Computer-aided design of bus route maps

The bus route map is a diagram that aims to convey necessary information for map readers to find an appropriate way of moving from an origin to a destination. Design of bus route map is a complicated and time-consuming task that requires careful consideration of readability and aesthetics. This paper proposes a new computational method for designing bus route maps. The method helps us to reduce six types of undesirable elements in bus route maps, i.e., gap, shift, crossing, overlap, misalignment, and acute bend. The method consists of two phases: line layout phase determines the relative order of bus routes on each road segment and map layout phase calculates the actual position of bus routes drawn on a map. This paper applies the method to the design of bus route maps of Chiba City, Japan. The result supports the effectiveness of the method as well as reveals open topics for future research.     

Mineralogy and geochemical behaviour during weathering of greenstone belt under tropical dry conditions in the extreme North Cameroon (Central Africa)

Mineralogy, major, trace and rare earth elements of a weathering profile developed on tertiary greenstone belt in the extreme North Cameroon are reported. The aim of which was to investigate mineralogical evolution and element mobilization and redistribution during weathering under dry tropical climate. The weathering profile consists of four main horizons: (1) a spheroidal weathering zone constituted by a corestone–shell complex, (2) a C horizon, (3) a Bw horizon and an Ah horizon. The results indicate that nontronite, a Fe-rich smectite, is the exclusive clay mineral formed in the exfoliated shells and the C horizon. It is associated with kaolinite in the upper horizons. The coexistence of these two clay minerals induced a decrease of CEC and pH which becomes neutral. The weathering index (WI) values reveal that weathering becomes more and more intensive from the corestone up to Bw horizon, which is the most weathered horizon in the weathering profile. Mass balance calculations, using Th as immobile element, indicate that Ti is quite mobile and that Al and Fe are relatively enriched at the bottom and strongly leached at the top of the profile. Alkalis and alkaline earth elements are strong leached through out the profile, except Ca which displays similar trend as Al and Fe. The same goes for LILE (Cs, Sr), TTE (Cr, Co, Ni) and HSFE (Y, Nb, Hf). In opposite, REE are depleted at the bottom and enriched in the upper horizons, with more enrichment for LREE than for HREE. It appears that weathering of greenstone belt causes a fractionation of HREE and induces a concentration of LREEs. Ce and Eu anomalies display opposite behaviour.     

Les laves du mont Bangou : une première manifestation volcanique éocène, à affinité transitionnelle,de la Ligne du Cameroun

Mount Bangou, an Eocene volcano (⁴⁰K–⁴⁰Ar ages between 44.7 and 43.1 ± 1 Ma) is the oldest dated volcano of the Cameroon Line. In this region, two magmatic series, evolving by fractional crystallization, show transitional affinities that are exceptionally known in this sector. Mineral compositions of basaltic rocks (scarce modal olivine and occurrence of normative hypersthene) as well as geochemical characteristics (low Ba, La, Ta contents and high Y/Nb ratios) are in agreement with this trend. The succession of magmas evolving in time from transitional to more typical alkaline compositions is evidenced in a continental setting. To cite this article: J. Fosso et al., C. R. Geoscience 337 (2005).     

Varved sediments of Lake Yoa (Ounianga Kebir,Chad) reveal progressive drying of the Sahara during the last 6100 years

The sedimentological and geochemical properties of a 7·47 m long laminated sequence from hypersaline Lake Yoa in northern Chad have been investigated, representing a unique, continuous 6100 year long continental record of climate and environmental change in the eastern Central Sahara. These data were used to reconstruct the Mid to Late Holocene history of this currently hyper‐arid region, in order to address the question of whether the Mid Holocene environmental transition from a humid to a dry Sahara was progressive or abrupt. This study involved a suite of analyses, including petrographic and scanning electron microscope examination of thin sections, X‐ray diffraction, X‐radiography, granulometry, loss on ignition and magnetic susceptibility. The potential of micro‐X‐ray fluorescence core scanning was tested at very high resolution. Detailed microscopic investigation revealed the sedimentary processes responsible for the formation of the fine laminations, identified the season during which they were formed, and confirmed their annually rhythmic nature. High‐resolution X‐ray fluorescence core scanning allowed the distinction of each individual lamination over the entire record, opening new perspectives for the study of finely laminated sediment sequences. Geochemical and mineralogical data reveal that, due to decreasing monsoon rainfall combined with continuous and strong evaporation, the hydrologically open and fresh Mid Holocene Lake Yoa slowly evolved into the present‐day hypersaline brine depleted in calcium, which has existed for about the past 1050 years. During the oldest part of the investigated period, Lake Yoa probably contained a permanently stratified lower water column that was nevertheless disrupted relatively frequently by mixing events. Deep‐water anoxia became more stable because of increased salinity‐driven density stratification. In parallel, the sediment grain‐size proxies record a progressive increase of aeolian input in the course of the last 6100 years. Altogether, all geochemical and sedimentological indicators point to a progressive drying of the eastern Central Sahara, strengthening previous conclusions based on palaeoecological indicators.     

Enhanced Oxygen Isotope Determination in Uranium Oxides Using BrF5 Fluorination

A new method for accurate determination of oxygen isotopes in uranium oxides encountered in the nuclear fuel cycle was developed using the conventional BrF₅ fluorination technique. Laser‐assisted fluorination was tested for comparison. We focused on fine powders of triuranium octoxide (U₃O₈), uranium dioxide (UO_2±x with 0 ≤ x ≤ 0.25), uranium trioxide (UO₃.nH₂O, with 0.8 ≤ n ≤ 2) and diuranates (M₂U₂O₇.nH₂O, with M = NH₄, Na or Mg_0.5 and 0 ≤ n ≤ 6). Fluorination at room temperature and heating under vacuum at 150 °C are shown to eliminate both adsorbed and structural water from the powder samples. Precision fit for purpose of δ¹⁸O values (± 0.3‰, 1s) and oxygen yields (close to 100%) were obtained for U₃O₈ and UO₂ where oxygen is only bound to uranium. A lower precision was observed for UO₃.nH₂O and M₂U₂O₇.nH₂O where oxygen is both present in the structural H₂O and bonded to uranium and where the extracted O_2(g) can be contaminated by NF₃ and NO_x compounds. Laser‐assisted fluorination gave shifted δ¹⁸O values between +0.8 and +1.4‰ for U₃O₈, around ?0.8‰ for UO₃.nH₂O and between ?3.9 and ?4.5‰ for M₂U₂O₇.nH₂O (± 0.3‰, 1s) compared with the conventional method.     

Fitting the Linear Model of Coregionalization by Generalized Least Squares

In geostatistical studies, the fitting of the linear model of coregionalization (LMC) to direct and cross experimental semivariograms is usually performed with a weighted least-squares (WLS) procedure based on the number of pairs of observations at each lag. So far, no study has investigated the efficiency of other least-squares procedures, such as ordinary least squares (OLS), generalized least squares (GLS), and WLS with other weighing functions, in the context of the LMC. In this article, we compare the statistical properties of the sill estimators obtained with eight least-squares procedures for fitting the LMC: OLS, four WLS, and three GLS. The WLS procedures are based on approximations of the variance of semivariogram estimates at each distance lag. The GLS procedures use a variance–covariance matrix of semivariogram estimates that is (i) estimated using the fourth-order moments with sill estimates (GLS₁), (ii) calculated using the fourth-order moments with the theoretical sills (GLS₂), and (iii) based on an approximation using the correlation between semivariogram estimates in the case of spatial independence of the observations (GLS₃). The current algorithm for fitting the LMC by WLS while ensuring the positive semidefiniteness of sill matrix estimates is modified to include any least-squares procedure. A Monte Carlo study is performed for 16 scenarios corresponding to different combinations of the number of variables, number of spatial structures, values of ranges, and scale dependence of the correlations among variables. Simulation results show that the mean square error is accounted for mostly by the variance of the sill estimators instead of their squared bias. Overall, the estimated GLS₁ and theoretical GLS₂ are the most efficient, followed by the WLS procedure that is based on the number of pairs of observations and the average distance at each lag. On that basis, GLS₁ can be recommended for future studies using the LMC.     

Fine sediment transport and accumulations at the mouth of the Seine estuary (France)

A comprehensive study of fine sediment transport in the macrotidal Seine estuary has been conducted, including observations of suspended particulate matter (SPM), surficial sediment, and bathymetric data, as well as use of a three dimensional mathematical model. Tide, river regime, wind, and wave forcings are accounted. The simulated turbidity maximum (TM) is described in terms of concentration and location according to tidal amplitude and the discharge of the Seine River. The TM is mainly generated by tidal pumping, but can be concentrated or stretched by the salinity front. The computed deposition patterns depend on the TM location and are seasonally dependent. The agreement with observations is reasonable, although resuspension by waves may be overestimated. Although wave resuspension is likely to increase the TM mass, it generally occurs simultaneously with westerly winds that induce a transverse circulation at the mouth of the estuary and then disperse the suspended material. The resulting effect is an output of material related to wind and wave events, more than to high river discharge. The mass of the computed TM remains stable over 6 months and independent of the river regime, depending mainly on the spring tide amplitude. Computed fluxes at different cross-sections of the lower estuary show the shift to the TM according to the river flow and point out the rapidity of the TM adjustment to any change of river discharge. The time for renewing the TM by riverine particles has been estimated to be one year.