Seasonal extreme rainfall variability over India and its association with surface air temperature

Theoretical and Applied Climatology - Spatial variability in catchment processes is crucial for hydrologic and water resources planning and management. The spatial density of ground-based rain...     

Mudbank regime off the Kerala coast during monsoon and non-monsoon seasons

Field experiments conducted in the nearshore ocean to understand the dynamics of mudbank off Kerala, south-west coast of India, are highlighted. Real time monitoring of the nearshore ocean off Purakkad, Kerala was accomplished using pressure transducers for nearshore surface wave measurements, and current sensors for nearshore velocity measurements. Comprehensive information on the spatial structure of mudbank was obtained from aerial surveys. Extensive data collected on surface waves and currents in the nearshore ocean, indicate that the infra-gravity (IG) waves (leaky modes and trapped edge wave modes), and far infra-gravity (FIG) waves coupled with strong shoreline reflections and undertow play an important role in the dynamics associated with the mudbanks off Kerala during the monsoon season. During the non-monsoon season evidence for progressive edge waves in the infragravity frequency band, an energetic gravity wave band and a strong undertow with weak reflections was observed.     

Numerical Simulation of North Indian Ocean State Prior to the Onset of SW Monsoon Using SSM/I Winds

The Sea Surface Temperatures (SST) and currents are simulated over the north Indian Ocean, during the onset phase of southwest monsoon for the three years 1994, 1995, and 1996, using daily Special Sensor Microwave/Imager (SSM/I) winds and National Center for Environmental Prediction (NCEP) heat fluxes as forcings in the 2½ layer thermodynamic numerical ocean model. The results are discussed for the 30-day period from 16 May to 13 June for all the three years, to determine the ocean state during the onset phase of SW monsoon. The maximum variability in the simulated SST is found along the Somali coast, Indian coasts, and equatorial regions. The maximum SST in the North Arabian Sea is found to be greater than 30°C and minimum SST in the west equatorial region is 25°C during the onset phase of all three years. Model SSTs are in agreement with Reynolds SST. SST gradients in the north-south as well as in the east-west directions, west of 80°E are found to change significantly prior to the onset. It can be inferred from the study that the SST gradient of 2.5°C/2000 km is seen due north and due west of the region 2° - 7°S, 60° - 65°E, about 8 to 10 days prior to the arrival of SW monsoon near Kerala coast. Upper and lower layer circulation fields do not show prominent interannual variability.     

Determination of Ocean Wave Period from Altimeter Data Using Wave-Age Concept

This study makes use of the concept of wave age in estimating ocean wave period from space borne altimeter measurements of backscattering coefficient and significant wave height. Introduction of wave age allowed better accounting of the difference between swells and wind waves. Using two years (1998 and 1999) data of TOPEX/Poseidon altimeter and ocean data buoy observations in the Indian Ocean, coefficients were generated for wave period, which were subsequently tested against data for the years 2000 and 2001. The results showed the wave period accuracy to be of the order of 0.6 sec (against 1.3 sec obtained with the semiempirical approach, reported earlier).     

Concurrent Use of OSCAT and AltiKa to Characterize Antarctic Ice Surface Features

Radar altimetry provides an important geophysical parameter, backscatter coefficient (σ₀), which is useful in studying target surface characteristics. Ku-band (Oceansat-2 scatterometer- OSCAT) and Ka-band (SARAL-AltiKa altimeter) data are concurrently used to characterize polar surface features over the Antarctic region. Maximum-likelihood classification has been employed to classify combined data set (AltiKa and OSCAT) for discrimination among sea ice, open water, and ice sheet (interior and exterior). The sea ice region obtained using the current approach has been compared with sea ice boundary derived from passive microwave data.     

Physical and biological response of the Arabian Sea to tropical cyclone Phyan and its implications

The response to the tropical cyclone Phyan, which developed in the eastern Arabian Sea during 9-11 November 2009, was rapid cooling of sea surface temperature (SST), enhancement of chlorophyll a and two-fold increase in net primary productivity (NPP). Cooling of SST was immediate in response to the strong wind-mixing, and the subsequent upward Ekman pumping sustained the cooling even after the dissipation of Phyan. The biological response mediated by the upward Ekman pumping driven vertical transport of subsurface nutrient showed a time lag of 3-4 days. The CO? flux to the atmosphere associated with Phyan was 0.123 Tg C, which accounted for ~85% of the total out-gassing from the eastern Arabian Sea during November. Thus, an increased occurrence of cyclones in a warming environment will lead to an enhanced biomass production and also increase in CO? out-gassing.     

Measurement and modeling of bed shear stress under solitary waves

Direct measurements of bed shear stresses (using a shear cell apparatus) generated by non-breaking solitary waves are presented. The measurements were carried out over a smooth bed in laminar and transitional flow regimes (~ 10⁴ < R_e < ~ 10⁵). Measurements were carried out where the wave height to water depth (h/d) ratio varied between 0.12 and 0.68; maximum near bed velocity varied between 0.16 m/s and 0.51 m/s and the maximum total shear stress (sum of skin shear stress and Froude–Krylov force) varied between 0.386 Pa and 2.06 Pa. The total stress is important in determining the stability of submarine sediment and in sheet flow regimes. Analytical modeling was carried out to predict total and skin shear stresses using convolution integration methods forced with the free stream velocity and incorporating a range of eddy viscosity models. Wave friction factors were estimated from skin shear stress at different instances over the wave (viz., time of maximum positive total shear stress, maximum skin shear stress and at the time of maximum velocity) using both the maximum velocity and the instantaneous velocity at that phase of the wave cycle. Similarly, force coefficients obtained from total stress were estimated at time of maximum positive and negative total stress and at maximum velocity. Maximum positive total shear stress was approximately 1.5 times larger than minimum negative total stress. Modeled and measured positive bed shear stresses are well correlated using the best convolution model, but the model underestimates the data by about 4%. Friction factors are dependent on the choice of normalizing using the maximum velocity, as is conventional, or the instantaneous velocity. These differ because the stress is not in phase with the velocity in general. Friction factors are consistent with previous data for monochromatic waves, and vary inversely with the square-root of the Reynolds number. The total shear stress leads the free stream fluid velocity by approximately 50°, whereas the skin friction shear stress leads by about 30°, which is similar to that reported by earlier researchers.     

On the application of similitude to installation operations of offshore steel jackets

The role of similitude in scaled simulation of major installation operations of offshore steel jackets, namely, loadout, launching and upending has been studied. The physical modelling can be looked upon both as an adjunct to numerical modelling using computers and also as an independent tool of investigation. The problems of design of models and of experiments are discussed and the prediction equations based on similitude are given.