Reef exploration in the East Sengkang Basin,Sulawesi, Indonesia

Reconnaissance seismic shot in 1971/72 showed a number of well defined seismic anomalies within the East Sengkang Basin which were interpreted as buried reefs. Subsequent fieldwork revealed that Upper Miocene reefs outcropped along the southern margin of the basin. A drilling programme in 1975 and 1976 proved the presence of shallow, gas-bearing, Upper Miocene reefs in the northern part of the basin. Seismic acquisition and drilling during 1981 confirmed the economic significance of these discoveries, with four separate accumulations containing about 750 × 10⁹ cubic feet of dry gas in place at an average depth of 700 m. Kampung Baru is the largest field and contains over half the total, both reservoir quality and gas deliverability are excellent. Deposition in the East Sengkang Basin probably started during the Early Miocene. A sequence of Lower Miocene mudstones and limestones unconformably overlies acoustic basement which consists of Eocene volcanics. During the tectonically active Middle Miocene, deposition was interrupted by two periods of deformation and erosion. Carbonate deposition became established in the Late Miocene with widespread development of platform limestones throughout the East Sengkang Basin. Thick pinnacle reef complexes developed in the areas where reef growth could keep pace with the relative rise in sea level. Most reef growth ceased at the end of the Miocene and subsequent renewed clastic sedimentation covered the irregular limestone surface. Late Pliocene regression culminated in the Holocene with erosion. The Walanae fault zone, part of a major regional sinistral strike-slip system, separates the East and West Sengkang Basins. Both normal and reverse faulting are inferred from seismic data and post Late Pliocene reverse faulting is seen in outcrop.     

Multiple longshore sand bars in the upper Chesapeake Bay

In the upper Chesapeake Bay (Maryland, U.S.A.) field surveys were conducted at 18 multiple longshore sand bar sites. The multiple bar systems were found in water depths less than approximately 2 m (mean sea level), and exhibited mild bottom slopes of 0·0052 or less. The number of bars composing each system ranged from four to 17 and the spacing between the crests typically increased in the offshore direction, ranging from 12 to 70 m. Bar height also typically increased with distance offshore and ranged from 0·03 to 0·61 m. A grain size analysis of crest and trough sediment did not reveal any significant differences and the sediment was categorized as ‘fine sand’. A review of the literature data indicated that the Chesapeake Bay multiple bars possessed similar characteristics to those found in Gelding Bay (Baltic Sea); similarities in fetch, wave height and tidal range between the two bays may account for this finding. The surf-scaling parameter indicated that the multiple bar systems were extremely dissipative with regard to wave energy, and wave height appeared to be an important factor in controlling bar spacing and bar height. A multiple wave break point hypothesis was discussed as a possible mechanism for the formation of Chesapeake Bay multiple longshore bars, and limited observational evidence appeared to support such a mechanism.     

Sonar cross sections of bodies partially insonified by finite sound beams

An object that is partially insonified by a collimated sound beam may have a scattering cross section sometimes much larger than when the object is totally covered by the incident beam. We quantitatively study this partial insonification problem here, under the classical method of physical optics. The importance of this study stems from the fact that partial coverage of the target by the beam is the situation most likely to occur in many cases of practical importance. We consider several basic target shapes partially insonified by finite beams. These shapes include the spherical, the infinite and finite cylinder, the flat plate, and the capped sphere. High-frequency approximations of the resulting integrals, obtained by means of the saddle-point method, show the relative importance of the scattering centers located at the beam's specular reflection points, or at the edges of the spots that the beam shines on the scatterers. The physical-optics method is extended to obtain formulas for the bistatic cross sections of partially insonified objects. The results are numerically evaluated and graphically displayed in many pertinent instances and compared to the predictions of approaches, such as the Fresnel-zones method and the Geometrical Theory of Diffraction (GTD). The predictions of the physical-optics method have all the advantages and deficiencies of this method and, with very minor modifications, hold equally well for the partial illumination of objects by beams of electromagnetic radiation.     

Porphyroblast inclusion-trail orientation data: eppure non son girate*!

Extensive examination of large numbers of spatially orientated thin sections of orientated samples from orogens of all ages around the world has demonstrated that porphyroblasts do not rotate relative to geographical coordinates during highly non-coaxial ductile deformation of the matrix subsequent to their growth. This has been demonstrated for all tectonic environments so far investigated. The work also has provided new insights and data on metamorphic, structural and tectonic processes including: (1) the intimate control of deformation partitioning on metamorphic reactions; (2) solutions to the lack of correlation between lineations that indicate the direction of movement within thrusts and shear zones, and relative plate motion; and (3) a possible technique for determining the direction of relative plate motion that caused orogenesis in ancient orogens.     

Rare earth, major and trace elements in Jurassic manganese shales of the Northern Calcareous Alps: hydrothermal versus hydrogenous origin of stratiform manganese deposits

Summary ?The rare earth, major and trace element geochemistry of Jurassic deep marine manganese shales allow insight into their environment of deposition. We present data of 24 samples from the Northern Calcareous Alps (Eastern Alps), collected from Late Jurassic strata of the Tennengebirge and from Early Jurassic strata of the Karwendel Mts. Whereas major and trace element geochemistry is controlled by the detrital input, rare earth element data and the relationship between total organic carbon and (pyritic) sulfur can be used to constrain the origin of the manganese accumulation. The data of this study are compatible with a hydrogenous precipitation of manganese by strongly varying redox-conditions at the sediment–water interface of a slope basin. Received December 21, 2001; revised version accepted February 18, 2002     

Tephrochronology and tephrostratigraphy of two Pleistocene continental fossiliferous successions from central Italy

The stratigraphical context of two Middle Pleistocene fossiliferous palaeosols from Central Italy (Abruzzo and Tuscany) have been studied. Small mammals and molluscs occur in both palaeosols, which are covered by tephra layers that were analysed using an interdisciplinary approach. Application of fission‐track dating to apatites separated from the Case Picconetto tephra (Pescara, Abruzzo), yielded an age of 0.48 ± 0.04 Ma, indistinguishable from those previously determined for the Campani Quarry (Lower Valdarno, Tuscany) (0.46 ± 0.05 Ma and 0.48 ± 0.05 Ma). Geochemical and petrographic investigations indicate that these tephra originated from different volcanoes, the Alban Hills Volcanic Complex and the Vico Volcano (Latium) respectively. Small mammal and mollusc assemblages indicate different palaeoclimatic and palaeoenvironmental conditions for the Case Picconetto and Campani Quarry palaeosols. Warm and humid conditions can be inferred for the Campani Quarry site, whereas open and cold conditions can be inferred for Case Picconetto. On the basis of faunal data, fission‐track dates and attribution of tephra to specific volcanic eruptions, we suggest a correlation of these faunas with marine oxygen isotope stage 14 (Case Picconetto) and with marine oxygen isotope stage 11 (Campani Quarry), respectively. Copyright © 2003 John Wiley & Sons, Ltd.     

Bond rolling resistance and its effect on yielding of bonded granulates by DEM analyses

A discrete element modelling of bonded granulates and investigation on the bond effect on their behaviour are very important to geomechanics. This paper presents a two‐dimensional (2‐D) discrete element theory for bonded granulates with bond rolling resistance and provides a numerical investigation into the effect of bond rolling resistance on the yielding of bonded granulates. The model consists of mechanical contact models and equations governing the motion of bonded particles. The key point of the theory is that the assumption in the original bond contact model previously proposed by the authors (55th CSCE‐ASCE Conference, Hamilton, Ont., Canada, 2002; 313–320; J. Eng. Mech. (ASCE) 2005; 131 (11):1209–1213) that bonded particles are in contact at discrete points, is here replaced by a more reliable assumption that bonded particles are in contact over a width. By making the idealization that the bond contact width is continuously distributed with the normal/tangential basic elements (BE) (each BE is composed of spring, dashpot, bond, slider or divider), we establish a bond rolling contact model together with bond normal/tangential contact models, and also relate the governing equations to local equilibrium. Only one physical parameter β needs to be introduced in the theory in comparison to the original bond discrete element model. The model has been implemented into a 2‐D distinct element method code, NS2D. Using the NS2D, a total of 86 1‐D, constant stress ratio, and biaxial compressions tests have been carried out on the bonded granular samples of different densities, bonding strengths and rolling resistances. The numerical results show that: (i) the new theory predicts a larger internal friction angle, a larger yielding stress, more brittle behaviour and larger final broken contact ratio than the original bond model; (ii) the yielding stress increases nonlinearly with the increasing value of β, and (iii) the first‐yield curve (initiation of bond breakage), which define a zone of none bond breakage and which shape and size are affected by the material density, is amplified by the bond rolling resistance in analogous to that predicted by the original bond model. Copyright © 2006 John Wiley & Sons, Ltd.     

Modelling of deformation response and chemo‐mechanical coupling in chalk

A constitutive relation is derived for describing the mechanical response of chalk. The approach is based on a phenomenological framework which employs chemo‐plasticity. The properties of the material are assumed to be affected by the physico‐chemical processes that occur through the interaction between the skeleton and the pore fluid. The underlying mechanism is discussed by invoking a micromechanical analysis. The performance of the framework is illustrated by examining the evolution of mechanical characteristics in the presence of different pore fluids. Copyright © 2006 John Wiley & Sons, Ltd.