High-Frequency Hydroacoustic Monitoring in an Underground Iron Mine

The monitoring of the stability of old mines constitutes an important research objective for our institution, BRGM. The study reported here shows the contribution of high-frequency (>30 kHz) acoustic emissions to the detection of the damage within a rock mass, during an experiment within a pilot site of an old flooded iron mine. The experiment consisted of recording all the hydroacoustic events in a broad frequency band (between 30 Hz and 180 kHz), during 18 months. The monitoring network has been calibrated by a triggered block fall that made it possible to highlight a relationship between the occurrence of high-frequency/low-frequency hydroacoustic emissions and rock falls. The events recorded have been associated with the micro-failure of the rock mass near the roof, prior to the detachment of the blocks. This monitoring showed important high-frequency hydroacoustic activity, which may be associated with mechanical instabilities generated by the evolution of water pressure during the experiment. In conclusion, the high-frequency hydroacoustic activity appears to be a good indicator of instability and, therefore, this new technique constitutes a promising tool for monitoring abandoned underground cavities.     

Spatial and temporal structure of the Denmark Strait Overflow revealed by acoustic observations

In spite of the fundamental role the Atlantic Meridional Overturning Circulation (AMOC) plays for global climate stability, no direct current measurement of the Denmark Strait Overflow, which is the densest part of the AMOC, has been available until recently that resolve the cross-stream structure at the sill for long periods. Since 1999, an array of bottom-mounted acoustic instruments measuring current velocity and bottom-to-surface acoustic travel times was deployed at the sill. Here, the optimization of the array configuration based on a numerical overflow model is discussed. The simulation proves that more than 80% of the dense water transport variability is captured by two to three acoustic current profilers (ADCPs). The results are compared with time series from ADCPs and Inverted Echo Sounders deployed from 1999 to 2003, confirming that the dense overflow plume can be reliably measured by bottom-mounted instruments and that the overflow is largely geostrophically balanced at the sill.     

Field‐based and spectral indicators for soil erosion mapping in semi‐arid mediterranean environments (Coastal Cordillera of central Chile)

The Coastal Cordillera of central Chile is naturally sensitive to soil erosion due to moderate to steep slopes, intense winter rains when the vegetation cover is scarce, and deeply weathered granitic rocks. In 1965, 60 per cent of its surface was moderately to very severely eroded. Today this process is still largely active, but no data are currently available to evaluate the real extent, distribution and severity of soil degradation on a regional scale. This information is vital to support efficient soil conservation plans. A multi‐scale approach was implemented to produce regional land degradation maps based on remote sensing technologies. Fieldwork has shown that the surface colour or ‘redness’ and the density of coarse fragments are pertinent erosion indicators to describe a typical sequence of soil degradation in the context of mediterranean soil developed on granitic materials and micaschists. Field radiometric experiments concluded that both factors influence the reflectance of natural surfaces and can be modelled using radiometric indices accessible from most satellites operating in the optical domain, i.e. redness index and brightness index. Finally the radiometric indices were successfully applied to SPOT images to produce land degradation maps. Only broad classes of erosion status were discriminated and the detection of the degradation processes was only possible when most of the fertile layer had already been removed. This technology provides decision‐making information required to develop regional soil conservation plans and to prioritize actions between catchment areas, especially in vast inter‐tropical regions where spatialized data are not always readily available. Copyright © 2006 John Wiley & Sons, Ltd.     

Study of the erosion rates in the upper Maracujá Basin (Quadrilátero Ferrífero/MG,Brazil) by the in situ produced cosmogenic 10Be method

The present work quantifies the erosive processes in the two main substrates (schists–phyllites and granites–gneisses) of the upper Maracujá Basin in the Quadrilátero Ferrífero/MG, Brazil, a region of semi‐humid tropical climate. Two measuring methods of concentration were used: (i) in situ produced ¹⁰Be in quartz veins (surface erosion rates) and (ii) ¹⁰Be in fluvial sediments (basin erosion rates). The results confirm that (i) erosion tends to be more aggressive close to the headwaters than in the lower parts of the basin and (ii) the region is now affected by dissection. Copyright © 2006 John Wiley & Sons, Ltd.     

The November 2002 eruption at Piton de la Fournaise volcano,La Réunion Island: ground deformation,seismicity, and pit crater collapse

An eruption on the eastern flank of Piton de la Fournaise volcano started on 16 November, 2002 after 10 months of quiescence. After a relatively constant level of activity during the first 13 days of the eruption, lava discharge, volcanic tremor and seismicity increased from 29 November to 3 December. Lava effusion suddenly ceased on 3 December while shallow earthquakes beneath the Dolomieu summit crater were still recorded at a rate of about one per minute. This unusual activity continued and increased in intensity over the next three weeks, ending with the formation of a pit crater within Dolomieu. Based on ground deformation, measured by rapid-static and continuous GPS and an extensometer, seismic data, and lava effusion patterns, the eruptive period is divided into five stages: 1) slow summit inflation and sporadic seismicity; 2) rapid summit inflation and a short seismic crisis; 3) rapid flank inflation, onset of summit deflation, sporadic seismicity, accompanied by stable effusion; 4) flank inflation, coupled with summit deflation, intense seismicity, and increased lava effusion; and finally 5) little deflation, intense shallow seismicity, and the end of lava effusion. We propose a model in which the pre-intrusive inflation of Stage 1 in the months preceding the eruption was caused by a magma body located near sea level. The magma reservoir was the source of an intrusion rising under the summit during Stage 2. In Stage 3, the magma ponded at a shallow level in the edifice while the lateral injection of a radial dike reached the surface on the eastern flank of the basaltic volcano, causing lava effusion. Pressure decrease in the magmatic plumbing system followed, resulting in upward migration of a collapse front, forming a subterranean column of debris by faulting and stoping. This caused intense shallow seismicity, increase in discharge of lava and volcanic tremor at the lateral vent in Stage 4 and, eventually the formation of a pit crater in Stage 5.     

GPS network monitors the Western Alps' deformation over a five-year period: 1993–1998

  The Western Alps are among the best studied collisional belts with both detailed structural mapping and also crustal geophysical investigations such as the ECORS and EGT seismic profile. By contrast, the present-day kinematics of the belt is still largely unknown due to small relative motions and the insufficient accuracy of the triangulation data. As a consequence, several tectonic problems still remain to be solved, such as the amount of N–S convergence in the Occidental Alps, the repartition of the deformation between the Alpine tectonic units, and the relation between deformation and rotation across the Alpine arc. In order to address these problems, the GPS ALPES group, made up of French, Swiss and Italian research organizations, has achieved the first large-scale GPS surveys of the Western Alps. More than 60 sites were surveyed in 1993 and 1998 with a minimum observation of 3 days at each site. GPS data processing has been done by three independent teams using different software. The different solutions have horizontal repeatabilities (N–E) of 4–7 mm in 1993 and 2–3 mm in 1998 and compare at the 3–5-mm level in position and 2-mm/yr level in velocity. A comparison of 1993 and 1998 coordinates shows that residual velocities of the GPS marks are generally smaller than 2 mm/yr, precluding a detailed tectonic interpretation of the differential motions. However, these data seem to suggest that the N–S compression of the Western Alps is quite mild (less than 2 mm/yr) compared to the global convergence between the African and Eurasian plate (6 mm/yr). This implies that the shortening must be accomodated elsewhere by the deformation of the Maghrebids and/or by rotations of Mediterranean microplates. Also, E–W velocity components analysis supports the idea that E–W extension exists, as already suggested by recent structural and seismotectonic data interpretation. Received: 27 November 2000 / Accepted: 17 September 2001     

Progress in Carrier Phase Time Transfer

The progress of the joint Pilot Project for time transfer, formed by the International GPS Service (IGS) and the Bureal International des Poids et Mesures (BIPM), was recently reviewed. Three notable milestones were set. (1) The IGS will implement, at least in a test mode, an internally realized time scale based on an integration of combined frequency standards within the IGS network. This will eventually become the reference time scale for all IGS clock products (instead of the current GPS broadcast time). (2) A new procedure for combined receiver and satellite clock products will be implemented officially in November 2000. Receiver clocks are an entirely new product of the IGS. (3) The BIPM will coordinate an effort to calibrate all Ashtech Z12-T (and possibly other) receivers suitable for time transfer applications, either differentially or absolutely. Progress reports will be presented publicly in the spring 2001. ? 2001 John Wiley & Sons, Inc.     

The surface energy balance of a snow cover: comparing measurements to two differentsimulation models

Summary  We compared two one-dimensional simulation models for heat and water fluxes in the soil-snow-atmosphere system with respect to their mathematical formulations of the surface heat exchange and the snow pack evolution. They were chosen as examples of a simple one-layer snow model and a more detailed multiple-layer snow model (SNTHERM). The snow models were combined with the same one-dimensional model for the heat and water balance of the underlying soil (CoupModel). Data from an arable field in central Sweden (Marsta), covering two years (1997–1999) of soil temperature, snow depth and eddy-correlation measurements were successfully compared with the models. Conditions with a snow pack deeper or shallower than 10 cm and bare soil resulted in similar discrepancies. The simulated net radiation and sensible heat flux were in good agreement with that measured during snow-covered periods, except for situations with snowmelt when the downward sensible heat flux was overestimated by 10–20 Wm⁻². The results showed that the uncertainties in parameter values were more important than the model formulation and that both models were useful in evaluating the limitations and uncertainties of the measurements. Received November 1, 1999 Revised April 20, 2000