Obtaining basic simulation data for a heterogeneous field with stratified marine soils

Thinly stratified sedimentary deposits in a heterogeneous field were investigated to obtain basic physical data for the simulation of water flow. A procedure is described which translates a thinly stratified soil profile into a number of functional layers using functional hydrological properties. A functional layer is defined as a combination of one or more soil horizons and should (i) be recognizable during a soil survey using an auger and (ii) show significantly different functional hydrological properties when compared with another functional layer. This procedure gave three easily recognizable functional layers. Sets of hydrological characteristics of these three functional layers were obtained by physical measurements of the soil and by estimation, using textural data for classification into a standard Dutch series. The performance of several combinations of these sets was tested by comparing simulated and measured soil matric potentials for seven plots during one year. The best simulation results were obtained if measured soil hydraulic characteristics were used for relatively homogeneous functional layers and if the soil hydraulic characteristics were estimated at each location for the most heterogeneous layer.     

Nutrient (P, N) dynamics in the southwestern Kattegat, Scandinavia: sedimentation and resuspension effects

 The yearly nutrient supply from land and atmosphere to the study area in SW Kattegat is 10 900 tons of N and 365 tons of P. This is only few percent of the supply from adjacent marine areas, as the yearly transport through the study area is 218 000 tons of N and 18 250 tons of P. Yearly net deposition makes up 1340 tons of N (on average 2.5 g m^–2 yr^–1) and 477 ton of P (on average 0.9 g m^–2 yr^–1). Shallow-water parts of the study area have no net deposition because of frequent (>35% of the year) resuspension. Resuspension frequency in deep water is <1% of the year. Resuspension rates, as averages for the study area, are 10–17 times higher than net deposition rates. Because of resuspension, shallow-water sediments are coarse lag deposits with small amounts of organic matter (1.1%) and nutrients (0.04% N and 0.02% P). Deep-water sediments, in contrast, are fine grained with high levels of organic matter (11.7%) and nutrients (0.43% N and 0.15% P). Laboratory studies showed that resuspension changes the diffusive sediment water fluxes of nutrients, oxygen consumption, and penetration into the sediment. Fluxes of dissolved reactive phosphate from sediment to water after resuspension were negative in organic-rich sediments (13.2% organic matter) with low porosity (56) and close to zero in coarse sediments with a low organic matter content (2.3%) and high porosity (73). Fluxes of inorganic N after resuspension were reduced to 70% and 0–20% in relation to the rates before resuspension, respectively. Received: 10 July 1995 · Accepted: 19 January 1996     

Initial phase of chromospheric evaporation in a solar flare

In this paper we discuss the initial phase of chromospheric evaporation during a solar flare observed with instruments on the Solar Maximum Mission on May 21, 1980 at 20:53 UT. Images of the flaring region taken with the Hard X-Ray Imaging Spectrometer in the energy bands from 3.5 to 8 keV and from 16 to 30 keV show that early in the event both the soft and hard X-ray emissions are localized near the footpoints, while they are weaker from the rest of the flaring loop system. This implies that there is no evidence for heating taking place at the top of the loops, but energy is deposited mainly at their base. The spectral analysis of the soft X-ray emission detected with the Bent Crystal Spectrometer evidences an initial phase of the flare, before the impulsive increase in hard X-ray emission, during which most of the thermal plasma at 10⁷ K was moving toward the observer with a mean velocity of about 80 km s^-1. At this time the plasma was highly turbulent. In a second phase, in coincidence with the impulsive rise in hard X-ray emission during the major burst, high-velocity (370 km s^-1) upward motions were observed. At this time, soft X-rays were still predominantly emitted near the loop footpoints. The energy deposition in the chromosphere by electrons accelerated in the flare region to energies above 25 keV, at the onset of the high-velocity upflows, was of the order of 4 × 10¹⁰ erg s^-1 cm^-2. These observations provide further support for interpreting the plasma upflows as the mechanism responsible for the formation of the soft X-ray flare, identified with chromospheric evaporation. Early in the flare soft X-rays are mainly from evaporating material close to the footpoints, while the magnetically confined coronal region is at lower density. The site where upflows originate is identified with the base of the loop system. Moreover, we can conclude that evaporation occurred in two regimes: an initial slow evaporation, observed as a motion of most of the thermal plasma, followed by a high-speed evaporation lasting as long as the soft X-ray emission of the flare was increasing, that is as long as plasma accumulation was observed in corona.     

Application of beam forming techniques to measurements of acoustic scattering from the ocean bottom

Signals from an explosive source backscattered from the seafloor and received at long range by hydrophones of a towed array are processed to estimate the directional distribution of energy for a given time increment. As assembly of these data shows the time and amplitude of scattering features, and after conversion to distance, the geographic location of the return. A frequency-domain beam-forming procedure is used in which beam levels are averaged over a given band of a broad-band source. The processing is applied to experimental data obtained in the southern Tyrrhenian Sea. The major backscattering occurred at the Baconi Seamounts and the coastal margin of Sardinia.     

The three-dimensional geometry of the heliospheric current sheet

The three-dimensional geometry of the heliospheric current sheet seen from fixed points in interplanetary space is constructed for idealized (sinusoidal) magnetic neutral lines (equators) and for an observed magnetic equator on the basis of the “kinematic method” developed by Hakamada and Akasofu (1982). The cross-sections of the wavy current sheet at distances 1, 2 and 5 a.u. are also constructed for the idealized magnetic neutral lines.     

Water transport from the North-east Irish Sea to western Scottish coastal waters: Further observations from time-trend matching of Sellafield radiocaesium

Radiocaesium isotopes, discharged into the North-east Irish Sea from the Sellafield (formerly Windscale) nuclear fuel reprocessing plant in Cumbria, have been employed as flow monitors to update and extend the record of coastal water movement from the Irish Sea to the Clyde Sea area and, further north, to Loch Etive. The temporal trends in radiocaesium levels have been used to determine the extent of water mixing en route and to define mean advection rates. Flow conditions from the Irish Sea have changed considerably since the mid-1970s, the residence time of northern Irish Sea waters being ～12 months during 1978–1980 inclusive. Average transport times of four and six months are estimated for the Sellafield to Clyde and Sellafield to Etive transects respectively. Sellafield ¹³⁷Cs levels in seawater were diluted by factors of 27 and 50 respectively during current movement to the Clyde and Etive areas. The decrease in salinity-corrected ¹³⁷Cs concentrations between the Clyde and Etive suggests that dilution by Atlantic water occurs, the latter mainly entering the Firth of Lorne from the west. The majority (～94%) of the radiocaesium supply to Loch Etive enters the Firth of Lorne via the portion of the coastal current circulating west of Islay, only ～6% arriving via the Sound of Jura.