calculated implicitly. Thus, there was no need to store the Hessian matrix. By simultaneously back‐propagating multi‐components consisting of the pressure and displacements, we could efficiently extract information on the subsurface structures. To verify our algorithm, we applied it to synthetic data sets generated from the Marmousi‐2 model and the modified SEG/EAGE salt model. We also extended our algorithm to the ocean‐bottom cable environment and verified it using ocean‐bottom cable data generated from the Marmousi‐2 model. With the assumption of a hard seafloor, we recovered both the P‐wave velocity of complicated subsurface structures as well as the S‐wave velocity. Although the inversion of the S‐wave velocity is not feasible for the high Poisson's ratios used to simulate a soft seafloor, several strategies exist to treat this problem. Our example using multi‐component data showed some promise in mitigating the soft seafloor effect. However, this issue still remains open.     

On the computation of the electrical potential inside a horizontally‐layered half‐space

A new formulation is proposed for the electrical potential developed inside a horizontally‐layered half‐space for a direct current point‐source at the surface. The recursion formula for the kernel coefficient in the potential integral is simpler than the generally used two‐coefficient recursion. The numerical difficulties that may occur during the computation of the integrals and near the source axis are examined and solutions are proposed. The set of equations permits a stable and accurate computation of the tabular potential everywhere in the medium.     

Nonlinear earthquake analysis of high arch dam–water–foundation rock systems

A nonlinear finite element model for earthquake response analysis of arch dam–water–foundation rock systems is proposed in this paper. The model includes dynamic dam–water and dam–foundation rock interactions, the opening of contraction joints, the radiation damping of semi‐unbounded foundation rock, the compressibility of impounded water, and the upstream energy propagating along the semi‐unbounded reservoir. Meanwhile, a new equivalent force scheme is suggested to achieve free‐field input in the model. The effects of the earthquake input mechanism, joint opening, water compressibility, and radiation damping on the earthquake response of the Ertan arch dam (240 m high) in China are investigated using the proposed model. The results show that these factors significantly affect the earthquake response of the Ertan arch dam. Such factors should therefore be considered in the earthquake response analysis and earthquake safety evaluation of high arch dams. Copyright © 2011 John Wiley & Sons, Ltd.     

Seismic isolation for low‐to‐medium‐rise buildings using granulated rubber–soil mixtures: numerical study

This paper presents the preliminary research works on a potential seismic isolation method that makes use of scrap rubber tires for the protection of low‐to‐medium‐rise buildings. The method involves mixing shredded rubber tire particles with soil materials and placing the mixtures around building foundations, which provides a function similar to that of a cushion. Meanwhile, the stockpiling of scrap tires is a significant threat to our environment, and the engineering community has been looking for long‐term viable solutions to the recycling and reuse of rubber. A finite element program has been developed for modeling the time‐domain dynamic responses of soil–foundation–structure system, by which the effectiveness and robustness of the proposed method have been evaluated. In general, the structural responses, in terms of acceleration and inter‐story drift, can be reduced by 40–60%. Copyright © 2012 John Wiley & Sons, Ltd.     

Fragility analysis of low‐rise masonry in‐filled reinforced concrete buildings by a coefficient‐based spectral acceleration method

This study presents a seismic fragility analysis of low‐rise masonry in‐filled (MI) reinforced concrete (RC) buildings using a proposed coefficient‐based spectral acceleration method. The coefficient‐based method, without requiring any complicated finite element analysis, is a simplified procedure for assessing the spectral acceleration demand (or capacity) of buildings subjected to earthquakes. This paper begins with a calibration of the proposed coefficient‐based method for low‐rise MI RC buildings using published experimental results obtained from shaking table tests. Spectral acceleration‐based fragility curves for low‐rise MI RC buildings under various inter‐story drift limits are then constructed using the calibrated coefficient‐based method. A comparison of the experimental and estimated results indicates that the simplified coefficient‐based method can provide good approximations of the spectral accelerations at peak loads of low‐rise MI RC buildings, if a proper set of drift‐related factors and initial fundamental periods of structures are used. Moreover, the fragility curves constructed using the coefficient‐based method can provide a satisfactory vulnerability evaluation for low‐rise MI RC buildings under a given performance level. Copyright © 2011 John Wiley & Sons, Ltd.     

Inelastic displacement demands in steel structures and their relationship with earthquake frequency content parameters

This paper deals with the estimation of peak inelastic displacements of SDOF systems, representative of typical steel structures, under constant relative strength scenarios. Mean inelastic deformation demands on bilinear systems (simulating moment resisting frames) are considered as the basis for comparative purposes. Additional SDOF models representing partially‐restrained and concentrically‐braced (CB) frames are introduced and employed to assess the influence of different force‐displacement relationships on peak inelastic displacement ratios. The studies presented in this paper illustrate that the ratio between the overall yield strength and the strength during pinching intervals is the main factor governing the inelastic deformations of partially‐restrained models and leading to significant differences when compared with predictions based on bilinear structures, especially in the short‐period range. It is also shown that the response of CB systems can differ significantly from other pinching models when subjected to low or moderate levels of seismic demand, highlighting the necessity of employing dedicated models for studying the response of CB structures. Particular attention is also given to the influence of a number of scalar parameters that characterise the frequency content of the ground motion on the estimated peak displacement ratios. The relative merits of using the average spectral period T_aver, mean period T_m, predominant period T_g, characteristic period T_c and smoothed spectral predominant period T_o of the earthquake ground motion, are assessed. This paper demonstrates that the predominant period, defined as the period at which the input energy is maximum throughout the period range, is the most suitable frequency content scalar parameter for reducing the variability in displacement estimations. Finally, noniterative equivalent linearisation expressions based on the secant period and equivalent damping ratios are presented and verified for the prediction of peak deformation demands in steel structures. Copyright © 2011 John Wiley & Sons, Ltd.     

Characteristics of concentrated flow hydraulics for rangeland ecosystems: implications for hydrologic modeling

Concentrated flow is often the dominant source of water erosion following disturbance on rangelands. Because of the lack of studies that explain the hydraulics of concentrated flow on rangelands, cropland‐based equations have typically been used for rangeland hydrology and erosion modeling, leading to less accurate predictions due to different soil and vegetation cover characteristics. This study investigates the hydraulics of concentrated flow using unconfined field experimental data over diverse rangeland landscapes within the Great Basin Region, United States. The results imply that the overall hydraulics of concentrated flow on rangelands differ significantly from those of cropland rills. Concentrated flow hydraulics on rangelands are largely controlled by the amount of cover or bare soil and hillslope angle. New predictive equations for concentrated flow velocity (R² = 0·47), hydraulic friction (R² = 0·52), and width (R² = 0·4) representing a diverse set of rangeland environments were developed. The resulting equations are applicable across a wide span of ecological sites, soils, slopes, and vegetation and ground cover conditions and can be used by physically‐based rangeland hydrology and erosion models to estimate rangeland concentrated flow hydraulic parameters. Published in 2011. This article is a US Government work and is in the public domain in the USA.     

Topographic predictors of susceptibility to alluvial fan flooding,Southern Apennines

The flooding susceptibility of alluvial fans in the Southern Apennines has long been neglected. To partly address this oversight, we focus on the region of Campania which contains highly urbanized piedmont areas particularly vulnerable to flooding. Our findings are based on stratigraphic analysis of the fans and morphometric analysis of the basin‐fan systems. Using geomorphological analysis we recognized active alluvial fans while stratigraphic analysis together with statistical analysis of the morphometric variables was used to classify the fans in terms of the transport process involved. The results indicate that in the geological context examined, the best discrimination between debris flow (Df) and water flood (Wf) processes is achieved by means of two related variables, one for the basin (feeder channel inclination, Cg) and one for the fan (fan length, Fl). The probability that an unclassified fan belongs to group Wf is computed by applying a logistic function in which a P value exceeding 0.5 indicates that a basin/fan system belongs to group Wf. This important result led to the classification of the entire basin/fan system data. As regards process intensity, debris flow‐dominated fans are susceptible to the occurrence of flows with high viscosity and hence subject to more severe events than water flood‐dominated fans. Bearing this in mind, the data gathered in this study allow us to detect where alluvial fan flooding might occur and give information on the different degrees of susceptibility at a regional scale. Regrettably, urban development in recent decades has failed to take the presence of such alluvial fans into account due to the long recurrence time (50–100 years) between floods. This paper outlines the distribution of such susceptibility scenarios throughout the region, thereby constituting an initial step to implementing alluvial fan flooding control and mitigation. Copyright © 2012 John Wiley & Sons, Ltd.     

Environmental change,hydromorphological reference conditions and the restoration of Polish Carpathian rivers

In the twentieth century Polish Carpathian rivers were considerably modified by channelization and gravel mining, with significant detrimental effects to their ecological integrity, vertical stability of the streambeds and flood hazard to downstream river reaches. Restoration of the rivers is thus necessary to improve their ecological status and re‐establish geomorphic dynamic equilibrium conditions. Various approaches to defining hydromorphological reference conditions, proposed to date in river restoration literature, have serious deficiencies. In particular, environmental changes that took place in the catchments of Carpathian rivers during the twentieth century invalidate the historical state of the rivers as reference for their restoration. This is illustrated by a change from bar‐braided to island‐braided channel pattern that occurred in the past century in unmanaged sections of the Czarny Dunajec in response to a reduction in flow and sediment dynamics of the river. We indicate that reference conditions should be defined as those which exist or would exist under present environmental conditions in the catchment but without human influence on the channel, riparian zone and floodplain of the river which is to be restored. This assumption was tested through the evaluation of hydromorphological river quality of the Czarny Dunajec according to the European Standard EN‐14614. The evaluation confirmed a high‐status hydromorphological quality in an unmanaged channel section, which can thus be used as a reference for restoration of impacted river sections. Copyright © 2012 John Wiley & Sons, Ltd.