The evolution of the z distribution of normal neutron stars in the Galaxy

Under the two initial 1‐D one parameter velocity distribution forms (one is normal, the other is exponential), the z direction scale height evolution of normal neutron stars in the Galaxy is studied by numerical simulation. We do statistics for the cases at different time segments, also do statistics for the cumulative cases made of each time segment. The results show in the cumulative cases the evolution curves of the scale heights are smoother than in the each time segment, i.e., the cumulation improve the signal‐to‐noise ratio. Certainly the evolution cases are different at different Galactic disk locations, which also have very large difference from the average cases in the whole disk. In the initial stages of z evolution of normal neutron stars, after the beginning transient states, the cumulative scale heights increase linearly with time, and the cumulative scale height increasing rates have linear relationship with the initial velocity distribution parameters, which have larger fluctuation in the vicinity of the Sun than in the whole disk. We utilize the linear relationship of the cumulative scale height increasing rates vs. the initial velocity distribution parameters in the vicinity of the Sun to make comparison with the observation near the Sun. The results show if there is no magnetic decay, then the deserved initial velocity parameters are obvious lower than the present well known results from some authors; whereas if introducing magnetic decay, for the 1‐D normal case we can make consistence among concerning results using magnetic decay time values which are supported by some authors, while for the 1‐D exponential case the results show the lackness of young pulsar samples in the larger z in the vicinity of the Sun (© 2010 WILEY‐VCH Verlag GmbH & Co. KGaA, Weinheim)     

江苏下扬子区二叠系龙潭组-大隆组页岩气勘探前景分析

江苏下扬子区龙潭组-大隆组暗色泥页岩厚度较大（60~100m）,有机碳含量较高（平均为2.0%~3.0%）,热演化程度区域上差异较大（0.5%~3.0%）,总体具有形成页岩气藏的良好潜力。暗色泥页岩中脆性矿物含量较高,利于后期的压裂和开发。根据研究区暗色泥页岩页岩厚度、埋深、有机碳含量和成熟度展布,以矿物成分和含气性特征等特征,运用信息叠合法,最终优选出溧水-句容、丹阳-海安为Ⅰ类有利区,无锡-张家港为Ⅱ类有利区。     

Effect of freeze–thaw cycles on strength and ductility and microstructure of cement-treated silt with polypropylene fiber

Acta Geotechnica - In this paper, the strength, ductility and microstructure behavior of cement-treated silt with polypropylene fiber was studied by a host of experimental studies. The influence of...     

多层界面快速反演在高精度石油重力勘探中的应用

重力勘探作为一种快速普查方法，在深部地质构造研究、区域地质构造划分及找矿勘探中均已取得显著的地质效果。自８０年代后期，由于在重力测地工作中使用红外测距仪及高精度ＧＰＳ定位技术，确保了重力测点位置及高程有较高的精度；在重力观测中普遍采用目前世界上精度最高的Ｌａｃｏｓｔｅ型重力仪进行基点联测，采用对恒温系统改进后的Ｗｏｒｄｅｎ重力仪进行重力测点观测，使得重力测量的质量及精度都有了很大提高，为扩大重力法的应用提供了条件。本文给出的一例是；在我国某含油沉积盆地上，根据对实测１：２５０００高精度重力资料（布格重力异常总观测均方误差：６０×１０￣－８ｍ／ｓ￣２）的处理及约束信息下多层界面反演结果，确定有利油气聚集的圈闭范围，推断含油层的大致规模。     

雷电防护技术在现代建筑中的应用

针对建筑物遭受雷击的危害及方式,探讨建筑工程设计与施工中应采取的各种防雷措施,以及防雷装置安装与使用中值得注意的问题.     

Five new E′ centers and their 29Si hyperfine structures in electron-irradiated α-quartz

Single-crystal electron paramagnetic resonance (EPR) spectra of fast-electron-irradiated quartz, after annealing at 120 and 200°C, reveal five new E′ type centers, herein labeled E ₅^￠ , E ₆^￠ , E ₇^￠ , E ₈^￠ , \textand E ₉^￠ E_{ 5}^{\prime } ,\,E_{ 6}^{\prime } ,\,E_{ 7}^{\prime } ,\,E_{ 8}^{\prime } ,\,{\text{and}}\,E_{ 9}^{\prime } . Centers E ₅^￠ , E ₇^￠ , \textand E ₉^￠ E_{ 5}^{\prime } ,\,E_{ 7}^{\prime } ,\,{\text{and}}\,E_{ 9}^{\prime } are characterized by the orientations of the unique principal g and A(²⁹Si) axes close to a short Si–O bond direction, hence representing new variants of the well-established E ₁^￠ E_{ 1}^{\prime } center. Centers E ₆^￠ E_{ 6}^{\prime } and E ₈^￠ E_{ 8}^{\prime } have the orientations of the unique principal g and A(²⁹Si) axes approximately along a long Si–O bond direction, similar to the E ₂^￠ E_{ 2}^{\prime } centers. Therefore, these new E′ type centers apparently arise from the removal of different oxygen atoms and represent variable local distortions around the oxygen vacancies.     

电感耦合等离子体质谱法(ICP-MS)测定水系沉积物中的铌钽锆铪

建立电感耦合等离子体质谱法(ICP-MS)测定水系沉积物中铌、钽、锆、铪四种元素的分析方法。将样品与氢氧化钠、过氧化钠混合物放入高温炉中,熔融分解完全,用热水提取,过滤后弃去滤液,将滤纸及沉淀用酒石酸-盐酸溶液溶解,稀释至刻度测定。方法检出限(3s)为:LD(Nb)=0.08μg/g,LD(Ta)=0.04μg/g,LD(Zr)=0.5μg/g,LD(Hf)=0.04μg/g,精密度(RSD%,n=6)为:0.84%~4.21%。该测定方法具有灵敏度高、精密度好、分析速度快、线性范围宽、操作性强等优势。采用该方法对国家一级标准物质进行测定表明,其结果与标准值吻合。此方法已在实际地质调查样品分析中得到应用。     

Electron Probe Microanalysis of Bromine in Minerals and Glasses with Correction for Spectral Interference from Aluminium,and Comparison with Microbeam Synchrotron X‐Ray Fluorescence Spectrometry

The strong spectral interference between Br‐ and Al‐induced X‐ray lines hampers the utilisation of electron probe microanalysis (EPMA) for measuring Br mass fractions in Al‐bearing minerals and glasses. Through measuring Br‐free Al‐bearing materials, we established an EPMA method to quantify the overlap from AlKα on BrLβ, which can be expressed as a linear function of the Al₂O₃ content. The count rate of the BrLβ peak signal was enhanced by high beam currents and long measurement times. Application of this EPMA method to Al‐ and Br‐bearing materials, such as sodalite and scapolite, and to five experimental glasses yielded Br mass fractions (in the range of 250–4000 μg g^?1) that are consistent with those measured by microbeam synchrotron X‐ray fluorescence (μ‐SXRF) spectrometry. The EPMA method has an estimated detection limit of ~ 100–300 μg g^?1. We propose that this method is useful for measuring Br mass fractions (hundreds to thousands of μg g^?1) in Al‐bearing minerals and glasses, including those produced in Br‐doped experiments. In addition, the natural marialitic scapolite (ON70) from Mpwapwa (Tanzania) containing homogeneously distributed high mass fractions of Br (2058 ± 56 μg g^?1) and Cl (1.98 ± 0.03% m/m) is an ideal reference material for future in situ analyses.     

Watershed delineation using hydrographic features and a DEM in plain river network region

Watershed delineation is a required step when conducting any spatially distributed hydrological modelling. Automated approaches are often proposed to delineate a watershed based on a river network extracted from the digital elevation model (DEM) using the deterministic eight‐neighbour (D8) method. However, a realistic river network cannot be derived from conventional DEM processing methods for a large flat area with a complex network of rivers, lakes, reservoirs, and polders, referred to as a plain river network region (PRNR). In this study, a new approach, which uses both hydrographic features and DEM, has been developed to address the problems of watershed delineation in PRNR. It extracts the river nodes and determines the flow directions of the river network based on a vector‐based hydrographic feature data model. The river network, lakes, reservoirs, and polders are then used to modify the flow directions of grid cells determined by D8 approach. The watershed is eventually delineated into four types of catchments including lakes, reservoirs, polders, and overland catchments based on the flow direction matrix and the location of river nodes. Multiple flow directions of grid cells are represented using a multi‐direction encoding method, and multiple outflows of catchments are also reflected in the topology of catchments. The proposed approach is applied to the western Taihu watershed in China. Comparisons between the results obtained from the D8 approach, the ‘stream burning’ approach, and those from the proposed approach clearly demonstrate an improvement of the new approach over the conventional approaches. This approach will benefit the development of distributed hydrological models in PRNR for the consideration of different types and multiple inlets and outlets of catchments. Copyright © 2015 John Wiley & Sons, Ltd.