Management and stability analysis of a seashore waste landfill site in Korea

Annual variation in the amount and composition of waste deposited in the Gimpo #2 landfill, the largest landfill around Seoul, Korea, is reviewed, and the stability of the same landfill is analyzed during waste disposal. For the stability analysis, three empirical stability prediction methods, i.e., linear stability, displacement velocity, and curve stability methods, are used to analyze field-measured settlement and horizontal displacement data. The analysis indicated that national waste management policy has greatly influenced the annual variation in the amount and composition of waste deposited in the landfill. Continuous measurement of geotechnical data and the use of stability analysis based on these data are necessary for landfills on seashore clay foundation. Stability of the landfill must be examined with various methods to ensure accurate determination of its stability.     

Aerobic oxidation of mackinawite (FeS) and its environmental implication for arsenic mobilization

Oxidation of mackinawite (FeS) and concurrent mobilization of arsenic were investigated as a function of pH under oxidizing conditions. At acidic pH, FeS oxidation is mainly initiated by the proton-promoted dissolution, which results in the release of Fe(II) and sulfide in the solution. While most of dissolved sulfide is volatilized before being oxidized, dissolved Fe(II) is oxidized into green rust-like precipitates and goethite (α-FeOOH). At basic pH, the development of Fe(III) (oxyhydr)oxide coating on the FeS surface inhibits the solution-phase oxidation following FeS dissolution. Instead, FeS is mostly oxidized into lepidocrocite (γ-FeOOH) via the surface-mediated oxidation without dissolution. At neutral pH, FeS is oxidized via both the solution-phase oxidation following FeS dissolution and the surface-mediated oxidation mechanisms. The mobilization of arsenic during FeS oxidation is strongly affected by FeS oxidation mechanisms. At acidic pH (and to some extent at neutral pH), the rapid FeS dissolution and the slow precipitation of Fe (oxyhydr)oxides results in arsenic accumulation in water. In contrast, the surface-mediated oxidation of FeS at basic pH leads to the direct formation of Fe (oxyhydr)oxides, which provides effective adsorbents for As under oxic conditions. At acidic and neutral pH, the solution-phase oxidation of dissolved Fe(II) accelerates the oxidation of the less adsorbing As(III) to the more adsorbing As(V). This study reveals that the oxidative mobilization of As may be a significant pathway for arsenic enrichment of porewaters in sulfidic sediments.     

Analysis of resistivity data obtained from cone penetrometer in contaminated soil layers

In horizontally layered soils of different electrical properties, electrical potential distribution becomes complex and the obtained resistivity data may be limited in reflecting the actual soil profile. Thus the objective of this study was to identify the factors that affect resistivity measurement on the cone penetrometer and further investigate the sensitivity of measured resistivity to different types and concentrations of contaminants at the subsurface level. First, a theoretical resistivity equation was derived to provide a means of computing the geometric factor. The effective volume of measurement on the cone penetrometer was investigated and laboratory soil box tests verified the dominance of partially high resistivity regions within the effective volume of measurement over the apparent resistivity. Such effect was found to lead to possible discrepancies between the recorded resistivity data and the actual depth of measurement. Measurements on contaminated soil layers indicated that resistivity cones are efffective in delineating inorganic contaminants in soils of high water contents, and detecting NAPLs floating above the groundwater table provided that soils adjacent to the plume are not dry of water. Electronic supplementary material  The online version of this article (doi:) contains supplementary material, which is available to authorized users.     

Increased As load to the Uchen stream due to mine drainage and soils in the abandoned Kangwon mining district of Korea

To determine the appropriate allocation of resources for the future restoration of the abandoned mining district of Kangwon in Korea, identification of the main pollutants and the main sources discharging these pollutants is crucial. Therefore, a 2-year study was undertaken to quantify the amount of pollutants in the Uchen stream (a potential sink for contamination), which runs through the district, and to determine the potential sources of these pollutants, including mine drainage and soil. Arsenic (As) was the main pollutant in mine drainage and soils showing concentrations above the Korean regulated standard levels of 50 μg L⁻¹ and 50 mg kg⁻¹ for water and soil, respectively. In addition, the pollution index (PI) showed that mine drainages were polluted by As to a moderate (2 ≤ PI < 3) or strong (4 ≤ PI < 5) degree. Consequently, As load in mine drainage and soil contributed to increased amounts of As in the stream. The As loads in mine drainages (11 and 587 g month⁻¹ for mine adit 1 and 2, respectively) accounted for only 9% of the total As load to the stream (6,378 g month⁻¹); and the influence of mine drainages on As contents in the stream was more reliant on the total volume of mine drainage generated rather than the As concentration in the mine drainage. Approximately 91% of the As in the stream was derived from the soils within the study area.     

Effect of spatial variability of cross‐correlated soil properties on bearing capacity of strip footing

Geotechnical engineering problems are characterized by many sources of uncertainty. Some of these sources are connected to the uncertainties of soil properties involved in the analysis. In this paper, a numerical procedure for a probabilistic analysis that considers the spatial variability of cross‐correlated soil properties is presented and applied to study the bearing capacity of spatially random soil with different autocorrelation distances in the vertical and horizontal directions. The approach integrates a commercial finite difference method and random field theory into the framework of a probabilistic analysis. Two‐dimensional cross‐correlated non‐Gaussian random fields are generated based on a Karhunen–Loève expansion in a manner consistent with a specified marginal distribution function, an autocorrelation function, and cross‐correlation coefficients. A Monte Carlo simulation is then used to determine the statistical response based on the random fields. A series of analyses was performed to study the effects of uncertainty due to the spatial heterogeneity on the bearing capacity of a rough strip footing. The simulations provide insight into the application of uncertainty treatment to geotechnical problems and show the importance of the spatial variability of soil properties with regard to the outcome of a probabilistic assessment. Copyright © 2009 John Wiley & Sons, Ltd.     

Characterization of hydrogeologic properties for a multi-layered alluvial aquifer using hydraulic and tracer tests and electrical resistivity survey

A multi-layered aquifer, typical of riverbank alluvial deposits in Korea, was studied to determine the hydrologic properties. The geologic logging showed that the subsurface of the study site was comprised of four distinctive hydrogeologic units: silt, sand, highly weathered and fresh bedrock layers. The electrical resistivity survey supplied information on lateral extension of hydrogeologic strata only partially identified by a limited number of the geologic loggings. The laboratory column tracer test for the recovered core of the sand layer resulted in a hydraulic conductivity of 5.00×10⁻² cm/s. The slug tests performed in the weathered rock layer yielded hydraulic conductivities of 4.32–7.72×10⁻⁴ cm/s. Hydraulic conductivities for the sand layer calculated from the breakthrough curves of bromide ranged between 2.08×10⁻³ and 2.44×10⁻² cm/s with a geometric mean of 6.89×10⁻³ cm/s, which is 7 times smaller than that from the laboratory column experiment. The trend of increasing hydraulic conductivity with an increase in tracer travel length is likely a result of the increased likelihood of encountering a high conductivity zone as more of the aquifer is tested. The combined hydrogeologic site characterization using hydraulic tests, tracer tests, and column test with geologic loggings and geophysical survey greatly enhanced the understanding of the hydrologic properties of the multi-layered alluvial aquifer.     

Tectonic relation between northeastern China and the Korean peninsula revealed by interpretation of GRACE satellite gravity data

The major continental blocks in northeastern Asia are the North China block and the South China block, which have collided starting from the Korean peninsula. Geologic and geophysical interpretations reveal a well defined suture zone in northeastern China from Qinling through Dabie to Jiaodong. The discovery of high-pressure metamorphic rocks in the Hongseong area of the Korean peninsula, prominent evidence for the collision zone, indicates extension of the collision zone in northeastern China into the Korean peninsula. Interpretation of the GRACE satellite gravity dataset shows two prominent structural boundaries in the Yellow Sea. One extends from the Jiaodong Belt in eastern China to the Imjingang Belt in the Korean peninsula. The other extends from near Nanjing, eastern China, to Hongseong. Tectonic movement in or near the suture zone may be responsible for seismic activity in the western Korean peninsula and the development of the Yellow Sea sedimentary basin.     

Distribution of cadmium, chromium, copper, lead and zinc in marine sediments in Hong Kong waters

Partitioning of heavy metals (Cd, Cr, Cu, Pb, Zn) in marine sediments collected from various sites in Hong Kong waters were determined using sequential extraction method. Sediments from Kellette Bank, located in Victoria Harbour, had higher metal concentrations especially Cu and Zn than most other sites. Slightly over 20% of total Cu and Cr existed as readily available forms in Peng Chau and Kellette Bank. At most sampling sites, over 15% of the Cu existed as the exchangeable form indicating that Cu could be readily released into the aqueous phase from sediments. A significantly higher percentage of Pb and Zn was associated with the three non-residual fractions. Hence, there is a greater environmental concern for remobilization of Pb and Zn compared with Cr. The high amount of residual Cd (>50%) and the relatively lower Cd content indicate that little environmental concern is warranted for the remobilization of Cd. Distribution of metals in sediments collected from different depth at Kellette Bank shows that metal concentrations decreased with profile depth. The levels of Pb and Zn associated with the two readily available fractions increased sharply in the surface sediment. These metals represented the pollutants, which were introduced into the area in the mid-eighties through early nineties as a result of rapid economic and industrial development in the territory. As significant portions of these metals were bound to the readily available phases in the surface sediments, metal remobilization could be a concern. An erratum to this article can be found at     

Nature of polymerization and properties of silicate melts and glasses at high pressure

The structures of sodium silicate and aluminosilicate glasses quenched from melts at high pressure (6-10 GPa) with varying degrees of polymerization (fractions of nonbridging oxygen) were explored using solid-state NMR [¹⁷O and ²⁷Al triple-quantum magic-angle spinning (3QMAS) NMR]. The bond connectivity in melts among four and highly coordinated network polyhedra, such as ^[4]Al, ^[5,6]Al, ^[4]Si, and ^[5,6]Si, at high pressure is shown to be significantly different from that at ambient pressure. In particular, in the silicate and aluminosilicate melts, the proportion of nonbridging oxygen (NBO) generally decreases with increasing pressure, leading to the formation of new oxygen clusters that include 5- and 6-coordinated Si and Al in addition to 4-coordinated Al and Si, such as ^[4]Si-O-^[5,6]Si, ^[4]Si-O-^[5,6]Al and Na-O-^[5,6]Si. While the fractions of ^[5,6]Al increase with pressure, the magnitude of this increase diminishes with increasing degrees of ambient-pressure polymerization under isobaric conditions. Incorporating the above structural information into models of melt properties reproduces the anomalous pressure-dependence of O²⁻ diffusivity and viscosity often observed in silicate melts.     

The optimal choice of residue management, crop rotations, and cost of carbon sequestration: empirical results in the Midwest US

This study investigates the cost of soil carbon sequestration in the Midwest US. The model addresses several missing components in earlier analyses: the link between the residue level choice and carbon payments, crop rotations, carbon loss when shifting from conservation to conventional tillage and the spatial pattern of carbon sequestration across different soil types. The results suggest that for $100 per metric ton of carbon, 1.5 million metric tons of carbon could be sequestered per year on the 19.9 million hectares of cropland in the study region. These estimates suggest less carbon potential than existing studies because the opportunity costs associated with conservation tillage are fairly high. Annual carbon rental payments are found to be more efficient, as expected, but for smaller programs, per hectare rental payments are not substantially more costly.