Field evidence of hydraulic connections between bedrock aquifers and overlying granular aquifers: examples from the Grenville Province of the Canadian Shield

Field evidence of hydraulic connections between a bedrock aquifer and an overlying granular aquifer in the Canadian Shield (Grenville Province) is presented. This issue is rarely considered and investigated despite its important hydraulic and chemical consequences and its widespread occurrence worldwide. The methodology employed is based on complementary field tests conducted at specific experimental sites instrumented both in the rock and in the overlying deposits. One of the bedrock sites revealed a natural hydraulic connection with the overlying granular aquifer caused by the weathered surface of the uppermost bedrock. Another site revealed an artificial hydraulic connection between the bedrock and the granular aquifer created by an improperly sealed casing. A regional study showed that hydraulic connections yield an erroneous interpretation of the true hydraulic properties of the tested aquifer. The detection of hydraulic connections is therefore essential to properly define well-capture areas and contamination conditions. It is recommended to practitioners that pumping tests be performed as well as hydrochemical comparisons of each existing aquifer unit. Falling-head permeability tests are also helpful in verifying the quality of the seal at the bedrock–casing contact. More effective procedural controls and better well-construction practices are necessary to reduce the risks of cross-contamination induced by defective seals.     

Oxygen isotope fractionation between apatite-bound carbonate and water determined from controlled experiments with synthetic apatites precipitated at 10-37 °C

The oxygen isotope fractionation between the structural carbonate of inorganically precipitated hydroxyapatite (HAP) and water was determined in the range 10-37 °C. Values of 1000 ln α() are linearly correlated with inverse temperature (K) according to the following equation: 1000 ln α() = 25.19 (±0.53)·T⁻¹ − 56.47 (±1.81) (R² = 0.998). This fractionation equation has a slightly steeper slope than those already established between calcite and water ( [O’Neil et al., 1969] and [Kim and O’Neil, 1997]) even though measured fractionations are of comparable amplitude in the temperature range of these experimental studies. It is consequently observed that the oxygen isotope fractionation between apatite carbonate and phosphate increases from about 7.5‰ up to 9.1‰ with decreasing temperature from 37 °C to 10 °C. A compilation of δ¹⁸O values of both phosphate and carbonate from modern mammal teeth and bones confirms that both variables are linearly correlated, despite a significant scattering up to 3.5‰, with a slope close to 1 and an intercept corresponding to a 1000 ln α() value of 8.1‰. This apparent fractionation factor is slightly higher or close to the fractionation factor expected to be in the range 7-8‰ at the body temperature of mammals.     

Behaviour of lithium and its isotopes during weathering in the Mackenzie Basin, Canada

We report Li isotopic compositions, for river waters and suspended sediments, of about 40 rivers sampled within the Mackenzie River Basin in northwestern Canada. The aim of this study is to characterize the behaviour of Li and its isotopes during weathering at the scale of a large mixed lithology basin. The Mackenzie River waters display systematically heavier Li isotopic compositions relative to source rocks and suspended sediments. The range in δ⁷Li is larger in dissolved load (from +9.3‰ to +29.0‰) compared to suspended sediments (from −1.7‰ to +3.2‰), which are not significantly different from δ⁷Li values in bedrocks. Our study shows that dissolved Li is essentially derived from the weathering of silicates and that its isotopic composition in the dissolved load is inversely correlated with its relative mobility when compared to Na. The highest enrichment of ⁷Li in the dissolved load is reported when Li is not or poorly incorporated in secondary phases after its release into solution by mineral dissolution. This counterintuitive observation is interpreted by the mixing of water types derived from two different weathering regimes producing different Li isotopic compositions within the Mackenzie River Basin. The incipient weathering regime characterizing the Rocky Mountains and the Shield areas produces ⁷Li enrichment in the fluid phase that is most simply explained by the precipitation of oxyhydroxide phases fractionating Li isotopes. The second weathering regime is found in the lowland area and produces the lower δ⁷Li waters (but still enriched in ⁷Li compared to bedrocks) and the most Li-depleted waters (compared to Na). Fractionation factors suggest that the incorporation of Li in clay minerals is the mechanism that explains the isotopic composition of the lowland rivers. The correlation of boron and lithium concentrations found in the dissolved load of the Mackenzie Rivers suggests that precipitation of clay minerals is favoured by the relatively high residence time of water in groundwater. In the Shield and Rocky Mountains, Li isotopes suggest that clay minerals are not forming and that secondary minerals with stronger affinity for ⁷Li appear.Although the weathering mechanisms operating in the Mackenzie Basin need to be characterized more precisely, the Li isotope data reported here clearly show the control of Li isotopes by the weathering intensity. The spatial diversity of weathering regimes, resulting from a complex combination of factors such as topography, geology, climate and hydrology explains, in fine, the spatial distribution of Li isotopic ratios in the large drainage basin of the Mackenzie River. There is no simple relationship between Li isotopic composition and chemical denudation fluxes in the Mackenzie River Basin.     

Pressure–temperature evolution of lawsonite eclogite in Sivrihisar; Tavşanlı Zone–Turkey

The Cretaceous blueschist belt, Tavşanlı Zone, representing the subducted and exhumed northern continental margin of the Anatolide–Tauride platform is exposed in Western Anatolia. The Sivrihisar area east of Tavşanlı is made up of tectonic units consisting of i) metaclastics and conformably overlying massive marbles (coherent blueschist unit), ii) blueschist-eclogite unit, iii) marble–calcschist intercalation and iv) metaperidotite slab. The metaclastics are composed of jadeite–lawsonite–glaucophane and jadeite–glaucophane–chloritoid schists, phengite phyllites, and calcschists with glaucophane–lawsonite metabasite layers. The blueschist-eclogite unit representing strongly sheared, deeply buried and imbricated tectonic slices of accreted uppermost levels of the oceanic crust with minor metamorphosed serpentinite bodies consists of lawsonite-bearing eclogitic metabasites (approximately 90% of the field), lawsonite eclogites, metagabbros, serpentinites, pelagic marbles, omphacite–glaucophane–lawsonite metapelites and metacherts. The mineral assemblage of the lawsonite eclogite (garnet + omphacite > 70%) is omphacite, garnet, lawsonite, glaucophane, phengite and rutile. Lawsonite eclogite lenses are enclosed by garnet–lawsonite blueschist envelopes.Textural evidence from lawsonite eclogites and country rocks reveals that they did not leave the stability field of lawsonite during subduction and exhumation. The widespread preservation of lawsonite in eclogitic metabasites and eclogites can be attributed to rapid subduction and subsequent exhumation in a low geothermal gradient of the oceanic crust material without experiencing a thermal relaxation. Peak P–T conditions of lawsonite eclogites are estimated at 24 ± 1 kbar and 460 ± 25 °C. These P–T conditions indicate a remarkably low geotherm of 6.2 °C/km corresponding to a burial depth of 74 km.     

A new amber deposit from the Cretaceous (uppermost Albian-lowermost Cenomanian) of southwestern France

A Cretaceous amber deposit has recently been discovered in a quarry of Charente-Maritime (southwestern France), at Cadeuil. This paper presents the sedimentary and palaeoenvironmental settings of the uppermost Albian-lowermost Cenomanian series including the amber deposit. A preliminary analysis of the amber samples reveals diverse fossil arthropods (a few mites and at least 20 insect families within 9 orders), as well as numerous micro-organisms, mainly algae and mycelia. A myceloid colony of bacteria, a flagellate algae and four especially well preserved insects are illustrated (Diptera Dolichopodidae, Diptera Chironomidae, Hymenoptera Parasitica, and Heteroptera Tingidae). The abundance of the limnic micro-organisms is discussed in terms of bloom events. Their relative scarcity in almost all the amber pieces containing fossil arthropods is attributed to differences in the origin of resin: production along trunk and branches for amber with arthropods; production by aquatic roots for amber rich in algae. The absence of pollen and spores in amber is attributed to differences in the respective periods of resin and palynomorph production, which may be related to a seasonal climate during the Albian-Cenomanian transition in Western Europe.