Monitoring volcanic hazard using eddy covariance at Solfatara volcano, Naples, Italy

An eddy covariance (EC) station was deployed at Solfatara crater, Italy, June 8–25, 2001 to assess if EC could reliably monitor CO₂ fluxes continuously at this site. Deployment at six different locations within the crater allowed areas of focused gas venting to be variably included in the measured flux. Turbulent (EC) fluxes calculated in 30-min averages varied between 950 and 4460 g CO₂ m⁻² d⁻¹; the highest measurements were made downwind of degassing pools. Comparing turbulent fluxes with chamber measurements of surface fluxes using footprint models in diffuse degassing regions yielded an average difference of 0% (±4%), indicating that EC measurements are representative of surface fluxes at this volcanic site. Similar comparisons made downwind of degassing pools yielded emission rates from 12 to 27 t CO₂ d⁻¹ for these features. Reliable EC measurements (i.e. measurements with sufficient and stationary turbulence) were obtained primarily during daytime hours (08:00 and 20:00 local time) when the wind speed exceeded 2 m s⁻¹. Daily average EC fluxes varied by ±50% and variations were likely correlated to changes in atmospheric pressure. Variations in CO₂ emissions due to volcanic processes at depth would have to be on the same order of magnitude as the measured diurnal variability in order to be useful in predicting volcanic hazard. First-order models of magma emplacement suggest that emissions could exceed this rate for reasonable assumptions of magma movement. EC therefore provides a useful method of monitoring volcanic hazard at Solfatara. Further, EC can monitor significantly larger areas than can be monitored by previous methods.     

Hydrogeological Zoning of the Central Minusinsk Basin by the Conditions of Formation of Fresh Groundwater Resources

A detailed hydrogeological zoning of the central part of the Minusinsk artesian basin is performed. Local basins confined to smaller plicated structures, as well as hydrogeological massifs of local scale, are recognized within large block structures. Direction of subsurface streams and their role in the formation of groundwater resources and composition are discussed. Forecast resources of fresh groundwater are estimated for every recognized structure.     

Effect of Sliding Rate on the Activity of Acoustic Emission During Stable Sliding

--The mechanical and statistical characteristics of acoustic emission (AE) events during stable sliding are investigated through a laboratory experiment using a granite specimen with a pre-cut fault. Numerous AE events are found to be generated on the pre-cut fault, indicating that microscopically unstable fracture occurs during macroscopically stable sliding. The composite focal mechanism solution of AE events is determined from the first motion directions of P-waves. The determined mechanism is consistent with the double-couple one expected for the slip on the pre-cut fault. The source radii of large AE events are estimated to be about 10 mm from the widths of the first P-wave pulses. These indicate that the AE events are generated by shear fracture whose faulting area is a part of the pre-cut fault plane. The occurrence of AE events as a stochastic process approximately obeys the Poisson process, if the effect of mutually dependent events consti tuting clusters is corrected. The observed amplitude-frequency relation of AE events approximately follows a power law for a limited amplitude range. As the macroscopic sliding rate increases, the number of AE events per unit sliding distance decreases. This rate dependence of the AE activity is qualitatively consistent with the observation that the real area of contact between sliding surfaces decreases with an increase in the sliding rate as reported in the literature.     

Modeling Lake Ladoga Zoobenthos and Studying Its Role in Phosphorus Exchange at the Water–Bed Interface

A zoobenthos submodel is included in an ecosystem model. The new model is used to assess the role of zoobenthos in the phosphorus exchange at the water–bed interface, in particular, the phosphorus cycle in the water body ecosystem is described more accurately. The calculated zoobenthos distribution over the bed of a lake can be used in modeling the lake ichthyocenoses.     

Extracting flow structures from tracer data

A method of visualizing structures in closed chaotic flows out of homogenous particle distributions is presented in the example of models of a meandering jet. To this end, the system will be leaked or opened up by defining a region of the flow, so that a particle is considered to be escaped if it leaves this region. By applying this method to an ensemble of nonescaped tracers, we are able to characterize mixing processes by visualizing the converging and stretching filamentations (stable and unstable manifolds) in the flow without using additional mathematical tools. The possibility of applying the algorithm to analyze buoy data, and a comparison with the finite time manifolds are discussed.     

Modelling of oxygen and nitrogen cycling as a function of macrophyte community in the Thau lagoon

A three-dimensional model coupling physical and biological processes for the whole Thau lagoon (Mediterranean coast of France) was developed in order to assess the relationships between macrophytes and the oxygen and nitrogen cycles. Ten species have been inserted as forcing variables in the model. Plankton dynamics, shellfish cultivation impact and mineralization of organic matter are also considered, as well as nutrient and oxygen exchanges between the sediment and the water column.Simulations with and without the macrophytes have shown that the system can be characterized as having a highly structured pattern involving lagoon nitrogen and oxygen cycles. This pattern is created by the combined influence of macrophytes, watershed and oyster farming.The model has been also used to assess the total annual macrophyte production at the whole lagoon scale. Comparisons with phytoplankton production and with results from other temperate lagoons have underlined the high productivity of the Thau lagoon supported by active nutrient regeneration.     

Tensor time domain electromagnetic resistivity measurements at Ngatamariki geothermal field, New Zealand

Experimental measurements in the Ngatamariki geothermal field, North Island, New Zealand were made to test the applicability of the time domain electromagnetic method for detailed investigation of the resistivity structure within a geothermal field. Low-frequency square wave signals were transmitted through three grounded bipole current sources sited about 8 km from the measurement lines. Despite high levels of electrical noise, transient electric field vectors could be determined reliably for times between 0.02 and 3.3 s after each step in the source current. Instantaneous apparent resistivity tensors were then calculated. Apparent resistivity pseudosections along the two measurement lines show smooth variations of resistivity from site to site. Over most of the field the images consistently show a three-layer resistivity structure with a conductive middle layer (3–10 Ωm) representing the conductive upper part of the thermal reservoir. A deep-seated region of low resistivity in the northwest of the field may indicate a conductive structure at about 1 km associated with a deeper diorite intrusion. Measurements sited closer than about 100 m to drillholes appear to have been disturbed by metallic casing in the holes. A change in resistivity structure in the east of the field may indicate a major geological or hydrothermal boundary.     

Failure Mode and Spatial Distribution of Damage in Rothbach Sandstone in the Brittle-ductile Transition

— To elucidate the spatial complexity of damage and evolution of localized failure in the transitional regime from brittle faulting to cataclastic ductile flow in a porous sandstone, we performed a series of triaxial compression experiments on Rothbach sandstone (20% porosity). Quantitative microstructural analysis and X-ray computed tomography (CT) imaging were conducted on deformed samples. Localized failure was observed in samples at effective pressures ranging from 5 MPa to 130 MPa. In the brittle faulting regime, dilating shear bands were observed. The CT images and stereological measurements reveal the geometric complexity and spatial heterogeneity of damage in the failed samples. In the transitional regime (at effective pressures between 45 MPa and 130 MPa), compacting shear bands at high angles and compaction bands perpendicular to the maximum compression direction were observed. The laboratory results suggest that these complex localized features can be pervasive in sandstone formations, not just limited to the very porous aeolian sandstone in which they were first documented. The microstructural observations are in qualitative agreement with theoretical predictions of bifurcation analyses, except for the occurrence of compaction bands in the sample deformed at effective pressure of 130 MPa. The bifurcation analysis with the constitutive model used in this paper is nonadequate to predict compaction band formation, may be due to the neglect of bedding anisotropy of the rock and multiple yield mechanisms in the constitutive model.     

Characterisation of the 1997 Vulcanian explosions of Soufrière Hills Volcano,Montserrat, by video analysis

The activity of Convention at Montserrat Soufrière Hills Volcano, Montserrat, during the period 1995–1999 included numerous violent explosions. Two major cycles of Vulcanian explosions occurred in 1997: a first of 13 explosions between 4 and 12 August and a second of 75 between 22 September and 21 October. The explosions were short-lived events lasting a few tens of seconds during which partial fountain collapse generated pyroclastic surges and pyroclastic flows, and buoyant plumes ascended 3–15 km into the atmosphere. Each explosion discharged on average 3×10⁵ m³ (dense-rock equivalent, DRE) of magma, draining the conduit to depths of 1–2 km. The paper focuses on the first few seconds of three explosions of the 75 that occurred in September/October 1997: 6 October 1997 at 17:50, 7 October 1997 at 16:02 and 9 October 1997 at 12:32. Physical parameters such as exit velocities, magmatic water contents and magma pressures at fragmentation are estimated by following and modelling the ascent of individual momentum-dominated finger jets visible on videos during the initial stages of each explosion. The model treats each finger jet as an incompressible flow sustained by a steady flux of gas and particles during the few seconds of ascent, and produces results that compare favourably with those using a multiphase compressible code run using similar eruptive parameters. Each explosion reveals a progressive increase in eruptive intensity with time, jet exit velocities increasing from 40 m s^–1 at the beginning of the explosion up to 140 m s^–1 after a few seconds. Modelling suggests that the first magma to exit was largely degassed, whereas that discharged after a few seconds contained up to 2 wt% water. Magma overpressures up to ~10 MPa are estimated to have existed in the conduit immediately prior to each explosion. Progressive increases in jet exit velocity with time over the first few seconds of each explosion provide direct evidence for strong pre-eruptive gradients in water content and magma pressure in the upper reaches (probably 100–500 m) of the conduit. Fountain collapse occurred during the first 10–20 s of each explosion because the discharging jets had bulk densities up to 100 times that of the atmosphere and were unable to entrain enough air to become buoyant. Such high eruptive densities were due to the presence of partially degassed magma in the conduit.Editorial responsibility: A. Woods     

Indoor Radon Radioactivity at the University of Brunei Darussalam

— Indoor radon radioactivity in the rooms on the ground floor and first floor of the Physics Department, Faculty of Science, Universiti Brunei Darussalam was measured using a system that consists of an air filter pump, ZnS detector, photomultiplier tube and counter. Ground floor rooms' radon radioactivity was found to be about three times higher than that of the first floor. The maximum ground floor indoor radioactivity is only 0.39 Bqm^?3, a value relatively low and safe compared to the mean outdoor radon concentration of 1.41 Bqm^?3 measured (HU and TAN, 2000). The main source of radon emanation originates from the ground soil rather than the building materials.