Carbonate sedimentation in seagrass beds on Ishigaki‐jima,Ryukyu Islands,southwestern Japan

In order to investigate biota and sedimentary facies, and to delineate processes of carbonate sedimentation in seagrass beds, we conducted sedimentological investigations along three onshore–offshore transects at two sites (Nagura and Yoshihara) on Ishigaki‐jima, Ryukyu Islands. Along the transects, the seagrass beds extended seaward 20–40 m from shore, and their widths parallel to the shore ranged from 60 to >110 m. The seagrass was dominated by Thalassia hemprichii, Cymodocea rotundata and subordinate C. serrulata. Seasonal changes in seagrass coverage were evident, with mean coverage relatively higher in summer and fall (July and October) than in winter and spring (January and April). The surface sediment throughout the seagrass beds was dominated by medium to very coarse sand‐sized bioclasts displaying grainstone/packstone fabrics. Bioclasts were dominated by corals and coralline algae, with lesser benthic foraminifers, mollusks, echinoids, and Halimeda. The grainstone/packstone was underlain by gravelly sediment with coral clasts, showing a rudstone fabric, at the Nagura Site. The lower part of the core sediment was blackened, indicating a reducing environment. Two dates of corals collected at the Nagura and Yoshihara sites (24.5 cm and 16.5 cm below the sea bottom) were 2781–2306 and 4374–3805 cal BP (2σ age range), respectively, suggesting extremely low sedimentation rates (<0.1 mm/year). Sediment influx was higher during July–January than during January–July. The relatively large influx during summer and fall is caused by massive sediment transport during typhoons and storms. The total sediment influx (i.e., suspension‐load sediment transportation) is 74–96 kg CaCO₃/m²/year at the Nagura Site and 21–57 kg CaCO₃/m²/year at the Yoshihara Site. Sediment influx was significantly greater in the seagrass beds than in surrounding areas, providing supporting evidence for an sediment trapping function of seagrass beds. Our data indicate that seagrass beds in the Ryukyu Islands are characterized by high sediment fluxes and extremely low sedimentation rates.     

PDF orientations in shocked quartz grains around the Chicxulub crater

Abstract— We measured 852 sets of planar deformation features (PDFs) in shocked quartz grains in impactite samples of the Yaxcopoil (YAX‐1) core and from 4 Cretaceous/Tertiary (K/T) boundary deposits: the Monaca, the Cacarajícara, and the Peñalver formations in Cuba, and DSDP site 536, within 800 km of the Chicxulub crater, in order to investigate variations of PDF orientations in the proximity of the crater. Orientations of PDFs show a broad distribution with peaks at ω {101¯3}, π {101¯2}, and ω {111¯2}, plus r, z {1011¯} orientations with minor c(0001), s{112¯1}, t{224¯1} plus x{516¯1}, and m{101¯0} plus a{112¯0} orientations. Planar deformation features with c(0001) orientation are relatively more abundant in the proximity of the Chicxulub crater than in distal sites such as North America, the Pacific Ocean, and Europe. This feature indicates that in the proximity of the crater, part of the shocked quartz grains in the K/T boundary deposits were derived from the low shock pressure zones. Moreover, the orientations of PDFs with ω {112¯2} plus r, z {101¯1} are high in our studied sites, and frequencies of these orientations decrease with increasing distance from the crater. On the other hand, absence of c(0001) and the rare occurrence of PDFs with ?ω {112¯2} plus r, z {101¯1} orientations in the sample from the YAX‐1 core that was taken at the top of the impactite layer of the Chicxulub crater suggests that the sampling horizon that reflects a certain cratering stage is also an important factor for variations in shocked quartz.     

Geometry of the Nojima Fault at Nojima-Hirabayashi, Japan – I. A Simple Damage Structure Inferred from Borehole Core Permeability

The 1995 Kobe (Hyogo-ken Nanbu) earthquake, M = 7.2, ruptured the Nojima fault in southwest Japan. We have studied core samples taken from two scientific drillholes that crossed the fault zone SW of the epicentral region on Awaji Island. The shallower hole, drilled by the Geological Survey of Japan (GSJ), was started 75 m to the SE of the surface trace of the Nojima fault and crossed the fault at a depth of 624 m. A deeper hole, drilled by the National Research Institute for Earth Science and Disaster Prevention (NIED) was started 302 m to the SE of the fault and crossed fault strands below a depth of 1140 m. We have measured strength and matrix permeability of core samples taken from these two drillholes. We find a strong correlation between permeability and proximity to the fault zone shear axes. The half-width of the high permeability zone (approximately 15 to 25 m) is in good agreement with the fault zone width inferred from trapped seismic wave analysis and other evidence. The fault zone core or shear axis contains clays with permeabilities of approximately 0.1 to 1 microdarcy at 50 MPa effective confining pressure (10 to 30 microdarcy at in situ pressures). Within a few meters of the fault zone core, the rock is highly fractured but has sustained little net shear. Matrix permeability of this zone is approximately 30 to 60 microdarcy at 50 MPa effective confining pressure (300 to 1000 microdarcy at in situ pressures). Outside this damage zone, matrix permeability drops below 0.01 microdarcy. The clay-rich core material has the lowest strength with a coefficient of friction of approximately 0.55. Shear strength increases with distance from the shear axis. These permeability and strength observations reveal a simple fault zone structure with a relatively weak fine-grained core surrounded by a damage zone of fractured rock. In this case, the damage zone will act as a high-permeability conduit for vertical and horizontal flow in the plane of the fault. The fine-grained core region, however, will impede fluid flow across the fault.     

Evidence for ocean water invasion into the Chicxulub crater at the Cretaceous/Tertiary boundary

Abstract— The possibility of ocean water invasion into the Chicxulub crater following the impact at the Cretaceous/Tertiary boundary was investigated based on examination of an impactite between approximately 794.63 and 894.94 m in the Yaxcopoil‐1 (Yax‐1) core. The presence of cross lamination in the uppermost part of the impactite suggests the influence of an ocean current at least during the sedimentation of this interval. Abundant occurrence of nannofossils of late Campanian to early Maastrichtian age in the matrices of samples from the upper part of the impactite suggests that the carbonate sediments deposited on the inner rim margin and outside the crater were eroded and transported into the crater most likely by ocean water that invaded the crater after its formation. The maximum grain size of limestone lithics and vesicular melt fragments, and grain and bulk chemical compositions show a cyclic variation in the upper part of the impactite. The upward fining grain size and the absence of erosional contact at the base of each cycle suggest that the sediments were derived from resuspension of units elsewhere in the crater, most likely by high energy currents association with ocean water invasion.     

Types of Pyrophyllite Deposits in Foldbelts

Abstract. Pyrophyllite deposits can be divided into five types on the basis of geology and genesis. The first two types are associated with hydrothermally altered rocks in felsic and intermediate volcanogenic suites. They are characterized by their metasomatites and their subsequent mineralogic transformations under varying volcanic conditions. The third type includes deposits and occurrences of metamorphic-metasomatic genesis, which is caused by transformations of terrigenous-sedimentary interbeds in felsic volcanics under greenschist facies conditions. The fourth type is associated with low and mid-temperature stages of hydrothermal vein formation at the limits of volcanogenic and metamorphic strata. The fifth type comprises pyrophyllite occurrences in weathering crusts on metamorphic strata and metasomatite.
The formation conditions and distribution of raw pyrophyllite deposits were influenced by the geodynamic situations and geochemical conditions, such as character of tectonic dislocations, volcanism and chemical composition of hydrothermal solutions.