The effects of initial soil moisture conditions on swale flow hydrographs

The effects of soil water content (SWC) on the formation of run‐off in grass swales draining into a storm sewer system were studied in two 30‐m test swales with trapezoidal cross sections. Swale 1 was built in a loamy fine‐sand soil, on a slope of 1.5%, and Swale 2 was built in a sandy loam soil, on a slope of 0.7%. In experimental runs, the swales were irrigated with 2 flow rates reproducing run‐off from block rainfalls with intensities approximately corresponding to 2‐month and 3‐year events. Run‐off experiments were conducted for initial SWC (SWC_ini) ranging from 0.18 to 0.43 m³/m³. For low SWC_ini, the run‐off volume was greatly reduced by up to 82%, but at high SWC_ini, the volume reduction was as low as 15%. The relative swale flow volume reductions decreased with increasing SWC_ini and, for the conditions studied, indicated a transition of the dominating swale functions from run‐off dissipation to conveyance. Run‐off flow peaks were reduced proportionally to the flow volume reductions, in the range from 4% to 55%. The swale outflow hydrograph lag times varied from 5 to 15 min, with the high values corresponding to low SWC_ini. Analysis of swale inflow/outflow hydrographs for high SWC_ini allowed estimations of the saturated hydraulic conductivities as 3.27 and 4.84 cm/hr in Swales 1 and 2, respectively. Such estimates differed from averages (N = 9) of double‐ring infiltrometer measurements (9.41 and 1.78 cm/hr). Irregularities in swale bottom slopes created bottom surface depression storage of 0.35 and 0.61 m³ for Swales 1 and 2, respectively, and functioned similarly as check berms contributing to run‐off attenuation. The experimental findings offer implications for drainage swale planning and design: (a) SWC_ini strongly affect swale functioning in run‐off dissipation and conveyance during the early phase of run‐off, which is particularly important for design storms and their antecedent moisture conditions, and (b) concerning the longevity of swale operation, Swale 1 remains fully functional even after almost 60 years of operation, as judged from its attractive appearance, good infiltration rates (3.27 cm/hr), and high flow capacity.     

A direct scaling analysis for the sea level rise

The estimation of long-term sea level variability is of primary importance for a climate change assessment. Despite the value of the subject, no scientific consensus has yet been reached on the existing acceleration in observed values. The existence of this acceleration is crucial for coastal protection planning purposes. The absence of the acceleration would enhance the debate on the general validity of current future projections. Methodologically, the evaluation of the acceleration is a controversial and still open discussion, reported in a number of review articles, which illustrate the state-of-art in the field of sea level research. In the present paper, the well-proven direct scaling analysis approach is proposed in order to describe the long-term sea level variability at 12 worldwide-selected tide gauge stations. For each of the stations, it has been shown that the long-term sea level variability exhibits a trimodal scaling behaviour, which can be modelled by a power law with three different pairs of shape and scale parameters. Compared to alternative methods in literature, which take into account multiple correlated factors, this simple method allows to reduce the uncertainties on the sea level rise parameters estimation.     

Probabilistic leak detectability assessment via state estimation in water transport networks

Leak detectability or leakage awareness refers to the capability of sensing losses from a water supply system. Several methods exist in the technical literature to tackle this problem, but only few address it with a state estimation approach. The aim of this paper is to present a new methodology that enables probabilistic assessment of the extent to which water loss could be detected using state estimation by only analysing a single hydraulic state, i.e. one time period. Significant leaks are sensed by identifying unusually high normalised state estimation residuals, which can be identified based on the largest normalised residual test. More specifically, the probability of detecting leaks is computed here by working with the multivariate distribution among measurements and estimates to take into account the noisy nature of measurements with an analytical approach rather than with sampling experiments, which are time-consuming. The methodology set out herein also provides a procedure to systematically assess the minimum leak that could be detected in different parts of the network for a specific measurement setting and operating condition. The method has been applied to a water transport network case study to show its potential and to highlight the usefulness of such a tool for practitioners. The limitations of such a methodology are also discussed, including its possible use for on-line leak detection strategies.     

The probabilistic seismic hazard assessment of Germany—version 2016, considering the range of epistemic uncertainties and aleatory variability

The basic seismic load parameters for the upcoming national design regulation for DIN EN 1998-1/NA result from the reassessment of the seismic hazard supported by the German Institution for Civil Engineering (DIBt). This 2016 version of the national seismic hazard assessment for Germany is based on a comprehensive involvement of all accessible uncertainties in models and parameters and includes the provision of a rational framework for integrating ranges of epistemic uncertainties and aleatory variabilities in a comprehensive and transparent way. The developed seismic hazard model incorporates significant improvements over previous versions. It is based on updated and extended databases, it includes robust methods to evolve sets of models representing epistemic uncertainties, and a selection of the latest generation of ground motion prediction equations. The new earthquake model is presented here, which consists of a logic tree with 4040 end branches and essential innovations employed for a realistic approach. The output specifications were designed according to the user oriented needs as suggested by two review teams supervising the entire project. Seismic load parameters, for rock conditions of \(v_{S30}\) = 800 m/s, are calculated for three hazard levels (10, 5 and 2% probability of occurrence or exceedance within 50 years) and delivered in the form of uniform hazard spectra, within the spectral period range 0.02–3 s, and seismic hazard maps for peak ground acceleration, spectral response accelerations and for macroseismic intensities. Results are supplied as the mean, the median and the 84th percentile. A broad analysis of resulting uncertainties of calculated seismic load parameters is included. The stability of the hazard maps with respect to previous versions and the cross-border comparison is emphasized.     

Evolution of seismic hazard maps in Turkey

A review on the historical evolution of seismic hazard maps in Turkey is followed by summarizing the important aspects of the updated national probabilistic seismic hazard maps. Comparisons with the predecessor probabilistic seismic hazard maps as well as the implications on the national design codes conclude the paper.     

Terahertz band simulations using two different radiative transfer models

A high-resolution dual-band terahertz (THz) radiometer was designed to measure vertical distributions of chemical elements in the middle atmosphere of the Tibetan Plateau. A forward simulation, which always should be conducted firstly for the development of a matching retrieval algorithm, has not been done before. We use two radiative transfer models, ARTS and AM, to simulate the water vapor, ozone and carbon monoxide spectra on the plateau based on the spectral design of the THz radiometer. The emission line characteristics of the three gases in this spectral band are identified. Reasons for the differences in the spectral simulations between the two models are analyzed for individual gases. The impact of several different spectral parameter settings on the simulations are evaluated through a series of sensitivity experiments. This study suggests that the ARTS is more suitable for the development of the THz radiometer retrieval algorithm. An optimal parameter setting of the ARTS for the three elements are given.     

Influence of multiple compton scattering on the spectrum of soft diffuse gamma rays at balloon altitudes

A Monte Carlo program has been developed in order to examine the influence of multiple Compton scattering in the atmosphere on the spectrum of cosmic diffuse gamma rays. It is shown that the corrections to the made to the measurements of the double-Compton gamma telescope at 2·5 gr cm^–2 rest atmosphere by Schönfelder and Lichti (1974) are lower than 4% in the energy range between 1.5 and 10 MeV.Under support of a fellowship by the Deutscher Akademischer Austauschdienst     

第二次土地调查中坐标系统转换方法研究

探讨了第二次土地调查(农村部分)中所涉及到的1954年北京坐标系和1980西安坐标系之间的转换方法,并以实际项目为例,采用不同的检测方法对坐标系统转换精度进行验证,为第二次土地调查中涉及到的坐标系统转换提供思路。     

Tracing of Peroxidase Activity in Humic Lake Water

An enzyme assay was developed for studies on peroxidase activities in humic lake water. 3,4-Dimethoxybenzyl alcohol (veratryl alcohol, VeraOH) was used as tracer substrate, and peroxidase (EC 1.11.1.7) activity was measured by high-performance liquid chromatography. The chemical stability of VeraOH and its application as peroxidase substrate was tested under light and dark conditions, different hydrogen peroxide (H₂O₂) concentrations and humic matter contents. VeraOH was stable under low UV radiation at in situ conditions in lake water (<0.010...0.25 kJ m^–2 d^–1), laboratory conditions (<0.05...0.30 kJ m^–2 d^–1), and low (1...100 μM) H₂O₂ concentrations. However, peroxides oxidized VeraOH above 1...10 mM H₂O₂ concentration in sterile Millipore-Q and humic lake water. Dark incubations showed little VeraOH oxidation products. The developed peroxidase assay was tested in the growth medium of Phanerochaete chrysosporium and a bacteria isolate (P.M.D. 20.4.3.1) from mesohumic lake Pääjärvi. Peroxidase activities were also measured in natural microbial communities under standard laboratory and under in situ conditions in humic lake water. Incubation times of about 5 to 12 days were usually needed to record significant (P < 0.05) peroxidase activities, in lake waters. In situ peroxidase activities varied in pelagial surface water (0...0.5 m) on a seasonal scale between 74 nmol L^–1 h^–1 and 273 nmol L^–1 (mean: 176 nmol L^–1 h^–1) and within the water column between 110 nmol L^–1 h^–1 and 800 nmol L^–1 h^–1 (mean: 500 nmol L^–1 h^–1) in polyhumic lake Mekkojärvi.