Effects of pulp bleach plant effluents on hepatic xenobiotic biotransformation enzymes in fish: Laboratory and field studies

The present preliminary report on studies of the influence of pulp bleach plant effluents on hepatic biotransformation enzymes in fish is a part of a major characterisation of biochemical and physiological effects of effluents from pulp industries in Sweden. Our studies on the xenobiotic biotransformation enzymes demonstrate, so far, that the pulp effluents have the potential to strongly induce 7-ethoxyresorufin-O-deethylase activity (EROD) in fish liver and that fish living in the receiving water of an effluent from a pulp bleach plant have induced hepatic EROD activities as well as higher hepatic UDP glucuronyltransferase activities than those living in an unpolluted area. It is thus apparent that measures of induction of biotransformation enzymes in fish liver may be a useful approach in monitoring the presence of potential hazardous compounds released from pulp industries.     

Size distribution of colloidal trace metals and organic carbon during a coastal bloom in the Baltic Sea

The physico-chemical speciation of organic carbon and selected metals was measured during a coastal bloom in Ekhagen Bay, Baltic Sea, using ultrafiltration.One important objective with the study was to see if any depletion of trace metals could be measured in the directly bioavailable fraction (<1000 Da, the soluble low molecular weight fraction, LMW) during a plankton bloom. Filters with five different cut-offs were used (1 kD (1000 Da), 5 kD, 10 kD, 100 kD and 0.22 μm) in order to delineate the size distribution of colloidal organic carbon (COC) and trace metals.During the bloom in May, LMW Al, Co, Cu, Mn and Ni concentrations decreased although the colloidal and particulate concentrations were relatively high. Data show that desorption of colloidal and particulate bound trace metals to the LMW fraction was slower than the process depleting the LMW fraction.Estimates of the maximum active uptake of Cu, Ni and Mn by the phytoplankton, and the loss of non-bioactive Al from the LMW fraction, indicate that processes other than active uptake by phytoplankton must contribute to the observed depletion of trace metals in the LMW fraction. Hence, in order to estimate the bioavailable pool of trace metals for plankton during bloom conditions, these other processes must be understood and quantified.Transparent Exopolymeric Particles (TEP, reflecting sugar-rich phytoplankton exudates) increased around eight times during the plankton bloom. We hypothesize that the formation of TEP is a process that might be important for the transfer of trace metals from the LMW to the particulate fraction during the phytoplankton bloom, but the significance of TEP for this depletion in Baltic Sea surface water remains to be shown.     

In Situ Measurement of Pinna nobilis Shells for Age and Growth Studies: A New Device

Abstract. Pinna nobilis Linnaeus 1758 is an endemic bivalve mollusc in the Mediterranean Sea, where it inhabits seagrass meadows, especially Posidonia oceanica (L.) Delile. It is the largest bivalve in the Mediterranean, reaching lengths up to 120 cm. In its natural habitat, P. nobilis lives with the anterior part of the valve buried in the seabed, attached to Posidonia rhizomes by byssus threads.
This habit makes it impossible to measure its total length directly in situ. As the only way to determine the individual age is the relationship between age and total length, several equations have been proposed to estimate total length by relating it to the unburied parts of the shell. Such measurements are essential to ecological studies that consider age, growth, and population dynamics, and that evaluate the environmental factors that affect this species.
Accurately estimating total length depends on the accuracy and precision of the method employed to measure the unburied shell parts. In this paper, we point out the lack of precision of the instruments and methods used until now; we also demonstrate the reason for this imprecision. A new device to measure unburied parts of Pinna nobilis with a precision comparable to that obtained when measuring extracted valves is described. This device is unaffected by substratum type and reduces measurement time. The latter is a very important feature, because these procedures are usually performed whilst SCUBA diving. Finally, a growth equation has been fitted to the measurements obtained with the new device from a population located in Moraira (Alicante, western Mediterranean).     

The POC / Th ratio of settling particles isolated using split flow-thin cell fractionation (SPLITT)

The common assumption that the ratio between particulate organic carbon (POC) and particulate ²³⁴Th obtained from shallow sediment traps and filterable particles are representative of the ratio in the total particle settling flux should be treated with caution in view of well-known biases associated with tethered shallow sediment traps and the decoupling between size and settling velocity of many natural particle regimes. To make progress toward reliably constraining the POC / ²³⁴Th ratio on truly settling particles, we have tested here a settling collection technique designed to remove any hydrodynamic bias; split flow-thin cell fractionation (SPLITT). These first results from a North Sea fjord and an open Baltic Sea time-series station indicates that the POC / ²³⁴Th ratio on the more complete particle-settling spectrum, isolated with SPLITT, was higher than the POC / ²³⁴Th ratio obtained simultaneously from tethered shallow sediment traps in seven out of seven parallel deployments with an average factor of 210%. The POC / ²³⁴Th ratio from the SPLITT was either in the same range or higher than that obtained on filtered “bulk” particles. To explain this novel data we hypothesize that the slowest settling fraction is organic-matter rich and does not strongly complex ²³⁴Th (i.e., high POC / ²³⁴Th). We suggest that this ultra-slow sinking fraction is better collected by SPLITT than with tethered sediment traps because of minimized hydrodynamic bias.This was tested using the ratio of POC / Al as a tracer of detrital mineral-ballast influenced settling velocity. The higher POC / Al ratios in SPLITT samples relative to in traps is consistent with the hypothesis that SPLITT is better suited for collecting also the slow-settling component of sinking particles. This important slow-settling component appears to here consist primarily of non-APS/TEP components of plankton exudates or other less-strongly ²³⁴Th-complexing organic matter. Further applications of the SPLITT technique are likely to return increasingly new insights on the composition (including “truly settling” POC / ²³⁴Th) of the total spectrum of particles settling out of the upper ocean.     

Temperature fluctuations in interstellar dust grains

Temperature fluctuations in interstellar dust grains caused by absorption of ultraviolet photons are discussed. Temperature probability distributions are presented for various assumptions about the grain specific heat and far infrared emissivity. Grains smaller than or about 0.01 may suffer large temperature fluctuations and would spend most of their time at very low temperatures. The equilibrium temperature is not a good measure for most average temperatures of such grains. It is shown that, although small grains spend only a small fraction of their time at the higher temperatures, the emitted far infrared spectrum is significantly shifted towards shorter wavelengths than predicted for grains assumed to be at the equilibrium temperature.Invited contribution to the Proceedings of a Workshop onThermodynamics and Kinetics of Dust Formation in the Space Medium held at the Lunar and Planetary Institute, Houston, 6–8 September, 1978.     

Interstellar clouds and the formation of stars

Part I gives a survey of the drastic revision of cosmic plasma physics which is precipitated by the exploration of the magnetosphere throughin situ measurements. The pseudo-plasma formalism, which until now has almost completely dominated theoretical astrophysics, must be replaced by an experimentally based approach involving the introduction of a number of neglected plasma phenomena, such as electric double layers, critical velocity, and pinch effect. The general belief that star light is the main ionizer is shown to be doubtful; hydromagnetic conversion of gravitational and kinetic energy may often be much more important.In Part II the revised plasma physics is applied to dark clouds and star formation. Magnetic fields do not necessarily counteract the contraction of a cloud; they may just as well pinch the cloud. Magnetic compression may be the main mechanism for forming interstellar clouds and keeping them together.Part III treats the formation of stars in a dusty cosmic plasma cloud. Star formation is due to an instability, but it is very unlikely that it has anything to do with the Jeans instability. A reasonable mechanism is that the sedimentation of dust (including solid bodies of different size) is triggering off a gravitationally assisted accretion. A stellesimal accretion analogous to the planetesimal accretion leads to the formation of a star surrounded by a very low density hollow in the cloud. Matter falling in from the cloud towards the star is the raw material for the formation of planets and satellites.The study of the evolution of a dark cloud leads to a scenario of planet formation which is reconcilable with the results obtained from studies based on solar system data. This means that the new approach to cosmical plasma physics discussed in Part I logically leads to a consistent picture of the evolution of dark clouds and the formation of solar systems.     

Structural similarity and variety at the tips in a wide range of strike–slip faults: a review

Strike–slip faults are often accompanied by a variety of structures, particularly at their tips. The zones of additional fracturing are classified as tip‐damage zones. These zones can be subdivided into several different damage patterns based on the nature and orientation of faults and fractures developed. Damage zones at the ends of small strike–slip faults (mode II tips) develop wing cracks, horsetail splays, antithetic faults, synthetic branch faults and solution surfaces. Similar tip‐damage patterns are also commonly observed at larger (regional) scales, but with a dominance of faulting over tensile cracks and solution surfaces. Wing cracks and horsetail splays developed at small‐scale faults are replaced by normal faults in large‐scale faults. Antithetic faults and synthetic branch faults are observed at small and large scales. Thrust faults are developed at large scales, in a similar pattern to solution surfaces at a small scale. All these structures may show slightly different angular relationships to the master fault at small and large scale, but develop in response similar stress distribution and mechanics around the fault. Thus, mode II tip‐damage zones show similar patterns over a wide range of fault scales.