Latitudinal variation of air sea fluxes in the western Indian ocean during austral summer and fall

Daily and zonal (latitudinal belt) averages of heat and momentum fluxes were computed using bulk aerodynamic formulae, from the meteorological parameters measured onboard M. S. Thuleland during the sixth Indian scientific expedition to Antarctica (26th November, 1986 to 22nd March, 1987). Both estimates showed significant variations, the momentum flux showing the largest variation. The maximum values of sensible and latent heat fluxes were observed over the 30°–40° S and 10°–20° S zones during the southern summer and fall respectively while the minimum values of latent heat flux were observed in the 60°–70° S zone for both seasons. The sensible heat flux minimum was observed in the 50°°60° S and 60°–70° S zones for summer and fall, respectively. Higher momentum flux values over the 40°–50° S zone in summer shifted to the 50°–60° S zone during fall.     

The Amazon river breeze and the local boundary layer: I. Observations

Observations of the diurnal evolution of the planetary boundary layer over the Amazon rain forest, made at sites close to the confluence of the Solimões and Negro rivers (approximately at 3°S, 60°W) near Manaus, Amazonas, Brazil, show the existence of a diurnal rotation of the wind near the surface and the frequent presence of low-level nocturnal wind maxima. These circulations are shown to be plausibly explained as elements of a river and land breeze circulation induced by the thermal contrast between the rivers and the adjacent forest.     

Petrological considerations for the demineralization of Rajmahal coals with <Emphasis Type="Italic">Pseudomonas mendocina</Emphasis> B6-1

The present study entails the results of the petrological coniderations for demineralization of Rajmahal Gondwana coals with Psudomonas mendocina B6-1. Inertinite group macerals are the dominant constituents of these coals, followed by vitrinite group, while liptinite occurs in low concentration. The amount of Mineral matter is moderately high. The concentration of major, minor and trace elements is high when compared with Clarke values. After the treatment of these coals with Pseudomonas mendocina strain B6-1, a significant reduction in the elemental content of oxygen, hydrogen and sulphur was observed. A gradual reduction of pyrite phase due to bioleaching was identified and its signatures were reflected in the XRD spectra and FTIR absorption bands. Over 5 % reduction in the ash content and decrease of major, minor and trace element to variable degrees were also noticed. Fe, As, and Ca positively correlate with the ash removal percentage indicating that the samples with high concentration of these elements were prone to demineralization with Pseudomonas mendocina strain B6-1 whereas Ni, Zn, Cr and Cu, negatively correlate with the ash removal percentage and shows that their enrichment impeded the process of demineralization. With increasing concentration of vitrinite the removal of major/minor/trace elements also increased which is attributed to the possible association of these elements with the mineral matter occurring as superficial mounting and superficial blanketing over the vitrinite macerals. This could facilitate the bacterial access to the elements to act upon and remove it to the variable extent. Some minerals occur intergrown with inertinites causing restricted bacterial action owing to the nonexposure of the mineral particles and less surface area available to the bacteria for bioleaching. Sulfur removal strongly relates with increase in inertinite content and decrease in liptinite content. This appears that sulfur associated with liptinites have shown difficult removal condition. The maximum removal of the trace elements like Cd, Cu, Co, Zn and Pb was observed from the ‘banded dull coal’ samples of the Rajmahal basin while maximum removal of major/minor elements like Fe, Ca and Mg was noticed from the ‘banded bright coal’ samples. However, maximum removal of Mn and As was also observed in the samples of ‘banded coal’.     

Monitoring and prediction of land use/land cover changes using CA-Markov model: a case study of Ravansar County in Iran

Human‐induced land use/land cover (LULC) changes are among the most important processes that shape the dynamics of the earth’s surface. This phenomenon, which is occurring at an astonishing rate, and its consequential environmental impacts have become an important area of research for scientists.Therefore, a wide range of methods and models have been developed to detect and predict these alterations, among which cellular automata (CA) models such as the CA‐Markov model, due to their affinity to geographic information system (GIS) and remote sensing (RS), are appropriate for detailed resolution modelling and simulating dynamic spatial processes. In Iran, the district of Ravansar has undergone severe LULC changes recently, thus to take the necessary precautions, decision‐makers need to predict and determine the extent of these changes. In this study, using spatial analysis methods the LULC changes in Ravansar were investigated from 1992 to 2015. Subsequently, the CA‐Markov model was applied to simulate the spatial pattern changes of LULC until 2030. Our results indicated that from 1992 to 2015, this region has witnessed a noticeable increase in the areas of the built‐up and agricultural lands (both aquatic and non‐aquatic), resulting in the decrease of the gardens, range, and bare lands. The simulated LULC map showed that this trend will continue due to more urbanization and development of agricultural areas.     

Underground Temperature Measurements as a Tool for Volcanic Activity Monitoring in the Island of Tenerife, Canary Islands

The spatial distribution of groundwater temperatures in the volcanic island of Tenerife, Canary Islands, has been inferred through measurements of water temperatures collected in the vast network of wells and subhorizontal tunnels, locally called “galleries,” which constitutes the main water supply of the island. The spatial coverage of the network of galleries allows us to reach from depth almost any geological feature of the island. The complex spatial distribution of temperatures in the interior of Tenerife is the result of the complex geological evolution of the island. Groundwater temperatures are greatly affected by groundwater flow and are considerably warmer in those galleries located in areas where water circulation is reduced due to the low permeability of materials and/or to the low infiltration rate of cooling meteoric water. In this sense, groundwater temperature should be characterized in quiescent conditions (background level), in order to facilitate monitoring changes in heat flow, such as those induced by ascending gases expected with an increase in volcanic activity.     

Influence of instruments on the H/V spectral ratios of ambient vibrations

For an optimal analysis of the H/V curve, it appears necessary to check the instrument signal to noise ratio in the studied frequency band, to ensure that the signal from the ground noise is well above the internal noise. We assess the reliability and accuracy of various digitizers, sensors and/or digitizer-sensor couples. Although this study is of general interest for any kind of seismological study, we emphasize the influence of equipment on H/V analysis results. To display the impact of the instrumental part on the H/V behavior, some series of tests have been carried out following a step-by-step procedure: first, the digitizers have been tested in the lab (sensitivity, internal noise...), then the three components sensors, still in the lab, and finally the usual user digitizers-sensors couple in lab and outdoors. In general, the digitizer characteristics, verified during this test, correspond well to the manufacturer specifications, however, depending on the digitizer, the quality of the digitized waveform can be very good to very poor, with variation from a channel to another channel (gain, time difference etc.). It appears very clearly that digitizers need a warming up time before the recording to avoid problems in the low-frequency range. Regarding the sensors, we recommend strongly to avoid the use of “classical” accelerometers (i.e., usual force balance technology). The majority of tested seismometers (broadband and short period, even 4.5 Hz) can be used without problems from 0.4 to 25 Hz. In all cases, the instrumentation should be checked first to verify that it works well for the defined study aim, but also to define its limit of use (frequency, sensitivity...).     

Early Mesozoic mantle-crust transitional zone in eastern Inner Mongolia: Evidence from measurements of compressional velocities of xenoliths at high pressure and high temperature

Compression wave velocityV _p has been measured on 10 representative rock samples from the Early Mesozoic granulite and mafic-ultramafic cumulate xenoliths population from the Harqin area of the Inner Mongolia Autonomous Region (for short Inner Mongolia) as an aid to interpretingin-situ seismic velocity data and investigating velocity variation with depth in a mafic lower crust. The experiments have been carried out at constant confining pressures up to 1 000 MPa and temperatures ranging from 20 to around 1 300°C, using the ultrasonic transmission technique. After corrections for estimatedin situ crustal pressures and temperatures, elastic wave velocities range from 6.5 to 7.4 km·s^?1, indicating that they are components of the Early Mesozoic crust-mantle transitional zone. Combining with previous experimental data, we have also reestablished the Early-Mesozoic continental compression velocity profile and compared it with those of the present and of the different tectonic environments in the world. The result shows that it is similar to the velocity pattern of the extensional tectonic area, providing new clues to the Mesozoic continental structure of the North China Craton.     

Distribution of arsenic and mercury in subtropical coastal beachrock,Gulf of Mannar,India

An assessment of coastal pollution was made on the basis of trace element concentrations (arsenic — As, mercury — Hg) in the Gulf of Mannar. The beachrock samples were collected along the coastal tracts between Rameswaram and Kanyakumari. The samples were dried and digested to determine the As and Hg using atomic absorption spectrophotometer (AAS-air-acetylene and nitrous oxide method). The As and Hg accumulation status of the beachrock was assessed using geo-accumulation index values (I _geo). The accumulation of As and Hg in the beachrock ranges from 2.75 to 20.72 μg g⁻¹ and from 0.06 to 0.31 μg g⁻¹, respectively. The As and Hg concentrations in the beachrocks are compared with crustal average values and average of other region sediments. The possible source of the contamination is from atmospheric deposition and anthropogenic activities.     

Origin of uranium and rare earth minerals in bone detritus from rare metal deposits

In order to ascertain the forms in which uranium is present in ores of the Melovoe rare metal sedimentary deposit of uranium and rare earth minerals (South Mangyshlak), we investigated a series of typical ore samples that were collected earlier; both the uranium content and the total content of rare earth metals in them lay within 0.1–0.3%. The study was carried out by analytical electron microscopy using transmission electron microscopy and scanning electron microscopy, electron microdiffraction, and microprobing. It was ascertained that both uranium and rare earth elements are present in ore mostly associated with biogenic phosphate in the form of natural minerals, such as uraninite, ningyoite, coffinite, autenite, and churchite. Iron hydroxides and graphitized organic matter are present in some samples. It is assumed that the co-occurrence of uranium and rare earth elements, which is nontypical for the sedimentary process, resulted from secondary epigenetic processes and alternation of reducing and oxidizing environmental conditions.     

Features of the upper atmosphere revealed by analysis of the orbit of cosmos 1009 rocket, 1978-50B

COSMOS 1009 rocket was launched on 19 May 1978 into an orbit with initial perigee height 150 km and apogee 1100 km: its lifetime was only 17 days. The orbit has been determined daily during the final 14 days of its life, using the RAE orbit refinement program PROP6,with about 1100 observations supplied by NORAD. An average accuracy of about 60 m, radial and cross-track, was achieved.The orbits were analysed to reveal three features of the upper atmosphere at heights between 125 and 175 km. From the decrease in perigee height, five values of density scale height, accurate to ±4%, were obtained. The first three were within 10% of those from CIRA 1972; the fourth, after a magnetic storm, was higher than expected; the fifth gave evidence of the decrease in drag coefficient at heights below 130 km.Atmospheric oblateness produced a change of 4° in perigee position during the last four days of the life. Analysis showed that the ellipticity of the upper atmosphere was approximately equal to that of the Earth, f, for the first two of the four days, and about $\text{1}\text{2}\text{f}$ in the last two.The orbital inclination decreased during the 14 days by about 50 times its standard deviation, and the observed variation was analysed to determine zonal winds at heights of 150–160 km at latitudes near 47° north. The zonal wind was very weak (0±30 m/s) for 23–28 May at local times near 03h; and 90±30 m/s east-to-west for 29 May to 4 June at local times near 01 h.