Environmental hydrogeology of the southern sector of the Samborombon Bay wetland,Argentina

The Samborombon Bay wetland is located on the west margin of the Rio de la Plata estuary, in the Province of Buenos Aires, Argentina. This paper analyses the geological, geomorphologic, soil and vegetation characteristics of the southernmost sector of this wetland and their influence on surface water and groundwater. The study area presents three hydrologic units: coastal dunes, sand sheets and coastal plain. Coastal dunes and sand sheets are recharge zones of high permeability with well-drained, non-saline soils, and a few surface water flows. Changes in the water table are related to rainfall. Groundwater in coastal dunes is Ca–Mg–HCO₃ to Na–HCO₃, and of low salinity (590 mg/l). Groundwater in sand sheets is mainly Na–HCO₃ with a salinity of about 1,020 mg/l. The coastal plain exhibits medium to low permeability sediments, with submerged saline soils poorly drained. Groundwater is Na–Cl with a mean salinity of 16,502 mg/l. A surface hydrological network develops in the coastal plain. Surface water levels near the shoreline are affected by tidal fluctuations; far from the shoreline water accumulates because of poor drainage. Both sectors have Na–Cl water, but the former is more saline. Human intervention and sea level rise may affect the wetland severely.     

Modifications of the porous network of sandstone accompanying the formation of black varnish

Black varnish commonly develops on rain-washed fine-grained monument sandstone. Stone modifications are, to the naked eye, limited to 10-μm thick black film and underlying modified zone about 1-mm thick. Transfer properties (absorption and drying kinetics and permeability) are, however, modified several centimetres under the surface. The present study investigates the modifications of black-varnish covered siliceous sandstones taken from Alsatian monuments (East of France) and of fresh sandstone undergoing wetting–drying cycles in the laboratory. Double-coloured thin-sections revealed gradual changes in the porous network, up to 3 cm under the black varnish. SEM observations showed that the film was mainly composed of iron and phosphorus while the modified zone was rich in calcium and sulphur. Fifty capillary absorption–drying cycles were carried out on fresh sandstone. Absorption kinetics was measured at each cycle. A continuous decrease of sandstone absorption kinetics over the fifty cycles was interpreted as a reorganisation of the porous network, reducing the connectivity of the porous network although total porosity remained unchanged. Wetting–drying cycles carried out under an environmental microscope (ESEM) showed a displacement of the finest particles (clay clusters), filling the macroporosity and decreasing the connectivity.     

High‐pressure metamorphism in Taiwan: from oceanic subduction to arc‐continent collision?

Abstract The Taiwan orogen has been the focus of a number of models of mountain building processes, but little attention has been paid to high‐pressure (HP) metamorphic rocks that are found as exotic blocks intermingled within the deepest units of the mountain belt. In this study, we re‐appraise from updated petrological and thermodynamic databases the physical conditions of HP metamorphism in Taiwan, and we combine our findings with available geochronological data to estimate the thermal history of these rocks. Our results indicate that peak metamorphic conditions of ～550 °C and 10–12 kbar have been followed by a rapid isothermal decompression, with exhumation possibly as rapid as burial. These units have subsequently been stored at a pressure of ～3 kbar for ～4–5 Myr, before their final exhumation, probably facilitated by the accretion of passive margin sequences during the Late Cenozoic collision. Therefore, HP units in Taiwan maintain a record of processes at depth from the early stages of oceanic subduction to the present arc‐continent collision.     

Interference of Multiple Strip Footings on Sand Using Small Scale Model Tests

By using small scale model tests, the interference effect on the vertical load-deformation behavior of a number of equally spaced strip footings, placed on the surface of dry sand, was investigated. At any stage, all the footings were assumed to (i) carry exactly equal magnitude of load, and (ii) settle to the same extent. No tilt of the footing was permitted. The effect of clear spacing (s) among footings on the results was explored. A new experimental setup was proposed in which only one footing needs to be employed rather than a number of footings. The bearing capacity increases continuously with decrease in spacing among the footings. The interference effect becomes further prominent with increase in soil friction angle. In contrast to an increase in the bearing capacity, with decrease in spacing of footings, an increase in the footing settlement associated with the ultimate state of shear failure was observed. The present experimental observations were similar to those predicted by the available theory, based on the method of characteristics. As compared to the theory, the present experimental data, however, indicates much greater effect of interference especially for larger spacing among footings.     

Analysis of the 2003 Varunawat Landslide,Uttarkashi, India using Earth Observation data

Mass movements such as landslides in mountainous terrains are natural degradation processes and one of the most important landscape-building factors. Varunawat Parbat overlooking Uttarkashi town witnessed a series of landslides on 23 September 2003 and the debris slides and rock falls continued for 2 weeks. This landslide complex was triggered due to the incessant rainfall prior to the event, and its occurrence led to the blockage of the pilgrim route to Gangotri (source of the Ganges river) and evacuation of thousands of people to safer places. Though there was no loss of lives due to timely evacuation, heavy losses to the property were reported. High-resolution stereoscopic earth observation data were acquired after the incidence to study the landslide in detail with emphasis on the cause of the landslide and mode of failure. Areas along the road and below the Varunawat foothill region are mapped for landslide risk. It was found that the foothill region of the Varunawat Parbat was highly disturbed by man-made activities and houses are dangerously located below steep slopes. The potential zones for landslides along with the existing active and old landslides are mapped. These areas are critical and their treatment with priority is required in order to minimise further landslide occurrences.     

Finite Element Modeling of Swelling Soil Pressures Using Joint/Interface Elements

There could be some discontinuities in a soil media such as layers, earth structures, cracks, and fissures so that estimation of stresses and deformations in these types of soil masses are somewhat different from continuous masses. The discontinuities in a soil mass could be considered as a special link between two blocks. Transmitted swelling pressures affected by the soil properties of the backfill especially at the interface between the backfill and retaining wall. In order to estimate the transmitted swelling pressure distribution behind a retaining wall, using with interface element, a new finite element model and a code (SWELPRES) have been developed. To evaluate the effect of backfill characteristics and interface element from the transmitted lateral swelling pressures, four cases of thickness of backfills with or without interface elements are investigated.     

Monitoring Large-Scale Tests for Nuclear Waste Disposal

Two large-scale “in situ” demonstration experiments and their instrumentation are described. The first test (FEBEX Experiment) involves the hydration of a compacted bentonite barrier under the combined effect of an inner source of heat and an outer water flow from the confining saturated granite rock. In the second case, the progressive de-saturation of Opalinus clay induced by maintained ventilation of an unlined tunnel is analyzed. The paper shows the performance of different sensors (capacitive cells, psychrometers, TDR’s) and a comparison of fill behaviour with modelling results. The long term performance of some instruments could also be evaluated specially in the case of FEBEX test. Capacitive sensors provide relative humidity data during long transient periods characterised by very large variations of suction within the bentonite.     

饱和粉砂不稳定性的试验研究

通过对净砂和级配良好粉砂(含10 %粉土)进行一系列三轴固结不排水试验（CU）,研究了粉土、孔隙比和围压对饱和粉砂不稳定性的影响。试验结果表明,净砂与粉砂在不排水剪切条件下均会出现应变软化现象（即不稳定性）。同一围压下脆性指数(IB)随孔隙比增加,但不稳定线的应力比随孔隙比增加而减小。引用等效粒间孔隙比(ege)后,净砂和粉砂在ege-ln p?平面上拥有基本相同的临界状态线。在临界状态理论及等效粒间孔隙比的基础上,提出在同一修正状态参数(?ge)下净砂和级配良好粉砂有相似的不稳定性。