Induced Microearthquake Patterns in Hydrocarbon and Geothermal Reservoirs: Six Case Studies

—?The injection or production of fluids can induce microseismic events in hydrocarbon and geothermal reservoirs. By deploying sensors downhole, data sets have been collected that consist of a few hundred to well over 10,000 induced events. We find that most induced events cluster into well-defined geometrical patterns. In many cases, we must apply high-precision, relative location techniques to observe these patterns. At three sedimentary sites, thin horizontal strands of activity are commonly found within the location patterns. We believe this reflects fracture containment between stratigraphic layers of differing mechanical properties or states of stress. At a massive carbonate and two crystalline sites, combinations of linear and planar features indicate networks of intersecting fractures and allow us to infer positions of aseismic fractures through their influence on the location patterns. In addition, the fine-scale seismicity patterns often evolve systematically with time. At sedimentary sites, migration of seismicity toward the injection point has been observed and may result from slip-induced stress along fractures that initially have little resolved shear. In such cases, triggering events may be critical to generate high levels of seismic activity. At one crystalline site, the early occurrence of linear features that traverse planes of activity indicate permeable zones and possible flow paths within fractures. We hope the continued development of microseismic techniques and refinement of conceptual models will further increase our understanding of fluid behavior and lead to improved resource management in fractured reservoirs.     

Modeling of Wide-Angle Seismic Attributes Using the Gaussian Beam Method

In this study, observed seismic attributes from shot gather 11 of the SAREX experiment are used to derive a preliminary velocity and attenuation model for the northern end of the profile in southern Alberta. Shot gather 11 was selected because of its prominent Pn arrivals and good signal to noise ratio. The 2-D Gaussian beam method was used to perform the modeling of the seismic attributes including travel times, peak envelope amplitudes and pulse instantaneous frequencies for selected phases. The preliminary model was obtained from the seismic attributes from shot gather 11 starting from prior tomographic results. The amplitudes and instantaneous frequencies were used to constrain the velocity and attenuation structure, with the amplitudes being more sensitive to the velocity gradients and the instantaneous frequencies more sensitive to the attenuation structure. The resulting velocity model has a velocity discontinuity between the upper and lower crust, and lower velocity gradients in the upper and lower crust compared to earlier studies. The attenuation model has Q _p ^-1 values between 0.011 and 0.004 in the upper crust, 0.0019 in the lower crust and a laterally variable Q _p ^-1 in the upper mantle. The Q _p ^-1 values are similar to those found in Archean terranes from other studies. Although the results from a single gather are non-unique, the initial model derived here provides a self-consistent starting point for a more complete seismic attribute inversion for the velocity and attenuation structure.     

A New Model for Heat Flow in Extensional Basins: Estimating Radiogenic Heat Production

Radiogenic heat production (RHP) represents a significant fraction of surface heat flow, both on cratons and in sedimentary basins. RHP within continental crust—especially the upper crust—is high. RHP at any depth within the crust can be estimated as a function of crustal age. Mantle RHP, in contrast, is always low, contributing at most 1 to 2 mW/m² to total heat flow. Radiogenic heat from any noncrystalline basement that may be present also contributes to total heat flow. RHP from metamorphic rocks is similar to or slightly lower than that from their precursor sedimentary rocks. When extension of the lithosphere occurs—as for example during rifting—the radiogenic contribution of each layer of the lithosphere and noncrystalline basement diminishes in direct proportion to the degree of extension of that layer. Lithospheric RHP today is somewhat less than in the distant past, as a result of radioactive decay. In modeling, RHP can be varied through time by considering the half lives of uranium, thorium, and potassium, and the proportional contribution of each of those elements to total RHP from basement. RHP from sedimentary rocks ranges from low for most evaporites to high for some shales, especially those rich in organic matter. The contribution to total heat flow of radiogenic heat from sediments depends strongly on total sediment thickness, and thus differs through time as subsidence and basin filling occur. RHP can be high for thick clastic sections. RHP in sediments can be calculated using ordinary or spectral gamma-ray logs, or it can be estimated from the lithology.     

Testate amoebae as paleoindicators of surface-moisture changes on Michigan peatlands: modern ecology and hydrological calibration

Peatland testate amoebae are sensitive indicators of local hydrology and have been used as proxies for surface moisture conditions in fossil studies. However, few regional calibration datasets exist in North America, and knowledge of testate amoeba ecology and distribution patterns are limited. The objectives of this study were to (1) investigate the relationship between testate amoebae, environment, and Sphagnum species in Michigan peatlands; (2) generate transfer functions from this dataset that can be applied to fossil data; and (3) describe vertical variation of testate amoebae inhabiting Sphagnum moss. Testate amoeba assemblages from 139 microsites within 11 peatlands in Michigan were compared to assess variability between and within peatlands. Most peatlands contained similar testate amoeba assemblages, although within individual peatlands the amount of assemblage variability is correlated to the amount of environmental heterogeneity. Of the measured environmental variables, depth to water table showed the strongest relationship with testate amoebae. Depth to water table can be reconstructed from fossil data with a mean error of ±7.5 cm, although predictive ability deteriorates in extremely dry environments (>30 cm water table depth). Vertical variation in testate amoeba assemblages was investigated at 89 Sphagnum-dominated microsites by directly comparing amoeba assemblages and the abundance and frequency of common taxa in upper and lower portions of the Sphagnum stem. Except for extremely dry microsites, considerable vertical variation in assemblage composition exists. Many agglutinate taxa are more abundant on lower portions of the Sphagnum stem, and taxa containing symbiotic zoochlorellae are more abundant on upper portions. Refinements in sampling procedures and analysis may improve the predictive ability of transfer functions.     

Chemical denudation rates in Kärkevagge, Swedish Lapland

This study examines the spatial and temporal variability of chemical denudation rates in Kärkevagge, northern Sweden. The chemical flux rates within the valley are strongly influenced by the local geology. Chemical denudation rates determined for the study period are more than double those previously reported in the literature for this valley. Rates of greater than 46t km⁻² a⁻¹ were measured at the valley mouth over the course of the melt season. This difference is likely due to differences in measurement technique compared to that used by past researchers. This rate is also much higher than for other arctic and alpine watersheds. Chemical denudation in Kärkevagge is comparable to larger temperate rivers. The rapid chemical denudation in Kärkevagge is likely due to sulfide weathering creating acid solutions.     

Late Archaean to Palaeoproterozoic geotherms in the Kaapvaal craton, South Africa: constraints on the thermal evolution of the Witwatersrand Basin

The c. 2.97–2.71 Ga Witwatersrand Basin located in the Kaapvaal craton of South Africa represents a remnant of a large Late Archaean sedimentary basin that hosts the world's premier gold deposit within a series of conglomerate horizons. Evidence of postdepositional gold mobility within these conglomerates associated with hydrothermal–metamorphic activity has led to speculation about the Late Archaean to Palaeoproterozoic geothermal gradients in the basin. We use surface heat flow and heat production data from rocks in the basin and its environs in order to calculate detailed temperature profiles for the central Kaapvaal craton that show that the steady state crustal geotherm during the Late Archaean and Palaeoproterozoic was relatively cool at 15–20 K km^?1. The geotherm in the upper crustal strata is also largely unaffected by substantial increases in the heat flow into the base of the crust. Consequently, regional greenschist facies metamorphism of the basin sediments could only have been achieved during a transient thermal event that advected heat into the upper crust. The most likely candidate for this is the Bushveld magmatic event at 2.06 Ga.     

Chasing a 'loose and baggy monster': almshouses and the geography of charity

This paper goes some way towards redressing the lack of geographical literature on charity through exploring the geography of the British domestic charitable sector. The size and geography of the third sector is outlined, followed by an analysis of how almshouses can be understood as inherently geographical and deeply embedded in local social networks of inclusion as well as exclusion.     

The interpretation of reaction textures in Fe‐rich metapelitic granulites of the Musgrave Block,central Australia: constraints from mineral equilibria calculations in the system K2O–FeO–MgO–Al2O3–SiO2–H2O–TiO2–Fe2O3

Fe‐rich metapelitic granulites of the Musgrave Block, central Australia, contain several symplectic and coronal reaction textures that post‐date a peak S2 metamorphic assemblage involving garnet, sillimanite, spinel, ilmenite, K‐feldspar and quartz. The earliest reaction textures involve spinel‐ and quartz‐bearing symplectites that enclose garnet and to a lesser extent sillimanite. The symplectic spinel and quartz are in places separated by later garnet and/or sillimanite coronas. The metamorphic effects of a later, D3, event are restricted to zones of moderate to high strain where a metamorphic assemblage of garnet, sillimanite, K‐feldspar, magnetite, ilmenite, quartz and biotite is preserved. Quantitative mineral equilibria calculations in the system K₂O–FeO–MgO–Al₂O₃–SiO₂–H₂O–TiO₂–Fe₂O₃ (KFMASHTO) using Thermocalc 3.0 and the accompanying internally consistent dataset provide important constraints on the influence of TiO₂ and Fe₂O₃ on biotite‐bearing and spinel‐bearing equilibria, respectively. Biotite‐bearing equilibria are shifted to higher temperatures and spinel‐bearing equilibria to higher pressures and lower temperatures in comparison to the equivalent equilibria in K₂O–FeO–MgO–Al₂O₃–SiO₂–H₂O (KFMASH). The sequence of reaction textures involving spinel is consistent with a D2 P–T path that involved a small amount of decompression followed predominantly by cooling within a single mineral assemblage stability field. Thus, the reaction textures reflect changes in modal proportions within an equilibrium assemblage rather than the crossing of a univariant reaction. The D3 metamorphic assemblage is consistent with lower temperatures than those inferred for D2.     

Enigmatic Efflorescence in Kärkevagge, Swedish Lapland: The Key to Chemical Weathering?

The second marvel to catch the eye of the visitor to Kärkevagge, after the impressive boulder deposit on the floor of the valley, is the series of prominent white stripes running down the valley's dark cliffs. Streams and springs descending the eastern flank of Kärkevagge are marked by the presence of whitish coatings on the black rock surfaces and on cobbles lining ephemeral waterways. These were referred to as 'lime crusts' by early investigators, but they are not reactive to HCl. We believe that they are a precipitate resulting from acid attack on the local rocks. Pyrite is common in many of the rocks in the valley and its oxidation produces sulfuric acid. As the dissolved mineral elements are carried in the drainage water, efflorescence forms on the surfaces where the water flows due to evaporation or to changes in temperature. The exact mineralogy of the white crusts is unknown, but the crusts are dominated by Al, S, and O, and in some cases by Ca, depending on the substrate and local conditions. Gypsum, illite, and chlorite have been identified by X–ray diffraction of some scrapings of white–coated rocks. However, we believe that some unidentified oxy–hydroxy aluminum sulfates make up the bulk of the precipitates.