Influence of the mean period of ground motion on the inelastic dynamic response of single and multi degree of freedom systems

This paper focuses on examining the effects of frequency content of the ground motion on the inelastic demands imposed on both single degree of freedom (SDF) and multi degree of freedom (MDF) steel‐framed systems. A detailed literature review is conducted to identify the indicator that best represents the frequency content of ground motion. The mean period (T_m) of ground motion is selected owing to its ability to distinguish between various spectral shapes of ground motion, and its relationship with magnitude, distance and site characteristics. Inelastic displacement demands on SDF systems for target ductility levels are first studied in the light of T_m, using a suite of 128 ground motion records. The study is then extended to MDF systems with the help of incremental dynamic analysis by employing the same ground motion ensemble to assess the influence of T_m on various engineering demand parameters. The results obtained indicate that, for SDF systems, the amplification of displacements occurs when the period ratio between elastic period (T_e) and T_m is lower than unity. For MDF systems, the results demonstrate that the influence of higher modes on the base shear and maximum storey drift profile becomes more pronounced, as T_m approaches the higher mode periods of the structure. These observations, for both SDF and MDF systems, tend to be more evident for higher levels of inelasticity. The significance of the results, with particular reference to European seismic design procedures, is highlighted. Copyright © 2010 John Wiley & Sons, Ltd.     

Variation of δ18O, δD and 3H in karst springs of south Kashmir,western Himalayas (India)

Water samples were collected from cold and warm karst springs for stable isotopes (δ¹⁸O and δD) and ³H from SE of Kashmir valley (western Himalayas) to distinguish the sources of recharge and infer their recharge areas. The spring water samples were most depleted in heavier isotopes in May (average δ¹⁸O: ?8.87‰ and δD: ?50.3‰) and enriched in September (average δ¹⁸O: ?7.58‰ and δD: ?48.1‰). The depleted ¹⁸O and ²H of spring waters bear the signatures of winter precipitation while as the enriched ¹⁸O and ²H of spring waters bear the signature of summer rainfall. D‐excess and ³H corroborate with the stable isotope results that the spring flow in spring season (May) and autumn (September) is dominantly controlled by the melting of winter snowmelt and summer rainfall, respectively. The results showed that unlike δD, the δ¹⁸O value in the karst spring waters decreases in January suggesting δ¹⁸O shift. The spring water samples also fall above the Local Meteoric Water Line and Global Meteoric Water Line indicating the δ¹⁸O shift due to interaction of groundwater with the host carbonate rocks during its traverse. The mean elevation of the recharge areas of the springs using δ¹⁸O and δD tracers was also estimated. Copyright © 2014 John Wiley & Sons, Ltd.     

Generation and hydrocarbon entrapment within Gondwanan sediments of the Mandapeta area, Krishna-Godavari Basin, India

The discovery of hydrocarbons (mainly gas) in commercial quantities from Gondwanan sediments in the Mandapeta field of Krishna-Godavari Basin, India, provided impetus for intensified exploration in Mandapeta and the adjoining Kommugudem, Draksharama and Endamuru fields. Both oil and gas have been found in the reservoirs of Mandapeta (Triassic) and Golapalli (Early Cretaceous) formations. Mature, localised, basal shales (1.0–1.1% Ro) in the Mandapeta formation have sourced the oils from the Mandapeta Sandstone reservoir (Triassic). The oils being produced from Golapalli Sandstone reservoir (Early Cretaceous) are relatively less mature and have been sourced by the underlying shales in the Mandapeta Formation at a maturity level of 0.80–0.85% Ro. The source and maturity data preclude liquid hydrocarbon sourcing from the Kommugudem (Permian) sequence. Permian coals and shales of the Kommugudem Formation are the major source rocks for gaseous hydrocarbons in this area. The hydrocarbon generation started in Early Cretaceous in the Kommugudem Formation, but the intermittent tectonic activity (with associated structural developments) has resulted in reorientation and redistribution of the then existing trap configurations. The present day maturity level of the Permian sediments in the Mandapeta field is 1.2% Ro or greater, capable of generating gas dominantly. The Raghavapuram shale in the Mandapeta area is adequately mature and has good hydrocarbon potential for oil generation. The probability of finding hydrocarbon reserves in the sands of Raghavapuram shales and other suitable traps is high. Modern seismic information together with geologic models can give new exploration leads.     

Geochemical Eccentricity of Ground Water Allied to Weathering of Basalts from the Deccan Volcanic Province,India: Insinuation on CO<Subscript>2</Subscript> Consumption

Analyses of 72 samples from Upper Panjhara basin in the northern part of Deccan Plateau, India, indicate that geochemical incongruity of groundwater is largely a function of mineral composition of the basaltic lithology. Higher proportion of alkaline earth elements to total cations and HCO₃>Cl + SO₄ reflect weathering of primary silicates as chief source of ions. Inputs of Cl, SO₄, and NO₃ are related to rainfall and localized anthropogenic factors. Groundwater from recharge area representing Ca + Mg–HCO₃ type progressively evolves to Ca + Na–HCO₃ and Na–Ca–HCO₃ class along flow direction replicates the role of cation exchange and precipitation processes. While the post-monsoon chemistry is controlled by silicate mineral dissolution + cation exchange reactions, pre-monsoon variability is attributable chiefly to precipitation reactions + anthropogenic factors. Positive correlations between Mg vs HCO₃ and Ca + Mg vs HCO₃ supports selective dissolution of olivine and pyroxene as dominant process in post-monsoon followed by dissolution of plagioclase feldspar and secondary carbonates. The pre-monsoon data however, points toward the dissolution of plagioclase and precipitation of CaCO₃ supported by improved correlation coefficients between Na + Ca vs HCO₃ and negative correlation of Ca vs HCO₃, respectively. It is proposed that the eccentricity in the composition of groundwater from the Panjhara basin is a function of selective dissolution of olivine > pyroxene followed by plagioclase feldspar. The data suggest siallitization (L < R and R _k) as dominant mechanism of chemical weathering of basalts, stimulating monosiallitic (kaolinite) and bisiallitic (montmorillonite) products. The chemical denudation rates for Panjhara basin worked out separately for the ground and surface water component range from 6.98 to 36.65 tons/km²/yr, respectively. The values of the CO₂ consumption rates range between 0.18 × 10⁶ mol//km²/yr (groundwater) and 0.9 × 10⁶ mol/km²/yr (surface water), which indicates that the groundwater forms a considerable fraction of CO₂ consumption, an inference, that is, not taken into contemplation in most of the studies.     

Evaluating the Long-term Urban Expansion of Ranchi Urban Agglomeration,India Using Geospatial Technology

The present study analyzes the built-up expansion of Ranchi urban agglomeration over a period of about 8 decades from 1927–2005. Satellite images and topographical maps were used to evaluate land use dynamics during these periods. Built-up growth of 473.7% during 1927–2005 was primarily at the expense of agricultural land along with reduction of natural water bodies reflects negative impacts of built-up expansion, which increased many folds in recent decades. The built-up growth is also analyzed with reference to population growth, land consumption rate and land transformation. The land loss due to increasing built-up growth of Ranchi were compared with other capital regions and cities along with population increase to provide insight into the possible scenario of built-up expansion in Ranchi urban area.     

Retention studies of chromium (VI) from aqueous solution on the surface of a novel carbonaceous material

In the present study, the retention capacity of carbonaceous material obtained from the diesel engine exhaust mufflers for Cr(VI) removal has been investigated. The physicochemical properties such as density, pH of aqueous slurry, pH at point of zero charge, ash content, moisture content, volatile matter, surface area, scanning electron microscopy and electron dispersive spectroscopy of the carbonaceous material were determined. The capacity of adsorbent for removal of Cr(VI) from aqueous solution was observed under different experimental condition like contact time, initial concentration of metal ions, pH and temperatures on the adsorption capacity of the adsorbent. Maximum adsorption of Cr(VI) ions was found at low pH. The adsorption process was found to follow second-order kinetics. The rate constant was evaluated at different temperatures along with other thermodynamic parameters like activation energy, Gibbs free energy change, enthalpy change and entropy change. Both Langmuir and Freundlich isotherms were used to describe the adsorption equilibrium of carbonaceous material at different temperatures. Langmuir isotherm shows better fit than Freundlich isotherm at given conditions. The result shows that low-cost carbonaceous material from diesel engine exhaust mufflers can be efficiently used for wastewater treatment containing Cr(VI) ions.     

Aftershock activity of Bhuj earthquake of january 26th, 2001

Following a large-sized Bhuj earthquake (M _s = 7.6) of January 26th, 2001, a small aperture 4-station temporary local network was deployed, in the epicentral area, for a period of about three weeks and resulted in the recording of more than 1800 aftershocks (-0.07 ≤M _L <5.0). Preliminary locations of epicenters of 297 aftershocks (2.0 ≤M _L <5.0) have brought out a dense cluster of aftershock activity, the center of which falls 20 km NW of Bhachau. Epicentral locations of after-shocks encompass a surface area of about 50 × 40 km² that seems to indicate the surface projection of the rupture area associated with the earthquake. The distribution of aftershock activity above magnitude 3, shows that aftershocks are nonuniformly distributed and are aligned in the north, northwest and northeast directions. The epicenter of the mainshock falls on the southern edge of the delineated zone of aftershock activity and the maximum clustering of activity occurs in close proximity of the mainshock. Well-constrained focal depths of 122 aftershocks show that 89% of the aftershocks occurred at depths ranging between 6 and 25 km and only 7% and 4% aftershocks occur at depths less than 5 and more than 25 km respectively. The Gutenberg-Richter (GR) relationship, logN = 4.52 - 0.89M_L, is fitted to the aftershock data (1.0<-M _L<5.0) and theb-value of 0.89 has been estimated for the aftershock activity.     

Interannual variability of Kelvin wave propagation in the wave guides of the equatorial Indian Ocean,the coastal Bay of Bengal and the southeastern Arabian Sea during 1993–2006

The observed variability of the Kelvin waves and their propagation in the equatorial wave guide of the Indian Ocean and in the coastal wave guides of the Bay of Bengal (BoB) and the southeastern Arabian Sea (AS) on seasonal to interannual time scales during years 1993–2006 is examined utilizing all the available satellite and in-situ measurements. The Kelvin wave regime inferred from the satellite-derived sea surface height anomalies (SSHA) shows a distinct annual cycle composed of two pairs of alternate upwelling (first one occurring during January–March and the second one occurring during August–September) and downwelling (first one occurring during April–June and the second one occurring during October–December) Kelvin waves that propagate eastward along the equator and hit the Sumatra coast and bifurcate. The northern branches propagate counterclockwise over varied distances along the coastal wave guide of the BoB. The potential mechanisms that contribute to the mid-way termination of the first upwelling and the first downwelling Kelvin waves in the wave guide of the BoB are hypothesized. The second downwelling Kelvin wave alone reaches the southeastern AS, and it shows large interannual variability caused primarily by similar variability in the equatorial westerly winds during boreal fall. The westward propagating downwelling Rossby waves triggered by the second downwelling Kelvin wave off the eastern rim of the BoB also shows large interannual variability in the near surface thermal structure derived from SODA analysis. The strength of the equatorial westerlies driven by the east–west gradient of the heat sources in the troposphere appears to be a critical factor in determining the observed interannual variability of the second downwelling Kelvin wave in the wave guides of the equatorial Indian Ocean, the coastal BoB, and the southeastern AS.     

Modelling Short‐Scale Variability and Uncertainty During Mineral Resource Estimation Using a Novel Fuzzy Estimation Technique

For mineral resource assessment, techniques based on fuzzy logic are attractive because they are capable of incorporating uncertainty associated with measured variables and can also quantify the uncertainty of the estimated grade, tonnage etc. The fuzzy grade estimation model is independent of the distribution of data, avoiding assumptions and constraints made during advanced geostatistical simulation, e.g., the turning bands method. Initially, fuzzy modelling classifies the data using all the component variables in the data set. We adopt a novel approach by taking into account the spatial irregularity of mineralisation patterns using the Gustafson–Kessel classification algorithm. The uncertainty at the point of estimation was derived through antecedent memberships in the input space (i.e., spatial coordinates) and transformed onto the output space (i.e., grades) through consequent membership at the point of estimation. Rather than probabilistic confidence intervals, this uncertainty was expressed in terms of fuzzy memberships, which indicated the occurrence of mixtures of different mineralogical phases at the point of estimation. Data from different sources (other than grades) could also be utilised during estimation. Application of the proposed technique on a real data set gave results that were comparable to those obtained from a turning bands simulation.