Numerical models of subduction and forearc deformation

Summary. Finite element models for shallow subduction produce realistic behaviour for a wide variety of mechanical strength and density distributions. Characteristic displacements are found to occur even without a discrete low-strength megathrust if there is a high-density subducted plate to localize lithospheric compression. A high-density plate is itself unnecessary in the presence of a low-strength megathrust and regional compression.
Successful finite element models produce an outer arc at the top of the trench slope, and forearc basin with geometry characteristic of natural analogues. These structural features occur by upward inelastic bending of the lithospheric wedge overlying the megathrust. This mechanically unstable behaviour may dissipate significant energy and cause the megathrust to migrate continuously by accretion, tectonic erosion, or abandonment and reinitiation farther offshore. Upward bending in the overriding plate is promoted by low megathrust dip, low megathrust shear strength, and high horizontal compression in the overriding plate.     

Multiple longshore sand bars in the upper Chesapeake Bay

In the upper Chesapeake Bay (Maryland, U.S.A.) field surveys were conducted at 18 multiple longshore sand bar sites. The multiple bar systems were found in water depths less than approximately 2 m (mean sea level), and exhibited mild bottom slopes of 0·0052 or less. The number of bars composing each system ranged from four to 17 and the spacing between the crests typically increased in the offshore direction, ranging from 12 to 70 m. Bar height also typically increased with distance offshore and ranged from 0·03 to 0·61 m. A grain size analysis of crest and trough sediment did not reveal any significant differences and the sediment was categorized as ‘fine sand’. A review of the literature data indicated that the Chesapeake Bay multiple bars possessed similar characteristics to those found in Gelding Bay (Baltic Sea); similarities in fetch, wave height and tidal range between the two bays may account for this finding. The surf-scaling parameter indicated that the multiple bar systems were extremely dissipative with regard to wave energy, and wave height appeared to be an important factor in controlling bar spacing and bar height. A multiple wave break point hypothesis was discussed as a possible mechanism for the formation of Chesapeake Bay multiple longshore bars, and limited observational evidence appeared to support such a mechanism.     

THE BLOOMINGTON (LL6) CHONDRITE AND ITS SHOCK MELT GLASSES

The Bloomington meteorite, a 67.8 gram veined, brecciated chondrite, fell during the summer of 1938 in Bloomington, Illinois. Its olivine, orthopyroxene and metal compositions (fo₆₉, en₇₄ and Fe₅₂ Ni₄₈ respectively) and its texture identify it as a brecciated LL6 chondrite of shock facies d. Shock melt glasses occur in Bloomington as sparse melt pockets and veins in clasts and as isolated masses in the black, clast-rich matrix. The vein glasses chemically resemble bulk LL-group chondrites and thus appear to reflect total melting of the host meteorite. The melt pocket and matrix glasses, like those described previously in L-group chondrites, have more varied compositions and are typically enriched in normative plagioclase. All glasses that we analyzed in Bloomington have FeO/MgO and Na/Al ratios similar to those of LL-group chondrites, indicating that melting of this meteorite involved neither a significant change in the oxidation state of iron nor loss of sodium to a vapor phase. Bloomington is a monomict breccia whose components formed in place as a result of a single episode of shock and attendant melting.     

A critical state model for sands dependent on stress and density

An elastoplastic model for sands is presented in this paper, which can describe stress–strain behaviour dependent on mean effective stress level and void ratio. The main features of the proposed model are: (a) a new state parameter, which is dependent on the initial void ratio and initial mean stress, is proposed and applied to the yield function in order to predict the plastic deformation for very loose sands; and (b) another new state parameter, which is used to determine the peak strength and describe the critical state behaviour of sands during shearing, is proposed in order to predict simply negative/positive dilatancy and the hardening/softening behaviour of medium or dense sands. In addition, the proposed model can also predict the stress–strain behaviour of sands under three-dimensional stress conditions by using a transformed stress tensor instead of ordinary stress tensor. Copyright © 2004 John Wiley & Sons, Ltd.     

Porphyroblast inclusion-trail orientation data: eppure non son girate*!

Extensive examination of large numbers of spatially orientated thin sections of orientated samples from orogens of all ages around the world has demonstrated that porphyroblasts do not rotate relative to geographical coordinates during highly non-coaxial ductile deformation of the matrix subsequent to their growth. This has been demonstrated for all tectonic environments so far investigated. The work also has provided new insights and data on metamorphic, structural and tectonic processes including: (1) the intimate control of deformation partitioning on metamorphic reactions; (2) solutions to the lack of correlation between lineations that indicate the direction of movement within thrusts and shear zones, and relative plate motion; and (3) a possible technique for determining the direction of relative plate motion that caused orogenesis in ancient orogens.     

Simulation of adaptive optics for the Vacuum Tower Telescope

A simulation model of the adaptive optics of the German Vacuum Tower Telescope (VTT), Observatorio del Teide, Tenerife, is presented. The model uses modules from the integrated model of the Euro50 extremely large telescope, and includes submodels of a Shack-Hartmann wavefront sensor, a de-formable mirror, a tip-tilt mirror, high-voltage amplifier low-pass filters, a reconstructor and a controller. We investigate the impact on the closed loop bandwidth of changes in controller configuration and certain system parameters, such as low pass filter bandwidth and camera integration and readout time. Control strategies were tested on simple models before implementation on the full VTT model. Using the models, different control strategies are compared.     

Formation of galactic subsystems in light of the magnesium abundance in field stars: The thin disk

Data from our compiled catalog of spectroscopically determined magnesium abundances in stars with accurate parallaxes are used to select thin-disk dwarfs and subgiants according to kinematic criteria. We analyze the relations between the relative magnesium abundances in stars, [Mg/Fe], and their metallicities, Galactic orbital elements, and ages. The [Mg/Fe] ratios in the thin disk at any metallicity in the range ?1.0 dex <[Fe/H] < ?0.4 dex are shown to be smaller than those in the thick disk, implying that the thin-disk stars are, on average, younger than the thick-disk stars. The relative magnesium abundances in such metal-poor thin-disk stars have been found to systematically decrease with increasing stellar orbital radii in such a way that magnesium overabundances ([Mg/Fe] > 0.2 dex) are essentially observed only in the stars whose orbits lie almost entirely within the solar circle. At the same time, the range of metallicities in magnesium-poor stars is displaced from ?0.5 dex < [Fe/H] < +0.3 dex to ?0.7 dex < [Fe/H] < +0.2 dex as their orbital radii increase. This behavior suggests that, first, the star formation rate decreases with increasing Galactocentric distance and, second, there was no star formation for some time outside the solar circle, while this process was continuous within the solar circle. The decrease in the star formation rate with increasing Galactocentric distance is responsible for the existence of a negative radial metallicity gradient (grad _R[Fe/H] = ?0.05 ± 0.01 kpc^?1) in the disk, which shows a tendency to increase with decreasing age. At the same time, the relative magnesium abundance exhibits no radial gradient. We have confirmed the existence of a steep negative vertical metallicity gradient (grad _Z[Fe/H] = ?0.29 ± 0.06 kpc^?1) and detected a significant positive vertical gradient in relative magnesium abundance (grad _Z[Mg/Fe] = 0.13 ± 0.02 kpc^?1); both gradients increase appreciably in absolute value with decreasing age. We have found that there is not only an age-metallicity relation, but also an age-magnesium abundance relation, in the thin disk. We surmise that the thin disk has a multicomponent structure, but the existence of a negative trend in the star formation rate along the Galactocentric radius does not allow the stars of its various components to be identified in the immediate solar neighborhood.     

The Siberian Solar Radio Telescope: the current state of the instrument,observations, and data

The Siberian Solar Radio Telescope (SSRT) is one of the world's largest solar radio heliographs. It commenced operation in 1983, and since then has undergone several upgrades. The operating frequency of the SSRT is 5.7 GHz. Since 1992 the instrument has had the capability to make one-dimensional scans with a high time resolution of 56 ms and an angular resolution of 15 arc sec. Making one of these scans now takes 14 ms. In 1996 the capability was added to make full, two-dimensional images of the solar disk. The SSRT is now capable of obtaining images with an angular resolution of 21 arc sec every 2 min. In this paper we describe the main features and operation of the instrument, particularly emphasizing issues pertaining to the imaging process and factors limiting data quality. Some of the data processing and analysis techniques are discussed. We present examples of full-disk solar images of the quiet Sun, recorded near solar activity minimum, and images of specific structures: plages, coronal bright points, filaments and prominences, and coronal holes. We also present some observations of dynamic phenomena, such as eruptive prominences and solar flares, which illustrate the high-time-resolution observations that can be done with this instrument. We compare SSRT observations at 5.7 GHz, including computed `light curves', both morphologically and quantatively, with observations made in other spectral domains, such as 17 GHz radio images, Hα filtergrams and magnetograms, extreme-ultraviolet and X-ray observations, and dynamic radio spectra.     

A Quantitative Method to Optimise Magnetic Field Line Fitting of Observed Coronal Loops

Many authors use magnetic-field models to extrapolate the field in the solar corona from magnetic data in the photosphere. The accuracy of such extrapolations is usually judged qualitatively by eye, where a less judgemental quantitative approach would be more desirable. In this paper, a robust method for obtaining the best fit between a theoretical magnetic field and intensity observations of coronal loops on the solar disk will be presented. The method will be applied to Yohkoh data using a linear force-free field as an illustration. Any other theoretical model for the magnetic field can be used, provided there is enough freedom in the model to optimize the fit.