Nonsulfide zinc deposits in the Silesia–Cracow district,Southern Poland

The Silesia–Cracow district in Poland has been one of the world’s principal sources of zinc from nonsulfide zinc ore (Polish: galman). The still remaining nonsulfide ore resources can be estimated at 57 Mt at 5.6% Zn and 1.4% Pb. Nonsulfide mineralization is mainly hosted by Lower Muschelkalk (Triassic) limestone and is associated with different generations of the hydrothermal ore-bearing dolomite (OBD I, II, III). A fundamental ore control is believed to have been exerted by the basement faults, which were repeatedly reactivated during the Alpine tectonic cycle, leading to the formation of horst-and-graben structures: these dislocations may have caused short periods of emersion and the circulation of meteoric waters during the Cenozoic. Nonsulfide ores show a wide range of morphological characteristics and textures. They occur as earthy masses, crystalline aggregates, and concretions in cavities. Breccia and replacement textures are also very common. The most important mineral phases are: smithsonite, Fe–smithsonite, Zn–dolomite, goethite, and Fe–Mn(hydr)oxides. Minor hemimorphite and hydrozincite have also been detected. Two distinct nonsulfide ore types occur: the predominant red galman and the rare white galman. In the white galman, Fe–smithsonite and Zn–dolomite are particularly abundant. This ore type is commonly considered as a peripheral hydrothermal alteration product related to the same fluids that precipitated both the OBD II–III and the sulfides. In contrast, a supergene origin is commonly assumed for the red galman. Evidence of the petrographic and mineralogical difference between white and red galman is also found in stable isotope data. Smithsonite from red galman shows a limited range of δ ¹³C_VPDB values (−10.1 to −11.4‰), and δ ¹⁸O_VSMOW values (25.3‰ to 28.5‰, mean 26.8 ± 0.3‰). The uniform and low carbon isotope values of red galman smithsonite are unusual for supergene carbonate-hosted deposits and indicate the predominance of a single organic carbon source. Smithsonite from white galman has a more variable, slightly more positive carbon isotope (−2.9‰ to −7.4‰), but broadly similar oxygen isotope composition (26.8‰ to 28.9‰). The relationship of the white galman ore with the hydrothermal system responsible for OBD II and sulfide generation is still uncertain. The most important paleoweathering events took place in both Lower and Upper Silesia during Late Cretaceous up to Paleogene and early Neogene time. During this period, several short-lasting emersions and intense weathering episodes facilitated the formation of sinkholes in the Triassic carbonate rocks and the oxidation of sulfide orebodies through percolating meteoric waters. These phenomena may have lasted until the Middle Miocene.     

Monitoring Large-Scale Tests for Nuclear Waste Disposal

Two large-scale “in situ” demonstration experiments and their instrumentation are described. The first test (FEBEX Experiment) involves the hydration of a compacted bentonite barrier under the combined effect of an inner source of heat and an outer water flow from the confining saturated granite rock. In the second case, the progressive de-saturation of Opalinus clay induced by maintained ventilation of an unlined tunnel is analyzed. The paper shows the performance of different sensors (capacitive cells, psychrometers, TDR’s) and a comparison of fill behaviour with modelling results. The long term performance of some instruments could also be evaluated specially in the case of FEBEX test. Capacitive sensors provide relative humidity data during long transient periods characterised by very large variations of suction within the bentonite.     

Risk assessment of maize drought disaster in southwest China using the Environmental Policy Integrated Climate model

The East Asian monsoon has a tremendous impact on agricultural production in China. An assessment of the risk of drought disaster in maize-producing regions is therefore important in ensuring a reduction in such disasters and an increase in food security. A risk assessment model, EPIC(Environmental Policy Integrated Climate) model, for maize drought disasters based on the Erosion Productivity Impact Calculator crop model is proposed for areas with the topographic characteristics of the mountainous karst region in southwest China. This region has one of the highest levels of environmental degradation in China. The results showed that the hazard risk level for the maize zone of southwest China is generally high. Most hazard index values were between 0.4 and 0.5,accounting for 47.32% of total study area. However,the risk level for drought loss was low. Most of the loss rate was 0.1, accounting for 96.24% of the total study area. The three high-risk areas were mainlydistributed in the parallel ridge–valley areas in the east of Sichuan Province, the West Mountain area of Guizhou Province, and the south of Yunnan Province.These results provide a scientific basis and support for the reduction of agricultural drought disasters and an increase in food security in the southwest China maize zone.     

A semi-continuous measurement of gaseous ammonia and particulate ammonium concentrations in PM<Subscript>2.5</Subscript> in the ambient atmosphere

Ammonia has a short residence time in the atmosphere and rapidly neutralizes acid gases that occur near its source, requiring a rapid measurement system for ammonia and particulate ammonium concentrations to better understand their sources, temporal variation of ammonia emissions, and the formation of secondary ammonium aerosols. A semi-continuous measurement system, consisting of a diffusion scrubber, a particle growth chamber, an air-liquid separator, and a fluorescent detector, was developed to determine both gaseous ammonia (NH₃) and particulate ammonium (NH ₄ ⁺ ) in PM_2.5 in the ambient atmosphere of Gwangju, South Korea, during the months of March, April, July, and September of 2007. During the sampling periods, the average concentrations of ammonia and ammonium were found to be 2.33?±?1.29 μg/m³ and 1.89?±?0.99 μg/m³, respectively. Although the average gaseous ammonia concentration was highest in March, the particulate ammonium concentration was higher during the warmer season, reaching 2.08?±?1.07 μg/m³ and 2.32?±?0.94 μg/m³ in April and July, respectively, while only 1.68?±?0.61 μg/m³ in March and 1.24?±?0.99 μg/m³ in September. It is proposed that the higher availability of acid species during the warmer months produced a significant amount of particulate ammonium sulfate. Diurnal fluctuation of ammonia and ammonium during the warmer months showed that their peak time occurred at approximately 10:00 am. Both ammonia and ammonium concentrations were better correlated during the warmer months than during the cooler months. Further, the data suggest that the ammonia and ammonium were measured under well dispersed conditions, and multiple sources contributed to the ammonia at the sampling site.     

GPS signal acquisition using the repeatability of successive code phase measurements

This paper introduces a new method for GPS signal acquisition, which is based on the repeatability of successive code phase measurements and the M-of-N search algorithm. The performance of the proposed method in terms of probability of signal detection is similar to that of traditional methods, except that the calculation of the probability of detection does not rely on the noise distribution or the Carrier-to-Noise ratio (C/N₀). The code phase repeatability-based method is presented along with equations for probability of detection and probability of false detection. If the distribution of the noise is known, it also provides an estimate of the C/N₀. The proposed method is illustrated for coherent and non-coherent acquisition and C/N₀ estimation.     

A review of research on seismic behaviour of irregular building structures since 2002

The paper presents an overview of the progress in research regarding seismic response of plan and vertically irregular building structures. Three areas of research are surveyed. The first is the study of the effects of plan-irregularity by means of single-storey and multi-storey building models. The second area encompasses passive control as a strategy to mitigate torsional effects, by means of base isolation and other types of devices. Lastly, the third area concerns vertically irregular structures and setback buildings. Although fewer papers have been published in this last area with respect to the former ones, this state-of-the-art reports extensively on research efforts and progress into the seismic behaviour of irregular buildings in elevation to show the growing interest among specialists in the field.     

Characters of the Pco2 and CO2 Flux in the East China Sea in Autumn

Pco2 of air and seawater samples from the East China Sea(ECS) were measured in situ in autumn, 1994,Ocean currents,terrestrial fluviation,biological activities,etc.,Pco2 char-acters in air and seawater were investigated,CO2 flux and its character in the East China Sea are discussed on the basis of the Pco2 profiles of air and seawater,It was clear that the nearshore was the source of CO2;and tht the oulter sea area was the sink of CO2; and that the shelf area of the EXS is a net sink for atmospheric CO2 in autumn.     

APPLICATION OF GEOGRAPHICAL PARAMETER DATABASE TO ESTABLISHMENT OF UNIT POPULATION DATABASE

Now GIS is turning into a good tool in handling geographical, economical, and population data, so we can obtain more and more information from these data. On the other hand, in some cases, for a calamity, such as hurricane, earthquake, flood, drought etc., or a decision-making, such as setting up a broadcasting transmitter, building a chemical plant etc., we have to evaluate the total population in the region influenced by a calamity or a project. In this paper, a method is put forward to evaluate the population in such special region. Through exploring the correlation of geographical parameters and the distribution of people in the same region by means of quantitative analysis and qualitative analysis, unit population database (1km× 1km) is established. In this way, estimating the number of people in a special region is capable by adding up the population in every grid involved in this region boundary. The geographical parameters are obtained from topographic database and DEM database on the scale of     

CARBON DYNAMICS OF WETLAND IN THE SANJIANG PLAIN

1INTRODUCTIONWetlandsplayanimportant roleintheprocessofcar-bonstorage.Thetotalcarbonstoredindifferentkindsofwetlandsisabout15%-35%ofthetotalcarboninthegloballandsoils(POSTetal.,1982;GORHAM,1991).Inaddition,wetlandsaresignificantnaturalsources fortheatmospheric CH4 (MOORE,1994).It isestimatedthatabout110×1012gCH4 originates fromanaerobicdecompositioninthenaturalwetlands,CH4 emission fromthenaturalwetlandsis15%-30%oftheglobalCH4 emission andtheCH4 emission from thepeat land at hi…     

Accuracy Assessment of Digital Elevation Model Generated by SAR Stereoscopic Technique Using COSMO-Skymed Data

Radargrammetry technique using the stereoscopic synthetic aperture radar (SAR) images is used for the generation of a digital elevation model (DEM) of a region requires only the amplitude images. SAR stereoscopic technique is analogous to the stereo-photogrammetric technique where the optical stereoscopic images are used for DEM generation. While the advantages of the SAR images are their indifference to atmospheric transparency and solar illumination conditions, the side-looking geometry of the SAR increases the complexity in the SAR stereo analysis. The availability of high spatial and temporal resolution SAR data in recent years has facilitated generation of high-resolution DEM with greater vertical accuracy using radargrammetric technique. In the present study, attempt has been made to generate the DEM of Dehra Dun region, India, from the COSMO-Skymed X-band SAR data-pair acquired at 8 days interval through the radargrammetry technique. Here, radargrammetric orientation approach has been adopted to generate the DEM and various issues and processing steps with the radargrammetry technique have been discussed. The DEM was validated with ground measured elevation values using a differential global positioning system and the root-mean-square error of the DEM was found as 7.3 m. The DEM was compared with the reference DEM of the study area generated from the Cartosat-1 stereo data with a model accuracy of 4 m.