Dynamic estimation of hydrodynamic damping

Data on the acceleration of an oscillating cylinder in water are analysed by a Kalman extended filter. A hydrodynamical forcing model based upon Morison's equation appears to be reasonable and drag estimation appears simple using simulated data. Estimation based upon real data gives an average drag coefficient decreasing with the oscillation amplitude. An assymetric drag coefficient variation over the oscillation period is estimated.     

Fluxes of iron and manganese across the sediment–water interface under various redox conditions

Fluxes of dissolved forms of iron and manganese across the sediment–water interface were studied in situ in the Gulf of Finland and the Vistula Lagoon (Baltic Sea), and in the Golubaya Bay (Black Sea) from 2001 to 2005. Fluxes were measured using chamber incubations, and sediment cores were collected and sliced to assess the porewater and solid phase metal distribution at different depths. Measured and calculated benthic fluxes of manganese and iron were directed out of sediment for all sites and were found to vary between 70–4450 and 5–1000 µmole m^− 2 day^− 1 for manganese and iron, respectively. The behavior of the studied metals at various redox conditions in the near-bottom water and in the sediment was the main focus in this study. Our results show the importance of bottom water redox conditions for iron fluxes. We measured no fluxes at oxic conditions, intermediate fluxes at anoxic conditions (up to 200 μmole m^− 2 day^− 1) and high fluxes at suboxic conditions (up to 1000 μmole m^− 2 day^− 1). Total dissolved iron fluxes were generally dominated by iron(II). Contribution of iron(III) to the total iron flux did not exceed 20%. Obtained fluxes of manganese at all studied regions showed a linear correlation (r² = 0.97) to its concentration in the porewater of the top sediment layer (0–5 mm) and did not depend on dissolved oxygen concentrations of bottom water. Organically complexed iron and manganese were in most cases not involved in the benthic exchange processes.     

On lipid surface films on the sea. I. A simple method for sampling and studies of composition

A method for collection of surface films on the sea has been developed and tested at various places along the Swedish West Coast. Considerable amounts of lipids on the sea surface were found even when no seaslicks were observed. Triglycerides, free fatty acids, and wax esters are the dominating constituents, and there are characteristic deviations in the fatty-acid patterns compared to the corresponding lipids dissolved in the sub-surface water. Organochlorine residues, phthalic acid esters and heavy metals also occur in considerable amounts.     

Nitrogen cycling in deep-sea sediments of the Porcupine Abyssal Plain, NE Atlantic

Rates of transformation, recycling and burial of nitrogen and their temporal and spatial variability were investigated in deep-sea sediments of the Porcupine Abyssal Plain (PAP), NE Atlantic during eight cruises from 1996 to 2000. Benthic fluxes of ammonium (NH₄) and nitrate (NO₃) were measured in situ using a benthic lander. Fluxes of dissolved organic nitrogen (DON) and denitrification rates were calculated from pore water profiles of DON and NO₃, respectively. Burial of nitrogen was calculated from down core profiles of nitrogen in the solid phase together with ¹⁴C-based sediment accumulation rates and dry bulk density. Average NH₄ and NO₃-effluxes were 7.4 ± 19 μmol m⁻² d⁻¹ (n = 7) and 52 ± 30 μmol m⁻² d⁻¹ (n = 14), respectively, during the period 1996–2000. During the same period, the DON-flux was 11 ± 5.6 μmol m⁻² d⁻¹ (n = 5) and the denitrification rate was 5.1 ± 3.0 μmol m⁻² d⁻¹ (n = 22). Temporal and spatial variations were only found in the benthic NO₃ fluxes. The average burial rate was 4.6 ± 0.9 μmol m⁻² d⁻¹. On average over the sampling period, the recycling efficiency of the PON input to the sediment was 94% and the burial efficiency hence 6%. The DON flux constituted 14% of the nitrogen recycled, and it was of similar magnitude as the sum of burial and denitrification. By assuming the PAP is representative of all deep-sea areas, rates of denitrification, burial and DON efflux were extrapolated to the total area of the deep-sea floor (>2000 m) and integrated values of denitrification and burial of 8 ± 5 and 7 ± 1 Tg N year⁻¹, respectively, were obtained. This value of total deep-sea sediment denitrification corresponds to 3–12% of the global ocean benthic denitrification. Burial in deep-sea sediments makes up at least 25% of the global ocean nitrogen burial. The integrated DON flux from the deep-sea floor is comparable in magnitude to a reported global riverine input of DON suggesting that deep-sea sediments constitute an important source of DON to the world ocean.     

Petrology,phase equilibria modelling and zircon U–Pb geochronology of Paleoproterozoic mafic granulites from the Fuping Complex,North China Craton

The Fuping Complex is one of the important basement terranes within the central segment of the Trans‐North China Orogen (TNCO) where mafic granulites are exposed as boudins within tonalite–trondhjemite–granodiorite (TTG) gneisses. Garnet in these granulites shows compositional zoning with homogeneous cores formed in the peak metamorphic stage, surrounded by thin rims with an increase in almandine and decrease in grossular contents suggesting retrograde decompression and cooling. Petrological and phase equilibria studies including pseudosection calculation using thermocalc define a clockwise P–T path. The peak mineral assemblages comprise garnet+clinopyroxene+amphibole+quartz+plagioclase+K‐feldspar+ilmenite±orthopyroxene±magnetite, with metamorphic P–T conditions estimated at 8.2–9.2 kbar, 870–882 °C (15FP‐02), 9.6–11.3 kbar, 855–870 °C (15FP‐03) and 9.7–10.5 kbar, 880–900 °C (15FP‐06) respectively. The pseudosections for the subsequent retrograde stages based on relatively higher H₂O contents from P/T–M(H₂O) diagrams define the retrograde P–T conditions of <6.1 kbar, <795 °C (15FP‐02), 5.6–5.8 kbar, <795 °C (15FP‐03), and <9 kbar, <865 °C (15FP‐06) respectively. Data from LA‐ICP‐MS zircon U–Pb dating show that the mafic dyke protoliths of the granulite were emplaced at c. 2327 Ma. The metamorphic zircon shows two groups of ages at 1.96–1.90 Ga (peak at 1.93–1.92 Ga) and 1.89–1.80 Ga (peak at 1.86–1.83 Ga), consistent with the two metamorphic events widely reported from different segments of the TNCO. The 1.93–1.92 Ga ages are considered to date the peak granulite facies metamorphism, whereas the 1.86–1.83 Ga ages are correlated with the retrograde event. Thus, the collisional assembly of the major crustal blocks in the North China Craton (NCC) might have occurred during 1.93–1.90 Ga, marking the final cratonization of the NCC.     

Formation and preservation of fresh lawsonite: Geothermobarometry of the North Makran Blueschists,southeast Iran

A low‐grade metamorphic “Coloured Mélange” in North Makran (SE Iran) contains lenses and a large klippe of low temperature, lawsonite‐bearing blueschists formed during the Cretaceous closure of the Tethys Ocean. The largest blueschist outcrop is a >1,000 m thick coherent unit with metagabbros overlain by interlayered metabasalts and metavolcanoclastic rocks. Blueschist metamorphism is only incipient in coarse‐grained rocks, whereas finer grained, foliated samples show thorough metamorphic recrystallization. The low‐variance blueschist peak assemblage is glaucophane, lawsonite, titanite, jadeite±phengitic mica. Investigated phase diagram sections of three blueschists with different protoliths yield peak conditions of ~300–380°C at 9–14 kbar. Magnesio‐hornblende and rutile cores indicate early amphibolite facies metamorphism at >460°C and 2–4 kbar. Later conditions at slightly higher pressures of 6–9 kbar at 350–450°C are recorded by barroisite, omphacite and rutile assemblages before entering into the blueschist facies and finally following a retrograde path through the pumpellyite–actinolite facies across the lawsonite stability field. Assuming that metamorphic pressure is lithostatic pressure, the corresponding counterclockwise P–T path is explained by burial along a warm geothermal gradient (~15°C/km) in a young subduction system, followed by exhumation along a cold gradient (~8°C/km); a specific setting that allows preservation of fresh undecomposed lawsonite in glaucophane‐bearing rocks.     

Volcanic particles in agriculture and gardening

Volcanic pyroclasts of small size, such as lapilli and small pumice stones, are widely used in agriculture, gardening, and for pot plants as natural inorganic mulch. The technique of using pyroclasts to enhance topsoil stems from the eighteenth century, and specifically from the ad 1730–1736 eruption on Lanzarote. Critical observations on plant development during and after the eruption showed that the vegetation died when buried under a thick layer of lapilli, but grew vigorously when covered thinly. While the agriculture of Lanzarote was restricted to cereals before the eruption, it diversified to many kinds of fruit and vegetables afterwards, including the production of the famous Malvasía wines in the Canaries. The population of Lanzarote doubled in the years after the eruption, from about 5000 in 1730 to near 10 000 in 1768, predominantly as a result of the higher agricultural productivity. This outcome led to widespread use of lapilli and pumice fragments throughout the islands and eventually the rest of the globe. Lapilli and pumice provide vesicle space for moisture to be retained longer within the planting soil, which can create an environment for micro‐bacteria to thrive in. Through this route, nutrients from volcanic matter are transported into the surrounding soil where they become available to plant life. The detailed processes that operate within the pyroclasts are less well understood, such as the breakdown of nutrients from the rock matrix and transport into the soil by biological action. Further studies promise significant potential to optimize future agricultural efforts, particularly in otherwise arid areas of the globe.     

Displacement ring load Green's functions for saturated porous transversely isotropic tri‐material full‐space

Based on the Biot's poroelastic theory and using scalar potential functions both the ring load and point load displacement Green's functions for a transversely isotropic saturated porous full‐space composed of an upper half‐space, a finite thickness middle layer and a lower half‐space is analytically presented for the first time. It is assumed that each region consists of a different transversely isotropic material. The equations of poroelastodymanics in terms of the solid displacements and the pore fluid pressure are uncoupled with the help of two scalar potential functions, so that the governing equations for the potential functions are either a second order wave equation or a repeated wave‐heat transfer equation of sixth order. With the aid of Fourier expansion with respect to circumferential direction and Hankel integral transforms with respect to the radial direction in cylindrical coordinate system, the response is determined in the form of line integrals in the real space, followed by theorem of inverse Hankel integral transforms. The solutions degenerate to a single phase elastic material, and the results are compared with previous studies, where an excellent agreement may be observed with the results provided in the literature. Some examples of displacement Green's functions are finally given to illustrate the solution. Copyright © 2016 John Wiley & Sons, Ltd.     

Impact of lithology and soil properties on abandoned dryland terraces during the early stages of soil erosion by water in south‐east Spain

Soil erosion by water in abandoned dry terraces is one of the most important environmental problems in semiarid areas, enhancing biological degradation and reducing possible resources that can be obtained. However, little is known about the effects of the types of lithology and soil properties on the early stages of soil erosion. Therefore, the main aim of this research was to assess the effect of different lithologies (marls, limestones, and metamorphic—phyllites, schists, and greywackes—materials) and soil properties on the early stages of soil erosion by water in abandoned dry terraces, compared with similar terraces still in agricultural use. Soil analyses (texture, aggregate stability, and bulk density) and 22 rainfall simulations were carried out under dry conditions. During the experiments, local inclination, vegetation and stone cover, total organic matter, and antecedent soil moisture were also quantified. The results showed that the highest soil loss (41.41 g/m² in cultivated plots and 17.05 g/m² in the abandoned plots) and runoff (3.79 L/m² in the abandoned plot) occurred on marl substrata. Marls also showed the shallowest infiltration front (9 cm) and lowest infiltration rate (4.3 cm/min). Limestones and, especially, metamorphic areas, showed a lower degree of soil erosion, higher infiltration rates, and deeper infiltration fronts.