Socio-political and ecological stresses on traditional pastoral systems: A review

Journal of Geographical Sciences - Pastoralism is a viable socio-economic system-shaped by landless and agro-pastoral communities in many pastoral regions of the world. This system is mainly based...     

Gulmarg,Kashmir, India: Potential Site for Optical Astronomical Observations

The site characteristics of Gulmarg, Kashmir at an altitude of about 2743.2 m above sea level is based on analysis of meteorological conditions, cloud cover, temperature, wind speed, wind direction, relative humidity and atmospheric pressure, etc. Analysis and characterization of meteorological conditions suggest that Gulmarg, Kashmir is a potential site for carrying out photometric as well as spectroscopic observations of celestial objects.     

Hydrogeochemical assessment of groundwater in Kashmir Valley,India

Groundwater samples (n = 163) were collected across Kashmir Valley in 2010 to assess the hydrogeochemistry of the groundwater in shallow and deep aquifers and its suitability for domestic, agriculture, horticulture, and livestock purposes. The groundwater is generally alkaline in nature. The electrical conductivity (EC) which is an index to represent the total concentration of soluble salts in water was used to measure the salinity hazard to crops as it reflects the TDS in groundwater ranging from 97 to 1385 μS/cm, except one well in Sopore. The average concentration of major ions was higher in shallow aquifers than in deeper aquifers. In general, Ca²⁺ is the dominant cation and HCO \(_{3}^{-}\) the dominant anion. Ca–HCO₃, Mg–HCO₃, Ca–Mg–HCO₃, Na–HCO₃ were the dominant hydrogeochemical facies. High concentration of HCO₃ and pH less than 8.8 clearly indicated that intense chemical weathering processes have taken place in the study area. The groundwater flow pattern in the area follows the local surface topography which not only modifies the hydrogeochemical facies but also controls their distribution. The groundwater in valley flows into four directions, i.e., SW–NE, NE–W, SE-NW and SE–NE directions. The results suggest that carbonate dissolution is the dominant source of major ions followed by silicate weathering and ion-exchange processes. The concentrations of all the major ions determined in the present study are within the permissible limits of WHO and BIS standards. The results of Total Hardness, SAR, Na%, Kelly Index, USDA classification, Magnesium absorption ratio, residual sodium carbonate, and PI suggested that groundwater is good for drinking, livestock, and irrigation purposes.     

Treatment of Hydrodynamic Loading for Random Sea State

- In order to employ cost effective frequency domain analysis for off-shore structures treatment of hydrodynamic loading is essential. Drag and inertia dominated, resonating and antiresonating cases under random sea states are analyzed to highlight the implications and relative merits of four salient linearization techniques.     

Influence of surface and vegetation characteristics on C-band radar measurements for soil moisture content

Soil moisture estimation using microwave remote sensing faces challenges of the segregation of influences mainly from roughness and vegetation. Under static surface conditions, it was found that Radarsat C-band SAR shows reasonably good correlation and sensitivity with changing soil moisture. Dynamic surface and vegetation conditions are supposed to result in a substantial reduction in radar sensitivity to soil moisture. A C-band scatterometer system (5.2 GHz) with a multi-polarization and multi-angular configuration was used 12 times to sense the soil moisture over a tall vegetated grass field. A score of vegetation and soil parameters were recorded on every occasion of the experiment. Three radar backscattering models Viz., Integral Equation Model (IEM), an empirical model and a volume scattering model, have been used to predict the backscattering phenomena. The volume scattering model, using the Distorted Born Approximation, is found to predict the backscattering phenomena reasonably well. But the surface scattering models are expectedly found to be inadequate for the purpose. The temporal variation of soil moisture does show good empirical relationship with the observed radar backscattering. But as the vegetation biomass increases, the radar shows higher sensitivity to the vegetation parameters compared to surface characteristics. A sensitivity analysis of the volume scattering model for all the parameters also reveals that the radar is more sensitive to plant parameters under high biomass conditions, particularly vegetation water content, but the sensitivity to surface characteristics, particularly to soil moisture, is also appreciable.     

Application of various methods for 2D inverse modeling of residual gravity anomalies

This paper presents a neural network approach to determine 2D inverse modeling of a buried structure from gravity anomaly profile. The results of the applied neural network method are compared with the results of two other methods, least-squares minimization and the simple method. Sphere, horizontal cylinder and vertical cylinder and their gravity effects are considered as the synthetic models and the synthetic data, respectively. The synthetic data are also corrupted with noise to evaluate the capability of the methods. Then the Dehloran bitumen map in Iran is chosen as a real data application. Anomaly value of the cross-section, which is taken from the gravity anomaly map of Dehloran bitumen, is very close to those obtained from these methods.     

Household vulnerability and resilience in flood hazards from disaster-prone areas of Punjab,Pakistan

Natural Hazards - An environmental variation has caused Pakistan an alarming portrait of vulnerability in flood disasters. The government has focused on a number of realistic actions, heartening...     

Numerical Prediction of Induced Pressure and Lift of the Planing Surfaces

This paper discusses the numerical prediction of the induced pressure and lift of the planing surfaces in a steady motion based on the potential flow solver as well as the spray drag by use of the practical method.The numerical method for computation of the induced pressure and lift is potential-based boundary element method.Special technique is identified to present upwash geometry and to determine the spray drag.Numerical results of a planing flat plate and planing craft model 4666 are presented.It is shown that the method is robust and efficient and the results agree well with the experimental measurements with various Froude humors.     

Direct CPT and CPTu methods for determining bearing capacity of helical piles

Helical piles are structural deep foundation elements, which can be categorized as torque-driven piles without any limitations to implement in marine situations. Different methods are used to predict the axial capacity of helical piles, such as static analysis, but have some limitation for this type of piles on marine conditions. In situ testing methods as supplement of static analysis have been rarely used for helical piles. In geotechnical engineering practice, the most common in situ tests particularly applicable for coastal or offshore site investigation are cone penetration test (CPT) and piezocone penetration test (CPTu). The CPT is simple, repeatable, and prepares the continuous records of soil layers. In this paper, a data bank has been compiled by collecting the results of static pile load tests on thirty-seven helical piles in ten different sites including CPT or CPTu data. Axial capacities of thirty-seven helical piles in different sites were predicted by direct CPT methods and static analysis. Accuracy estimation of ten direct CPT methods to predict the axial capacity of helical piles was investigated in this study. Comparisons have been made among predicted values and measured capacity from the pile load tests. Results indicated that the recently developed methods such as NGI-05 (2005), ICP-05 (2005), and UWA-05 (2005) predicted axial capacity of helical piles more accurately than the other methods such as Meyerhof (1983), Schmertmann (1978), Dutch (1979), LCPC (1982), or Unicone (1997). However, more investigations are required to establish better correlation between CPT data and axial capacity of helical piles.     

Morphotectonic and lithostratigraphic analysis of intermontane Karewa Basin of Kashmir Himalayas, India

Morpho-tectonic study plays an important role in deciphering the effects of tectonic activity in the geomorphic evolution of the drainage basins.Romushi watershed forms one of the major watersheds of the intermontane Karewa Basin of Kashmir Valley.The Karewa sediments are characterized by glacio-fluvio-lacustrine deposits capped by the aeolian loess.The geomorphic,morphometric and lithostratigraphic studies of these cap deposits have been carried out to elucidate the effect of tectonics on the geomorphic evolution of Romushi Watershed.Geomorphic mapping was carried out using GPS measurements,DEM at 30m resolution,Topographic Position Index(TPI) model,topographic maps,LANDSAT TM Imagery and field data.Morphometric and morphotectonic analyses in GIS environment were used to calculate various geomorphic indices(Mountain Front Sinuosity Index,Bifurcation Ratio,Asymmetry Factor,River Profile,etc).These indices reveal that the tectonic uplift observed in the region due to Himalayan orogeny coupled with mass movement and aeolian deposition have dominated the landscape evolution of intermontane Karewa Basin of Kashmir throughout the Late Quaternary Period.Additional data from lithostratigraphic measurements were analyzed to understand the geomorphic evolution of intermontane Karewa Basin.The data revealed that the basin has experienced differential uplift and erosion rates from time to time in the geological past.This was corroborated by the results from the morphometric and morphotectonic analysis.