Characterization of interface roughness of rippled sand off Fort Walton Beach, Florida

As part of the environmental characterization to model acoustic bottom scattering during the high-frequency sediment acoustics experiment (SAX99), fine-scale sediment roughness of a medium sand was successfully measured within a 600 /spl times/ 600-m area by two methods: stereo photography and a technique using a conductivity system. Areal coverage of the two methods, representing approximately 0.16 m/sup 2/ of the sea floor, was comparable, resulting in the depiction and quantification of half-meter wavelength sand ripples. Photogrammetric results were restricted to profiles digitized at 1-mm intervals; sediment conductivity results generated gridded micro-bathymetric measurements with 1- to 2-cm node spacing. Roughness power spectra give similar results in the low-spatial-frequency domains where the spectra estimated from both approaches overlap. However, spectra derived from higher resolution photogrammetric results appear to exhibit a multiple-power-law fit. Roughness measurements also indicate that spectrum changes as a function of time. Application of statistical confidence bounds on the power spectra indicates that roughness measurements separated by only 1-2 m may be spatially nonstationary.     

The dynamic method of calculating currents and analysis of the vertical kinematic structure

The basic relations of the classical dyamic method have been complemented with the condition allowing for the non-monotonicity of the vertical kinematic structure. The elements of the multi-layered system of geostrophic currents have been found to correlate over depth with seawater density and hydrostatic pressure distribution. An example of the analysis of the vertical structure of currents, involving specific hydrological data, is given. Translated by Vladimir A. Puchkin.     

The effects of oil exploration and production in the northern North Sea: Part 2—microbial biodegradation of hydrocarbons in water and sediments, 1978–1981

The potential of heterotrophs to degrade aromatic hydrocarbons derived from oil in water and sediments in the northern North Sea around the Brent, Beryl, Forties and Murchison oilfields and at a number of stations, from the Forties field to the Firth of Forth, was estimated using 1-¹⁴C naphthalene and 7, 10-¹⁴C benzo(a)pyrene. The degradation of uniformly labelled ¹⁴C mixed 1-amino acids was used as a measure of total heterotrophic activity. Results showed that microorganisms have the potential to degrade the smaller aromatic hydrocarbon molecules rapidly in the water column and in surface sediments. Close to the Beryl platform, where diesel-washed drill cuttings have been continuously dumped, the rate of input of hydrocarbons to the sediment has exceeded the rate of degradation. Mineralization of benzo(a)pyrene, estimated in the sediments only, was minimal. Close to production platforms the biodegradation rate of mixed 1-amino acids showed no increase comparable with that found for naphthalene, suggesting that existing microbial populations had not increased but adapted to degrade oil in water and sediments.     

Effect of shallow and narrow water on added mass of cylinders with various cross-sectional shapes

The sway, heave and roll added masses of three uniform cylinders with semi-circular, rectangular and triangular cross-sectional shapes in shallow and narrow water are numerically analysed. The method is based on simulation of the potential flow induced by the cylinder's mode of motion. The effects of shallow and narrow water on added mass are analysed and presented. It is concluded that the shallow and narrow water effects on added mass depend on the different cross-section shapes of the cylinders. In particular, the water depth effect on sway added mass is stronger than that on heave added mass while the narrow water effect on sway is weaker than that on heave. The shallow water effect on added mass tends to weaken the narrow water effect. Lastly the effect of shallow and narrow water on added mass on a rectangular cylinder is the strongest while that on a triangular cylinder is the weakest.     

Sample Disturbance in Soft and Sensitive Clays: Analysis and Assessment

Despite the sophisticated methods employed to obtain high quality samples, they are prone to disturbance, due to stress release, let apart, due to sampling tools and techniques adopted. Critical reappraisal of different methods suggest that any method of sample quality assessment involving strength and deformation parameters would enable easier implementation and correct other engineering parameters for estimated sample disturbance. In this technical paper, sample disturbance index, using merely the slopes of compression paths, (representing mechanical response), in the pre- and post-yield stress regimes under odeometric loading conditions is proposed. This method is based on single oedometer test results on samples of unknown degrees of disturbance during sampling and handling. The unique feature of this approach is that the ideal rigid plastic material behavior is taken as reference. This eliminates the need for any additional experimental data or any calculations from the relationships formulated with any set of assumptions.     

Recent and Late Holocene environments on the southeastern shelf of the Laptev Sea as inferred from microfossil data

The study of diatoms and benthic foraminifers from the southeastern shelf of the Laptev Sea shows that their most diverse and abundant recent assemblages populate the peripheral underwater part of the Lena River delta representing the marginal filter of the sea. This area is characterized by an intense interaction between the fresh waters of the Siberian rivers and the basin seawater, the Atlantic one included. Local Late Holocene (～last 2300 years) environments reflect the main regional and global paleoclimatic changes, the Medieval Warm Period (～600–1100 years B.P.) and the Little Ice Age (～100–600 years B.P.) inclusive. In addition, the composition and distribution of planktonic foraminifers implies a strong influence of the Atlantic water during the Holocene optimum ～5100–6200 years B.P.     

Wave runup on a concentric twin perforated circular cylinder

The regular wave interaction with a twin concentric porous circular cylinder system consisting of an inner impermeable cylinder and an outer perforated cylinder was studied through physical model and numerical model studies. The experiments were carried out on the twin concentric cylinder model in a wave flume to study the wave runup and rundown at the leading and trailing edges of the perforated cylinder. It was found that the maximum wave runup on the perforated cylinder is almost same as the incident wave height. The experimental results were used to develop the predictive formulae for the wave runup and rundown on the perforated cylinder, which can be easily used for design applications. The wave runup profiles around the perforated cylinder for different values of ka and porosities were studied numerically using Green's Identity Method. The results of the numerical study are presented and compared with the experimental measurements.