Rock magnetic records of the sediments of the eastern Arabian Sea: Evidence for late Quaternary climatic change

Rock-magnetic measurements along with grain size, acid-insoluble residue (AIR), organic carbon (OC), CaCO₃ and δ¹⁸O of the planktonic foraminifers of the sediments were determined for 15 gravity cores recovered from the western continental margin of India. Magnetic susceptibility (MS) values in the surficial sediments reflect the land-derived input and, in general, are the highest in terrigenous sediment-dominated sections of the cores off Saurashtra–Ratnagiri, followed by the sediments off Indus–Gulf of Kachchh and then Mangalore–Cape Comorin.

The down-core variations in mineral magnetic parameters reveal that the glacial sediments off the Indus are characterized by low MS values/S-ratios associated with high AIR-content, low OC/CaCO₃ contents and relatively high δ¹⁸O values, while those off SW India are characterized by low MS values/high S-ratio% associated with low AIR content, and relatively high OC, CaCO₃ and δ¹⁸O values. Conversely, the Early Holocene sediments of all cores are characterized by high MS values/S-ratio% associated with high AIR content, low OC, CaCO₃ contents and gradually decreased δ¹⁸O values. These results imply that during the Last Glacial Maximum (LGM), the cores off northwestern India received abundant continental supply leading to the predominance of eolian/fluvial sedimentation. In the SW region the influence of hinterland flux is less evident during this period, but convective mixing associated with the NE monsoon resulted in increased productivity. During the early Holocene intense SW monsoon conditions resulted in high precipitation on land, which in turn contributed increased AIR content/MS values in the continental margin sediments. A shallow water core off Kochi further suggests that the intense SW monsoon conditions prevailed until about 5 ka. The late Holocene organic-rich sediments of the SW margin of India were, however, subjected to early diagenesis at different intervals in the cores. Therefore, caution is needed when interpreting regional climatic change from down-core changes in sediment magnetic properties.     

Numerical and experimental study on hydrodynamic interaction of side-by-side moored multiple vessels

This paper aims to investigate the basic interaction characteristics of side-by-side moored vessels both numerically and experimentally. A higher-order boundary element method (HOBEM) combined with generalized mode approach is applied to analysis of motion and drift force of side-by-side moored multiple vessels (LNG FPSO, LNGC and shuttle tankers). Model tests were carried out for the same floating bodies investigated in the numerical study in regular and irregular waves. Global and local motion responses and drift forces of three vessels are compared with those of calculations. Discussions is highlighted on applicability of numerical method to prediction of sophisticated multi-body interaction problem of which motion behavior is very important to analysis of mooring dynamics of deep sea floating bodies.     

Developing a Marine Information System by Integrating Existing Ocean Models Using Object-Oriented Technology

Information systems developed for different applications within the environmental domain have common characteristics, which can potentially be abstracted for sharing and reuse of design and software modules. This article presents an approach to designing for reuse by abstracting commonalities in the design of a Marine Information System (MIS), facilitating data management in a prototype operational monitoring, forecasting, and management system for the North Atlantic and the Nordic Seas. A detailed study of the requirements and data analysis was carried out, and Object-Oriented Technology (OOT) is employed to encapsulate abstractions and to promote reuse of code and design. This article identifies the Object-Oriented Frameworks (OOFW) required to build the MIS. It also provides guidelines to environmental scientists for restructuring legacy software and employing modern programming techniques.     

Steady-state analysis of undersea cables

A numerical solution and computer program developed to analyse undersea flexible cable problems is presented. The cable is subject to hydrodynamic loads from a surrounding fluid medium. The object is to determine the cable profile and tensile forces developed. The cable equations and boundary conditions result in a classical two-point boundary value problem. An iteration ‘shooting method’ is used for solution. The program has been written to analyse a class of towing and anchoring problems. However the analysis is general and applicable to most steady-state cable problems.     

Imaging of Buried Archaeological Materials: The Reflection Properties of Archaeological Wood

Effective marine archaeological site management demands detailed information on not only the spatial distribution of artefacts but also the degradation state of the materials present. Although sonar methods have frequently been used in an attempt to detect buried wooden shipwrecks they are currently unable to indicate their degradation state. To assess the sensitivity of acoustic measurements to changes in the degradation state of such material, and hence the potential for sonars to quantify degradation, laboratory measurements of compressional wave velocity, as well as bulk density for oak and pine samples, in varying states of decay, were undertaken. These data enabled the calculation of theoretical reflection coefficients for such materials buried in various marine sediments. As wood degrades, the reflection coefficients become more negative, resulting in the hypothesis that the more degraded wood becomes, the easier it should be to detect. Typical reflection coefficients of the order of −0.43 and −0.52 for the most degraded oak and pine samples in sand are predicted. Conversely, for wood exposed to seawater the predicted reflection coefficients are large and positive for undegraded material (0.35 for oak, 0.18 for pine) and decrease to zero or slightly below for the most degraded samples. This indicates that exposed timbers, when heavily degraded, can be acoustically transparent and so undetectable by acoustic methods. Corroboration of these experimental results was provided through comparison with high resolution seismic reflection data that has been acquired over two shipwrecks.     

Management of a shallow temperate estuary to control eutrophication: The effect of hydrodynamics on the system’s nutrient loading

The Mondego estuary, a shallow warm-temperate intertidal system located on the west coast of Portugal, has for some decades been under severe ecological stress, mainly caused by eutrophication. Water circulation in this system was, until 1998, mainly dependent on tides and on the freshwater input of a small tributary artificially controlled by a sluice. After 1998, the sluice opening was effectively minimised to reduce the nutrient loading, and the system hydrodynamics improved due to engineering work in the upstream areas. The objective of the present study was to evaluate the effect of the mitigation measures implemented in 1998. Changes to the hydrodynamics of the system were assessed using precipitation and salinity data in relation to the concentrations of dissolved inorganic nutrients, as well as the linkage between dissolved N:P ratios and the biological parameters (phytoplankton chlorophyll a concentrations, green macroalgal biomass and seagrass biomass). Two distinctive periods were compared, over a ten year period: from January 1993 to January 1997 and from January 1999 until January 2003. The effective reduction in the dissolved N:P atomic ratio from 37.7 to 13.2 after 1998 is a result of lowered ammonia, but not the oxidised forms of nitrogen (nitrate plus nitrite), or increased concentrations of dissolved inorganic phosphorus. Results suggest that the phytoplankton is not nutrient limited, yet maximum and mean biomass of green macroalgae was reduced by one order of magnitude after the mitigation measures. This suggests that besides lowering the water residence time of the system, macroalgal growth became nitrogen limited. In parallel to these changes the seagrass-covered area and biomass of Zostera noltii showed signs of recovery.     

Longitudinal strength of a high-speed ferry

The longitudinal strength of the high-speed ferry was investigated by subjecting the ship's hull girder to long-term loads obtained from a frequency-domain panel code. Prior to the statistical analysis, linearly computed transfer functions were corrected for nonlinear effects, yielding two sets of transfer functions valid for different wave amplitudes. One set corresponded to the hogging condition; the other set, to the sagging condition. Two regular equivalent design waves were specified that resulted in loads representing the most severe global design load conditions. The still-water loading condition, yielding a still-water vertical bending moment in hogging, was superimposed on the wave-induced loads to obtain the total (design) loads in hogging. For the sagging condition only, additional impact-related loads were superimposed to obtain the total (design) loads in sagging. A finite element model of the ship's structure was subjected to pressure distributions according to the two regular design waves. For comparison with classification society rule values, a simple beam theory strength analysis of the ship's midship section was performed first, and then another finite element analysis was carried out, whereby the imposed loads were tuned to the rule values of vertical bending moments. Rule-based magnitudes of nominal maximum longitudinal stress deviated significantly (25–39%) from comparable stresses obtained by the panel code based finite element analysis. However, stresses obtained from the rule-based finite element analysis agreed more favorably, especially in hogging. In the uppermost deck, for example, the panel code based compressive stress was only 9% larger than the comparable stress from the rule-based finite element analysis.     

The Dynamics of Covering Behaviour in Dominant Echinoid Populations from American and European West Coasts

Abstract.  The so-called 'covering behaviour' of echinoids is known to vary with habitat according to the types of covering items available, but the full extent of the role played by habitat characteristics in this behaviour is not known. Moreover, whether or not different species inhabiting similar environmental conditions and habitats also show similar patterns of this particular behaviour has yet to be investigated. In this study, two prominent west coast echinoid species, Paracentrotus lividus and Strongylocentrotus purpuratus , were examined with respect to covering behaviour and spatial organisation. Populations of both species are found in exposed intertidal zones, occupying boreholes within tidepools. Important similarities were found in the spatial organisation of both species' populations, with lowest densities in upper shore pools. However, the size distributions of the two populations differed significantly; P. lividus within upper shore pools were significantly larger than those in mid or lower shore pools, whereas S. purpuratus on the lower shore were significantly larger than those at other shore heights. We found significant between-species variability in covering item use, although the number of covering items available at both sites was not significantly different. For example, greater densities of covering items were used by P. lividus than by S. purpuratus . We also found that the percent of echinoid surface area covered varied significantly in space for both species. These data emphasise the complex and multifaceted nature of covering behaviour, but most importantly, they also strongly suggest that habitat characteristics can only partly explain the extent of this behavioural variability amongst echinoid species.