Magnetic studies over the northern extension of the Prathap Ridge complex,eastern Arabian Sea

The northern parts of the Prathap and Laccadive Ridge system, eastern Arabian Sea, consist of three parallel basement ridge peaks at varied depths. The topographic highs are associated with either well-developed or subdued magnetic signatures. Model studies, constrained by seismic results, determine the varied nature and depth to the top of the causative basement bodies. Similarities of the geophysical signatures of the ridges and their structural resemblance perhaps point to their common origin. Hence we propose that the Prathap Ridge complex may be a part of the Chagos-Laccadive Ridge system and formed because of the Reunion hotspot activity.     

Approximate methods in short-term wave response distribution

The design and performance of an offshore structure depends largely upon the response of the structure to the environmental loading such as waves. The extreme response chosen for the design of a structure should meet its lifetime response, operational response as well as the fatigue damage. The failure of the structural member may be caused by the maximum instantaneous stress experienced by the member due to a given environment. This is considered short-term as opposed to long-term or fatigue damage. The short-term response statistics are obtained on the basis of one particular seastate. Since this seastate is invariably high, nonlinearity in the excitation and response of the structure is almost invariably present. The general nonlinear problem in the extreme response prediction is largely unsolved. Response characteristics are often obtained from the perturbation methods and equivalent linearization techniques. Unlike nonlinear problems, these methods greatly simplify the analysis for extreme values. This paper reviews the available approximation techniques in the response computation and the limits of their applicability in a design situation. Results are illustrated so that a designer may evaluate the suitability of a method in a particular design condition.     

Formation of pockmarks by pore-water escape

During the course of a North Sea rig site investigation, a number of seabed depressions were observed on side-scan sonar records, some of which may be identified as pockmarks. Others are described as pits. A pockmark evolutionary series is proposed on the basis of all these features with a suggested mechanism which would favor release of pore water, but does not exclude gas escape. Acoustic voids are considered to be a related phenomenon.     

Determination of characteristics of atmospheric motions from satellite multiwave remote sensing data

A method of determination of atmospheric dynamic characteristics from the data of remote sensing from a geostationary satellite is described. The method is based on the use of inhomogeneities in the concentration field of a conservative additive as tracers and on the application of correlation-extreme algorithms. Unlike the common methods used abroad, this method is able to determine not only the vector field of wind velocity but also the coefficient of turbulent diffusion and vorticity. Results of computations of the fields of the horizontal component of wind velocity and the effective coefficient of horizontal mesoscale turbulent diffusion from the Meteosat-8 SEVIRI water-vapor channel data are presented. It is shown that the average values of the effective coefficient of mesoscale horizontal turbulent diffusion in the areas with a predominantly turbulized air-mass motion are 1.5 times greater than in the areas where a laminar motion dominates. Specific features of the calculated values of the upper-troposphere dynamic characteristics in different stages of the North Atlantic TC Helene (September 2006) are analyzed.     

Characterization of interface roughness of rippled sand off Fort Walton Beach, Florida

As part of the environmental characterization to model acoustic bottom scattering during the high-frequency sediment acoustics experiment (SAX99), fine-scale sediment roughness of a medium sand was successfully measured within a 600 /spl times/ 600-m area by two methods: stereo photography and a technique using a conductivity system. Areal coverage of the two methods, representing approximately 0.16 m/sup 2/ of the sea floor, was comparable, resulting in the depiction and quantification of half-meter wavelength sand ripples. Photogrammetric results were restricted to profiles digitized at 1-mm intervals; sediment conductivity results generated gridded micro-bathymetric measurements with 1- to 2-cm node spacing. Roughness power spectra give similar results in the low-spatial-frequency domains where the spectra estimated from both approaches overlap. However, spectra derived from higher resolution photogrammetric results appear to exhibit a multiple-power-law fit. Roughness measurements also indicate that spectrum changes as a function of time. Application of statistical confidence bounds on the power spectra indicates that roughness measurements separated by only 1-2 m may be spatially nonstationary.     

Surface heat fluxes and subsurface heat content at a site over the southeastern Bering Sea shelf, May–July 1996

Observations from a surface mooring, in a weak-flow regime over the southeastern Bering Sea shelf, were used to derive surface heat fluxes for the period May–July 1996. Changes in heat content of the water column also were determined from subsurface temperature measurements. Agreement of net surface heat flux and change in heat content was within 2%. This result provides additional evidence that heat advection and diffusion are small in this region.     

Effect of shallow and narrow water on added mass of cylinders with various cross-sectional shapes

The sway, heave and roll added masses of three uniform cylinders with semi-circular, rectangular and triangular cross-sectional shapes in shallow and narrow water are numerically analysed. The method is based on simulation of the potential flow induced by the cylinder's mode of motion. The effects of shallow and narrow water on added mass are analysed and presented. It is concluded that the shallow and narrow water effects on added mass depend on the different cross-section shapes of the cylinders. In particular, the water depth effect on sway added mass is stronger than that on heave added mass while the narrow water effect on sway is weaker than that on heave. The shallow water effect on added mass tends to weaken the narrow water effect. Lastly the effect of shallow and narrow water on added mass on a rectangular cylinder is the strongest while that on a triangular cylinder is the weakest.