Tritium profiles in the Weddell Sea

Tritium data were collected between 1985 and 1987 on several cruises of the German research icebreaker “Polarstern” to the Weddell Sea. Maximum tritium concentrations in the surface waters are of the order of 200 mTU. The minimum values observed in the Weddell Sea Deep Water at about 1000 m depth are about 15–40 mTU. The bottom waters show tritium concentrations of about 70–100 mTU in the central gyre, increasing to about 120 mTU in the northwestern corner of the Weddell Sea. The overflowing Ice Shelf Water observed on the continental slope west of the Filchner Depression has tritium concentrations close to those of the surface waters, indicating rapid renewal of this water mass. The data reflect the rapid renewal of the bottom waters in the northwestern corner of the Weddell Sea and the mixing of bottom water from this boundary current into the bottom waters of the central Weddell Gyre.     

Fracture activity: A possible triggering mechanism for slope instabilities in the Eastern Atlantic?

The largest known submarine slope instabilities occur on gently inclined slopes or in the deep sea. The sedimentation rates are mostly too low to induce an excess pore-water pressure sufficient to create failure. A possible triggering mechanism for these instabilities is additional horizontal ground acceleration caused by earthquakes. Old zones of weakness, represented by fracture zones, can be reactivated by isostatic movements and induce seismic activity. The distribution of some major slope instabilities and the trend of fracture zones in the Eastern Atlantic are compared and Fracture activity is suggested as the main triggering mechanism for these slope instabilities.     

Phytoplankton biomass and size fractions in surface waters of the Australian sector of the southern ocean

We collected surface water along the 142nd E meridian from Tasmania to Antarctica in December 1999. We measured temperature, salinity and total chlorophyll a; additionally, we collected suspended particle size fractions and used fluorometric analysis to determine the quantity of chlorophyll a in each of four cell size classes: picoplankton (<3 μm), two nanoplankton fractions (3–10 μm and 10–20 μm) and microplankton (> 20 μm). Changes in temperature and salinity show that we crossed 6 water masses separated by 5 fronts. We found low abundance (<0.2 mg m⁻³) of chlorophyll in all size classes, with the exception of higher values near the continent (0.2 to 0.4 mg m⁻³). Lowest chlorophyll values (<0.1 mg m⁻³) were found in the Polar Frontal Zone (51° to 54°S). Microplankton made up the largest portion of total chlorophyll throughout most of the region. We conclude that biomass of all phytoplankton fractions, especially pico-and nanoplankton, was constrained by limiting factors, most probably iron, throughout the region and that ecosystem dynamics within a zone are not circumpolar but are regionalized within sectors.     

Influence of capture stress, salinity and reproductive status on zinc associated with metallothionein-like proteins in the livers of three marine teleost species

The influence of capture stress, salinity and reproductive status on zinc associated with the metallothionein-like (MT-like) proteins in the livers of three marine teleost species was investigated. In striped mullet, Mugil cephalus L., the zinc associated with the MT-like protein, as determined by gel-permeation HPLC, increased significantly from approximately 102 to 1162 nmol zinc bound/g wet wt 7 days following capture in the field, handling, transportation to the laboratory and transfer to holding tanks. Significant increases were also observed following exposure to reduced salinity for 7 days. Smaller increases were observed in cultured red drum, Sciaenops ocellatus, livers following exposure to reduced salinity and physical trauma for 7 days. Finally, there was approximately a 2·5-fold increase in the zinc associated with the MT-like protein in livers of female spotted seatrout, Cynoscion nebulosus, collected during the reproductive season compared to regressed animals. These findings emphasize the need for establishing the natural fluctuations in MT levels as well as the response to common physical environmental variables before measurement of MT can be used reliably as a biochemical indicator of environmental contamination.     

Design of a 3D Chirp Sub-bottom Imaging System

Chirp sub-bottom profilers are marine acoustic devices that use a known and repeatable source signature (1–24 kHz) to produce decimetre vertical resolution cross-sections of the sub-seabed. Here the design and development of the first true 3D Chirp system is described. When developing the design, critical factors that had to be considered included spatial aliasing, and precise positioning of sources and receivers. Full 3D numerical modelling of the combined source and receiver directivity was completed to determine optimal source and receiver geometries. The design incorporates four source transducers (1.5–13 kHz) that can be arranged into different configurations, including Maltese Cross, a square and two separated pairs. The receive array comprises 240 hydrophones in 60 groups whose group-centres are separated by 25 cm in both horizontal directions, with each hydrophone group containing four individual elements and a pre-amplifier. After careful consideration, it was concluded that the only way to determine with sufficient accuracy the source–receiver geometry, was to fix the sources and receivers within a rigid array. Positional information for the array is given by a Real Time Kinematic GPS and attitude system incorporating four antennas to give position, heading, pitch and roll. It is shown that this system offers vertical positioning accuracy with a root-mean-square (rms) error less than 2.6 cm, while the horizontal positioning rms error was less than 2.0 cm. The system is configured so that the Chirp source signature can be chosen by software aboard the acquisition vessel. The complete system is described and initial navigational and seismic data results are presented. These data demonstrate that the approach of using fixed source-receiver geometry combined with RTK navigation can provide complete 3D imaging of the sub-surface.     

The alleged kimberlite-carbonatite relationship: evidence from ilmenite and spinel from Premier and Wesselton mines and the Benfontein sill,South Africa

Carbonate-rich, SiO₂-poor residua are developed in some kimberlites solidifying as ocelli, layers, or discrete dikes which satisfy petrographic definitions of carbonatite. Arguments that these rocks have mineralogies, antecedents, and comagmatic rocks differing from those of the carbonatites in alkaline rock complexes, including the specific observation that kimberlites and carbonatites contain ilmenites and spinels of different composition, have been used to refute the alleged kimberlite-carbonatite relationship. New microprobe analyses of ilmenites and spinels from carbonate-rich rocks associated with kimberlites in three South African localities correspond to spinels and ilmenites of carbonatites from alkalic complexes, or have characteristics intermediate between those of carbonatites and kimberlites. The ilmenites are distinguished from kimberlite ilmenites by higher MnO, FeTiO₃, and Nb₂O₅, and by negligible Cr₂O₃. The spinels are distinguished from kimberlite spinels by their Al₂O₃ and Cr₂O₃ contents. There is clearly a genetic relationship between the kimberlites and the carbonate-rich rocks, despite the observation that their ilmenites and spinels are distinctly different, which indicates that the same observation is not a valid argument against a petrogenetic relationship between kimberlites and carbonatites. These rocks are among the diverse products from mantle processes influenced by CO₂, and we believe that the petrogenetic links among them are forged in the upper mantle. We see insufficient justification to deny the name carbonatite to carbonate-rich rocks associated with kimberlites if they satisfy the petrographic definition in terms of major mineralogy.     

Tectonic and magmatic ridges in the eltanin fault system,South Pacific

A Seabeam reconnaissance of the 400 km-long fast-slipping (88 mm yr^-1) Heezen transform fault zone and the 55 km-long spreading center that links it to Tharp transform defined and bathymetrically described several types of ridges built by tectonic uplift and volcanic construction. Most prominent is an asymmetric transverse ridge, at which abyssal hills adjacent to the fault zone have been raised 2–3 km above normal rise-flank depths. Topographic and petrologic evidence suggests that this uplift, which has produced a 5400 m scarp from the crest of the ridge to the floor of a 10 km-wide transform valley, is caused by rapid serpentinization of upper mantle which has been exposed to hydrothermal circulation by fault-zone fracturing of an unusually thin crust. Transverse ridges have been thought atypical of fast-slipping transforms. One class of volcanic ridge more common at these sites is the overshot ridge, formed by prolongation of spreading-center rift zones obliquely across the transform. Overshot ridges are well developed at Heezen transform, especially at the eastern end where an eruptive rift zone extending 60 km from the southern tip of the East Pacific Rise has built a transform-parallel ridge that fills the eastern transform valley. Obliteration of fault-zone structure by ridges overshooting from the spreading center intersections means that the topography of the aseismic fracture zones is not just inherited from that of the active transform fault zone. The latter has several en echelon and overlapping fault traces, linked by short oblique spreading axes that generally form pull-apart basins rather than volcanic ridges. Interpretation of the origin and pattern of the fault zone's tectonic and volcanic relief requires refinement of the plate geography and history of this part of the Pacific-Antarctic boundary, using new Seabeam and magnetic traverses to supplement and adjust the existing geophysical data base.