Existing Territories and Formalization of Territorial Use Rights for Moored Fish Aggregating Devices: The Case of Small-Scale Fisheries in the La Désirade Island (France)

Moored fish aggregating devices (MFADs) are used by small-scale fishers to access fish species difficult to harvest in large numbers. In the case of Guadeloupe (Caribbean area), the use of MFADs has increased considerably and this is causing congestion in these fishing areas and creating conflict between fishers. The aim of this article is to understand how informal fishing territories around the La Desirade Island were established and examine these territories through the lens of economic defendability theory. Results of semistructured interviews show that MFAD fishers display territoriality along MFAD tract lines forming quasi-privatized areas. Territoriality in this article is based on the following factors: the type of targeted resources, the cost of harvesting, the defending of territories, and the acknowledgment of territories by the fishing community. Conflicts and utilization of MFADs (overcapacity) have raised an opportunity to create co-managed legalized territorial use rights for fisheries.     

The recording of floods and earthquakes in Lake Chichój,Guatemala during the twentieth century

Laguna Chichój (Lake Chichój) is the only deep permanent lake in the central highlands of Guatemala. The lake is located in the boundary zone between the North American and Caribbean plates. The lake has been struck by devastating earthquakes and tropical cyclones in historical times. We investigated the imprint of twentieth century extreme events on the sedimentary record of this tropical lake using a bathymetric survey of the lake, coring the lake floor, and providing a chronology of sediment accumulation. The lake occupies a series of circular depressions likely formed by the rapid dissolution of a buried body of gypsum. ²¹⁰Pb and ¹³⁷Cs inventories and varve counting indicate high rates of sedimentation (1–2 cm year^?1). The annually layered sediment is interrupted by turbidites of two types: a darker-colored turbidite, enriched in lake-derived biogenic constituents, and interpreted as a seismite, and a lighter-colored type, enriched in catchment-derived constituents, interpreted as a flood layer. Comparison of our ¹³⁷Cs-determined layer ages with a catalog of twentieth century earthquakes shows that an earthquake on the Motagua fault in 1976 generated a conspicuous darker-colored turbidite and slumped deposits in separate parts of the lake. The entire earthquake inventory further reveals that mass movements in the lake are triggered at Modified Mercalli Intensities higher than V. Tropical cyclonic depressions known to have affected the lake area had limited effect on the lake, including Hurricane Mitch in 1998. One storm however produced a significantly thicker flood layer in the 1940s. This storm is reportedly the only event to have generated widespread slope failures in the lake catchment. It is thus inferred that abundant landsliding provided large amounts of concentrated sediment to the lake, through hyperpycnal flows.     

Numerical modelling of strain in lava tubes

Received: 5 November 1998 / Accepted: 17 November 1999     

Numerical simulation of the propagation of P waves in fractured media

We study the propagation of P waves through media containing open fractures by performing numerical simulations. The important parameter in such problems is the ratio between crack length and incident wavelength. When the wavelength of the incident wavefield is close to or shorter than the crack length, the scattered waves are efficiently excited and the attenuation of the primary waves can be observed on synthetic seismograms. On the other hand, when the incident wavelength is greater than the crack length, we can simulate the anisotropic behaviour of fractured media resulting from the scattering of seismic waves by the cracks through the time delay of the arrival of the transmitted wave. The method of calculation used is a boundary element method in which the Green's functions are computed by the discrete wavenumber method. For simplicity, the 2-D elastodynamic diffraction problem is considered. The rock matrix is supposed to be elastic, isotropic and homogeneous, while the cracks are all empty and have the same length and strike direction. An iterative method of calculation of the diffracted wavefield is developed in the case where a large number of cracks are present in order to reduce the computation time. The attenuation factor Q ⁻¹ of the direct waves passing through a fractured zone is measured in several frequency bands. We observe that the attenuation factor Q ⁻¹ of the direct P wave peaks around kd = 2, where k is the incident wavenumber and d the crack length, and decreases proportionally to ( kd ) ⁻¹ in the high-wavenumber range. In the long-wavelength domain, the velocity of the direct P wave measured for two different crack realizations is very close to the value predicted by Hudson's theory on the overall elastic properties of fractured materials.     

Offshore experiments on styrene spillage in marine waters for risk assessment

Within the context of risk evaluation of chemical spillages into the marine environment, this paper reports on an offshore experiment to study the behaviour of styrene spilled into sea under natural conditions and discusses theoretical approaches. Floating structures were used to enclose the spillage and the gaseous cloud formation, and dissolution processes were in situ monitored. The identification of spill risks for man and marine environment through GESAMP's hazard profile is described for styrene: Styrene is rated as a chemical with a significant health hazard that will float but also evaporate. However, monitoring of the water column in the experiments showed that the concentration of styrene in water during the first hour represents 50% of the product spilled. For the potentially exposed public, the GESAMP hazard rating recommends the closure of beaches and evacuation. The risk assessment developed from experimental data confirms this safety advice.     

Conflicting structural and geochronological data from the Ibituruna quartz-syenite (SE Brazil): Effect of protracted “hot” orogeny and slow cooling rate?

The Ibituruna quartz-syenite was emplaced as a sill in the Ribeira-Araçuaí Neoproterozoic belt (Southeastern Brazil) during the last stages of the Gondwana supercontinent amalgamation. We have measured the Anisotropy of Magnetic Susceptibility (AMS) in samples from the Ibituruna sill to unravel its magnetic fabric that is regarded as a proxy for its magmatic fabric. A large magnetic anisotropy, dominantly due to magnetite, and a consistent magnetic fabric have been determined over the entire Ibituruna massif. The magmatic foliation and lineation are strikingly parallel to the solid-state mylonitic foliation and lineation measured in the country-rock. Altogether, these observations suggest that the Ibituruna sill was emplaced during the high temperature (~ 750 °C) regional deformation and was deformed before full solidification coherently with its country-rock. Unexpectedly, geochronological data suggest a rather different conclusion. LA-ICP-MS and SHRIMP ages of zircons from the Ibituruna quartz-syenite are in the range 530–535 Ma and LA-ICP-MS ages of zircons and monazites from synkinematic leucocratic veins in the country-rocks suggest a crystallization at ~ 570–580 Ma, i.e., an HT deformation > 35My older than the emplacement of the Ibituruna quartz-syenite. Conclusions from the structural and the geochronological studies are therefore conflicting. A possible explanation arises from ⁴⁰Ar–³⁹Ar thermochronology. We have dated amphiboles from the quartz-syenite, and amphiboles and biotites from the country-rock. Together with the ages of monazites and zircons in the country-rock, ⁴⁰Ar–³⁹Ar mineral ages suggest a very low cooling rate: < 3 °C/My between 570 and ~ 500 Ma and ~ 5 °C/My between 500 and 460 Ma. Assuming a protracted regional deformation consistent over tens of My, under such stable thermal conditions the fabric and microstructure of deformed rocks may remain almost unchanged even if they underwent and recorded strain pulses separated by long periods of time. This may be a characteristic of slow cooling “hot orogens” that rocks deformed at significantly different periods during the orogeny, but under roughly unchanged temperature conditions, may display almost indiscernible microstructure and fabric.     

Effect of the processing methodology on satellite altimetry-based global mean sea level rise over the Jason-1 operating period

Determining how the global mean sea level (GMSL) evolves with time is of primary importance to understand one of the main consequences of global warming and its potential impact on populations living near coasts or in low-lying islands. Five groups are routinely providing satellite altimetry-based estimates of the GMSL over the altimetry era (since late 1992). Because each group developed its own approach to compute the GMSL time series, this leads to some differences in the GMSL interannual variability and linear trend. While over the whole high-precision altimetry time span (1993–2012), good agreement is noticed for the computed GMSL linear trend (of $3.1\pm 0.4$  mm/year), on shorter time spans (e.g., ${<}10~\hbox {years}$ ), trend differences are significantly larger than the 0.4 mm/year uncertainty. Here we investigate the sources of the trend differences, focusing on the averaging methods used to generate the GMSL. For that purpose, we consider outputs from two different groups: the Colorado University (CU) and Archiving, Validation and Interpretation of Satellite Oceanographic Data (AVISO) because associated processing of each group is largely representative of all other groups. For this investigation, we use the high-resolution MERCATOR ocean circulation model with data assimilation (version Glorys2-v1) and compute synthetic sea surface height (SSH) data by interpolating the model grids at the time and location of “true” along-track satellite altimetry measurements, focusing on the Jason-1 operating period (i.e., 2002–2009). These synthetic SSH data are then treated as “real” altimetry measurements, allowing us to test the different averaging methods used by the two processing groups for computing the GMSL: (1) averaging along-track altimetry data (as done by CU) or (2) gridding the along-track data into $2^{\circ }\times 2^{\circ }$ meshes and then geographical averaging of the gridded data (as done by AVISO). We also investigate the effect of considering or not SSH data at shallow depths $({<}120~\hbox {m})$ as well as the editing procedure. We find that the main difference comes from the averaging method with significant differences depending on latitude. In the tropics, the $2^{\circ }\times 2^{\circ }$ gridding method used by AVISO overestimates by 11 % the GMSL trend. At high latitudes (above $60^{\circ }\hbox {N}/\hbox {S}$ ), both methods underestimate the GMSL trend. Our calculation shows that the CU method (along-track averaging) and AVISO gridding process underestimate the trend in high latitudes of the northern hemisphere by 0.9 and 1.2 mm/year, respectively. While we were able to attribute the AVISO trend overestimation in the tropics to grid cells with too few data, the cause of underestimation at high latitudes remains unclear and needs further investigation.