Improvement of the JRC Calculation Using Different Parameters Obtained Through a New Survey Method Applied to Rock Discontinuities

This paper presents a new, fast and economical method for digitizing a rock surface profile to determine its joint roughness coefficient (JRC) value (Barton and Choubey, Rock Mech Rock Eng 10:1–54, 1977) using a set of existing parameters, the appropriateness of which has been tested. The new procedure was applied to four rock road cuts in the Alpujarra area of Granada province (Andalusia, Spain), supported by 117 digitized profiles. The method avoids any personal subjectivity bias. The usual subjectivity in the visualization and assessment of the JRC value is estimated here by a survey test answered by 90 trained users. The survey test consisted of a set of JRC visual comparisons of 12 roughness profiles, selected from the 117 profiles surveyed during the field research in the Alpujarra region, with the Barton typical profiles. The results of the survey clearly show systematic inaccuracies in the traditional procedure that are reduced if the advice presented in the conclusions of this paper is taken in account when performing the visual estimation.     

SWAT manual calibration and parameters sensitivity analysis in a semi-arid watershed in North-western Morocco

Being a laborious approach, manual calibration of hydrologic model in a semi-arid context requires in-depth knowledge of the watershed and as much as possible field input data to obtain reliable simulations. In this study, manual calibration and relative sensitivity analysis approaches of the SWAT model (Soil and Water Assessment Tool) were applied for water balance in a 1993 km² watershed (on the R’dom river) located in North-western Morocco. The watershed is located in a semi-arid area dominated by agro-forestry activities. The objectives of this study were (i) to perform a local sensitivity analysis of the SWAT model taking into consideration the watershed characteristics and (ii) to implement a detailed methodology of manual calibration and validation of the model in a semi-arid context. Sensitivity analysis has been carried out on 12 different SWAT input parameters, and has revealed that 4 input parameters only were the most influential ones on flow components of the R’dom watershed. Model manual calibration was conducted along 2006 and 2007 by comparing measured and predicted monthly and daily discharges and taking Nash-Sutcliffe coefficient (NSE), determination coefficient (R ²), and percent bias (PBIAS) as goodness-of-fit indicators. Validation has been performed by the same approach through 2008 and 2009 period. All final NSE values were above 0.5, R ² values exceeded 0.7, and PBIAS lower than 25% demonstrating satisfactory model performances over the study watershed conditions. The SWAT model set-up with measured input data, manually calibrated and validated, reflects well the real hydrologic processes occurring in the R’dom watershed and can be used to assess current and future conditions and to evaluate alternative management practices.     

Gold–palladium mineralization at Bleïda Far West, Bou Azzer–El Graara Inlier, Anti-Atlas, Morocco

The structurally controlled Au–Pd mineralization at Bleïda Far West occurs in a volcano-sedimentary rock sequence in altered amphibolites and chlorite schists of the Neoproterozoic Bou Azzer–El Graara inlier. The Au–Pd mineralization is virtually sulfide-free; instead, gold is associated with hematite, barite, quartz, and calcite. The gold grains are silver- and palladium-bearing (up to 19 wt% Ag and 6.3 wt% Pd) and are intergrown with a distinct suite of mainly Pd-dominated platinum group minerals, namely mertieite-I/isomertieite, merenskyite, keithconnite, kotulskite, palladseite, and sperrylite, defining a Au–Pd–As–Sb–Se–Te chemical signature. Stable isotope and fluid inclusion studies indicate a wide range of fluid compositions with a prominent saline component. In conjunction with the mineral association, oxidizing fluids are indicated, and Au and PGE transport and deposition likely took place by chloride complexes in the epithermal range, at elevated f O₂ and/or low pH. It is still speculative whether the mineralization is late Pan-African (～600–550 Ma) in age, or connected with the Variscan orogeny (～330–300 Ma), or related to some other hydrothermal event. Common to all Au–Pd mineralizations worldwide (Brazil, Australia, UK), including Bleïda Far West, is their formation in the epithermal (<300°C) range; deposition mainly in brittle structures; sulfide-poor mineral assemblages comprising hematite, sulfate minerals, and selenides; and metal transport by, and deposition from, oxidized, chloride-rich fluids. These deposits are further characterized by noble metal abundances in the order Au>Pd>Pt and the chemical signature Au–Pd–Se–Te (±As, Sb, Bi). As such, the Au–Pd association represents a discrete style of gold mineralization distinct from other classes of gold deposits.     

Behavior of Loose Silty Sand of Chlef River: Effect of Low Plastic Fine Contents and Other Parameters

This article presents a laboratory study of static behavior of silty-sand soils. The objective of this laboratory investigation is to study the effect of initial confining pressures and fines content on the undrained shear strength (known as liquefaction resistance) response, pore pressure, and hydraulic conductivity of sand–silt mixtures. The triaxial tests were conducted on reconstituted saturated silty-sand samples at initial relative density D_r = 15% with fines content ranging from 0 to 50%. All the samples were subjected to a range of initial confining pressures (50, 100, and 200 kPa). The obtained results indicate that the presence of low plastic fines in sand–silt mixture leads to a more compressible soil fabric, and consequently to a significant loss in the soil resistance to liquefaction. The evaluation of the data indicates that the undrained shear strength can be correlated to fines content (F_c), inter-granular void ratio (e_g), and excess of pore pressure (Δu). The undrained shear strength decreases with the decrease of saturated hydraulic conductivity and the increase of fines content for all confining pressures under consideration. There is a relatively high degree of correlation between the peak shear strength (q_peak) and the logarithm of the saturated hydraulic conductivity (k_sat) for all confining pressures.     

The Importance of the Precipitation and the Susceptibility of the Slopes for the Triggering of Landslides Along the Roads

In order to characterise the influence of the heavyrains on the observed landslides during the 1996–1997hydrological cycle, rainfall records for the last 100years are analysed from 104 stations in easternAndalusia. Regarding the amounts of rain recordedbetween October 1996 and March 1997 in the 104stations studied, 31 presented new all-time records;15 presented values that were 80–100% of thepre-1995 record; 49 stations, 80–50%; and 9stations, < 50%. A map has been devised of thesusceptibility of the materials through which thesouth-eastern Andalusian road network crosses,together with an inventory of the damage caused byinstability phenomena on banks and cuttings of theroad network during the winter of 1996–1997. Therelationships between the rainfall during the studyperiod, the damage caused to the road network and thesusceptibility of the materials affected are analysed.The results indicate that there is a clearcorrespondence between the rainfall recorded and thesusceptibility of the materials with the inventorieddamage. It is concluded that the widespread seriousdamage caused in early 1997 to the roads andsurrounding areas in the Alpujarra region and thecoast of the Province of Granada was mainly caused bythe extraordinarily heavy rains. However, considerablyless damage was observed where the susceptibility ofthe terrain is low, thus highlighting the extremeusefulness of terrain-susceptibility maps for riskprevention and territorial planning.     

Première caractérisation palynologique du Trias moyen dans le Haut Atlas ; implications pour l'initiation du rifting téthysien au Maroc

The Middle Anisian has been palynologically characterized for the first time, at the whole Moroccan scale, in the High Atlas of Marrakech. The stratigraphic, tectonic and paleogeographic implications of this discovery are analysed. To cite this article: E.H. El Arabi et al., C. R. Geoscience 338 (2006).     

Unsteady convective atmospheric vortices

The convective atmospheric vortex models of Kuo (1966) and Kendall (1978) are extended to allow the formulation of similarity equations for the unsteady vortex arising from an ambient flow with unstable stratification and rotation. In particular, a new analytical solution is found which allows flow at large radius that is more physically realistic than in any earlier solutions. Additional unsteady solutions are obtained numerically but at large radius these are subject to the limitations of earlier solutions.     

Comparison of climatic threshold of geographical distribution between dominant plants and surface pollen in China

The geographical distribution of dominant plant species in China was georeferenced and climatic variables were interpolated into all grids.Accordingly,the percentage distributions of principal pollen taxa based on 1860 surface pollen sites in China were selected and the related climate values were interpolated with the same method. The geographical and climatic comparison between the two data-sets indicated that the climate threshold of most pollen taxa from surface pollen is coherent with plant distributions. The climatic envelopes of dominant plant are mostly accordant with those of pollen taxa at certain levels. However, some distinct offsets of the climate ranges exist between the two datasets for most pollen taxa identified at family level, such as Ericaceae,Asteraceae, Poaceae and Chenopodiaceae. The present study provides for the first time rich information on temperature and precipitation in relation to pollen and plant distribution based on the datasets on a continental scale useful for global ecological modeling and Quaternary palaeoclimate reconstruction.     

Fast Upscaling of the Hydraulic Conductivity of Three-Dimensional Fractured Porous Rock for Reservoir Modeling

Mathematical Geosciences - A fast upscaling procedure for determining the equivalent hydraulic conductivity of a three-dimensional fractured rock is presented in this paper. A modified...