伶仃洋L＿2和L＿（16）孔第四纪有孔虫群与孢粉化石带特征及其地质意义

本文所依据的分析样品是取自珠江最大的一个河口湾伶仃洋中部的水下钻孔岩芯，其底部到达花岗岩基底。通过对第四纪有孔虫群与孢粉化石带特征的分析，阐明在相同的钻孔岩芯中，有孔虫分布变化所反映的古沉积环境特征与孢粉分析的古气候特征较为吻合，并与相应的沉积相对应，结合￣（１４）Ｃ和￣（２３０）Ｔｈ／￣（２３２）Ｔｈ比值法测年数据，从而较好地重塑本区晚更新世中期以来的地质历史。     

潜水员水下用电安全技术规范的编制与认识

本文介绍了国家标准《潜水员水下用电安全技术规范》的研究、编制过程，以及编者对该标准性质、适用范围、总体结构、电气安全数值取舍等的基本认识，并就该标准制定实施后的经济、社会效益进行了初步预测。     

Frequency-selective attenuation of sound propagation and reverberation in shallow water

Ｆｒｅｑｕｅｎｃｙ－ｓｅｌｅｃｔｉｖｅ　ａｔｔｅｎｕａｔｉｏｎ　ｏｆ　ｓｏｕｎｄ　ｐｒｏｐａｇａｉｏｎ　ａｎｄ　ｒｅｖｅｒｂｅｒａｔｉｏｎ　ｉｎ　ｓｈａｌｌｏｗ　ｗａｔｅｒTXＦｒｅｑｕｅｎｃｙ－ｓｅｌｅｃｔｉｖｅａｔｔｅｎｕａｔｉｏｎｏｆｓｏｕｎｄｐ...     

几种药物治疗对虾聚缩虫病试验

本文报道了1990年在平湖对虾养殖场用几种药物治疗聚缩虫病所做的试验。结果表明,高锰酸钾和新洁尔灭的疗效较为显著。     

Remote estimation of surficial seafloor properties through the application Angular Range Analysis to multibeam sonar data

The variation of the backscatter strength with the angle of incidence is an intrinsic property of the seafloor, which can be used in methods for acoustic seafloor characterization. Although multibeam sonars acquire backscatter over a wide range of incidence angles, the angular information is normally neglected during standard backscatter processing and mosaicking. An approach called Angular Range Analysis has been developed to preserve the backscatter angular information, and use it for remote estimation of seafloor properties. Angular Range Analysis starts with the beam-by-beam time-series of acoustic backscatter provided by the multibeam sonar and then corrects the backscatter for seafloor slope, beam pattern, time varying and angle varying gains, and area of insonification. Subsequently a series of parameters are calculated from the stacking of consecutive time series over a spatial scale that approximates half of the swath width. Based on these calculated parameters and the inversion of an acoustic backscatter model, we estimate the acoustic impedance and the roughness of the insonified area on the seafloor. In the process of this inversion, the behavior of the model parameters is constrained by established inter-property relationships. The approach has been tested using a 300 kHz Simrad EM3000 multibeam sonar in Little Bay, NH. Impedance estimates are compared to in situ measurements of sound speed. The comparison shows a very good correlation, indicating the potential of this approach for robust seafloor characterization.     

4D seismic time-lapse monitoring of an active cold vent,northern Cascadia margin

Two single-channel seismic (SCS) data sets collected in 2000 and 2005 were used for a four-dimensional (4D) time-lapse analysis of an active cold vent (Bullseye Vent). The data set acquired in 2000 serves as a reference in the applied processing sequence. The 4D processing sequence utilizes time- and phase-matching, gain adjustments and shaping filters to transform the 2005 data set so that it is most comparable to the conditions under which the 2000 data were acquired. The cold vent is characterized by seismic blanking, which is a result of the presence of gas hydrate in the subsurface either within coarser-grained turbidite sands or in fractures, as well as free gas trapped in these fracture systems. The area of blanking was defined using the seismic attributes instantaneous amplitude and similarity. Several areas were identified where blanking was reduced in 2005 relative to 2000. But most of the centre of Bullseye Vent and the area around it were seen to be characterized by intensified blanking in 2005. Tracing these areas of intensified blanking through the three-dimensional (3D) seismic volume defined several apparent new flow pathways that were not seen in the 2000 data, which are interpreted as newly generated fractures/faults for upward fluid migration. Intensified blanking is interpreted as a result of new formation of gas hydrate in the subsurface along new fracture pathways. Areas with reduced blanking may be zones where formerly plugged fractures that had trapped some free gas may have been opened and free gas was liberated.     

Phytoplankton biomass and size fractions in surface waters of the Australian sector of the southern ocean

We collected surface water along the 142nd E meridian from Tasmania to Antarctica in December 1999. We measured temperature, salinity and total chlorophyll a; additionally, we collected suspended particle size fractions and used fluorometric analysis to determine the quantity of chlorophyll a in each of four cell size classes: picoplankton (<3 μm), two nanoplankton fractions (3–10 μm and 10–20 μm) and microplankton (> 20 μm). Changes in temperature and salinity show that we crossed 6 water masses separated by 5 fronts. We found low abundance (<0.2 mg m⁻³) of chlorophyll in all size classes, with the exception of higher values near the continent (0.2 to 0.4 mg m⁻³). Lowest chlorophyll values (<0.1 mg m⁻³) were found in the Polar Frontal Zone (51° to 54°S). Microplankton made up the largest portion of total chlorophyll throughout most of the region. We conclude that biomass of all phytoplankton fractions, especially pico-and nanoplankton, was constrained by limiting factors, most probably iron, throughout the region and that ecosystem dynamics within a zone are not circumpolar but are regionalized within sectors.     

Effects of an Artificial Breakwater on the Distributions of Planktonic Microbial Communities

The summer distributions of planktonic microbial communities (heterotrophic and phtosynthetic bacteria, phtosynthetic and heterotrophic nanoflagellates, ciliate plankton, and microphytoplankton) were compared between inner and outer areas of Lake Sihwa, divided by an artificial breakwater, located on the western coast of Korea, in September 2003. The semienclosed, inner area was characterized by hyposaline surface water (<17 psu), and by low concentrations of dissolved oxygen (avg. 0.4 mg L¹) and high concentrations of inorganic nutrients (nitrogenous nutrients >36 μM, phosphate <4 μM) in the bottom layer. Higher densities of heterotrophic bacteria and nanoflagellates also occurred in the inner area than did in the outer area, while microphytoplankton (mainly diatoms) occurred abundantly in the outer area. A tiny tintinnid ciliate, Tintinnopsis nana, bloomed into more than 10⁶ cells L¹ at the surface layer of the inner area, while its abundance was much lower (10³-10⁴ cells L¹) in the outer area of the breakwater. Ciliate abundance was highly correlated with heterotrophic bacteria (r = 0.886, p < 0.001) and heterotrophic flagellates (r = 0.962, p < 0.001), indicating that rich food availability may have led to theT. nana bloom. These results suggest that the breakwater causes the eutrophic environment in artificial lakes with limited flushing of enriched water and develops into abundant bacteria, nanoflagellates, and ciliates.     

On dynamic coupling effects between a spar and its mooring lines

The responses of a spar constrained by slack mooring lines to steep ocean waves and tensions in the mooring lines are simulated using two different numerical schemes: a quasi-static approach (SMACOS) and a coupled dynamic approach (COUPLE). The two approaches are the same in computing wave loads on the structure. Their difference is in modeling dynamic forces of mooring lines; that is the dynamic forces are included in the computation of COUPLE but neglected in SMACOS. The numerical simulation is examined against the laboratory measurements of the JIP Spar in a water depth of 318 m. The dynamic coupling effects between the JIP Spar and its mooring lines in different water depths (318, 618 and 1018 m) are investigated by the comparison of numerical simulations obtained using the quasi-static and coupled dynamic approaches. It is found that the damping of mooring lines reduces the slow-drift surge and pitch of the Spar, especially in deep water. The reduction in the amplitude of slow-drift surge can reach about 10% in a water depth of 1018 m. The tension in mooring lines may greatly increase in the wave frequency range when dynamic forces in mooring lines are considered. The mooring-line tension in the wave frequency range predicted by the coupled dynamic approach can be eight times as great as the corresponding prediction by the quasi-static approach in a water depth of 1018 m. This finding may have important implications for the estimation of the fatigue strength and life span of the mooring lines deployed in deep water oceans.     

Strength Analysis of Turret Mooring Productive/Storage Tanker

The longitudinal strength of turret mooring productive/storage tanker is studied.A numeri-cal example has been implemented according to the method presented in this paper to give practical il-lustration.From the results of the numerical example,it is concluded that the turret hole located near theforward of the amidships has small effect on the longitudinal strength of the ship hull.As for design ex-treme value of wave bending moment of storage tanker,statistic method is a more reasonablemethodology,especially with the consideration of the servere environmental conditions.The primary esti-mation of design section modulus of turret storage tanker can be determined by this design bending mo-ment.