An optimized sequential extraction scheme for molybdenum association in environmental samples

By comparing three sequential extraction procedures, a new optimized extraction scheme for the molybdenum association in environmental samples was proposed. Five operational steps were described as exchangeable (KH₂PO₄ + K₂HPO₄: including water-soluble), associated with organic matter (NaOH), Fe–Mn oxides and/or carbonates (HCl), sulfides (H₂O₂) and residue (HNO₃ + HF + H₂O₂). An optimized extraction scheme was compared with Tessier’s procedure and the Commission of European Communities Bureau of Reference (BCR) was applied to black shales. Results showed Tessier’s procedure gave the lowest concentration values for exchangeable molybdenum and the highest values for the residual molybdenum, which could not present the efficiency of the extraction reagents. BCR’s procedure showed the highest values in oxidizable molybdenum and presented four fractions of molybdenum, which did not demonstrate the fractions of molybdenum in the black shales in detail. The optimized extraction scheme demonstrated a certain improvement on extraction efficiency over Tessier’s procedure for the lowest residual molybdenum, and revealed more featured fraction information of molybdenum in black shales than BCR’s. Therefore, after a comparison with other two extraction procedures, the optimized extraction scheme proved suitable for the molybdenum in black shales and it also showed an accurate determination of the molybdenum in the fractions and source of bioavailable Mo.     

Ra’s Abdah of the north Eastern Desert of Egypt: the role of granitic dykes in the formation of radioactive mineralization,evidenced by zircon morphology and chemistry

Syenogranitic dykes in the north of Egypt’s Eastern Desert are of geological and economic interest because of the presence of magmatic and supergene enrichment of radioactive mineralization. Zircon crystal morphology within the syenogranitic dykes allows precise definition of sub-alkaline series granites and crystallized at mean temperature of about 637 °C. The growth pattern of the zircons suggest magmatic and hydrothermal origins of radioactive mineralization. Hydrothermal processes are responsible for the formation of significant zircon overgrowth; high U-zircon margins might have occurred contemporaneously with the emplacement of syenogranitic dykes which show anomalous uranium (eU) and thorium (eTh) contents of up to 1386 and 7330 ppm, respectively. Zircon chemistry revealed a relative increase of Hf consistent with decreasing Zr content, suggesting the replacement of Zr by Hf during hydrothermal activity. Visible uranium mineralization is present and recognized by the presence of uranophane and autunite.     

Geochemistry of sedimentary rocks from Permian–Triassic boundary sections of Tethys Himalaya: implications for paleo-weathering,provenance, and tectonic setting

The geochemical characteristics of two sections—the Permian–Triassic boundary (PTB) Guryul Ravine section, Kashmir Valley, Jammu and Kashmir, India; and the Attargoo section, Spiti Valley, Himachal Pradesh, India—have been studied in the context of provenance, paleo-weathering, and plate tectonic setting. These sections represent the siliciclastic sedimentary sequence from the Tethys Himalaya. The PTB siliciclastic sedimentary sequence in these regions primarily consists of sandstones and shales with variable thickness. Present studied sandstones and shales of both sections had chemical index of alteration values between 65 and 74; such values reveal low-to-moderate degree of chemical weathering. The chemical index of weathering in studied samples ranged from 71 to 94, suggesting a minor K-metasomatism effect on these samples. Plagioclase index of alteration in studied sections ranged from 68 to 92, indicating a moderate degree of weathering of plagioclase feldspars. The provenance discriminant function diagram suggests that the detritus involved in the formation of present studied siliciclastic sedimentary rocks fall in quartzose sedimentary and felsic igneous provenances. These sediments were deposited in a passive continental margin plate tectonic setting according to their location on a Si₂O versus K₂O/Na₂O tectonic setting diagram.     

Nuclear field shift effects on stable isotope fractionation: a review

An anomalous isotope effect exists in many heavy element isotope systems (e.g., Sr, Gd, Zn, U). This effect used to be called the “odd–even isotope effect” because the odd mass number isotopes behave differently from the even mass number isotopes. This mass-independent isotope fractionation driving force, which originates from the difference in the ground-state electronic energies caused by differences in nuclear size and shape, is currently denoted as the nuclear field shift effect (NFSE). It is found that the NFSE can drive isotope fractionation of some heavy elements (e.g., Hg, Tl, U) to an astonishing degree, far more than the magnitude caused by the conventional mass-dependent effect (MDE). For light elements, the MDE is the dominant factor in isotope fractionation, while the NFSE is neglectable. Furthermore, the MDE and the NFSE both decrease as temperatures increase, though at different rates. The MDE decreases rapidly with a factor of 1/T², while the NFSE decreases slowly with a factor of 1/T. As a result, even at high temperatures, the NFSE is still significant for many heavy element isotope systems. In this review paper, we begin with an introduction of the basic concept of the NSFE, including its history and recent progress, and follow with the potential implications of the inclusion of the NFSE into the kinetic isotope fractionation effect (KIE) and heavy isotope geochronology.     

Fractionation characteristics of rare earth elements (REEs) linked with secondary Fe,Mn, and Al minerals in soils

Soil secondary minerals are important scavengers of rare earth elements (REEs) in soils and thus affect geochemical behavior and occurrence of REEs. The fractionation of REEs is a common geochemical phenomenon in soils but has received little attention, especially fractionation induced by secondary minerals. In this study, REEs (La to Lu and Y) associated with soil-abundant secondary minerals Fe-, Al-, and Mn-oxides in 196 soil samples were investigated to explore the fractionation and anomalies of REEs related to the minerals. The results show right-inclined chondrite-normalized REE patterns for La–Lu in soils subjected to total soil digestion and partial soil extraction. Light REEs (LREEs) enrichment features were negatively correlated with a Eu anomaly and positively correlated with a Ce anomaly. The fractionation between LREEs and heavy REEs (HREEs) was attributed to the high adsorption affinity of LREEs to secondary minerals and the preferred activation/leaching of HREEs. The substantial fractions of REEs in soils extracted by oxalate and Dithionite-Citrate-Bicarbonate buffer solutions were labile (10 %–30 %), which were similar to the mass fraction of Fe (10 %–20 %). Furthermore, Eu was found to be more mobile than the other REEs in the soils, whereas Ce was less mobile. These results add to our understanding of the distribution and geochemical behavior of REEs in soils, and also help to deduce the conditions of soil formation from REE fractionation.     

Rainfall over Oman and its teleconnection with El Niño Southern Oscillation

The Sultanate of Oman is located in the south-eastern part of the Arabian Peninsula and covers the larger part of the southern coasts of the Arabian Peninsula in both arid and semi-arid environments except for the southern part which is swept by the monsoon affecting the Arabian Sea during the period from June to September. The summer rainfall over Oman shows year-to-year variability, and this is caused by oceanic and atmospheric influences. In the present study, we tried to explore the influence of El Niño on the rainfall over Oman using different data sets. The empirical orthogonal function (EOF) technique employed to the zonal wind at 850 hPa for the 30-year period shows that the second and third modes of EOF are showing high variability over the Oman regions. The corresponding PCs were subjected to FFT analysis, and it showed a peak about 5–6 years. In addition to this, the zonal wind over the Oman regions is correlated with the global zonal wind and found a significant correlation (1 % significant level). It has already been proved that the wind and rainfall during summer monsoon is in phase. Moreover, the spectral analysis of rainfall at Masirah station and the Niño3.4 index show the similar mode of variability indicating a direct relationship. The correlation between rainfall and the Niño3.4 index is also showing a positive significant value, and therefore, it can be concluded that the El Niño in the Pacific favours rainfall over the Oman region.     

Multichannel analysis of surface waves (MASW) for seismic site characterization using 2D genetic algorithm at Bahrah area,Wadi Fatima,Saudi Arabia

The present study deals with the seismic site classification of Bahrah area, Wadi Fatima, to characterize the local site conditions. The dynamic behavior of sediments was studied by the application of surface wave inversion. The multichannel analysis of surface waves (MASW) shallow geophysical technique was utilized for site classification. MASW survey was carried out at 66 sites along with 13 seismic refraction profiles at suitable localities. MASW and seismic refraction profiles were processed and compared with the available borehole data. The integration of MASW techniques with seismic refraction and borehole data progressively enhanced the subsurface visualization and reliability of the shear wave velocity estimation in the subsurface in the study area. The subsurface shear-wave velocity model was achieved by the solution of an inverse problem-based dispersion of surface waves and propagation in a vertically heterogeneous medium. The 2D genetic algorithm was employed for the inversion of dispersion curves to obtain velocity and thickness of subsurface layers. The depth to engineering bedrock and velocity of shear waves in the first 30 m was deciphered and mapped. The depth of bedrock in study area varies from 4 to 30 m, and V _{S 30} ranges from 320 to 800 m/s. The most of study area falls in B and C class categories in addition to few sites of D class according to the NEHRP guidelines.     

Assessing groundwater storage changes in the Nubian aquifer using GRACE data

Gravity Recovery and Climate Experiment (GRACE) level two (L2) data is used in estimating the groundwater storage changes (GWSC) in the Nubian Sandstone Aquifer System (NSAS). This set of data consists of spherical harmonics coefficients with specific degree and order. The GRACE data is de-correlated using a sixth degree polynomial in order to reduce the effect of the noise error resulting from the correlation between the spherical harmonics coefficients with the same degree parity. The GRACE estimates of GWSC are smoothed using Gaussian filter with half width of 1000 km. This half width is chosen in order to maximize the correlation between the GRACE estimates of GWSC and previous modeling results of the NSAS. The loss in groundwater storage occurring in each of the four countries sharing the NSAS is calculated to assess the sustainability of using the NSAS as a water resource in each country. The overarching finding in this study is that NSAS is losing its groundwater storage at a very high rate. Also, it is found that Egypt is the fastest in losing its groundwater storage from the NSAS. This loss of groundwater storage in Egypt may not necessarily be resulting from in-country extractions because of the trans-boundary nature of this aquifer. The GRACE-based estimates are found to be close to available data and previous modeling results of the NSAS.     

Detachment folding in a Lower Cambrian–Upper Permian karst reservoir: 3D model of the Yubei 3D area (eastern Markit Slope,Tarim Basin,Northwest China)

A three-dimensional (3D) structural modeling of the Lower Cambrian–Upper Permian Yubei 3D area was performed to understand its structural evolution. This model reproduces the present-day structure of the basin and comprises 11 horizons within Lower Cambrian to Upper Permian rocks. The analysis is based on 3D depth views and faults. The results image salt movements due to tectonics and/or burial. From these observations, this paper deduces that salt structures are correlated to the main faults and tectonic events. From the model analysis, we interpret the timing and geometry of Tarim Basin tectonics. The fault geometry can be resolved based on the strike of the fault, the morphology of hanging wall strata, and the stratigraphic distribution. Emphasis is placed on gypsum rock detachment, considering its movements during the Middle Caledonian event and decoupling effects during tectonic evolution. Moreover, we point to the structural control of the Paleozoic basement and the crustal architecture (Yubei 3D Zone) on the geometry of the Tarim Basin.     

A GIS-index integration approach to groundwater suitability zoning for irrigation purposes

In recent decades, the high population growth has increased the demand for agricultural lands and products. Groundwater offers reliability and flexibility in access to water for irrigation purposes, especially in arid and semi-arid areas, such as Amol-Babol Plain, Iran. However, the quality and quantity of groundwater may not be suitable for irrigation purposes in all areas due to urbanizations, and intensive agricultural and industrial activities. Groundwater suitability zoning for irrigation purposes could be useful to improve water resources and land use planning, mostly in areas with water scarcity. Therefore, a GIS-based indices method is proposed to assess suitable zones for agricultural activities, integrating the irrigation water quality (IWQ) index and hydrogeological factors. IWQ index was utilized to assess groundwater quality based on salinity hazard, infiltration hazard, specific ions, and trace elements hazards, and miscellaneous effects such as pH, bicarbonate, and nitrate. The potential of the aquifer for irrigation water abstraction was investigated using hydrogeological surveys such as slope angle of the plain, hydraulic conductivity, and aquifer thickness. The groundwater suitability index classified most of the study area (more than 90 %) as “excellent” or “good” suitability zones for irrigation purposes. A limited area of around 5.6 % of the total area has moderate suitability for irrigation purposes due to the Caspian Seawater intrusion and the presence of fossil saline water. The proposed methodology provides useful information in order to allow irrigation management to prevent water and soil deterioration.