The international GLONASS experiment: products, progress and prospects

 In October 1998 the IGEX field campaign, the first coordinated international effort to monitor GLONASS satellites on global basis, was started. Currently about 40 institutions worldwide support this effort either by providing GLONASS tracking data or in operating related data and analysis centers. The increasing quality and consistency of the calculated GLONASS orbits (about 25 cm early in 2000), even after the end of the official IGEX field campaign, are shown. Particular attention is drawn to the combination of precise ephemerides in order to generate a robust, reliable and complete IGEX orbits product. Some problems in modeling the effect of solar radiation pressure on GLONASS satellites are demonstrated. Finally, the expected benefits and prospects of the upcoming International GLOnass Service-Pilot Project (IGLOS-PP) of the International GPS Service (IGS) are discussed in more detail. Received: 17 August 2000 / Accepted: 12 April 2001     

Temperature Sensitivity of Timing Measurements Using Dorne Margolin Antennas

We have inferred the temperature sensitivity of Dorne Margolin choke ring antennas by direct estimation from differential clock estimates for two GPS sites separated by 2400 km. At each site, the cable and receiver systems are very well isolated from environmental variations. By direct comparison of the observed clock variations between these sites with local temperature measurements, empirical temperature coefficients for each system have been estimated. These thermal coefficients most likely apply to the only uncontrolled components of the systems, the Dorne Margolin choke ring antennas. Based on these results, the short-term (diurnal) stability of the antennas appears to be better than 2 ps/°C. The possibility that longer-term effects exist due to sensitivity in the daily average of the pseudorange observations has not been tested and cannot be excluded. ? 2001 John Wiley & Sons, Inc.     

Lineaments and seismicity of Kerala — a remote sensing based analysis

Seismically active lineaments of Kerala State were identified by correlating the lineaments mapped using IRS LISS-I data with the earthquake occurrences. There are 31 earthquake incidences in Kerala since 1821, out of which 22 are falling on/close to 9 major lineaments/faults (length more than 20 km) indicating the possible correlation between lineaments/faults and earthquakes. It was observed that the earthquake occurrences are mostly associated with the NNW-SSE to NW-SE trending lineaments (6 out of 9 lineaments), which are considered to be formed sympathetic to the West Coast Fault. Hence, there is a need to monitor these seismically active lineaments using advanced techniques such as GPS, SAR Interferometry etc. for better understanding of the influence of these lineaments on the seismic activities of Kerala.     

A Case Study on the Effects of Heterogeneous Soil Moisture on Mesoscale Boundary-Layer Structure in the Southern Great Plains, U.S.A. Part II: Mesoscale Modelling

The importance of soil moisture inputs and improved model physics in the prediction of the daytime boundary-layer structure during the Southern Great Plains Hydrology Experiment 1997 (SGP97) is investigated using the non-hydrostatic fifth-generation Pennsylvania State University/National Center for Atmospheric Research (PSU/NCAR) Mesoscale Model MM5. This is Part II of a two-part study examining the relationship of surface heterogeneity to observed boundary-layer structure. Part I focuses on observations and utilizes a simple model while Part II uses observations and MM5 modelling. Soil moisture inputs tested include a lookup table based on soil type and season, output from an offline land-surface model (LSM) forced by atmospheric observations, and high-resolution ( 800 m) airborne microwave remotely sensed data. Model physics improvements are investigated by comparing an LSM directly coupled with the MM5 to a simpler force-restore method at the surface. The scale of land surface heterogeneities is compared to the scale of their effects on boundary-layer structure.The use of more detailed soil moisture fields allowed the MM5 to better represent the large-scale (hundreds of km) and small-scale (tens of km) horizontal gradients in surface-layer weather and, to a lesser degree, the atmospheric boundary-layer (ABL) height, which was evaluated against observations measured by differential absorption lidar (DIAL). The benefits of coupling an LSM to the MM5 were not readily evident in this summertime case, with the model having particular difficulty simulating the timing of maximum surface fluxes while underestimating the depth of the mixed layer.     

Thermodynamic controls on element partitioning between titanomagnetite and andesitic–dacitic silicate melts

Titanomagnetite–melt partitioning of Mg, Mn, Al, Ti, Sc, V, Co, Ni, Cu, Zn, Ga, Zr, Nb, Mo, Hf and Ta was investigated experimentally as a function of oxygen fugacity (fO₂) and temperature (T) in an andesitic–dacitic bulk-chemical compositional range. In these bulk systems, at constant T, there are strong increases in the titanomagnetite–melt partitioning of the divalent cations (Mg²⁺, Mn²⁺, Co²⁺, Ni²⁺, Zn²⁺) and Cu²⁺/Cu⁺ with increasing fO₂ between 0.2 and 3.7 log units above the fayalite–magnetite–quartz buffer. This is attributed to a coupling between magnetite crystallisation and melt composition. Although melt structure has been invoked to explain the patterns of mineral–melt partitioning of divalent cations, a more rigorous justification of magnetite–melt partitioning can be derived from thermodynamic principles, which accounts for much of the supposed influence ascribed to melt structure. The presence of magnetite-rich spinel in equilibrium with melt over a range of fO₂ implies a reciprocal relationship between a(Fe²⁺O) and a(Fe³⁺O_1.5) in the melt. We show that this relationship accounts for the observed dependence of titanomagnetite–melt partitioning of divalent cations with fO₂ in magnetite-rich spinel. As a result of this, titanomagnetite–melt partitioning of divalent cations is indirectly sensitive to changes in fO₂ in silicic, but less so in mafic bulk systems.     

Evaluation of significant sources influencing the variation of physico-chemical parameters in Port Blair Bay,South Andaman,India by using multivariate statistics

Port Blair is the capital city of Andaman & Nicobar Islands, the union territory of India. More than 50% of the population of these islands lives around Port Blair Bay. Therefore the anthropogenic effects in the bay water were studied for monitoring purpose from seven stations. Physico-chemical parameters of seawater were analyzed in samples collected once in every 3 months for 2 years from seven sampling stations located in Port Blair Bay, South Andaman Island to evaluate the spatial and tidal variation. Cluster analysis and factor analysis were applied to the experimental data in an attempt to understand the sources of variation of physico-chemical parameters. In cluster analysis, the stations Junglighat Bay and Phoenix Bay having high anthropogenic influence formed a separate group. The factors obtained from factor analysis indicated that the parameters responsible for physico-chemical variations are mainly related to land run-off, sewage outfall and tidal flow.     

Application of Hilbert‐like transforms for enhanced processing of full tensor magnetic gradient data

Commonly, geomagnetic prospection is performed via scalar magnetometers that measure values of the total magnetic intensity. Recent developments of superconducting quantum interference devices have led to their integration in full tensor magnetic gradiometry systems consisting of planar‐type first‐order gradiometers and magnetometers fabricated in thin‐film technology. With these systems measuring directly the magnetic gradient tensor and field vector, a significantly higher magnetic and spatial resolution of the magnetic maps is yield than those produced via conventional magnetometers. In order to preserve the high data quality in this work, we develop a workflow containing all the necessary steps for generating the gradient tensor and field vector quantities from the raw measurement data up to their integration into high­resolution, low­noise, and artefactless two‐dimensional maps of the magnetic field vector. The gradient tensor components are processed by superposition of the balanced gradiometer signals and rotation into an Earth‐centred Earth‐fixed coordinate frame. As the magnetometers have sensitivity lower than that of gradiometers and the total magnetic intensity is not directly recorded, we employ Hilbert‐like transforms, e.g., integration of the gradient tensor components or the conversion of the total magnetic intensity derived by calibrated magnetometer readings to obtain these values. This can lead to a better interpretation of the measured magnetic anomalies of the Earth's magnetic field that is possible from scalar total magnetic intensity measurements. Our conclusions are drawn from the application of these algorithms on a survey acquired in South Africa containing full tensor magnetic gradiometry data.     

Acid mine drainage at Cerro Rico de Potosí I: unabated high-strength discharges reflect a five century legacy of mining

Intensive mining and processing of Ag, Sn, Pb and Zn ores have occurred in various locations within and around the city of Potosí, Bolivia since 1545. Surface and subsurface waters, stream sediments and soils are contaminated with various ecotoxic metals in the headwaters of the economically vital, yet highly impacted, upper Rio Pilcomayo watershed. Previous studies have documented downstream trace metal contamination, however, not addressed specific sources. The AMD discharges identified in this study help link downstream pollution to primary origins. The majority of AMD would be considered high-strength due to metal concentrations and acidity orders of magnitude greater than typical AMD. Discharges from both operating and abandoned portals as well as tailings-related deposits displayed a high degree of heterogeneity with total metal concentrations ranging from 0.11 to 7480, <0.022 to 889, <0.0006 to 65.3, <0.001 to 310, 0.12 to 72,100, 0.3 to 402, <0.012 to 34.8, and 0.24 to 19,600 mg/L of Al, As, Cd, Cu, Fe, Mn, Pb and Zn, respectively. Net acidity and pH ranged from −10 to 246,000 mg/L as CaCO₃ equivalent and 0.90–6.94 standard units, respectively. Data were gathered during two sampling events centered around the most extreme periods of the dry and wet seasons of one water-year. Loadings to local streams were marginally greater for most metals in the wet season. If observed loadings are historically representative, Cerro Rico AMD has contributed thousands of tonnes of ecotoxic metals to the upper Rio Pilcomayo over the last five centuries. Metal and hydrogen ion concentrations in the majority of AMD sampled were several orders of magnitude above discharge limits set by the Bolivian government, yet no action has historically or contemporarily been taken.     

Anthropogenic relief changes in a long-lasting lignite mining area (‘Ville’, Germany) derived from historic maps and digital elevation models

Humans constitute one of the main geomorphological agents in modern times. As an example, post-mining regions represent a typical landscape of the Anthropocene. Strong relief modifications are particularly obvious with open pit mining. However, many existing mining areas are lacking detailed pre-mining information for the quantification of anthropogenic relief changes, which is a considerable challenge in regions with historic mining activities. Here, the Ville (Rhenish lignite district, Germany) is used to quantify surface mining induced relief changes in one of the oldest and currently largest lignite districts in Europe. Historical maps from first geodetic mapping in 1893 enabled construction of a historic digital elevation model to quantify the relief changes in comparison to elevation data from 2000 and 2015. The vertical accuracy of the historic data is remarkably high, with relief differences < 2 m in areas not affected by mining. In total, 49.2% of the investigated area (184 km²) shows a relief deficit and 14.5% has positive relief differences. Absolute changes account for more than 80 m heightening (dumpsites of overburden) and lowering of the natural relief (pits). Besides these altitudinal changes, overall steeper slopes are significant for the new topography, but levelling exists likewise. The spatial variabilities are discussed in the context of the regional geology and the mining techniques. Undoubtedly, such large-scale anthropogenic relief changes persist for a very long time and will last as a human legacy far into the future. Only the detailed reconstruction of the pre-mining relief offers the ability to clarify the dimension of humans as geomorphological agents and to understand landscape perception. Due to the fact that the impact of open pit mining has such a large vertical and horizontal extension, their consideration as part of anthropogeomorphology can significantly contribute to support future Critical Zone research in the Anthropocene.