New active galactic nuclei among the INTEGRAL and SWIFT X-ray sources

We present the results of our optical identifications of a set of X-ray sources from the INTEGRAL and SWIFT all-sky surveys. The optical data have been obtained with the 1.5-m Russian-Turkish Telescope (RTT-150). Nine X-ray sources have been identified with active galactic nuclei (AGNs). Two of them are located in the nearby spiral galaxies MCG-01-05-047 and NGC 973 seen almost edge-on. One source, IGR J16562-3301, is probably a BL Lac object (blazar). The remaining AGNs are observed as the starlike nuclei of spiral galaxies whose spectra exhibit broad emission lines. The relation between the hard X-ray (17–60 keV) luminosity and the [O III] 5007 line luminosity, log L _x/L _{[O III]} ≈ 2.1, holds good for most of the AGNs detected in hard X rays. However, the luminosities of some AGNs deviate from this relation. The fraction of such objects can reach ～20%. In particular, the [O III] line flux is lower for two nearby edge-on spiral galaxies. This can be explained by the effect of absorption in the galactic disks.     

Biochemical study of the gonads of Mystus vittatus exposed to the fertilizer NPK during the spawning season. Part 1: Carbohydrates

The gonads of spawning Mystus vittatus exposed for 96 h to the LC₅₀-96 h dose (i.e. 550 ppm) of NPK, the agricultural fertilizer, were biochemically analysed for their carbohydrate content. The glucose and glycogen contents of the spawning fish were found to be lowered significantly, and the total carbohydrate and lactic acid contents altered insignificantly, under the pollutional stress. The stressed fish also exhibited the presence of some additional free sugars within their gonads.     

Trace elements in organic- and iron-rich surficial fluids of the boreal zone: Assessing colloidal forms via dialysis and ultrafiltration

On-site size fractionation of about 40 major and trace elements (TE) was performed on waters from boreal small rivers and their estuaries in the Karelia region of North-West Russia around the “Vetreny Belt” mountain range and in Paanajärvi National Park (Northern Karelia). Samples were filtered in the field using a progressively decreasing pore size (5 μm, 2.5 (3) μm, 0.22 (0.45) μm, 100 kDa, 10 and 1 kDa) by means of frontal filtration and ultrafiltration (UF) techniques and employing in-situ dialysis with 10 and 1 kDa membranes followed by ICP-MS analysis. For most samples, dialysis yields a systematically higher (factor of 2-3) proportion of colloidal forms compared to UF. Nevertheless, dialysis is able to provide a fast and artefact-free in-situ separation of colloidal and dissolved components.Similar to previous studies in European subarctic zones, poor correlation of iron concentration with that of organic carbon (OC) in (ultra)filtrates and dialysates reflect the presence of two pools of colloids composed of organic-rich and Fe-rich particles. All major anions and silica are present as dissolved species (or solutes) passing through the 1-kDa membrane. Size-separation ultrafiltration experiments show the existence of larger or smaller pools of colloidal particles different for each of the considered elements.The effect of rock lithology (acidic versus basic) on the colloidal speciation of TE is seen solely in the increase of Fe and some accompanying TE concentrations in catchment areas dominated by basic rocks compared to granitic catchments. Neither the ultrafiltration pattern nor the relative proportions of colloidal versus truly dissolved TE are affected by the lithology of the underlying rocks: within ±10% uncertainty, the two colloidal (10 kDa-0.22 μm and 1-10 kDa) and the truly dissolved (<1 kDa) pools show no difference in percentage of TE distribution between two types of bedrock lithology. The same conclusion is held for organic- and Fe-rich waters. In contrast, landscape context analysis demonstrated slight dominance, for most TE affected by UF, of large-size colloids (10 kDa-0.22 μm) in rivers and streams and small-size colloids and truly dissolved fractions in swamp stagnant surface waters. This supports the existence of two pathways of colloids formation: during the plant litter degradation in wetland zones and at the redox front in river riparian zone.     

Soil-structure interaction experiment using impulse response

A new experimental method using a finite soil model with no special treatement on its boundaries is employed for soil-structure intration problems to simulate the semi-infinitenesss of the actual soil medium. The present method utlizies the characteristics of transient response to an impluse load to obtain the impedance functions and effective input motions for surface and embedded foundations. This technique is applicable to a linear elastic system whose impulse response decreases to a small enough value before observing the reflected waves. The experimentally obtained impedance functions and effective input motions are compared with those obtained by the direct boundary integral equation method and the hybrid approach. Good agreement between the xperimental and analytical results validates the present method as well as the accuracy of the numerical tools.     

Potentiality of Paleocene source rocks and their contribution in generating the accumulated oil in the Eocene Pila Spi Reservoir in Taq Taq Oil Field, Kurdistan Region, Iraq

The organic matters within the Paleocene Aaliji and Kolosh Formations in the well TT-04, Taq Taq Oil Field in Kurdistan Region, NE Iraq have been studied optically and also analytically by means of pyrolysis, Gas Chromatography (GC), and Gas Chromatography/Mass Spectrometry (GC/MS). Amorphous organic matters seemed to be the dominant component of the extracted organic matters within the studied section with an obvious increase of the Phytoclasts at the upper part of Kolosh Formation. Thermal Alteration Index, vitrinite reflectance, pyrolysis, and gas chromatography data all indicated the maturity of the lower part from the studied layers (known generally as Aaliji/Kolosh) and within the early stages of oil generation. Oil–source correlation indicates the possibility of contribution of the Paleocene source rocks in generating the accumulated oil in the Eocene Pila Spi reservoir in the field which also appeared to be a mature and of marine-to-mixed carbonate source. Oil–oil correlation between the oil in Pila Spi and the oil in the Upper Cretaceous reservoirs showed the possibility of existence of more than one source for the two oils. GC/MS analysis for the Pila Spi oil indicated the effect of biodegradation which may be considered as one of the reasons for being the American Petroleum Institute (API) of this oil about 24° while the oil in the Cretaceous reservoirs is of more than 47° API.     

Real-time risk assessment in seismic early warning and rapid response: a feasibility study in Bishkek (Kyrgyzstan)

Earthquake early warning systems (EEWS) are considered to be an effective, pragmatic, and viable tool for seismic risk reduction in cities. While standard EEWS approaches focus on the real-time estimation of an earthquake’s location and magnitude, innovative developments in EEWS include the capacity for the rapid assessment of damage. Clearly, for all public authorities that are engaged in coordinating emergency activities during and soon after earthquakes, real-time information about the potential damage distribution within a city is invaluable. In this work, we present a first attempt to design an early warning and rapid response procedure for real-time risk assessment. In particular, the procedure uses typical real-time information (i.e., P-wave arrival times and early waveforms) derived from a regional seismic network for locating and evaluating the size of an earthquake, information which in turn is exploited for extracting a risk map representing the potential distribution of damage from a dataset of predicted scenarios compiled for the target city. A feasibility study of the procedure is presented for the city of Bishkek, the capital of Kyrgyzstan, which is surrounded by the Kyrgyz seismic network by mimicking the ground motion associated with two historical events that occurred close to Bishkek, namely the 1911 Kemin (M?=?8.2; ±0.2) and the 1885 Belovodsk (M?=?6.9; ±0.5) earthquakes. Various methodologies from previous studies were considered when planning the implementation of the early warning and rapid response procedure for real-time risk assessment: the Satriano et al. (Bull Seismol Soc Am 98(3):1482–1494, 2008) approach to real-time earthquake location; the Caprio et al. (Geophys Res Lett 38:L02301, 2011) approach for estimating moment magnitude in real time; the EXSIM method for ground motion simulation (Motazedian and Atkinson, Bull Seismol Soc Am 95:995–1010, 2005); the Sokolov (Earthquake Spectra 161: 679–694, 2002) approach for estimating intensity from Fourier amplitude spectra; and the Tyagunov et al. (Nat Hazard Earth Syst Sci 6:573–586, 2006) approach for risk computation. Innovatively, all these methods are jointly applied to assess in real time the seismic risk of a particular target site, namely the city of Bishkek. Finally, the site amplification and vulnerability datasets considered in the proposed methodology are taken from previous studies, i.e., Parolai et al. (Bull Seismol Soc Am, 2010) and Bindi et al. (Soil Dyn Earthq Eng, 2011), respectively.     

Geotechnical aspects of fine-grained mass flow deposits: California Continental Borderland

Seismic reflection profiling demonstrates the importance of mass movement in the north-central California Borderland. Bulk properties of surficial hemipelagic sediments in the Santa Barbara, Santa Cruz, and San Nicolas basins show that different types of mass-transported sediments have different properties, although their general sedimentologic characteristics are very similar. Slump deposits have moderate water contents (48% wet weight basis), high plasticity indices (46%), and moderate activities (1.6). For debris flows these values are low: 28%, 5%, and 0.3, respectively, and for other types (liquefied flow, mudflows, and turbidities) the values are high: 54 to 63%, 49 to 58%, and 1.2 to 1.5, respectively.     

Shape optimization of two-dimensional cavitators in supercavitating flows, using NSGA II algorithm

The reduction of energy consumption of high speed submersible bodies is an important challenge in hydrodynamic researches. In this paper, shape optimization of two-dimensional cavitators in supercavitating flows is studied. A two dimensional supercavitation potential flow passes a symmetric two dimensional cavitator, which is placed perpendicular to the flow in a channel of infinite length and immediately a cavity is formed behind the cavitator. This is because of the generation of a gas or vapor cavity between the body and the surrounding liquid due to the change in a high speed flow direction passing the cavitator. Drag force acting on this supercavitating body dictates the thrust requirements for the propulsion system, to maintain a required cavity at the operating speed. Therefore, any reduction in the drag force, by modifying the shape of the cavitator, will lead to decrease this force. This study concentrates on the optimization of two dimensional cavitators in order to decrease drag coefficient for a specified after body length and velocity in a potential flow. To achieve this goal a multi-objective optimization problem is defined to optimize cavitator shapes in supercavitating flow. The so-called NSGA II (Non-dominated Sorting Genetic Algorithm) algorithm is used as an optimization method. Design parameters and constraints are obtained according to supercavitating flow characteristics and cavitator modeling and objective functions are generated using Linear Regression Method. The obtained results are compared with other classic optimization methods, like the weighted sum method, for validation.     

Cone-penetrometer exploration of Sinkholes: Stratigraphy and soil properties

Four sinkholes with varying surficial expressions were subjected to detailed stratigraphic and soil analysis by means of Standard Penetration Tests (SPT) and Electric Friction Cone Penetration Tests (CPT) in order to evaluate applications of CPT to sinkhole investigations. Although widely used, SPT data are of limited value and difficult to apply to sinkhole mapping. CPT is sensitive to minor lithologic variability and is superior to SPT as a cost-effective technique for determining geotechnical properties of sinkholes. The effectiveness of CPT data results from the force measurements made along the sleeve of the cone. The friction ratio (ratio of sleeve to tip resistance) is a good indicator of soil stratigraphy and properties. By smoothing the friction-ratio data, general stratigraphy and changes in soil properties are easily identified. Stratigraphy of the sinks has been complicated by intense weathering, karstification and marine, transgressions. The resulting deposits include five stratigraphic units. I and II represent Plio-Pleistocene marine sediments with Unit II being the zone of soil clay accumulation. III and IV are horizons residual from Miocene strata and indicate an episode of karstification prior to deposition of Units I and II. Conduit fill is a mixture of materials with low cohesion. The fill materials indicate centripetal and downward movement of insoluble sediments derived from the surrounding strata. Loss of cohesion results in near-zero friction ratios. Very low friction ratios, coupled with materials with little cohesion, indicate potentially-liquefiable soils in the immediate vicinity of zones where piping failure may be imminent. SPT does not provide sufficient data to predict these zones of potential, failure. CPT provides sufficient information for recognition of sinkhole stratigraphy and geotechnical properties. When coupled with laboratory soil analysis, CPT provides unique information about sinkhole geometry and dynamics. In contrast, SPT data fail to produce consistent indicators of sinkhole stratigraphy or properties. With laboratory soil data, SPT indicates general, inconclusive trends.