Sources and hydrothermal alteration of organic matter in Quaternary sediments: A synthesis of studies from the Central Gulf of California

Deep sea drilling in the Central Gulf of California, a young and active spreading centre, shows that the high heat flow typical of these regions causes extensive alteration of sediment organic matter, especially near sills and above magma chambers where hydrothermal activity is concentrated. Even on the nearby passive margin, where there are no sills, heat flow is moderately high and hydrocarbon generation has begun in immature sequences. Migrating light hydrocarbons are detected especially where hydrothermal activity is concentrated. Thermogenic methane is more widespread, though not in the passive margin bordering the spreading centre. Despite the incidence of hydrocarbon generation and migration, the amounts of hydrocarbons involved are relatively small and apparently do not lead to commercially significant accumulations of petroleum.The organic matter in these sediments is mostly marine because the Gulf of California generally has low runoff from land and highly productive surface waters. Turbidites rich in terrigenous organic material are locally abundant in the mainly pelagic section in the Guaymas Basin. The highest concentrations of organic matter are found in laminated diatomites deposited on the Guaymas passive margin within the oxygen minimum zone.     

Rational approximations in the parabolic equation method for water waves

Approximations based on minimax principles are developed in order to allow for large-angle propagation in the parabolic equation method. Numerical studies show that the minimax approximations do not cause any significant degradation of accuracy at small angles of incidence when compared with an existing model based on a (1,1) Padé approximant, and that they allow for much more successful treatment of large angles of incidence than is possible using the previously available methods.     

AN ECOSYSTEM MODEL ANALYSIS OF THE EFFECT OF MINE TAILINGS ON THE EUPHOTIC ZONE OF A PELAGIC ECOSYSTEM

A computer analysis was performed on experimental results obtained when mine tailings were added to seawater. The Mixed Upper-Layer Ecotrophie Simulation (MULES) model was tested by changing the extinction coefficient and the abundance of heterotrophic zooflagellates. Increasing the extinction coefficient resulted in a delay of phytoplankton growth, an increase in zooplankton standing stock and better growth of autotrophic flagellates compared with diatoms. Zooflagellates in the ecosystem influence the growth of zooplankton; secondary production by zooplankton was markedly depressed at low levels of zooflagellates. These results are believed to be of general significance for the diagnosis of suspended sediment effects on planktonic ecosystems.     

Longitudinal strength of a high-speed ferry

The longitudinal strength of the high-speed ferry was investigated by subjecting the ship's hull girder to long-term loads obtained from a frequency-domain panel code. Prior to the statistical analysis, linearly computed transfer functions were corrected for nonlinear effects, yielding two sets of transfer functions valid for different wave amplitudes. One set corresponded to the hogging condition; the other set, to the sagging condition. Two regular equivalent design waves were specified that resulted in loads representing the most severe global design load conditions. The still-water loading condition, yielding a still-water vertical bending moment in hogging, was superimposed on the wave-induced loads to obtain the total (design) loads in hogging. For the sagging condition only, additional impact-related loads were superimposed to obtain the total (design) loads in sagging. A finite element model of the ship's structure was subjected to pressure distributions according to the two regular design waves. For comparison with classification society rule values, a simple beam theory strength analysis of the ship's midship section was performed first, and then another finite element analysis was carried out, whereby the imposed loads were tuned to the rule values of vertical bending moments. Rule-based magnitudes of nominal maximum longitudinal stress deviated significantly (25–39%) from comparable stresses obtained by the panel code based finite element analysis. However, stresses obtained from the rule-based finite element analysis agreed more favorably, especially in hogging. In the uppermost deck, for example, the panel code based compressive stress was only 9% larger than the comparable stress from the rule-based finite element analysis.     

Scaling analysis of deposition from turbidity currents

Many oil-bearing sedimentary deposits are formed by the settling of particles from turbidity currents. Modeling sedimentary processes that form these turbidites enables the calculation of properties such as extent, depth, porosity and permeability of hydrocarbon-bearing reservoirs. This paper estimates the extent and thickness of turbidites from the initial conditions of the turbidity flow. This is achieved by the application of scaling analysis of the partial differential equations that govern the dynamics of and deposition from turbidity currents. We apply the results of scaling analysis to five modern submarine fans. The predicted and actual values of the dimensions of the fan deposits match well. We then compare the derived results against tabulated sizes of ancient turbidites. The comparisons are good as long as we correctly identify the flow regimes in which the deposition took place. The good agreements observed in the two cases show that the estimates obtained using scaling analysis can provide useful first-guess values for the dimensions of the deposits.     

Geology of the Continental Margin of Enderby and Mac. Robertson Lands, East Antarctica: Insights from a Regional Data Set

In 2001 and 2002, Australia acquired an integrated geophysical data set over the deep-water continental margin of East Antarctica from west of Enderby Land to offshore from Prydz Bay. The data include approximately 7700 km of high-quality, deep-seismic data with coincident gravity, magnetic and bathymetry data, and 37 non-reversed refraction stations using expendable sonobuoys. Integration of these data with similar quality data recorded by Japan in 1999 allows a new regional interpretation of this sector of the Antarctic margin. This part of the Antarctic continental margin formed during the breakup of the eastern margin of India and East Antarctica, which culminated with the onset of seafloor spreading in the Valanginian. The geology of the Antarctic margin and the adjacent oceanic crust can be divided into distinct east and west sectors by an interpreted crustal boundary at approximately 58° E. Across this boundary, the continent–ocean boundary (COB), defined as the inboard edge of unequivocal oceanic crust, steps outboard from west to east by about 100 km. Structure in the sector west of 58° E is largely controlled by the mixed rift-transform setting. The edge of the onshore Archaean–Proterozoic Napier Complex is downfaulted oceanwards near the shelf edge by at least 6 km and these rocks are interpreted to underlie a rift basin beneath the continental slope. The thickness of rift and pre-rift rocks cannot be accurately determined with the available data, but they appear to be relatively thin. The margin is overlain by a blanket of post-rift sedimentary rocks that are up to 6 km thick beneath the lower continental slope. The COB in this sector is interpreted from the seismic reflection data and potential field modelling to coincide with the base of a basement depression at 8.0–8.5 s two-way time, approximately 170 km oceanwards of the shelf-edge bounding fault system. Oceanic crust in this sector is highly variable in character, from rugged with a relief of more than 1 km over distances of 10–20 km, to rugose with low-amplitude relief set on a long-wavelength undulating basement. The crustal velocity profile appears unusual, with velocities of 7.6–7.95 km s⁻¹ being recorded at several stations at a depth that gives a thickness of crust of only 4 km. If these velocities are from mantle, then the thin crust may be due to the presence of fracture zones. Alternatively, the velocities may be coming from a lower crust that has been heavily altered by the intrusion of mantle rocks. The sector east of 58° E has formed in a normal rifted margin setting, with complexities in the east from the underlying structure of the N–S trending Palaeozoic Lambert Graben. The Napier Complex is downfaulted to depths of 8–10 km beneath the upper continental slope, and the margin rift basin is more than 300 km wide. As in the western sector, the rift-stage rocks are probably relatively thin. This part of the margin is blanketed by post-rift sediments that are up to about 8 km thick. The interpreted COB in the eastern sector is the most prominent boundary in deep water, and typically coincides with a prominent oceanwards step-up in the basement level of up to 1 km. As in the west, the interpretation of this boundary is supported by potential field modelling. The oceanic crust adjacent to the COB in this sector has a highly distinctive character, commonly with (1) a smooth upper surface underlain by short, seaward-dipping flows; (2) a transparent upper crustal layer; (3) a lower crust dominated by dipping high-amplitude reflections that probably reflect intruded or altered shears; (4) a strong reflection Moho, confirmed by seismic refraction modelling; and (5) prominent landward-dipping upper mantle reflections on several adjacent lines. A similar style of oceanic crust is also found in contemporaneous ocean basins that developed between Greater India and Australia–Antarctica west of Bruce Rise on the Antarctic margin, and along the Cuvier margin of northwest Australia.     

Oxidative stress in two populations of killifish (Fundulus heteroclitus) with differing contaminant exposure histories

A population of killifish (Fundulus heteroclitus) inhabiting a creosote-polluted inlet of the Elizabeth River demonstrates tolerance to the acute toxic effects exerted by contaminated sediments on reference site killifish. Previous data have suggested that upregulated antioxidant defenses contribute to short-term tolerance in killifish exposed to Elizabeth River sediments. This study investigated population differences in antioxidant defenses from wild caught Elizabeth River and reference population killifish in different seasons, and after being held in the laboratory. Parameters measured in the killifish were total glutathione concentrations (GSH(T)), activities of glutathione reductase (GR), glutathione peroxidase (GPx), and lipid peroxidation (LPO), all in adult hepatic tissues. The Elizabeth River population exhibited greater GSH(T), higher GPx activities, and increased LPO as compared to the reference population. Sex specific population differences were also observed in GSH(T) and GPx. Both populations displayed decreased GSH(T) and increased GR from early to late summer, as well as after being held in the laboratory. This study indicates that there are many factors that may contribute to differences in levels of antioxidant defenses in addition to exposure to contaminants, including reproductive status and environmental conditions.     

Simulating a heavy metal spill under estuarine conditions: Effects on the clam Scrobicularia plana

We describe the effect of heavy metals Zn, Cd, Pb and Cu on the induction of methallothioneins on the clam Scrobicularia plana along a salinity gradient simulated under laboratory conditions. The clams were exposed to constant heavy metal concentrations in a dynamic estuary simulator during a 15-day assay to investigate possible induction of metal-binding proteins in them. The concentration of heavy metals in water was analysed. Clams were analysed for methallothionein concentrations. The speciation of Zn, Cd, Pb and Cu along the salinity gradient was modelled. Zn showed the highest concentrations and its prevalent species was the free ion. Intersite differences have been observed in methallothionein concentration and related to the salinity gradient. It seems that synthesis of methallothioneins is the result of physiological forces acting in concert with the changes in the chemical speciation of metals, owing to the trace metals uptake is controlled by means of an interaction of physiology and physicochemistry.