Twenty-five uniaxial compression tests were performed to determine stress at onset of dilation, referred to herein as “the crack damage stress,” in heterogeneous dolomites and limestones. A simplified model for crack damage stress (σcd) is developed here using porosity, elastic modulus, Poisson's ratio and three empirical coefficients. The model shows that when porosity decreases and elastic modulus increases, σcd rapidly increases and approaches its maximum value. On the other hand, when porosity increases and elastic modulus decreases, σcd rapidly decreases and approaches its minimum value. The proposed model is validated for six heterogeneous limestone and dolomite formations which are widely distributed in Israel. 相似文献
The permeability of sedimentary rocks during triaxial compression tests was investigated to relate it to the complete strain–stress process. It was found that the permeability was not constant, but varied with the stress and strain states in the rocks. Prior to the peak strength, the permeability decreases with increasing load. A dramatic increase in permeability occurs during the strain softening period. In the present study, in situ measurements of fluid flow and pressure in floor strata was carried out in a double longwall mining face in the Yangzhuang colliery. These measurements show that both the strata pressure and the position with respect to the mining face influence the hydrogeologic properties. The permeability increased in the floor strata behind the mining face because those mining induced fractures opened as the strata pressure decreased. To better understand this change in hydraulic behavior around the mining faces, 3-D numerical modeling was carried out. The model provides the general picture of the stress distribution and failure zone both in the floor and roof strata. The field and model results demonstrate the importance of changes in the stress and strain states on the hydrogeology of a site. 相似文献
The solubility of Ti- and P-rich accessory minerals has been examined as a function of pressure and K2O/Na2O ratio in two series of highly evolved silicate systems. These systems correspond to (a) alkaline, varying from alkaline to peralkaline with increasing K2O/Na2O ratio; and (b) strongly metaluminous (essentially trondhjemitic at the lowest K2O/Na2O ratio) and remaining metaluminous with increasing K2O/Na2O ratio (to 3). The experiments were conducted at a fixed temperature of 1000 °C, with water contents varying from 5 wt.% at low pressure (0.5 GPa), increasing through 5–10 wt.% at 1.5–2.5 GPa to 10 wt.% at 3.5 GPa. Pressure was extended outside the normal crustal range, so that the results may also be applied to derivation of hydrous silicic melts from subducted oceanic crust.
For the alkaline composition series, the TiO2 content of the melt at Ti-rich mineral saturation decreases with increasing pressure but is unchanged with increasing K content (at fixed pressure). The P2O5 content of the alkaline melts at apatite saturation increases with increased pressure at 3.5 GPa only, but decreases with increasing K content (and peralkalinity). For the metaluminous composition series (termed as “trondhjemite-based series” (T series)), the TiO2 content of the melt at Ti-rich mineral saturation decreases with increasing pressure and with increasing K content (at fixed pressure). The P2O5 content of the T series melts at apatite saturation is unchanged with increasing pressure, but decreases with increasing K content. The contrasting results for P and Ti saturation levels, as a function of pressure in both compositions, point to contrasting behaviour of Ti and P in the structure of evolved silicate melts. Ti content at Ti-rich mineral saturation is lower in the alkaline compared with the T series at 0.5 GPa, but is similar at higher pressures, whereas P content at apatite saturation is lower in the T series at all pressures studied. The results have application to A-type granite suites that are alkaline to peralkaline, and to I-type metaluminous suites that frequently exhibit differing K2O/Na2O ratios from one suite to another. 相似文献
The peraluminous tonalite–monzogranite Port Mouton Pluton is a petrological, geochemical, structural, and geochronological anomaly among the many Late Devonian granitoid intrusions of the Meguma Lithotectonic Zone of southern Nova Scotia. The most remarkable structural feature of this pluton is a 4-km-wide zone of strongly foliated (040/subvertical) monzogranites culminating in a narrow (10–30 m), straight, zone of compositionally banded rocks that extends for at least 3 km along strike. The banded monzogranites consist of alternating melanocratic and leucocratic compositions that are complementary to the overall composition of that part of the pluton, suggesting an origin by mineral–melt and mineral–mineral sorting. Biotite and feldspar are strongly foliated in the plane of the compositional bands. These compositional variations and foliations originated by a process of segregation flow during shearing of the main magma with a crystallinity of 55–75%. Subsequent minor brittle fracturing of feldspars, twinning of microcline, development of blocky sub-grains in quartz, and kinking of micas demonstrate overprinting by a high-temperature deformation straddling the monzogranite solidus. Small folds and late sigmoidal dykes indicate dextral movement on the shear zone. This Port Mouton Shear Zone (PMSZ) is approximately co-linear with the only outcrops of Late Devonian mafic intrusions in the area, two of which are syn-plutonic with well-developed mingling textures in the marginal tonalite of the Port Mouton Pluton. Also closely co-linear with the mafic intrusions are a granitoid dyke that extends well beyond the outer contact of the Port Mouton Pluton, a swarm of large aligned angular xenolithic slabs, a zone of thin wispy schlieren banding, a large Be-bearing pegmatite, and a breccia pipe with abundant garnetiferous metapelitic xenoliths. In various ways, the shear zone may control all of these features. The Port Mouton Shear Zone is parallel to many other NE-trending faults and shear zones in the northern Appalachians, probably related to the docking of the Meguma Zone along the Cobequid–Chedabucto Fault system. 相似文献
Diamondiferous Group A eclogites constitute a minor portion of the mantle-derived xenoliths in the eastern Finland kimberlites. They have been derived from the depth interval 150–230 km where they are inferred to occur as thin layers or small pods within coarse-grained garnet peridotites. The chemical and isotopic composition of minerals suggest that they represent (Proterozoic?) mantle-derived melts or cumulates rather than subducted oceanic lithosphere. During magma ascent and emplacement of the kimberlites, the eclogite xenoliths were mechanically and chemically rounded judging from the types of surface markings. In addition, those octahedral crystal faces of diamonds that were partially exposed from the rounded eclogite xenolith became covered by trigons and overlain by microlamination due to their reaction with the kimberlite magma. The diamonds bear evidence of pervasive plastic deformation which is not, however, evident in the eclogite host. This suggests that annealing at ambient lithospheric temperatures has effectively recrystallised the silicates while the diamond has retained its lattice imperfections and thus still has the potential to yield information about ancient mantle deformation. One of our samples is estimated to contain approximately 90,000 ct/ton diamond implying that some diamonds occur within very high-grade pods or thin seams in the lithospheric mantle. To our knowledge, this is one of the most diamondiferous samples described. 相似文献
Summary
A hydro-mechanical testing system, which is capable of measuring both the flow rates and the normal and shear displacement
of a rock fracture, was built to investigate the hydraulic behaviour of rough tension fractures. Laboratory hydraulic tests
in linear flow were conducted on rough rock fractures, artificially created using a splitter under various normal and shear
loading. Prior to the tests, aperture distributions were determined by measuring the topography of upper and lower fracture
surfaces using a laser profilometer. Experimental variograms of the initial aperture distributions were classified into four
groups of geostatistical model, though the overall experimental variograms could be well fitted to the exponential model.
The permeability of the rough rock fractures decayed exponentially with respect to the normal stress increase up to 5 MPa.
Hydraulic behaviours during monotonic shear loading were significantly affected by the dilation occurring until the shear
stress reached the peak strength. With the further dilation, the permeability of the rough fracture specimens increased more.
However, beyond shear displacement of about 7 to 8 mm, permeability gradually reached a maximum threshold value. The combined
effects of both asperity degradation and gouge production, which prohibited the subsequent enlargement of mean fracture aperture,
mainly caused this phenomenon. Permeability changes during cyclic shear loading showed somewhat irregular variations, especially
after the first shear loading cycle, due to the complex interaction from asperity degradations and production of gouge materials.
The relation between hydraulic and mechanical apertures was analyzed to investigate the valid range of mechanical apertures
to be applied to the cubic law.
Received June 12, 2001; accepted February 26, 2002 Published online September 2, 2002 相似文献
Trace element concentrations of altered basaltic glass shards (layer silicates) and zeolites in volcaniclastic sediments drilled in the volcanic apron northeast of Gran Canaria during Ocean Drilling Program (ODP) leg 157 document variable element mobilities during low-temperature alteration processes in a marine environment. Clay minerals (saponite, montmorillonite, smectite) replacing volcanic glass particles are enriched in transition metals and rare earth elements (REE). The degree of retention of REE within the alteration products of the basaltic glass is correlated with the field strength of the cations. The high field-strength elements are preferentially retained or enriched in the alteration products by sorption through clay minerals. Most trace elements are enriched in a boundary layer close to the interface mineral-altered glass. This boundary layer has a key function for the physico-chemical conditions of the subsequent alteration process by providing a large reactive surface and by lowering the fluid permeability. The release of most elements is buffered by incorporation into secondary precipitates (sodium-rich zeolites, phillipsite, Fe- and Mn-oxides) as shown by calculated distribution coefficients between altered glasses and authigenic minerals. Chemical fluxes change from an open to a closed system behavior during prograde low-temperature alteration of volcaniclastic sediments with no significant trace metal flux from the sediment to the water column. 相似文献
. Naphthalenesulfonates and their condensation products with formaldehyde are manufactured in the chemical industry for broad application as tanning agents, dispersing agents, and as superplasticizers for concrete. With the disposal of waste they have found their way into the aquatic environment. Five monomeric naphthalenesulfonates and a group of dimeric sulfonated naphthalene-formaldehyde condensates (SNFC) were identified in the leachate and in groundwater observation wells downstream in the plume of the Karlsruhe-West landfill, situated in the Upper Rhine Valley in southwest Germany. For the main monomer of technical SNFC products, 2-naphthalenesulfonate (2-NS), the concentration in the leachate was 170 µg l1, which decreased to 9.5 µg l1 at a distance of about 300 m from the boundary of the landfill. In the Merdingen tracer test field, the transport of these compounds was studied under more controlled conditions in two tracer experiments with (1) two model compounds, and (2) a technical SNFC product and uranine as a reference tracer. In these experiments, the monomeric naphthalenesulfonates and the SNFC with n=2 behave as conservative tracers. Thus, the findings of the landfill study were supported by these results. Higher molecular SNFC were strongly retarded, which is attributed to adsorption to soil particles. The results of the second tracer experiment suggest a degradation of 2-NS and 2,6-naphthalenedisulfonate (2,6-NDS) after adaptation of the microorganisms in the groundwater aquifer as a consequence of the first tracer experiment. 相似文献
A tandem deployment system was used to critically evaluate relationships between important water chemistry parameters (pH, salinity, dissolved oxygen) and biotic performance based on clam growth. The effects of environmental conditions on growth of juvenile clams,Mercenaria mercenaria, were determined after 7-day field deployments in cages at reference sites from 1998 to 2000. Continuous measurements of the overlying water chemistry parameters were monitored by deploying an in situ water quality instrument (Hydrolab Datasonde) at the same time. While salinity was identified as an important determinant of clam growth over wide salinity ranges (10–35‰), pH was also found to be a very important parameter, especially in low-salinity regimes (<25‰). Average pH measurements ranged from 7.2 to 7.8; minimal pHs ranged from 6.9 to 7.6. The results indicated that when average pH levels fell below 7.5 or minimum pH levels fell below 7.2, growth rates were <50% that of clams deployed under higher pH conditions. Estuarine systems are generally perceived as being well-buffered so pH is frequently assumed to be unimportant, but our results suggest that pH levels can decline in estuarine systems to levels that can adversely affect biological responses. The potential impacts on biological resources of even moderate decreases in pH, particularly in systems that naturally tend to have lower pH conditions, may be more important than previously realized. 相似文献
Fluxes of particulate organic carbon (POC) through the oxygen deficient waters in the eastern tropical North Pacific were found to be relatively less attenuated with depth than elsewhere in the eastern North Pacific. The attenuation coefficient (b) for the flux was found to be 0.40 versus the composite value of 0.86 determined by Martin et al. (1987). To examine this further, sinking POC was collected using sediment traps and allowed to degrade in oxic and suboxic experiments. Using a kinetic model, it was found that degradation proceeded at similar rates (roughly 0.8 day−1) under oxic and suboxic conditions, but a greater fraction of bulk POC was resistant to degradation in the suboxic experiments (61% vs. 23%). Amino acids accounted for 37% of POC collected at 75m, but following degradation the value dropped to 17% and 16% in the oxic and suboxic experiments respectively. POC collected from 500m was 10% amino acids. The non-AA component of POC collected at 75m was not degraded under suboxic conditions, while under oxic conditions it was. These results suggest that microbes degrading OC under suboxic conditions via denitrification preferentially utilize nitrogen-rich amino acids. This preferential degradation of amino acids suggests that 9% more nitrogen may be lost via water column denitrification than is accounted for when a more “Redfieldian” stoichiometry for POC is assumed. 相似文献