Nonlinear wave coupling in type IV solar radio bursts

In order to explain a fine structure of parallel ridges in stationary type IV continua, the emission due to the coupling of electrostatic upper hybrid waves and Bernstein waves at the sum frequency of the upper hybrid and harmonics of the gyro frequency has been calculated. If the energy density of these electrostatic waves is of the order of 10^-3 times the thermal energy density, then the observed zebra pattern can be emitted by a region with a diameter of 10³ km.     

Thermobarometry of the Bleikvassli Zn-Pb-(Cu) deposit, Nordland, Norway

The Bleikvassli massive sulfide ore deposit is hosted by Proterozoic pelitic, quartzofeldspathic, and amphibolitic rocks of the Uppermost Allochthon of the Scandinavian Caledonides. Staurolite-garnet-biotite and kyanite-staurolite-biotite assemblages indicate that metamorphism reached the kyanite zone of the amphibolite facies. Geothermobarometry was conducted on rocks in and around the deposit using a variety of silicate and sulfide calibrations. Temperature determinations are most reliant on the garnet-biotite exchange reaction, with analyses obtained from 259 garnet rims and adjacent biotite. Results from nine calibrations of the garnet-biotite geothermometer are considered, but compositional limitations of many calibrations involving high Ca and Mn contents in garnet and Al^VI and Ti in biotite make many of the coexisting mineral pairs unsuitable. Average temperatures calculated from the two calibrations that most closely address the garnet-biotite compositions observed at Bleikvassli are 584 °C ± 49 °C and 570 °C ± 40 °C. The application of two calibrations of the garnet-staurolite geothermometer on a limited number of samples yields 581 °C ± 2 °C and 589 °C ± 12 °C, assuming a _H2O=0.84, based upon calculations of the modal proportions of gaseous species. Pressure determinations are less constrained. Phengite and plagioclase-biotite-garnet-muscovite geobarometers give average pressures of approximately 5.0 kbar and 8.5 ± 1.2 kbar, respectively. Pressures obtained from the sphalerite-hexagonal pyrrhotite-pyrite barometer average 7.7 ± 1.0 kbar. In consideration of these results, the peak metamorphic conditions at the Bleikvassli deposit are estimated to be 580 °C and 8 kbar. Received: 18 June 1997 / Accepted: 14 May 1998     

Effects of dredging operations on estuarine benthic macrofauna

Dredging operations in a Swedish estuary reduced the number and diversity of benthic species. The larval recruitment in the vicinity of the dredged area was strongly affected. An overall increase in concentrations of Hg, Cd, Zn, Cu, Pb and Ni were recorded in benthic fauna. One and a half years after termination of dredging, the benthic community structure was nearly restored and the high concentrations of heavy metals had decreased considerably.     

Weakly ionized cosmic gas: ionization and characterization

Since collective plasma behavior may determine important transport processes (e.g., plasma diffusion across a magnetic field) in certain cosmic environments, it is important to delineate the parameter space in which weakly ionized cosmic gases may be characterized as plasmas. In this short note, we do so. First, we use values for the ionization fraction given in the literature, wherein the ionization is generally assumed to be due primarily to ionization by cosmic rays. We also discuss an additional mechanism for ionization in such environments, namely, the photoelectric emission of electrons from cosmic dust grains in an interstellar FUV radiation field. Simple estimates suggest that under certain conditions this mechanism may dominate cosmic ray ionization, and possibly also the photoionization of metal atoms by the interstellar FUV field, and thereby lead to an enhanced ionization level.     

Effects of Volcanic Ash on Computers and Electronic Equipment

Computers and electronic equipment are an important component of the infrastructure of our modern environment. It is therefore essential that we know the effects of volcanic ash on such equipment. This paper presents the results of a pilot study to test computers and cooling fans in an ash-charged environment to assess their vulnerability. In the experiment, ash was poured on to computers and cooling fans in a sealed 0.216 m³ perspex box, with the effects on both the ash and the equipment monitored. Three different types of ash (1996 Ruapehu andesitic ash, Sakurajima andesitic ash and Kaharoa rhyolitic ash) were used in the experiments.In the first experiment each type of ash was photographed by Scanning Electron Microscope (SEM), then passed through the bearing unit of a cooling fan and photographed again afterwards. The bearings within the cooling fan continued to work even after 720 h of testing and there was no significant abrasion of the fan-shaft bearing. The ash was however fragmented, suggesting that the brittle ash shattered to fine dust, which caused significantly less abrasion to the bearings or shaft than expected. Three computers were then tested in the sealed box. Ash was introduced at increasing rates to simulate catastrophic entry of ash into a work environment, and computers were tested throughout using the BURNIN^® testing programme. Failure times ranged from 100 to 150 h; most failures occurring when humidity was increased by spraying water mist into the airflow. If dried out the computers continued to operate again if failure was not catastrophic. Card slot edge connectors proved to be one of the weakest links, as a bridge of ash formed across the gap. They were also subject to abrasion with some of the gold plating being removed. This did not however cause operating difficulties.The conclusions are that computers are more resilient than originally thought, unless the ash is moist. Simple low-tech procedures should be adequate to protect computers from small amounts of dry and moist ash contamination.     

A possibly direct measurement of coronal magnetic field strengths

During a unique solar radio event on March 2, 1970, among very diverse features, a very regular pattern was observed in the solar radio spectrographic record between 220 and 320 MHz. The proposed explanation is emission by slightly relativistic electrons at the sum frequency of the plasma frequency ( 160 MHz) and the lower harmonics of the local gyrofrequency (n from 3 to 10), rather than emission at pure harmonics of the gyrofrequency (n from 15 to 20). The derived magnetic field strengths range from 3 to 8 G, and can be determined very accurately. From the simultaneously occurring pulsating structure in the type IV emission and the deduced magnetic field strength a typical size of the emitting region of 2–300 km is derived.     

Marine quality assessment by use of benthic species-abundance distributions: a proposed new protocol within the European Union Water Framework Directive

The aim of this study is to develop a new method for classification of marine benthic quality according to the European Union Water Framework Directive. Tolerance values to environmental disturbance were determined in an objective analysis for benthic species along the Swedish west coast by using 4676 samples from 257 stations. Based on a combination of the species tolerance values, abundance and diversity, a benthic quality index (BQI) was calculated for the assessment of environmental status at a particular station. The qualification of BQI was evaluated in relation to known spatial and temporal gradients of disturbance.     

Preparing for climate change in Washington State

Climate change is expected to bring potentially significant changes to Washington State’s natural, institutional, cultural, and economic landscape. Addressing climate change impacts will require a sustained commitment to integrating climate information into the day-to-day governance and management of infrastructure, programs, and services that may be affected by climate change. This paper discusses fundamental concepts for planning for climate change and identifies options for adapting to the climate impacts evaluated in the Washington Climate Change Impacts Assessment. Additionally, the paper highlights potential avenues for increasing flexibility in the policies and regulations used to govern human and natural systems in Washington.     

Trends in 1,4-Dioxane Analyses: Implications for Identification and Characterization of Contaminated Groundwater Sites

1,4-Dioxane is a contaminant of emerging concern, and there is significant uncertainty about how its environmental occurrence in groundwater is being assessed given the various analytical methods available. This study compiled public sampling records from 2000 to 2019 that included >106,000 analyses of 1,4-dioxane from 822 different U.S. sites. The 1,4-dioxane detection frequency in the entire dataset (including all methods) was 45%, and the median detected concentration was 10 μg/L, highlighting the dilute nature of 1,4-dioxane in environmental media and the importance of selecting methods with adequate sensitivity. The annual distribution of samples analyzed by each method type confirmed a shift towards methods designed for semi-volatile compounds (Method 8270 and Method 8270 SIM) that exhibited consistently lower reporting limits (median reporting limit for each year typically ≤1 μg/L). In contrast, the method designed for volatile compounds (Method 8260) exhibited less sensitivity for 1,4-dioxane (median reporting limit per year between 40 and 100 μg/L) and its use declined significantly over time with increasing use of the moderately sensitive Method 8260 SIM in later years. This shift contributed to an increase in the 1,4-dioxane detection frequency over time, with a strong correlation between the annual detection frequency and the median reporting limit. Sites where 1,4-dioxane was analyzed but not detected overwhelmingly used less-sensitive methods that may not have been adequate for the expected concentration levels. Given the sub-μg/L groundwater criteria issued for 1,4-dioxane by some regulatory agencies, more sensitive and accurate methods will be increasingly needed to assess compliance.